Numerical simulation of group combustion of pulverized coal

A mathematical model for the group combustion of pulverized coal particles was developed in a previous work. It includes the Lagrangian description of the dehumidification, devolatilization and char gasification reactions of the coal particles in the homogenized gaseous environment resulting from the three fuels, CO, H2 and volatiles, supplied by the gasification of the particles and their simultaneous group combustion by the gas phase oxidation reactions, which are considered to be very fast. This model is complemented here with an analysis of the particle dynamics, determined principally by the effects of aerodynamic drag and gravity, and its dispersion based on a stochastic model. It is also extended to include two other simpler models for the gasification of the particles: the first one for particles small enough to extinguish the surrounding diffusion flames, and a second one for particles with small ash content when the porous shell of ashes remaining after gasification of the char, non structurally stable, is disrupted. As an example of the applicability of the models, they are used in the numerical simulation of an experiment of a non-swirling pulverized coal jet with a nearly stagnant air at ambient temperature, with an initial region of interaction with a small annular methane flame. Computational algorithms for solving the different stages undergone by a coal particle during its combustion are proposed. For the partial differential equations modeling the gas phase, a second order finite element method combined with a semi-Lagrangian characteristics method are used. The results obtained with the three versions of the model are compared among them and show how the first of the simpler models fits better the experimental results.

A novel technique for polarisation mode dispersion measurements in optical fibres

A novel technique for determining the polarisation mode dispersion in optical fibres is described. The technique makes use of a sinusoidally frequency modulated source, and is applied to the measurement of the beat length of highly birefringent monomode fibre. The temporal delay between the two modes of the fibre is measured with a resolution of approximately ±0.6 ps.

An RZ DPSK receiver design with significantly improved dispersion tolerance

We show an improved DPSK receiver design which can increase useful dispersion tolerance by up to a factor of two. The increased dispersion tolerance is achieved through optimization of the optical filter at the receiver and the delay of the Mach-Zehnder interferometer. In this paper we fully explain the concept, quantify the gain and provide an explanation for the operation of the receiver. © 2007 Optical Society of America.

Experimental verification of the dispersion tolerance improvement of partial DPSK with optimised filtering

We experimentally confirm the optimum combination of modulator delay and filter bandwidth to maximize the dispersion tolerance of partial DPSK.

Delay of light in an optical bottle resonator with nanoscale radius variation : dispersionless, broadband, and low-loss

It is shown theoretically that an optical bottle resonator with a nanoscale radius variation can perform a multinanosecond long dispersionless delay of light in a nanometer-order bandwidth with minimal losses. Experimentally, a 3 mm long resonator with a 2.8 nm deep semiparabolic radius variation is fabricated from a 19??µm radius silica fiber with a subangstrom precision. In excellent agreement with theory, the resonator exhibits the impedance-matched 2.58 ns (3 bytes) delay of 100 ps pulses with 0.44??dB/ns intrinsic loss. This is a miniature slow light delay line with the record large delay time, record small transmission loss, dispersion, and effective speed of light.

Delay of light in an optical bottle resonator with nanoscale radius variation:dispersionless, broadband, and low-loss

It is shown theoretically that an optical bottle resonator with a nanoscale radius variation can perform a multinanosecond long dispersionless delay of light in a nanometer-order bandwidth with minimal losses. Experimentally, a 3 mm long resonator with a 2.8 nm deep semiparabolic radius variation is fabricated from a 19??µm radius silica fiber with a subangstrom precision. In excellent agreement with theory, the resonator exhibits the impedance-matched 2.58 ns (3 bytes) delay of 100 ps pulses with 0.44??dB/ns intrinsic loss. This is a miniature slow light delay line with the record large delay time, record small transmission loss, dispersion, and effective speed of light.

Refractive index sensitivity characteristics near the dispersion turning point of the multimode microfiber-based Mach–Zehnder interferometer

The turning point of the refractive index (RI) sensitivity based on the multimode microfiber (MMMF) in-line Mach–Zehnder interferometer (MZI) is observed. By tracking the resonant wavelength shift of the MZI generated between the HE11 and HE12 modes in the MMMF, the surrounding RI (SRI) could be detected. Theoretical analysis demonstrates that the RI sensitivity will reach ±∞ on either side of the turning point due to the group effective RI difference (퐺) approaching zero. Significantly, the positive sensitivity exists in a very wide fiber diameter range, while the negative sensitivity can be achieved in a narrow diameter range of only 0.3 μm. Meanwhile, the experimental sensitivities and variation trend at different diameters exhibit high consistency with the theoretical results. High RI sensitivity of 10777.8 nm/RIU (RI unit) at the fiber diameter of 4.6 μm and the RI around 1.3334 is realized. The discovery of the sensitivity turning points has great significance on trace detection due to the possibility of ultrahigh RI sensitivity.

Dispersionless low-loss miniature slow light delay lines based on optical fibers

A miniature slow light delay line with the record large delay time, small transmission loss, dispersion, and effective speed of light is proposed and demonstrated using the SNAP (Surface Nanoscale Axial Photonics) technology. © 2014 OSA.

Near-constant time delay response of fibre grating Sagnac loop filters

A theoretical and experimental investigation of the time delay characteristics of fiber Bragg grating-based Sagnac loops (FBGSLs) is presented. Analytic expressions for the phase and time delay of the FBGSL have been derived and excellent agreement is found between their predictions and experimental results for configurations incorporating uniform-period and chirped-period gratings. For symmetrical grating structures, it is found that the FBGSL time delay response is similar to that of the incorporated grating; with asymmetrical gratings, the FBGSL response is quite different. It is shown that wavelength-division-multiplexing filters exhibiting near-zero dispersion characteristics can be implemented using FBGSLs.

Band-pass filter with flat time delay response based on fiber grating Sagnac loop

We have developed the analytic expressions for the phase response and time delay of FBGSL of arbitrary grating structure and found that the results from the modelling are in excellent agreement with that of the experimentally measured real devices. The theoretical and experimental investigation clearly reveals that FBGSLs utilizing uniform and linearly chirped gratings exhibit a near-constant time delay in the passbands. Such multi-channel bandpass filters should be highly attractive to WDM applications as they are operating in transmission regime and offering near-zero dispersion.

Phase noise influence in long-range coherent optical OFDM systems with delay detection, IFFT multiplexing and FFT demodulation

We present a study of the influence of dispersion induced phase noise for CO-OFDM systems using FFT multiplexing/IFFT demultiplexing techniques (software based). The software based system provides a method for a rigorous evaluation of the phase noise variance caused by Common Phase Error (CPE) and Inter-Carrier Interference (ICI) including - for the first time to our knowledge - in explicit form the effect of equalization enhanced phase noise (EEPN). This, in turns, leads to an analytic BER specification. Numerical results focus on a CO-OFDM system with 10-25 GS/s QPSK channel modulation. A worst case constellation configuration is identified for the phase noise influence and the resulting BER is compared to the BER of a conventional single channel QPSK system with the same capacity as the CO-OFDM implementation. Results are evaluated as a function of transmission distance. For both types of systems, the phase noise variance increases significantly with increasing transmission distance. For a total capacity of 400 (1000) Gbit/s, the transmission distance to have the BER < 10-2 for the worst case CO-OFDM design is less than 800 and 460 km, respectively, whereas for a single channel QPSK system it is less than 1400 and 560 km.

An RZ DPSK receiver design with significantly improved dispersion tolerance

We show an improved DPSK receiver design which can increase useful dispersion tolerance by up to a factor of two. The increased dispersion tolerance is achieved through optimization of the optical filter at the receiver and the delay of the Mach-Zehnder interferometer. In this paper we fully explain the concept, quantify the gain and provide an explanation for the operation of the receiver. © 2007 Optical Society of America.

Miniature optical delay lines and buffers

Creation of miniature optical delay lines and buffers is one of the greatest challenges of the modern photonics which can revolutionize optical communications and computing. Several remarkable designs of slow light optical delay lines employing coupled ring resonators and photonic crystal waveguides has been suggested and experimentally demonstrated. However, the insertion loss of these devices is too large for their practical applications. Alternatively, the recently developed photonic fabrication platform, Surface Nanoscale Axial Photonics (SNAP) allows us to fabricate record small delay lines with unprecedentedly small dispersion and low loss. In this report, we review the recent progress in fabrication and design of miniature slow light devices and buffers, in particular, those based on the SNAP technology.

A comparative study: long and short term effect of a nutrition sensitive approach to delay the progression of HIV to AIDS among people living with HIV (PLWH) in Nigeria

Background: Malnutrition has a negative impact on optimal immune function, thus increasing susceptibility to morbidity and mortality among HIV positive patients. Evidence indicates that the prevalence of macro and micronutrient deficiencies (particularly magnesium, selenium, zinc, and vitamin C) has a negative impact on optimal immune function, through the progressive depletion of CD4 T-lymphocyte cells, which thereby increases susceptibility to morbidity and mortality among PLWH. Objective: To assess the short and long term effects of a nutrition sensitive intervention to delay the progression of human immune-deficiency virus (HIV) to AIDS among people living with HIV in Abuja, Nigeria. Methods: A randomized control trial was carried out on 400 PLWH (adult, male and female of different religious background) in Nigeria between January and December 2012. Out of these 400 participants, 100 were randomly selected for the pilot study, which took place over six months (January to June, 2012). The participants in the pilot study overlapped to form part of the scale-up participants (n 400) monitored from June to December 2012. The comparative effect of daily 354.92 kcal/d optimized meals consumed for six and twelve months was ascertained through the nutritional status and biochemical indices of the study participants (n=100 pilot interventions), who were and were not taking the intervention meal. The meal consisted of: Glycine max 50g (Soya bean); Pennisetum americanum 20g (Millet); Moringa oleifera 15g (Moringa); Daucus carota spp. sativa 15g (Carrot). Results: At the end of sixth month intervention, mean CD4 cell count (cell/mm3) for Pre-ART and ART Test groups increased by 6.31% and 12.12% respectively. Mean mid upper arm circumference (MUAC) for Pre-ART and ART Test groups increased by 2.72% and 2.52% within the same period (n 400). Comparatively, participants who overlapped from pilot to scale-up intervention (long term use, n 100) were assessed for 12 months. Mean CD4 cell count (cell/mm3) for Pre-ART and ART test groups increased by 2.21% and 12.14%. Mean MUAC for Pre-ART and ART test groups increased by 2.08% and 3.95% respectively. Moreover, student’s t-test analysis suggests a strong association between the intervention meal, MUAC, and CD4 count on long term use of optimized meal in the group of participants being treated with antiretroviral therapy (ART) (P<0.05). Conclusion: Although the achieved results take the form of specific technology, it suggests that a prolong consumption of the intervention meal will be suitable to sustain the gained improvements in the anthropometric and biochemical indices of PLWHIV in Nigeria.

Polymyalgia Rheumatica (PMR) Special Interest Group at OMERACT 11: outcomes of importance for patients with PMR

We worked toward developing a core outcome set for clinical research studies in polymyalgia rheumatica (PMR) by conducting (1) patient consultations using modified nominal group technique; (2) a systematic literature review of outcome measures in PMR; (3) a pilot observational study of patients presenting with untreated PMR, and further discussion with patient research partners; and (4) a qualitative focus group study of patients with PMR on the meaning of stiffness, using thematic analysis. (1) Consultations included 104 patients at 4 centers. Symptoms of PMR included pain, stiffness, fatigue, and sleep disturbance. Function, anxiety, and depression were also often mentioned. Participants expressed concerns about diagnostic delay, adverse effects of glucocorticoids, and fear of relapse. (2) In the systematic review, outcome measures previously used for PMR include pain visual analog scores (VAS), morning stiffness, blood markers, function, and quality of life; standardized effect sizes posttreatment were large. (3) Findings from the observational study indicated that asking about symptom severity at 7 AM, or "on waking," appeared more relevant to disease activity than asking about symptom severity "now" (which depended on the time of assessment). (4) Preliminary results were presented from the focus group qualitative study, encompassing broad themes of stiffness, pain, and the effect of PMR on patients' lives. It was concluded that further validation work is required before a core outcome set in PMR can be recommended. Nevertheless, the large standardized effect sizes suggest that pain VAS is likely to be satisfactory as a primary outcome measure for assessing response to initial therapy of PMR. Dissection of between-patient heterogeneity in the subsequent treatment course may require attention to comorbidity as a potential confounding factor.