Seawater carbonate chemistry and calcification rate of eastern oyster Crassostrea virginica, 2011

Anthropogenic carbon dioxide (CO2) emissions reduce pH of marine waters due to the absorption of atmospheric CO2 and formation of carbonic acid. Estuarine waters are more susceptible to acidification because they are subject to multiple acid sources and are less buffered than marine waters. Consequently, estuarine shell forming species may experience acidification sooner than marine species although the tolerance of estuarine calcifiers to pH changes is poorly understood. We analyzed 23 years of Chesapeake Bay water quality monitoring data and found that daytime average pH significantly decreased across polyhaline waters although pH has not significantly changed across mesohaline waters. In some tributaries that once supported large oyster populations, pH is increasing. Current average conditions within some tributaries however correspond to values that we found in laboratory studies to reduce oyster biocalcification rates or resulted in net shell dissolution. Calcification rates of juvenile eastern oysters, Crassostrea virginica, were measured in laboratory studies in a three-way factorial design with 3 pH levels, two salinities, and two temperatures. Biocalcification declined significantly with a reduction of ~0.5 pH units and higher temperature and salinity mitigated the decrease in biocalcification.

Laboratory Investigation of Diluted Bitumen Trapping and Dissolution in Gravel

The Canadian economy is largely dependent on the distribution of large volumes of oil to domestic and international markets by a long network of pipelines. Unfortunately, accidents occur, and oil can leak or spill from these pipelines before it reaches its destination. Of particular concern are the long-term consequences of oil spills in freshwater, which include sinking of oil in water and the contamination of sensitive areas, such as where fish (e.g., salmon) deposit their eggs in gravel-dominated river sediments. There is a knowledge gap regarding the fate and behaviour of oil in river sediment. To this end, this study aimed at finding the potential for diluted bitumen (dilbit) oil to become trapped in gravel and to transfer hydrocarbons into water by dissolution, which are harmful to aquatic life. Two sets of laboratory experiments were conducted to simulate conditions of an oil spill on an exposed bank or in shallow water. In the first set, by conducting capillary pressure-saturation (Pc-Sw) experiments it was found that dilbit can enter gravel pores without much resistance and approximately 14% of the pore volume can be occupied by discontinuous single or multipore blobs of dilbit following imbibition of water. Air-water Pc-Sw experiments done in laboratory 1-D columns required gravity correction and could be successfully scaled to predict dilbit-water Pc-Sw curves, except for the trapped amount of dilbit. Trapped dilbit constituents can be dissolved into the water flowing through gravel pores (hyporheic flow) at different velocities. In the second set, dissolution experiments suggested that for the duration of the test, hydrocarbons that cause acute toxicity dissolve rapidly, likely resulting in a decrease in their effective solubility. However, dilbit saturation changed only <2% within that time. Chronically toxic PAH compounds were also detected in the effluent water. The total concentration of all detected PAHs and alkylPAHs exceeded the threshold literature value to protect early-life stage fish. Observations of decreased concentrations with increased aqueous velocities as well as less than equilibrium concentrations indicated that the mass transfer was rate-limited. A correlation was developed for the mass transfer rate coefficient to understand the mass transfer behaviour beyond the conditions used in the experiments, which had a Reynolds number exponent similar to the studies of NAPL dissolution in groundwater.

Biostratigraphy and average linear sedimentation rate and accumulation rate of ODP Site 159-959 (Table 1)

Reconstructing the long-term evolution of organic sedimentation in the eastern Equatorial Atlantic (ODP Leg 159) provides information about the history of the climate/ocean system, sediment accumulation, and deposition of hydrocarbon-prone rocks. The recovery of a continuous, 1200 m long sequence at ODP Site 959 covering sediments from Albian (?) to the present day (about 120 Ma) makes this position a key location to study these aspects in a tropical oceanic setting. New high resolution carbon and pyrolysis records identify three main periods of enhanced organic carbon accumulation in the eastern tropical Atlantic, i.e. the late Cretaceous, the Eocene-Oligocene, and the Pliocene-Pleistocene. Formation of Upper Cretaceous black shales off West Africa was closely related to the tectonosedimentary evolution of the semi-isolated Deep Ivorian Basin north of the Côte d'Ivoire-Ghana Transform Margin. Their deposition was confined to certain intervals of the last two Cretaceous anoxic events, the early Turonian OAE2 and the Coniacian-Santonian OAE3. Organic geochemical characteristics of laminated Coniacian-Santonian shales reveal peak organic carbon concentrations of up to 17% and kerogen type I/II organic matter, which qualify them as excellent hydrocarbon source rocks, similar to those reported from other marginal and deep sea basins. A middle to late Eocene high productivity period occurred off equatorial West Africa. Porcellanites deposited during that interval show enhanced total organic carbon (TOC) accumulation and a good hydrocarbon potential associated with oil-prone kerogen. Deposition of these TOC-rich beds was likely related to a reversal in the deep-water circulation in the adjacent Sierra Leone Basin. Accordingly, outflow of old deep waters of Southern Ocean origin from the Sierra Leone Basin into the northern Gulf of Guinea favored upwelling of nutrient-enriched waters and simultaneously enhanced the preservation potential of sedimentary organic matter along the West African continental margin. A pronounced cyclicity in the carbon record of Oligocene-lower Miocene diatomite-chalk interbeds indicates orbital forcing of paleoceanographic conditions in the eastern Equatorial Atlantic since the Oligocene-Miocene transition. A similar control may date back to the early Oligocene but has to be confirmed by further studies. Latest Miocene-early Pliocene organic carbon deposition was closely linked to the evolution of the African trade winds, continental upwelling in the eastern Equatorial Atlantic, ocean chemistry and eustatic sea level fluctuations. Reduction in carbonate carbon preservation associated with enhanced carbon dissolution is recorded in the uppermost Miocene (5.82-5.2 Ma) section and suggests that the latest Miocene carbon record of Site 959 documents the influence of corrosive deep waters which formed in response to the Messinian Salinity Crisis. Furthermore, sea level-related displacement of higher productive areas towards the West African shelf edge is indicated at 5.65, 5.6, 5.55, 5.2, 4.8 Ma. In view of humid conditions in tropical Africa and a strong West African monsoonal system around the Miocene-Pliocene transition, the onset of pronounced TOC cycles at about 5.6 Ma marks the first establishment of upwelling cycles in the northern Gulf of Guinea. An amplification in organic carbon deposition at 3.3 Ma and 2.45 Ma links organic sedimentation in the tropical eastern Equatorial Atlantic to the main steps of northern hemisphere glaciation and testifies to the late Pliocene transition from humid to arid conditions in central and western African climate. Aridification of central Africa around 2.8 Ma is not clearly recorded at Site 959. However, decreased and highly fluctuating carbonate carbon concentrations are observed from 2.85 Ma on that may relate to enhanced terrigenous (eolian) dilution from Africa.

Sensitization to indoor aeroallergens in children who attended the Allergy Service of the “Dr. José Eleuterio González” University Hospital of Monterrey, Mexico

Background: Indoor aeroallergens are the main cause of sensitization in children and represent a risk factor for the development of allergic diseases. Objective: Identify the major indoor aeroallergens most often sensitized to pediatric patients treated at the Allergy Service at the “Dr. José Eleuterio González” University Hospital of Monterrey Methods: We performed an observational and descriptive study where we reviewed reports of positive skin tests to the following common indoor aeroallergens: Dermatophagoides farinae (D. farinae), Dermatophagoides pteronyssinus (D. pteronyssinus), Canis familiaris (C. familiaris), Felis domesticus (F. domesticus), Blattella germanica (B. germanica) and Periplaneta americana (P. americana), found in patients under 16 years with symptoms of allergy, during the period of 2011-2012. Results: We performed 439 skin tests to aeroallergens in pediatric patients. Of these, 57.6% were male and 42.4% were female. Mean age was 6.3 years. The age groups were under 3 years: 17.8%, 3-5 years: 35%, 6-12 years: 36%, and 13-16 years: 11.2%. The main diagnoses were: allergic rhinitis (71.8%), asthma (16.6%), and atopic dermatitis (4.3%). In 57.9% of the cases, they had at least one positive skin test to any aeroallergen. The rate of sensitization to speciic aeroallergens was: D. Pteronyssinus 49.0%, D. farinae 44.6%, B. germanica 13.9%, P. Americana 10.9%, F. domesticus 10.7%, and C. familiaris 5.9%. Conclusion: Indoor aeroallergen sensitization can occur early in life, although it was more frequent in the preschooler and elementary school group. Dust house mites were the most commom cause of allergic sensitization.

Effect of pH and temperature on the carbonate promoted dissolution of sodium meta-autunite

Release of uranium from Na-autunite, an artificial mineral created as a result of polyphosphate injection in the subsurface at the DOE Hanford Site, takes place during slow dissolution of the mineral structure. Stability information of the uranyl-phosphate phases is limited to conditions involving pH, temperature, and a few aqueous organic materials. The carbonate ion, which creates very strong complexes with uranium, is the predominant ion in the groundwater composition. The polyphosphate technology with the formation of autunite was identified as the most feasible remediation strategy to sequester uranium in contaminated groundwater and soil in situ. The objectives of the experimental work were (i) to quantify the effect of bicarbonate on the stability of synthetic sodium meta-autunite created as a result of uranium stabilization through polyphosphate injection, (ii) calculate the kinetic rate law parameters of the uranium release from Na-autunite during dissolution, and (iii) to compare the process parameters with those obtained for natural calcium meta-autunite. Experiments were conducted using SPTF apparatus, which consists of syringe pumps for controlling flow rate, Teflon reactors and a heating/cooling system. 0.25 grams of synthetic Na-autunite was placed in the reactor and buffer solutions with varying bicarbonate concentrations (0.0005 to 0.003 M) at different pH (6 - 11) were pumped through the reactors. Experiments were conducted at four different temperatures in the range of 5 - 60oC. It was concluded that the rate of release of uranium from synthetic Na-autunite is directly correlated to the bicarbonate concentration. The rate of release of uranium increased from 1.90 x 10-12 at pH 6 to 2.64 x 10-10 (mol m-2 s-1) at pH 11 at 23oC over the bicarbonate concentration range tested. The activation energy values were invariant with the change in the bicarbonate concentration; however, pH is shown to influence the activation energy values. Uranyl hydroxides and uranyl carbonates complexes helped accelerate the dissolution of autunite mineral.

Raman microscopy of formamide-intercalated kaolinites treated by controlled-rate thermal analysis technology

Raman spectroscopy of formamide-intercalated kaolinites treated using controlled-rate thermal analysis technology (CRTA), allowing the separation of adsorbed formamide from intercalated formamide in formamide-intercalated kaolinites, is reported. The Raman spectra of the CRTA-treated formamide-intercalated kaolinites are significantly different from those of the intercalated kaolinites, which display a combination of both intercalated and adsorbed formamide. An intense band is observed at 3629 cm-1, attributed to the inner surface hydroxyls hydrogen bonded to the formamide. Broad bands are observed at 3600 and 3639 cm-1, assigned to the inner surface hydroxyls, which are hydrogen bonded to the adsorbed water molecules. The hydroxyl-stretching band of the inner hydroxyl is observed at 3621 cm-1 in the Raman spectra of the CRTA-treated formamide-intercalated kaolinites. The results of thermal analysis show that the amount of intercalated formamide between the kaolinite layers is independent of the presence of water. Significant differences are observed in the CO stretching region between the adsorbed and intercalated formamide.

Hydrazine-hydrate intercalated halloysite under controlled-rate thermal analysis conditions

The thermal behaviour of halloysite fully expanded with hydrazine-hydrate has been investigated in nitrogen atmosphere under dynamic heating and at a constant, pre-set decomposition rate of 0.15 mg min-1. Under controlled-rate thermal analysis (CRTA) conditions it was possible to resolve the closely overlapping decomposition stages and to distinguish between adsorbed and bonded reagent. Three types of bonded reagent could be identified. The loosely bonded reagent amounting to 0.20 mol hydrazine-hydrate per mol inner surface hydroxyl is connected to the internal and external surfaces of the expanded mineral and is present as a space filler between the sheets of the delaminated mineral. The strongly bonded (intercalated) hydrazine-hydrate is connected to the kaolinite inner surface OH groups by the formation of hydrogen bonds. Based on the thermoanalytical results two different types of bonded reagent could be distinguished in the complex. Type 1 reagent (approx. 0.06 mol hydrazine-hydrate/mol inner surface OH) is liberated between 77 and 103°C. Type 2 reagent is lost between 103 and 227°C, corresponding to a quantity of 0.36 mol hydrazine/mol inner surface OH. When heating the complex to 77°C under CRTA conditions a new reflection appears in the XRD pattern with a d-value of 9.6 Å, in addition to the 10.2 Ĺ reflection. This new reflection disappears in contact with moist air and the complex re-expands to the original d-value of 10.2 Å in a few h. The appearance of the 9.6 Å reflection is interpreted as the expansion of kaolinite with hydrazine alone, while the 10.2 Å one is due to expansion with hydrazine-hydrate. FTIR (DRIFT) spectroscopic results showed that the treated mineral after intercalation/deintercalation and heat treatment to 300°C is slightly more ordered than the original (untreated) clay.