(Table 1) Elements at DSDP Section 93-605-66-1

The oldest sediments cored at Site 605 are upper Maestrichtian argillaceous limestone (Hole 605, Subunit VB). The terrigeneous silt content of the uppermost Maestrichtian is quite low, averaging about 3%, whereas the carbonate content is high, usually greater than 60%; the silt contains only traces of glauconite (Site 605 chapter, this volume). Within Subunit VB a K/T boundary was defined by planktonic foraminifers. It was expected to be spread over an extended vertical interval because of the continental margin depositional setting. Examination by the shipboard party showed that the K/T boundary occurs in Section 605-66-1, between 70 and 75 cm. At the contact, the foraminiferal Globigerina pseudobulloides Zone (PIc) and the Coccolith Cruciplacolithus primus Subzone (CPla) overlie, respectively, the Abathomphalus mayaroensis and Nephrolithus frequens zones (Site 605). However, the thin K/T boundary clay, which is always present in complete sections, was not found, indicating either that the K/T boundary clay was not present or, more likely, that it was washed away during the coring operation.

(Table 1) Ooze/chalk cycles: frequency of occurrence at DSDP Leg 74 Sites

Shallow- to deep-water environments are represented by the sediments and rocks recovered from the Walvis Ridge- Angola Basin transect. These calcareous oozes, chalks, limestones, and volcaniclastic sedimentary rocks are used to define and correlate four lithostratigraphic units. The sediments were deposited in cycles which represent recurring tectonic or Oceanographic events and may be related to climatic fluctuations and orbital perturbations. Turbidites are the most common and easily identified sedimentary cycle. They are Late Cretaceous to Paleocene in age and are repeated in intervals ranging from thousands to tens of thousands of years. They are also found interbedded between basalt layers. Turbidites are easily distinguished from the other cycles present by their sedimentary structures, mineral composition, alteration products, and physical properties (GRAPE) data. Large-scale turbidites, debris, or slump breccias are found at or just above the Cretaceous/Tertiary boundary and indicate an event of considerable energy possibly related to intense tectonic activity. Diagenetic cycles, interpreted as small-scale dissolution cycles or sequences produced by biogenic activity, occur in early Paleocene chalks. The recurrence intervals average -20,000 y. but have a wide range of values. Variations in CaCO3 content, color, gradational boundaries, and trace fossil content characterize these sediments. These cycles reflect bottom-water conditions. Ooze-chalk cycles occur in upper Oligocene to upper Paleocene sediments and represent conditions that once existed at the sediment/water interface where they obtained their diagenetic potential. These oscillations are repeated over tens of thousands of years and may have no modern analogs. Color variations in sediments at the Cretaceous/Tertiary boundary indicate local fluctuations in oxygen content within the sediments or the water column. This situation lasted for several hundred thousand years and is not repeated elsewhere in the sequence. Large dissolution cycles are recorded in the sediments at Site 527 that are of middle Miocene and early Oligocene to middle Eocene age. During this time the seafloor at this site appears to have been located at or subsided to a depth occupied by a fluctuating CCD and lysocline.

Calcium carbonate concentrations of ODP Sites 113-689 and 113-690

An almost continuous Upper Cretaceous through Pleistocene biogenic sediment section was recovered from two sites on Maud Rise, a volcanic edifice in the Weddell Sea, off eastern Antarctica. Calcium carbonate values were determined for 1100 closely spaced samples using a Coulometrics CO2 Coulometer. Following a very brief decrease in the percentage of calcium carbonate immediately above the Cretaceous/Tertiary boundary, values remain high (~70%-80%), throughout most of the Paleocene, with variations primarily attributed to changes in the relative abundance of terrigenous and biogenic components. A small general decrease in calcium carbonate is observed from the upper Paleocene to lower middle Eocene. Eocene values continue to show small to moderate fluctuations. These fluctuations become more pronounced in the Oligocene as biosiliceous and carbonate sediments are mixed and interlayered. A distinct decrease in the calcium carbonate component is observed in the upper Oligocene through lower middle Miocene. Calcium carbonate becomes dominant again in the middle and lower upper Miocene, followed by almost exclusive biosiliceous sedimentation until the Pleistocene, where foraminifer-dominated calcareous ooze was recovered. Interpretation of this data will be carried out when a more finalized chronostratigraphy for the sequence has been produced.

Osmium isotopic composition and platinum group element concentrations in sediments from ODP Hole 145-886C

Paired analyses of Os isotope composition and concentration of bulk sediment and leachable Os in a metalliferous pelagic clay sequence from the North Pacific, ODP Site 886C, are used to reconstruct the marine Os isotope record and the particulate meteoritic Os flux between 65.5 and 78 Ma. Measured 187Os/188Os of bulk sediments ranges from approximately 0.64 to 0.32 and those of leach analyses are very similar to bulk analyses. Hydrogenous Os dominates the sedimentary Os inventory throughout most of the studied interval. As a result the measured 187Os/188Os of leachable Os approximates that of contemporaneous seawater. The ODP 886C record shows rising 187Os/188Os in the deepest portion of the core, with a local maximum of 0.66 close to 74 Ma. The 67-72 Ma portion of the record is characterized by nearly constant 187Os/188Os ratios close to 0.6. The structure of the marine Os isotope record from ODP 886C differs markedly from the seawater 87Sr/86Sr curve, which rises monotonically throughout the time interval studied here. Calculated particulate meteoritic Os fluxes are between 0.5 and 2 pg/cm**2/kyr throughout most of the studied interval. Two discrete intervals of the core (one of which is within Cretaceous Tertiary, boundary KTB interval) are characterized by higher fluxes of meteoritic Os. Excluding these two intervals, the average background flux of particulate meteoritic Os is roughly half of that estimated from analyses of Cenozoic marine sediments. These are the first Os isotope data to provide evidence of resolvable temporal variations in the background flux of particulate meteoritic material to the Earth.

Abundance of calcareous nannofossils in ODP Hole 121-752B (Table 1)

A biostratigraphically complete Cretaceous/Tertiary boundary was recovered during Ocean Drilling Program Leg 121. The boundary, cored in ODP Hole 752B on Broken Ridge, is the most expanded deep-sea section yet recovered by ODP/DSDP. The initial Danian subzone, CP la, spans nearly 5 m and the underlying uppermost Maestrichtian Nephrolithus frequens Zone extends 50 m below the boundary. The paleolatitude of Broken Ridge at Cretaceous/Tertiary time is estimated at 50°-55°S which includes this site among the latest in a series of complete or near complete high southern latitude Cretaceous/Tertiary boundary sections recovered by ODP (Leg 113 Site 690 and Leg 119 Site 738). The boundary at Site 752 lies at the base of a thick (6-6.5 m) volcanic ash unit composed of multiple ash layers which overlies indurated Maestrichtian chalks. Magnetostratigraphy indicates that the boundary lies within Subchron 29R, which is the case for all other known complete sections for which the polarity has been determined. Anomalous abundances of the trace element iridium are present at the boundary. A second iridium peak, 80 cm above the boundary, corresponds to an increase in redeposited Cretaceous nannofossils. The nannofossil succession is similar to that found at previously studied austral high-latitude ODP drill sites with few differences due to the more northerly location of this site. Individual nannofossil species were counted and placed into three categories. A plot of the percent abundance of Cretaceous, Tertiary, and 'survivor' groups illustrates the rapid replacement of the Cretaceous nannoflora by 'survivor' forms beginning at the boundary and the dominance of this latter group through the initial Danian biozone. This 'survivor' or opportunistic assemblage is then rapidly replaced by newly evolved Tertiary taxa. The assemblage of the uppermost Maestrichtian is biased toward dissolution-resistant forms such as Micula decussata. In those few intervals where preservation is good, the dissolution susceptible species, Prediscosphaera stoveri, is more prevalent and overall diversity of the assemblage is higher. The 'survivor' assemblage is dominated by Zygodiscus sigmoides and Thoracosphaera. The Tertiary assemblage consists of rare Biantholithus sparsus, the first of this group to appear. It is followed several meters upsection by Cruciplacolithus primus. Cruciplacolithus tenuis and small Prinsius spp. dominate the assemblage beginning at about 5 m above the boundary.

(Table 1) Magnetozone boundaries, age and sedimentation rate at DSDP Hole 93-605

Natural Remanent Magnetization (NRM) was measured for regularly spaced samples from the 620-m-thick, lower middle Eocene to upper Maestrichtian section of DSDP Site 605. The total NRM of the Eocene chalks was too low (5-50 µA/m) to establish a reliable magnetic polarity stratigraphy. However, the results from the somewhat more clayrich Paleocene-upper Maestrichtian section are useful. A fourfold quality classification of the results of progressive demagnetization studies aided in determining the polarity of the original remanence. Two types (1 and 2a) showed a Characteristic Remanent Magnetization (ChRM) direction with reversed and normal polarity, respectively; the third type (2b) can be interpreted as having a reversed ChRM, which could not be cleaned, whereas the fourth type (3) is considered to be unreliable. The Site 605 magnetic polarity stratigraphy compares well with published sections, adding important detail to the correlation with planktonic microfossil zones and, hence, to the resolution of this portion of the time scale (C24-C32 on the Berggren et al., 1985, scale). The Cretaceous/Tertiary boundary occurs in a reversed polarity zone that has been correlated with Subchron C29r. We suspect the presence of an unconformity at the boundary between lithostratigraphic Units Va and IV a location which is also the level of Reflection Horizon A*.

Catalog of fossil spores and pollen,

Cumulative index: v. 11-20, 1965. v. 21-30, 1970. v. 31-40, 1977.

Microchemistry and microstructures of hydrothermally altered shock-metamorphosed basement gneiss, Woodleigh impact structure, Southern Carnarvon Basin, Western Australia

Hydrothermally altered shock-metamorphosed gneisses consisting of relic igneous biotite-K-feldspor-Na-rich alkali feldspar - plagioclase - quartz assemblages ( accessory garnet, corundum, titanite, monazite, zircon), and showing extensive replacement by montmorillonite, illite, sericite, and to a lesser extent chlorite, calcite, epidote, zoisite and pyrite, occur in the basement core uplift of the Woodleigh impact structure, Western Australia. The rocks display extensive hydrothermal clay alteration, complicating identification of pre-hydrothermal and pre-impact textures and compositions. Analysis of quartz-hosted planar deformation features (PDFs) indicates a majority of indexed sets parallel to omega{10 (1) over bar3}, a lesser abundance of sets parallel to pi{10 (1) over bar2}, and some sets parallel to the basal plane (0001) and r,z {10 (1) over bar1}, consistent with pressures about or over 20 GPa. Feldspar-hosted FDFs form reticulate vein networks displaying checkerboard-like to irregular and serrated patterns attributable to preferential replacement of shock-damaged PDFs and/or perthitic twin lamella by clay minerals. The gneisses are pervaded by clay-dominated intergranular and intragranular veins of cryptocrystalline material that display marked departures from bulk-rock chemistry and from mineral compositions. XRD analysis identifies the cryptocrystalline components as illite - montmorillonite, illite and chlorite, while laser Raman analysis identifies high-fluorescence sub-micrometre clay assemblage, feldspar, quartz and minor mica. SEM/EDS-probe and laser-ICPMS analysis indicate low-K high-Mg clay mineral compositions consistent with montmorillonite. Quartz PDF-hosted cryptocrystalline laminae display distinct enrichments in Al, Mg, Ca and K. Altered intergranular veins and feldspar-hosted cryptocrystalline components show consistent enrichment in the relatively refractory elements (Al, Cc, Mg, Fe) and depletion in relatively volatile elements (Si, K, Na). The clay alteration retards determination whether clay-dominated vein networks represent altered shock-induced pseudotachylite veins, diaplectic zones and/or shock-damaged twin lamella, and/or result from purely mineralogical and chemical differentiation affected by hydrothermal fluids, Overall enrichment of the shocked gneiss and of the cryptocrystalline components in Mg and trace ferromagnesian elements (Ni, Cc, Cr) may be attributed alternatively to introduction of siderophile element-rich fluid from the projectile, or/and contamination of hydrothermal fluids by MgO from dolomites surrounding the basement uplift. High Ni/Co and Ni/Cr and anomalous DGE (platinum group elements) may support the former model.

Mineralogy, geochemistry and elemental ratios of ODP Core 171B-1049C-8X

Inorganic geochemistry and mineralogy of Core 171B-1049C-8X, containing a Cretaceous/Tertiary boundary section, was investigated by X-ray fluorescence (XRF) and X-ray diffraction (XRD). The ages of samples analyzed stretched from the latest Maastrichtian into the Danian. XRD measurements were made using the peak height method. A reduction in low-magnesium calcite and an increase in quartz were found above the spherule layer. Substantial amounts of dolomite were noted just above the spherule layer. XRF analyses were performed using the RHSMALL program to measure the abundance of major and minor elements. Replicate analyses for each technique were performed to assess the precision of the results. The section above the spherule bed was found to be characterized by peaks in many elements, including Si, Al, Fe, and Mg, as well as the following elemental ratios: Fe/Al, Ni/Al, Zr/Rb, and Rb/Sr'. Above the spherule bed, there were significant reductions in Ca, Sr/Ca, Ti/Al, K/Al, Rb/Al, Cr/Al, Ba/Al, biogenic Ba, and excess P.