Variation in response of Schistosoma mansoni strains to schistosomicides

The BH strain of Schistosoma mansoni was found to be highly susceptible, to hy cant hone (1 x 80 mg/kg), oxamniquine (1 x 100 mg/kg) niridazole (5 x 100 mg/kg), praziquantel (1 x 100 mg/kg), oltipraz (5 x 125 mg/kg) and amoscanate (1 x 300 mg/kg) and is therefore a good reference strain for chemotherapeutic trials. By contrast, the MPR-1 strain was shown to have developed resistance to oxamniquine without ever having been dosed with oxamniquine. Other oxamniquine/hycanthone resistant strains were shown to have maintained their resistance and a strain believed to be partially resistant to oltipraz was evaluated.

Use of saprophytic leptospira strains in the serodiagnosis of experimental leptospirosis in guinea-pigs (Cavia sp)

The efficiency of four Leptospira biflexa strains (Buenos Aires, Patoc 1, Rufino and São Paulo) as single antigen in the serodiagnosis in guinea-pigs experimentally infected with seven Leptospira interrogans serovars (canicola, grippotyphosa, hardjo, icterohaemorrhagiae, pomona, tarassovi and wolffi) was evaluated by the microscopic agglutination test. The four saprophytic strains were not able to reveal antibody titres in sera of guinea-pigs experimentally infected with Leptospira interrogans. Serological cross-reactions were observed between strains Patoc 1 and São Paulo and between serovars wolffi and hardjo.

Finite Element Analysis (FEA) applied to heat transfer optimization process of pultrusion die systems

The aim of this study is to optimize the heat flow through the pultrusion die assembly system on the manufacturing process of a specific glass-fiber reinforced polymer (GFRP) pultrusion profile. The control of heat flow and its distribution through whole die assembly system is of vital importance in optimizing the actual GFRP pultrusion process. Through mathematical modeling of heating-die process, by means of Finite Element Analysis (FEA) program, an optimum heater selection, die position and temperature control was achieved. The thermal environment within the die was critically modeled relative not only to the applied heat sources, but also to the conductive and convective losses, as well as the thermal contribution arising from the exothermic reaction of resin matrix as it cures or polymerizes from the liquid to solid condition. Numerical simulation was validated with basis on thermographic measurements carried out on key points along the die during pultrusion process.

Optimizing the embedded heaters position in the pultrusion process using finite element analysis

This study is based on a previous experimental work in which embedded cylindrical heaters were applied to a pultrusion machine die, and resultant energetic performance compared with that achieved with the former heating system based on planar resistances. The previous work allowed to conclude that the use of embedded resistances enhances significantly the energetic performance of pultrusion process, leading to 57% decrease of energy consumption. However, the aforementioned study was developed with basis on an existing pultrusion die, which only allowed a single relative position for the heaters. In the present work, new relative positions for the heaters were investigated in order to optimize heat distribution process and energy consumption. Finite Elements Analysis was applied as an efficient tool to identify the best relative position of the heaters into the die, taking into account the usual parameters involved in the process and the control system already tested in the previous study. The analysis was firstly developed with basis on eight cylindrical heaters located in four different location plans. In a second phase, in order to refine the results, a new approach was adopted using sixteen heaters with the same total power. Final results allow to conclude that the correct positioning of the heaters can contribute to about 10% of energy consumption reduction, decreasing the production costs and leading to a better eco-efficiency of pultrusion process.

Entamoeba histolytica: antigenic characterization of axenic strains from Brazil

Trophozoites from cultures of Entamoeba histolytica strains isolated and grown axenically in Brazil (ICB-CSP, ICB-462 and ICB-32) were used for immune sera production and for characterization of their antigens by using electrophoretic and glycoproteic profiles, in parallel with a standard strain isolated and kept under axenic conditions in USA (HK-9). Hyperimmune sera, presenting high antibody titers with homologous and heterologous antigens, were obtained. The four strains in study revealed similar and complex electrophoretic and glycoproteic profiles showing polypep-tides with molecular weights ranging from 200 to less than 29 kDa. No significant differences were detected between the pathogenic and non-pathogenic strains.

Congruences on monoids of transformations preserving the orientation on a finite chain

Journal of Algebra, 321 (2009), p. 743–757

Immunoelectrophoretic study on common antigens of São Lourenço da Mata and Belo Horizonte strains of Schistosoma mansoni adult worms and Biomphalaria snails

Immunoelectrophoretic studies on common antigens were carried out by using rabbits sera immunized against São Lourenço da Mata and Belo Horizonte strains of Schistosoma mansoni adult worms and antigens of Biomphalaria glabrata pigmented (Jaboatão - PE); B. glabrata albino (Belo Horizonte - MG) and B. straminea (São Lourenço da Mata, PE). Furthermore, the reverse approach was proceeded, namely, sera anti Biomphalaria snails produced in rabbits were tested against both strains of Schistosoma adult worm antigens. The analysis of the common antigens between the SLM strains of S. mansoni adult worm and B. glabrata pigmented showed 8 to 9 precipitin bands, 3 bands with B. glabrata albino and only 1 band with B. straminea crude extracts. On the other hand, the BH strain of S. mansoni adult worm antisera produced 6 to 7 bands with B. glabrata pigmented, 5 bands with B. glabrata albino and 1 band with B. straminea antigenic extract. Biomphalaria snails crude extracts were fractionated by Sephadex G-100 column and three fractions were collected from each snail strain. The fractions were tested with anti SLM and BH strains of S. mansoni adult worm sera by immunoelectrophoresis. The common antigens fractionated from Biomphalaria snails crude extracts and those found for both strains of S. mansoni adult worm mostly existed in the first fraction and they were estimated to have molecular weight over 158,000 daltons. In our laboratory, it was found a relationship between the antigenic similarities and experimental infection rates of S. mansoni towards Biomphalaria snails so that more bands were seen with increasing infection rates of S. mansoni.

A novel colorimetric assay of beta-D-glucans in basidiomycete strains by alcian blue dye in a 96-well microtiter plate

Basidiomycete strains synthesize several types of beta-D-glucans, which play a major role in the medicinal properties of mushrooms. Therefore, the specific quantification of these beta-D-glucans in mushroom strains is of great biochemical importance. Because published assay methods for these beta-D-glucans present some disadvantages, a novel colorimetric assay method for beta-D-glucan with alcian blue dye was developed. The complex formation was detected by following the decrease in absorbance in the range of 620 nm and by hypsochromic shift from 620 to 606 nm (similar to 14 nm) in UV-Vis spectrophotometer. Analysis of variance was used for optimization of the slope of the calibration curve by using the assay mixture containing 0.017% (w/v) alcian blue in 2% (v/v) acetic acid at pH 3.0. The high-throughput colorimetric assay method on microtiter plates was used for quantification of beta-D-glucans in the range of 0-0.8 mu g, with a slope of 44.15 x 10(-2) and a limit of detection of 0.017 mu g/well. Recovery experiments were carried out by using a sample of Hericium erinaceus, which exhibited a recovery of 95.8% for beta-1,3-D-glucan. The present assay method exhibited a 10-fold higher sensitivity and a 59-fold lower limit of detection compared with the published method with congo red beta-D-glucans of several mushrooms strains were isolated from fruiting bodies and mycelia, and they were quantified by this assay method. This assay method is fast, specific, simple, and it can be used to quantify beta-D-glucans from other biological sources. (C) 2015 American Institute of Chemical Engineers

Antimicrobial resistance and plasmid detection in strains of the Bacteroides fragilis group

Resistant populations of the Bacteroides fragilis group bacteria (two reference ones and two isolated from human and Callithrix penicillata marmoset) were obtained by the gradient plate technique, to clindamycin, penicillin G, metronidazole and mercuric chloride. All the four tested strains were originaly susceptible to the four antimicrobial drugs at the breakpoint used in this study. MICs determination for the four cultures gave constant values for each antimicrobial, on the several steps by the gradient plate technique. The intestinal human B. fragilis strains showed three DNA bands, that could be representative of only two plasmids in the closed covalently circular (CCC) form with molecular weights of approximately 25 and 2.5 Md. The results do not permit an association between the presence of plasmid in the human strain with the susceptibility to the studied drugs. The four strains were ß-lactamase negative in the two methods used, and no particular chromosomal genetic resistance marker was demonstred. The resistance (MIC) observed, after contact with penicillin G and mercuric chloride, were two-fold in the four tested strains

Toroid inductor development for a SIC DC-DC converter up to 150kW, based on finite element method

Dissertação para a obtenção do grau de Mestre em Engenharia Electrotécnica Ramo de Energia

Layerwise mixed models for analysis of multilayered piezoelectric composite plates using least-squares formulation

This work provides an assessment of layerwise mixed models using least-squares formulation for the coupled electromechanical static analysis of multilayered plates. In agreement with three-dimensional (3D) exact solutions, due to compatibility and equilibrium conditions at the layers interfaces, certain mechanical and electrical variables must fulfill interlaminar C-0 continuity, namely: displacements, in-plane strains, transverse stresses, electric potential, in-plane electric field components and transverse electric displacement (if no potential is imposed between layers). Hence, two layerwise mixed least-squares models are here investigated, with two different sets of chosen independent variables: Model A, developed earlier, fulfills a priori the interiaminar C-0 continuity of all those aforementioned variables, taken as independent variables; Model B, here newly developed, rather reduces the number of independent variables, but also fulfills a priori the interlaminar C-0 continuity of displacements, transverse stresses, electric potential and transverse electric displacement, taken as independent variables. The predictive capabilities of both models are assessed by comparison with 3D exact solutions, considering multilayered piezoelectric composite plates of different aspect ratios, under an applied transverse load or surface potential. It is shown that both models are able to predict an accurate quasi-3D description of the static electromechanical analysis of multilayered plates for all aspect ratios.

An attemp at reversibility and increase of the virulence of axenic strains of Entamoeba histolytica

In this study we have tried to verify whether the interaction "in vitro" with bacteria or small pieces of normal hamster liver would modify the pathogenic behavior of axenic strains of E. histolytica: avirulent ones (ICB-32 and ICB-RPS), of attenuated virulence (ICB-CSP and HM1) and of mean virulence (ICB-462). Every attempt to render virulent, recover or increase the virulence of axenic strains of E. histolytica has failed

Susceptibility of Biomphalaria tenagophila and Biomphalaria glabrata from the same region to two Brazilian strains of Schistosoma mansoni

B. tenagophila snails from Ouro Branco, MG, showed positivity for S. mansoni, with infection rates of 5%, 10%, (SJ strain), and 1% (LE strain) using a pool of miracidia. The mollusks were found to be susceptive from the 3rd generation reared in laboratory onwards. The B. tenagophila (OB, MG) when individually exposed to 10 miracidia, showed infection rate of 2% for LE strain. B. glabrata snails from Gagé, MG, showed a positivity rate of 58% for S. mansoni (LE strain), under experimental conditions. The B. tenagophila from Cabo Frio, RJ and B. glabrata from Belo Horizonte, MG used as a control for SJ strain showed infection rates of 47% - 85% and 36% respectivily. For the LE strain, B. glabrata (BH, MG) used as control showed infection rate of 40% - 75%.

Investigation on the possibility of spontaneous cure of mice infected with different strains of Trypanosoma cruzi

Seventy Swiss mice chronically infected with different strains of Trypanosoma cruzi, with persistently negative parasitemia on routine blood examination were parasitologically investigated to find out whether spontaneous cure occurred. Duration of infection varied from 90 to 250 days in the initial phase of this investigation. Parasitological tests consisted of daily direct blood examination performed during at least 25 days, followed by xenodiagnosis and subinoculation of blood into newborn mice. Mice that persisted negative were treated with Cyclophosphamide with one dose of 250 mg/kg of body weight and then investigated by direct blood examination, xenodiagnosis and subinoculation. A second dose of 250 mg/kg b. w. was given to the persistently negative mice. With one single exception, all mice showed positive parasitological tests in the different stages of the present investigation and we conclude that spontaneous cure did not occur in this group, which is representative of the chronic infection with different strains of T cruzi.

Presentations for monoids of finite partial isometries

In this paper we give presentations for the monoid DPn of all partial isometries on {1,..., n} and for its submonoid ODPn of all order-preserving partial isometries.