Radiolaria in the surface layer of bottom sediments from the northern sector of the Benguela upwelling

Quantitative data on radiolarian assemblages from the Benguela upwelling at 17-25°S were obtained from analysis of 18 bottom sediment samples. The maximum abundance of Radiolaria (20000-40000 individuals per 1 g of sediment) was determined in sediments of the open ocean at depth 2000-4100 m. Species of tropical zones dominate in the assemblages; however content of species of subpolar and moderate zones reaches considerable values. In shelf sediments at depth 60-160 m abundance of Radiolaria (up to 5000 ind./g) is greater than in sediments of the continental slope. In shelf assemblages species of subpolar and temperate zones dominate. A characteristic feature of the shelf upwelling assemblages of Radiolaria is expressed by predominance of Lithomelissa setosa (Joerg.) (up to 50-80% at 23-25°S). L. setosa is a common representative of radiolarian assemblages of subpolar and temperate regions of the World Ocean. It is presumably regarded as an eurybiont species. Probably, it propagates with subantarctic intermediate water masses from the circumantarctic area to the Benguela upwelling region where there are favorable living conditions: subsurface water temperature is not higher than 10°C and there are high concentrations of nutrients.

(Table 1) Relarive abundance of foraminiferal species in the surface layer of bottom sediments from the Atlantic Ocean

Quantitative ratios of tests of planktonic foraminiferal species in thanatocoenoses within the surface layer of bottom sediments from Iceland to the Equator are described. Subarctic, boreal, subtropical and tropical types of thanatocoenoses and their subtypes are distinguished. Each subtype corresponds to a 2-3°C interval of mean annual temperature of the upper layer of ocean water. Comparison of fossil thanatocoenoses from Quaternary sediment cores with recent thanatocoenoses offers new potentials for paleotemperature analysis.

(Table 1) Iron and manganese speciations in surface layer bottom sediments of the Pacific Ocean

Distribution of iron and manganese speciations in ocean sediments of a section from the coast of Japan to the open Pacific Ocean is under consideration. Determinations of total iron, as well as of reactive iron contents and of total manganese, as well as of Mn4+ contents have been done. Significant increase of total Fe content in sediments from the coast to the pelagic zone occurs without noticeable increase in reactive Fe content. Presence of layers of volcanic and terrigenous coarse clastic material in clayey sediments results to sharp change in iron content. Manganese content increases from near coastal to pelagic sediments more than 10 times; oxidation degree of sediments also increases. There are three types of bottom sediments different by contents of iron and manganese forms: reduced, oxidized (red clay), and transitional. Content of total Fe is almost does not change with depth in sediments, content of reactive Fe increases in reduced sediments, and decreases in oxidized ones. Manganese content in red clay mass increases several times.

An interactive and adaptive building layer : strategies for allowing people to become advanced building-users

This paper reports outcomes of a pilot study to develop a conceptual framework to allow people to retrofit a building-layer to gain better control of their own built- environments. The study was initiated by the realisation that discussions surrounding the improvement of building performances tend to be about top-down technological solutions rather than to help and encourage bottom-up involvement of building-users. While users are the ultimate beneficiaries and their feedback is always appreciated, their direct involvements in managing buildings would often be regarded as obstruction or distraction. This is largely because casual interventions by uninformed building-users tend to disrupt the system. Some earlier researches showed however that direct and active participation of users could improve the building performance if appropriate training and/or systems were introduced. We also speculate this in long run would also make the built environment more sustainable. With this in mind, we looked for opportunities to retrofit our own office with an interactive layer to study how we could introduce ad-hoc systems for building-users. The aim of this paper is to describe our vision and initial attempts followed by discussion.

A comparison study on hydrogen sensing performance of Pt/MoO3 nanoplatelets coated with a thin layer of Ta2O5 or La2O3

In this work, we investigate how hydrogen sensing performance of thermally evaporated MoO3 nanoplatelets can be further improved by RF sputtering a thin layer of tantalum oxide (Ta2O5) or lanthanum oxide (La2O3). We show that dissociated hydrogen atoms cause the thin film layer to be polarised, inducing a measurable potential difference greater than that as reported previously. We attribute these observations to the presence of numerous traps in the thin layer; their states allow a stronger trapping of charge at the Pt-thin film oxide interface as compared to the MoO3 sensors without the coating. Under exposure to H2 (10 000 ppm) the maximum change in dielectric constant of 45.6 (at 260 °C) for the Ta2O5/MoO3 nanoplatelets and 31.6 (at 220 °C) for La2O3/MoO3 nanoplatelets. Subsequently, the maximum sensitivity for the Ta2O5/MoO3 is 16.87 (at 260 °C) and La2O3/MoO3 is 7.52 (at 300 °C).