979 resultados para 850
Resumo:
Barium-functionalized multiwalled carbon nanotube yarns were fabricated by drawing and twisting multiwalled carbon nanotube forests through a solution containing barium nitrate. After heat activation under vacuum, the functionalized yarns were enriched in barium oxide due to the high surface-to-volume ratio of the nanotubes. The cathodes exhibited good thermionic properties, with a work function as low as 1.73-2.06 eV and thermionic current density that exceeded 185 mA/cm(2) in a field of 850 V/5 mm at 1317 K. The barium-functionalized yarns had high tensile strength of up to 420 MPa and retained strength of similar to 250 MPa after a 2 h activation process. (C) 2008 American Institute of Physics.
Resumo:
<正> 洋脊中轴裂谷是板块的创生边界,多年来一直吸引着地球科学家的注意。但是,对于中轴裂谷的成因,至今没有得到圓满的解释。本文利用我们在文献[1]中所提出的上涌流动模式,算出了裂谷的深度和宽度、裂谷内底宽度等。这些结果均与观测数据符合,从而给出了洋脊中轴裂谷地形的动力学解释。
Resumo:
对经不同扩散工艺处理的热浸镀铝层高温抗氧化性进行了研究,通过SEM、TEM、XRD分析了经扩散处理后,热浸镀铝层高温氧化过程中组织结构的变化情况,分析了热浸镀铝层高温抗氧化性能和微观结构的关系,确定了提高热浸镀铝层高温抗氧化性的适宜扩散温度。结果表明,经750℃扩散处理,热浸镀铝层结构由较厚的外表层(Fe2Al5+FeAl2)及内层(FeAl+条状:FeAl2)组成,条状FeAl2的形成为氧提供了扩散通道,其抗氧化性较差;经950℃扩散处理,镀层外表层变薄,外表层转为单一FeAl2、内层为FeAl,并出现早期内氧化裂纹,其抗氧化性较差:当扩散处理温度为850℃时,镀层外表层变薄,结构转为FeAl2+少量Fe2Al5,而内层增厚,其结构为FeAl+球状FeAl2,而内层FeAl2球化,增强了氧由内层向基体扩散的阻碍作用,使氧只能逐层形成Al2O3+Fe2O3的氧化膜,提高了镀层的高温抗氧化性。
Resumo:
采用自行研制的中心嵌有铜柱感应件的小尺寸杆状热流探针,在低扰动条件下,对射入大气环境的纯氩层流等离子体射流传向铜探头表面的热流密度进行了动态测量。结果表明,在射流最高温度16500 K、最大轴向速度850 m/s、探针垂直于射流流动方向的移动速度130~260 mm/s的实验参数范围内,随着探针移动速度的提高,测得的热流密度值减小;射流温度和速度越高,探针移动速度对热流密度测量值的影响越大。
Resumo:
245 p. : il.
Resumo:
Ponencia presentada en I Congreso de Estudios Históricos del Condado de Treviño: 850 aniversario de la fundación de la Villa de Treviño, celebrado los días 1,2 y 3 de junio de 2011 en Treviño (Condado de Treviño)
Resumo:
One of the causes of lower artesian pressure, water waste and aquifer contamination is the misuse and insufficient care of artesian wells. In 1953, Senate Bill No. 57, entitled "An Act to Protect and Control the Artesian Waters of the State" (see Appendix) became a law. This law was passed through the efforts exerted by leading members of the Senate and the House of Representatives, who understood the need for a wise and controlled expenditure of our most valuable natural resource. The State Geologist and his authorized representatives were designated by this law to enforce this conservation measure; however, no financial provision was included for the 1953-55 biennium. The proposed program of the Florida Geological Survey for this biennium did not include the funds nor provide any full-time personnel for the enforcement of this statute. As a result, little actual work was accomplished during these two years, although much time was given to planning and discussion of the problem. Realizing that this program could provide additional basic data needed in the analysis of the water-supply problem, the State Geologist sought and was granted by the 1955 Legislature adequate funds with which to activate the first phase of the enforcement of Florida Statute No. 370.051-054. Enumerated below is a summary of the progress made on this investigation as outlined previously: 1. Data have been collected on 967 wildly flowing wells in 22 counties. 2. Chloride determinations have been run on 850 of the 967 wells. 3. Of the 967 wells, 554 have chlorides in excess of the 250 ppm, the upper limit assigned by the State Board of Health for public consumption. 4. Water escapes at the rate of 37, 762 gallons per minute from these 967 wells. This amounts to 54, 377, 280 gallons per day. The investigation is incomplete at this time; therefore, no final conclusions can be reached. However, from data already collected, the following recommendations are proposed: 1. That the present inventory of wildly flowing wells be completed for the entire State. 2. That the current inventory of wildly flowing wells be expanded at the conclusion of the present inventory to include all flowing wells. 3. That a complete statewide inventory program be established and conducted in cooperation with the Ground Water Branchof the U.S. Geological Survey. 4. That the enforcement functions as set down in Sections 370.051/.054, Florida Statutes, be separated from the program to collect water-resource data and that these functions be given to the Water Resources Department, if such is created (to be recommended by the Water Resources Study Commission in a water policy law presented to the 1957 Legislature). 5. That the research phase (well inventory) of the program remain under the direction of the Florida Geological Survey. (PDF contains 204 pages.)
Resumo:
[ES]Este trabajo se centra en el análisis de la relación entre las políticas crediticias de las entidades de crédito y el comportamiento de las mismas ex post. Se hace una revisión de la teoría que justifica que los mercados crediticios pueden estar sujetos, en determinadas circunstancias, a un componente endógeno más elevado de lo que, en general, se atribuye. Se plantea como hipótesis de trabajo la existencia de una relación entre la intensidad en el crecimiento de la cartera crediticia de los bancos en las fases de expansión crediticia y su comportamiento ex post. Los resultados preliminares presentados confirman la hipótesis de que las entidades que más desvían su crecimiento crediticio respecto del crecimiento del PIB nominal, están sujetas a un peor comportamiento en cuanto a la evolución posterior de sus beneficios, rentabilidades e insolvencias.
Resumo:
At present the fishery for the brown shrimp (Crangon crangon L.) is one of the most economically rewarding fisheries in Europe. Due to the small size of the target objects this fishery has to be carried out with rather small meshes. As it is, however, performed on the nursing grounds of important fish species it encounters a severe bycatch problem. On this basis, EU Council regulation 850/98 demands the use of either sieve nets or sorting grids from 1 July, and to pass pertaining national bye-laws. Germany discusses to use either sieve nets of 70 mm mesh opening or sorting grids of 20 mm bar distance, and tries to achieve a harmonization of the byelaw with neighbouring countries of The Netherlands and Denmark to ensure equal conditions on the same fishing grounds.
Resumo:
Among the branches of astronomy, radio astronomy is unique in that it spans the largest portion of the electromagnetic spectrum, e.g., from about 10 MHz to 300 GHz. On the other hand, due to scientific priorities as well as technological limitations, radio astronomy receivers have traditionally covered only about an octave bandwidth. This approach of "one specialized receiver for one primary science goal" is, however, not only becoming too expensive for next-generation radio telescopes comprising thousands of small antennas, but also is inadequate to answer some of the scientific questions of today which require simultaneous coverage of very large bandwidths.
This thesis presents significant improvements on the state of the art of two key receiver components in pursuit of decade-bandwidth radio astronomy: 1) reflector feed antennas; 2) low-noise amplifiers on compound-semiconductor technologies. The first part of this thesis introduces the quadruple-ridged flared horn, a flexible, dual linear-polarization reflector feed antenna that achieves 5:1-7:1 frequency bandwidths while maintaining near-constant beamwidth. The horn is unique in that it is the only wideband feed antenna suitable for radio astronomy that: 1) can be designed to have nominal 10 dB beamwidth between 30 and 150 degrees; 2) requires one single-ended 50 Ohm low-noise amplifier per polarization. Design, analysis, and measurements of several quad-ridged horns are presented to demonstrate its feasibility and flexibility.
The second part of the thesis focuses on modeling and measurements of discrete high-electron mobility transistors (HEMTs) and their applications in wideband, extremely low-noise amplifiers. The transistors and microwave monolithic integrated circuit low-noise amplifiers described herein have been fabricated on two state-of-the-art HEMT processes: 1) 35 nm indium phosphide; 2) 70 nm gallium arsenide. DC and microwave performance of transistors from both processes at room and cryogenic temperatures are included, as well as first-reported measurements of detailed noise characterization of the sub-micron HEMTs at both temperatures. Design and measurements of two low-noise amplifiers covering 1--20 and 8—50 GHz fabricated on both processes are also provided, which show that the 1--20 GHz amplifier improves the state of the art in cryogenic noise and bandwidth, while the 8--50 GHz amplifier achieves noise performance only slightly worse than the best published results but does so with nearly a decade bandwidth.
Resumo:
While New Hanover County is the second smallest county in North Carolina, it is also the second most densely populated with approximately 850 people per square mile. Nestled between the Cape Fear River and Atlantic Ocean with surrounding barrier island beach communities, the County’s geographic location provides a prime vacation destination, as well as an ideal location for residents who wish to live at the water’s edge. Wilmington is the largest city in the County with a population just under 200,000. Most of the Wilmington metropolitan area is developed, creating intense development pressures for the remaining undeveloped land in the unincorporated County. In order to provide development opportunities for mixed use or high density projects within unincorporated New Hanover County where appropriate urban features are in place to support such projects without the negative effects of urban sprawl, County Planning Staff recently developed an Exceptional Design Zoning District (EDZD). Largely based on the LEED for Neighborhood Development program, the EDZD standards were scaled to fit the unique conditions of the County with the goal of encouraging sustainable development while providing density incentives to entice the use of the voluntary district. The incentive for the voluntary zoning district is increased density in areas where the density may not be allowed under normal circumstances. The rationale behind allowing for higher density projects is that development can be concentrated in areas where appropriate urban features are in place to support such projects, and the tendency toward urban sprawl can be minimized. With water quality being of high importance, it is perceived that higher density development will better protect water quality then lower density projects. (PDF contains 4 pages)
Resumo:
The depth, alkalinity, total dissolved solids and conductivity of Kubanni Reservoir were monitored biweekly between December 2003 and April 2004. The range values and their means were 0.8-4.64m, 42-67mg/l, 52-71mg/l and 104-142 mhos/cm; 2.8m, 42.6mg/l, 59.8mg/l and 119.6 mhos/cm respectively. Total Dissolved solids correlated significantly (P<0.05) with depth and conductivity while alkalinity correlated highly and significantly(P<0.05) with conductivity, total dissolved solids but negatively correlated with depth. The electrical conductivity was positively and highly correlated with depth while Morpho-Edaphic Index (MEI) which increased with depth decrease correlated positively with conductivity. Based on the average value of the MEI the potential fish catch of the reservoir was estimated to be 38kg/ha. This estimate was compared with other values obtained from other African reservoirs/lakes and management considerations under "private liability company" are proffered
Resumo:
Under coronal conditions, the steady state rate-equations are used to calculate the inter-stage line ratios between Li-like Is(2)2p(P-2(3/2))-> 1s(2)2s -> ((2) S-1/2) and He-like 1s2p (P-1(1))-> 1s(2) (S-1(0)) transitions for Ti in the electronic temperature ranges from 0.1 keV to 20 keV. The results show that the. temperature sensitivities are higher at the electronic temperature less than 5000 eV and the temperature sensitivities will decrease with the increase of electronic temperature.
Resumo:
This thesis describes a series of experimental studies of lead chalcogenide thermoelectric semiconductors, mainly PbSe. Focusing on a well-studied semiconductor and reporting good but not extraordinary zT, this thesis distinguishes itself by answering the following questions that haven’t been answered: What represents the thermoelectric performance of PbSe? Where does the high zT come from? How (and how much) can we make it better? For the first question, samples were made with highest quality. Each transport property was carefully measured, cross-verified and compared with both historical and contemporary report to overturn commonly believed underestimation of zT. For n- and p-type PbSe zT at 850 K can be 1.1 and 1.0, respectively. For the second question, a systematic approach of quality factor B was used. In n-type PbSe zT is benefited from its high-quality conduction band that combines good degeneracy, low band mass and low deformation potential, whereas zT of p-type is boosted when two mediocre valence bands converge (in band edge energy). In both cases the thermal conductivity from PbSe lattice is inherently low. For the third question, the use of solid solution lead chalcogenide alloys was first evaluated. Simple criteria were proposed to help quickly evaluate the potential of improving zT by introducing atomic disorder. For both PbTe1-xSex and PbSe1-xSx, the impacts in electron and phonon transport compensate each other. Thus, zT in each case was roughly the average of two binary compounds. In p-type Pb1-xSrxSe alloys an improvement of zT from 1.1 to 1.5 at 900 K was achieved, due to the band engineering effect that moves the two valence bands closer in energy. To date, making n-type PbSe better hasn’t been accomplished, but possible strategy is discussed.