Effect of combined bending strain and thermal cycling on the voltage-current characteristic curves of Bi-2223 tapes

High critical temperature superconductors are evolving from a scientific research subject into large-scale application devices. In order to meet this development demand they must withstand high current capacity under mechanical loads arising from thermal contraction during cooling from room temperature down to operating temperature (usually 77 K) and due to the electromagnetic forces generated by the current and the induced magnetic field. Among the HTS materials, the Bi2Sr2Ca2Cu3Ox, compound imbedded in an Ag/AgMg sheath has shown the best results in terms of critical current at 77 K and tolerance against mechanical strain. Aiming to evaluate the influence of thermal stress induced by a number of thermal shock cycles we have evaluated the V-I characteristic curves of samples mounted onto semicircular holders with different curvature radius (9.75 to 44.5 mm). The most deformed sample (epsilon = 1.08%) showed the largest reduction of critical current (40%) compared to the undeformed sample and the highest sensitivity to thermal stress (I-c/I-c0 = 0.5). The V-I characteristic curves were also fitted by a potential curve displaying n-exponents varying from 20 down to 10 between the initial and last thermal shock cycle.

Dipole moments in Langmuir monolayers from aromatic carboxylic acids

The three-layer capacitor model proposed by Demchak and Fort [J. Colloid Interface Sci. 46 (1974) 191] is employed to relate measured surface potentials of Langmuir monolayers from a series of polyphenyl carboxylic acids to molecular dipole moments calculated using semiempirical quantum methods. The effective dielectric constant at the air/monolayer interface is 3.0 +/- 0.6, very close to that estimated for aliphatic compounds. Good agreement between theory and experiment is obtained by adopting a dielectric constant of 6.4 for the monolayer/water interface and a contribution from the water reorientation of -0.064 +/- 0.006 D, which shows that the parameters in the DF model are essentially the same as for aliphatic amphiphiles, such as esters, acids, alcohols and ethers. (C) 2000 Elsevier B.V. B.V. All rights reserved.

A BEM formulation based on Reissner's theory to perform simple bending analysis of plates reinforced by rectangular beams

In this work, the plate bending formulation of the boundary element method (BEM), based on the Reissner's hypothesis, is extended to the analysis of plates reinforced by rectangular beams. This composed structure is modelled by a zoned plate, being the beams represented by narrow sub-regions with larger thickness. The integral equations are derived by applying the weighted residual method to each sub-region, and summing them to get the equation for the whole plate. Equilibrium and compatibility conditions are automatically imposed by the integral equations, which treat this composed structure as a single body. In order to decrease the number of degrees of freedom, some approximations are considered for both displacements and tractions along the beam width. The accuracy of the proposed model is illustrated by simple examples whose exact solution are known as well as by more complex examples whose numerical results are compared with a well-known finite element code.

Non-linear analysis of reinforced concrete plates by the boundary element method and continuum damage mechanics

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

EPR linewidth of local magnetic moments diluted in Ce intermediate-valence compounds

Anomalous thermal behavior on the EPR linewidths has been observed for Gd impurities diluted in CexA1-xBn (A=La,Y, B=Ir,Os,Rh,Pd) intermediate-valence compounds. In this work we show that the exchange interaction between the local magnetic moments and the intermediate-valence host ions has an important contribution to the relaxation rates of the local moments. We calculated the relaxation, using the Redfield formalism and the ideas contained in the interconfigurational fluctuation model of Hirst. We show that the exchange interaction contribution has an exponential dependence on the excitation energy of the intermediate-valence ions. © 1992 The American Physical Society.

Gravitomagnetic moments of the fundamental fields

The quadratic form of the Dirac equation in a Riemann space-time yields a gravitational gyromagnetic ratio κ(S) = 2 for the interaction of a Dirac spinor with curvature. A gravitational gyromagnetic ratio κ(S) = 1 is also found for the interaction of a vector field with curvature. It is shown that the Dirac equation in a curved background can be obtained as the square-root of the corresponding vector field equation only if the gravitational gyromagnetic ratios are properly taken into account.

A theoretical and experimental analysis of cold-formed steel shapes subjected to bending - Channel and simple lipped channel

Cold-formed steel shapes have been widely employed in steel construction, where they frequently offer a lower cost solution than do traditional laminated shapes. A classic application of cold-formed steel shapes is purlins in the roof panel of industrial buildings, connected to the roof panel by means of screws. The combined effect of these two elements has been the subject of investigations in some countries. Design criteria were included in the AISI Code in 1991 and 1996. This paper presents and discusses the results obtained from bending tests carried out on shapes commonly used in Brazil, i.e., the channel and the simple lipped channel, Tests were carried out on double shapes with 4.5 and 6.0 meter spans, which were subjected to concentrated loads and braced against each other on the supports and at intermediary points in three different load situations. The panel shape was also analyzed experimentally, simulating the action of wind by means of a vacuum box designed specifically for this purpose. The test results were then compared to those obtained through the theoretical analysis, enabling us to extract important information upon which to base proposed design criteria for the new Brazilian code.

Distortional buckling of simple lipped channel in bending results of the experimental analysis versus direct strength methods

Cold-formed steel members are subject to failure caused by buckling, normally under loads smaller than those corresponding to partial or total yielding of the cross section. The buckling of members in bending can be classified as local or global, and the occurrence of one or the other type is expected by the members' geometric characteristics and by the constraints and load conditions. One of the local instability modes that can characterize a member's failure is distortional buckling of the cross section occurring on its own plane and involving lateral displacements and rotations. This paper presents and discusses the procedures and results obtained from experimental tests of cold-formed steel members under bending. Forty-eight beams were carried out on members in simple lipped channel, in pairs, with 6-meter spans and loads applied by concentrated forces at every 1/3 of the span. The thickness, width and dimensions, of the stiffeners were chosen so that the instability by distortion buckling of the cross section was the principal failure mode expected. The experimental results are compared with the obtained results by using the direct strength method.

Synergy of DNA-bending nucleoid proteins and macromolecular crowding in condensing DNA

Many prokaryotic nucleoid proteins bend DNA and form extended helical protein-DNA fibers rather than condensed structures. On the other hand, it is known that such proteins (such as bacterial HU) strongly promote DNA condensation by macromolecular crowding. Using theoretical arguments, we show that this synergy is a simple consequence of the larger diameter and lower net charge density of the protein-DNA filaments as compared to naked DNA, and hence, should be quite general. To illustrate this generality, we use light-scattering to show that the 7kDa basic archaeal nucleoid protein Sso7d from Sulfolobus solfataricus (known to sharply bend DNA) likewise does not significantly condense DNA by itself. However, the resulting protein-DNA fibers are again highly susceptible to crowding-induced condensation. Clearly, if DNA-bending nucleoid proteins fail to condense DNA in dilute solution, this does not mean that they do not contribute to DNA condensation in the context of the crowded living cell. © 2007 World Scientific Publishing Company.

Analysis of mechanical behavior in bending of polymer composites using the finite elements method

The use of composite materials has increased in the recent decades, mainly in the aeronautics and automotives industries. In the present study is elaborated a computational simulation program of the bending test using the finite elements method, in the commercial software ANSYS. This simulation has the objective of analyze the mechanical behavior in bending of two composites with polymeric matrix reinforced with carbon fibers. Also are realized bending tests of the 3 points to obtain the resistances of the materials. Data from simulation and tests are used to make a comparison between two failures criteria, Tsai-Wu and Hashin criterion. Copyright © 2009 SAE International.

Chromosomal imbalances in successive moments of human bladder urothelial carcinoma

Objective: To understand developmental characteristics of urinary bladder carcinomas (UBC) by evaluating genomic alterations and p53 protein expression in primary tumors, their recurrences, and in the morphologically normal urothelium of UBC patients. Methods: Tumors and their respective recurrences, six low-grade and five high-grade cases, provided 19 samples that were submitted to laser microdissection capture followed by high resolution comparative genomic hybridization (HR-CGH). HR-CGH profiles went through two different analyses-all tumors combined or classified according to their respective histologic grades. In a supplementary analysis, 124 primary urothelial tumors, their recurrences, and normal urothelium biopsied during the period between tumor surgical resection and recurrence, were submitted to immunohistochemical analyses of the p53 protein. During the follow-up of at least 21 patients, urinary bladder washes citologically negative for neoplastic cells were submitted to fluorescence in situ hybridization (FISH) to detect copy number alterations in centromeres 7, 17, and 9p21 region. Results and Conclusions: HR-CGH indicated high frequencies (80%) of gains in 11p12 and losses in 16p12, in line with suggestions that these chromosome regions contain genes critical for urinary bladder carcinogenesis. Within a same patient, tumors and their respective recurrences showed common genomic losses and gains, which implies that the genomic profile acquired by primary tumors was relatively stable. There were exclusive genomic alterations in low and in high grade tumors. Genes mapped in these regions should be investigated on their involvement in the urinary bladder carcinogenesis. Successive tumors from same patient did not present similar levels of protein p53 expression; however, when cases were grouped according to tumor histologic grades, p53 expression was directly proportional to tumor grades. Biopsies taken during the follow-up of patients with history of previously resected UBC revealed that 5/15 patients with no histologic alterations had more than 25% of urothelial cells expressing the p53 protein, suggesting that the apparently normal urothelium was genomically unstable. No numerical alterations of the chromosomes 7, 17, and 9p21 region were found by FISH during the periods free-of-neoplasia. Our data are informative for further studies to better understand urinary bladder urothelial carcinogenesis. © 2013 Elsevier Inc.

Efeito do exercício aeróbio na menopausa induzida por ooforectomia: estudo clínico, biomecânico e densitométrico em ratas

Pós-graduação em Bases Gerais da Cirurgia - FMB

Cardiorespiratory evaluation in pre and post operative moments of laparoscopic cholecystectomy

PURPOSE: To analyze the changes in both respiratory function and cardiopulmonary exercise tests results in patients subjected to laparoscopic cholecystectomy. METHODS: Fifty patients were evaluated (76% women) and the average age was 47.8±14.2 years. All individuals underwent the measurement of spirometry, manovacuometry, 6-minute walk test (6MWT) and stair-climbing test (SCT). All tests were performed at the first (PO1), fifth (PO5) and thirtieth (PO30) postoperative days. RESULTS: BMI average was 28.8±4.8 kg/m2. Sample comprised 68% non-smokers, 20% current smokers, and 12% former smokers. There was no incidence of postoperative complication whatsoever. There was a significant decrease in spirometric values at PO1, but values were similar to the ones of PRE at PO30. Manovacuometry showed alterations at PO1 displaying values that were similar to the ones of PRE at PO30. 6MWT was significantly shorter at until PO5, but at PO30 values were similar to ones of PRE. As for SCT, values were significantly compromised at PO5 and PO30 since they were similar to the ones of PRE. CONCLUSION: Patients submitted to laparoscopic cholecystectomy present a decrease in cardiorespiratory function on the first postoperative moments but there is a rapid return to preoperative conditions.