Quality of certain ready-to-eat fish products of the domestic trade

Quality of 181 samples of ready-to-eat fish products comprising fried fish, fish curry and fish/prawn pickles collected from Cochin and Calicut were studied. Salmonella was absent in all the samples. V. cholerae was tested in the samples collected at Cochin and was absent in all the cases. Coliforms, E. coli, faecal streptococci and coagulase-positive staphylococci were present in some of the samples studied. The study indicated the necessity to improve the sanitary and hygienic conditions of the hotels engaged in the preparation of these products. The study further indicated that fried fish and fish curry shall not be served after 6 hours of their preparation. Added care is to be exercised in the selection of shrimps and fish for the preparation of pickles.

Quality of fish in retail markets of Bombay

Study carried out on the quality of fresh fish in retail markets of Bombay revealed that only 75% of the samples were of acceptable quality. Incidence of faecal streptococci was generally high, indicating poor sanitary and hygienic practices in handling of fresh fish. Total bacterial counts higher than Indian standard specified limits were observed in more than one third of the samples analysed. 7.5% of the samples were found to be contaminated either with Salmonella or Clostridium perfringens, thus posing a serious potential health hazard to the consumer. The quality of fish in different markets is also discussed. The urgent need for formulation and implementation of quality standards for fresh fish in domestic trade is highlighted.

Quality of commercial frozen boiled clam meat

The bacterial quality and sand content of commercial frozen boiled clam meat are discussed. In general the commercial frozen boiled clam meat belonging to the Villorita cyprinoides sp. collected from Cochin are highly contaminated with faecal indicator and pathogenic organisms than that belonging to the Katelysia opima sp. collected from Quilon. The studies also show that the bacterial quality of frozen boiled clam meat can be improved by enforcing better hygienic and sanitary practices.

Study ectoparasite infestation of 10 common imported freshwater ornamental fish species

In the present study, ectoparasite infestation of common freshwater ornamental fish species imported into Iran including: Dwarf gourami (Colisa lalia), Angelfish (Pterophyllum scalare), Oscar (Astronatus ocellatus), Red eye Tetra ( Moenkhansia Sanctaefilomenae), Barb( Capoeta tetrazona), Arowana (Osteoglossum bicirrhosum), Goldfish(Carassius auratus), Red fin Shark (Lebeo elythrurus, Catfish (Hypostomus plecostomus) and Pangasius sutchi ( Pangasius hypophthalmus) from May until April was investigated.A total of 6 specimens sample of each fish species) randomly were obtained and taken alive to the lab. After observing gill and skin wet smear under the microscope , gill was dissected and examined carefully .Photo and films were taken from the isolated parasites and parasite identification was performed according to Yamaguti AP1), Bychowsky (■Y).From a total of examined fishes 1\ ► sample (YY.V.) were parasitized .Parasite groups that were observed consisting ciliated protozoan myxosporidian , monogenean Digenean metacercaria and crustacean .The only non-parasitized fish was Barb. Monogenea Trianchoratus sp. , Cleidodiscus sp. , Ancylodiscoides sp. , Thaparocleidus sp. , Centrocestus formosanus metacercaria and Myxobolus longisporus report for the first time in ornamental fish which imported from Southeast of Asia to Iran. According to the results, it seems that severe quarantine and sanitary rules are necessary.

Representations and evolutionary operators for the scheduling of pump operations in water distribution networks.

Reducing the energy consumption of water distribution networks has never had more significance. The greatest energy savings can be obtained by carefully scheduling the operations of pumps. Schedules can be defined either implicitly, in terms of other elements of the network such as tank levels, or explicitly by specifying the time during which each pump is on/off. The traditional representation of explicit schedules is a string of binary values with each bit representing pump on/off status during a particular time interval. In this paper, we formally define and analyze two new explicit representations based on time-controlled triggers, where the maximum number of pump switches is established beforehand and the schedule may contain less switches than the maximum. In these representations, a pump schedule is divided into a series of integers with each integer representing the number of hours for which a pump is active/inactive. This reduces the number of potential schedules compared to the binary representation, and allows the algorithm to operate on the feasible region of the search space. We propose evolutionary operators for these two new representations. The new representations and their corresponding operations are compared with the two most-used representations in pump scheduling, namely, binary representation and level-controlled triggers. A detailed statistical analysis of the results indicates which parameters have the greatest effect on the performance of evolutionary algorithms. The empirical results show that an evolutionary algorithm using the proposed representations improves over the results obtained by a recent state-of-the-art Hybrid Genetic Algorithm for pump scheduling using level-controlled triggers.

A toolkit approach to solar radiation modelling.

Considerable effort is required to implement solar radiation models in software. Many existing implementations have efficiency as their main priority rather than re-usability, and this can adversely affect their further development since the relationships between the software and physical quantities may be obscured. The Solar Toolkit is an attempt to overcome such barriers by exploiting the current abundance of computing resource, and the availability of user-oriented tools such as Microsoft Excel®. The Solar Toolkit takes the form of a set of functions written in Visual Basic for Applications® (VBA) made available under the Academic Free Licence. Transparency is the overriding priority throughout the implementation so that the Toolkit can provide a platform for further modelling initiatives.

Solar photovoltaic system applications: a guidebook for off-grid electrification.

Presenting a complete guide for the planning, design and implementation of solar PV systems for off-grid applications, this book features analysis based on the authors’ own laboratory testing as well as their in the field experiences. Incorporating the latest developments in smart-digital and control technologies into the design criteria of the PV system, this book will also focus on how to integrate newer smart design approaches and techniques for improving the efficiency, reliability and flexibility of the entire system. The design and implementation of India’s first-of its-kind Smart Mini-Grid system (SMG) at TERI premises, which involves the integration of multiple renewable energy resources (including solar PV) through smart controllers for managing the load intelligently and effectively is presented as a key case study. Maximizing reader insights into the performance of different components of solar PV systems under different operating conditions, the book will be of interest to graduate students, researchers, PV designers, planners, and practitioners working in the area of solar PV design, implementation and assessment.

Environmental and Human Pathogenic Microorganisms

As the study of interactions between pathogenic microorganisms and their environment is part of microbial ecology, this chapter reviews the different types of human pathogens found in the environment, the different types of fecal indicators used in water quality monitoring, the biotic and abiotic factors affecting the survival and the infectivity of pathogenic microorganisms during their transportation in the environment, and the methods presently available to detect rare microorganisms in environmental samples. This chapter exclusively focuses on human pathogens.

Application of accelerated carbonation with a combination of Na2CO3 and CO2 in cement-based solidification/stabilization of heavy metal-bearing sediment

The efficient remediation of heavy metal-bearing sediment has been one of top priorities of ecosystem protection. Cement-based solidification/stabilization (s/s) is an option for reducing the mobility of heavy metals in the sediment and the subsequent hazard for human beings and animals. This work uses sodium carbonate as an internal carbon source of accelerated carbonation and gaseous CO2 as an external carbon source to overcome deleterious effects of heavy metals on strength development and improve the effectiveness of s/s of heavy metal-bearing sediment. In addition to the compressive strength and porosity measurements, leaching tests followed the Chinese solid waste extraction procedure for leaching toxicity - sulfuric acid and nitric acid method (HJ/T299-2007), German leaching procedure (DIN38414-S4) and US toxicity characteristic leaching procedures (TCLP) have been conducted. The experimental results indicated that the solidified sediment by accelerated carbonation was capable of reaching all performance criteria for the disposal at a Portland cement dosage of 10 wt.% and a solid/water ratio of 1: 1. The concentrations of mercury and other heavy metals in the leachates were below 0.10 mg/L and 5 mg/L, respectively, complying with Chinese regulatory level (GB5085-2007). Compared to the hydration, accelerated carbonation improved the compressive strength of the solidified sediment by more than 100% and reduced leaching concentrations of heavy metals significantly. It is considered that accelerated carbonation technology with a combination of Na2CO3 and CO2 may practically apply to cement-based s/s of heavy metal-bearing sediment. (C) 2008 Elsevier B.V. All rights reserved.

Precipitation of heavy metals from wastewater using simulated flue gas: sequent additions of fly ash, lime and carbon dioxide

Lime is a preferred precipitant for the removal of heavy metals from industrial wastewater due to its relatively low cost. To reduce heavy metal concentration to an acceptable level for discharge, in this work, fly ash was added as a seed material to enhance lime precipitation and the suspension was exposed to CO2 gas. The fly ash-lime-carbonation treatment increased the particle size of the precipitate and significantly improved sedimentation of sludge and the efficiency of heavy metal removal. The residual concentrations of chromium, copper, lead and zinc in effluents can be reduced to (mg L-1) 0.08, 0.14, 0.03 and 0.45, respectively. Examination of the precipitates by XRD and thermal analysis techniques showed that calcium-heavy metal double hydroxides and carbonates were present. The precipitate agglomerated and hardened naturally, facilitating disposal without the need for additional solidification/stabilization measures prior to landfill. It is suggested that fly ash, lime and CO2, captured directly from flue gas, may have potential as a method for wastewater treatment. This method could allow the ex-situ sequestration of CO2, particularly where flue-gas derived CO2 is available near wastewater treatment facilities. (C) 2009 Elsevier Ltd. All rights reserved.

Immobilisation of heavy metal in cement-based solidification/stabilisation: a review

Heavy metal-bearing waste usually needs solidification/stabilization (s/s) prior to landfill to lower the leaching rate. Cement is the most adaptable binder currently available for the immobilisation of heavy metals. The selection of cements and operating parameters depends upon an understanding of chemistry of the system. This paper discusses interactions of heavy metals and cement phases in the solidification/stabilisation process. It provides a clarification of heavy metal effects on cement hydration. According to the decomposition rate of minerals, heavy metals accelerate the hydration of tricalcium silicate (C3S) and Portland cement, although they retard the precipitation of portlandite due to the reduction of pH resulted from hydrolyses of heavy metal ions. The chemical mechanism relevant to the accelerating effect of heavy metals is considered to be H+ attacks on cement phases and the precipitation of calcium heavy metal double hydroxides, which consumes calcium ions and then promotes the decomposition Of C3S. In this work, molecular models of calcium silicate hydrate gel are presented based on the examination of Si-29 solid-state magic angle spinning/nuclear magnetic resonance (MAS/NMR). This paper also reviews immobilisation mechanisms of heavy metals in hydrated cement matrices, focusing on the sorption, precipitation and chemical incorporation of cement hydration products. It is concluded that further research oil the phase development during cement hydration in the presence of heavy metals and thermodynamic modelling is needed to improve effectiveness of cement-based s/s and extend this waste management technique. (C) 2008 Elsevier Ltd. All rights reserved.

Aqueous solution of anionic surfactants mixed with soils show a synergistic reduction in surface tension

Water retention and transport in soils is dependent upon the surface tension of the aqueous phase. Surfactants present in aqueous solution reduce the surface tension of aqueous phase. In soil–water systems, this can result in water drainage and reductions in field capacity and hydraulic conductivity. In this investigation, the surface tension of surfactant solutions mixed with soil—in a constant fixed ratio—was measured as a function of surfactant concentration. Two anionic surfactants were used: sodium dodecyl sulphate and sodium bis (2-ethylhexyl) sulfosuccinate. Two soils were also used—a clay soil and a sandy soil. The key observation made by this investigation was that the addition of soil to the surfactant solution provided a further component of surface tension reduction. Neither soil sample reduced the surface tension of water when surfactant was absent from the aqueous phase, though both soils released soil organic matter at low surfactant concentrations as shown by measurement of the chemical oxygen demand of the supernatant solutions. Furthermore, both surfactants were shown to be weakly adsorbed by soil as shown by the use of a methylene blue assay. It is therefore proposed that the additional reduction in surface tension arises from synergistic interactions between the surfactants and dissolved soil organic matter.

Influence of carbonation on the acid neutralization capacity of cements and cement-solidified/stabilized electroplating sludge

Portland cement (PC) and blended cements containing pulverized fuel ash (PFA) or granulated blast-furnace slag (GGBS) were used to solidify/stabilize an electroplating sludge in this work. The acid neutralization capacity (ANC) of the hydrated pastes increased in the order of PC > PC/GGBS > PC/PFA. The GGBS or PFA replacement (80 wt%) reduced the ANC of the hydrated pastes by 30–50%. The ANC of the blended cement-solidified electroplating sludge (cement/sludge 1:2) was 20–30% higher than that of the hydrated blended cement pastes. Upon carbonation, there was little difference in the ANC of the three cement pastes, but the presence of electroplating sludge (cement/sludge 1:2) increased the ANC by 20%. Blended cements were more effective binders for immobilization of Ni, Cr and Cu, compared with PC, whereas Zn was encapsulated more effectively in the latter. Accelerated carbonation improved the immobilization of Cr, Cu and Zn, but not Ni. The geochemical code PHREEQC, with the edited database from EQ3/6 and HATCHES, was used to calculate the saturation index and solubility of likely heavy metal precipitates in cement-based solidification/stabilization systems. The release of heavy metals could be related to the disruption of cement matrices and the remarkable variation of solubility of heavy metal precipitates at different pH values.

La réforme des systèmes d'approvisionnement et d'assainissement dans l'Union européenne

Ce chapitre s’intéresse à plusieurs pays de l’UE et souligne les principaux aspects de leur cadre institutionnel respectif concernant les activités d’appro-visionnement en eau et d’assainissement. Il fournit également des exemples de cas où la participation du secteur privé dans le domaine de l’eau a posé un pro-blème, et d’autres où le secteur public est en charge du réseau de distribution. Le choix des pays évoqués vise à présenter diverses expériences et divers contextes géopolitiques, de l’Europe méditerranéenne à l’Europe du Nord en passant par les pays d’Europe centrale et orientale. En outre, les pays choisis comptent à la fois d’anciens membres de l’Europe des 15 et des membres plus récents. La dernière partie du chapitre traite de l’infuence de la législation européenne sur la gestion et la fourniture de services de distribution en eau. [Introductory paragraph to paper - see Additional Information].