Geochemistry and minerals at DSDP Hole 70-504B

In three veins from the lower part of Deep Sea Drilling Project Hole 504B, 298 meters below the top of basement, primary augite is replaced by aegirine-augite. This transformation occurs only in subophitic basalts, at the contact with veins which always include a dark-olive, Mg-rich clay mineral. Talc occurs in one of these veins; it can be regarded either as a vein constituent or as a product of augite alteration. Melanite (Ca,Fe,Ti-rich garnet) appears in only one of these three veins, where a Ca-carbonate is associated with a Mg-rich clay mineral. The occurrence of melanite in Hole 504B could be due to the conjunction of particular conditions: (1) basalt with a subophitic texture, (2) presence of hydrothermal fluids carrying Ca, Fe, Si, Ti, Al, Mg, and Na, (3) rather high temperatures. Possibly the melanite and aegirine-augite formed by deuteric alteration.

Chemistry of basalts of ODP Hole 111-504B

The effect of oxygen fugacity (fO2) on the partition relationship of Mg and Fe between Plagioclase and sillicate liquid was investigated at 1 atm for basaltic samples recovered during ODP Leg 111 from Hole 504B. Samples 111-504B-143R-2 (Piece 8) and 111-504B-169R-1 (Piece 1) have Plagioclase as the liquidus phase. The distribution coefficient of Mg between Plagioclase and melt is constant at about 0.04 against the variation of fO2, whereas that of Fe (total Fe) varies from 0.3 at f(O2) = 0.2 atm to 0.03 at f(o2) = 10**-11.5 at 1200°C. The distribution coefficient of Mg is slightly higher than that calculated from the phenocryst and bulk-rock compositions, suggesting a kinetic disequilibrium effect on the distribution of Mg in Plagioclase. Because Mg, Fe, and Fe3+ have similar diffusion coefficients in silicate melt, the disequilibrium effect is greatly reduced for the exchange reaction of Mg and total Fe between Plagioclase and liquid. The exchange partition coefficient is highly dependent on fo2, with log fo2 ranging from -0.7 to - 11.5 at approximately 1200°C. Using this relationship, the f(O2) of crystallization of the magmas is estimated to be near the one defined by the fayalite-quartz-magnetite assemblage.

Magnetic properties and geochemistry in DSDP Holes 69-504B an d 69-505B

More than 60 basalt samples from two Deep Sea Drilling Project holes on the Costa Rica Rift were studied for magnetic properties and were found to have no properties significantly different from other DSDP basalts. Opaque mineralogical and thermomagnetic properties of these samples, however, to some extent show differences from normal submarine basalts; a new type of thermomagnetic curve and wide range of chemical compositions were recognized. Oxidized samples possibly containing incipient ilmenite exsolution lamellae were reduced and re-equilibrated during heating. The Curie temperatures of the re-equilibrated titanomagnetites are interpreted to be those of the original crystallized phase before oxidation.

Geochemistry of minerals at DSDP Holes 68-501 and 69-504B

The interaction of seawater with basalts in DSDP Hole 501 and the upper part of Hole 504B (Costa Rica Rift) produced oxidative alteration and a zonation of clay minerals along cracks. From rock edges to interiors in many cracks the following succession occurs, based on microscopic observations and microprobe analysis: iron hydroxides (red), "protoceladonite" (green), iddingsite (orange), and saponite (yellow). Clay minerals replace olivines and fill vesicles and cracks. Other secondary minerals are phillipsite, aragonite, and unidentified carbonates. Some glass is transformed to Mg-rich palagonite. Bulk rock chemistry is related to the composition of the secondary minerals. The zonation can be interpreted as a succession of postburial nonoxidative and oxidative diagenesis similar to that described in the Leg 34 basalts.