The impact of installer business models on the uptake of residential microgeneration in the UK: Evidence from a nation-wide survey

This paper arises from a doctoral thesis comparing the impact of alternative installer business models on the rate at which microgeneration is taken up in homes and installation standards across the UK. The paper presents the results of the first large-scale academic survey of businesses certified to install residential microgeneration. The aim is to systematically capture those characteristics which define the business model of each surveyed company, and relate these to the number, location and type of technologies that they install, and the quality of these installations. The methodology comprised a pilot web survey of 235 certified installer businesses, which was carried out in June last year and achieved a response rate of 30%. Following optimisation of the design, the main web survey was emailed to over 2000 businesses between October and December 2011, with 317 valid responses received. The survey is being complemented during summer 2012 by semi-structured interviews with a representative sample of installers who completed the main survey. The survey results are currently being analysed. The early results indicate an emerging and volatile market where solar PV, solar hot water and air source heat pumps are the dominant technologies. Three quarters of respondents are founders of their installer business, while only 22 businesses are owned by another company. Over half of the 317 businesses have five employees or less, while 166 businesses are no more than four years old. In addition, half of the businesses stated that 100% of their employees work on microgeneration-related activities. 85% of the surveyed companies have only one business location in the UK. A third of the businesses are based either in the South West or South East regions of England. This paper outlines the interim results of the survey combined with the outcomes from additional interviews with installers to date. The research identifies some of the business models underpinning microgeneration installers and some of the ways in which installer business models impact on the rate and standards of microgeneration uptake. A tentative conclusion is that installer business models are profoundly dependent on the levels and timing of support from the UK Feed-in Tariffs and Renewable Heat Incentive.

Striving for inclusive design in the built environment: learning strategy adopted by policy implementers at local authorities in England

The research will explore views on inclusive design policy implementation and learning strategy used in practice by Local Authorities’ planning, building control and policy departments in England. It reports emerging research findings. The research aim was developed from an extensive literature review, and informed by a pilot study with relevant Local Authority departments. The pilot study highlighted gaps within the process of policy implementation, a lack of awareness of the process and flaws in the design guidance policy. This has helped inform the development of a robust research design using both a survey and semi-structured interviews. The questionnaire targeted key employees within Local Authorities designed to establish how employees learn about inclusive design policy and to determine their views on current approaches of inclusive design policy implementation adopted by their Local Authorities. The questionnaire produces 117 responses. Interestingly approximately 9 out of 129 Local Authorities approached claimed that they were unable to participate either because an inclusive design policy was not adopted or they were faced with a high workload and thus unable to take part. An emerging finding is a lack of understanding of inclusive design problems, which may lead to problem with inclusive design policy implementation, and thus adversely affect how the built environment can be experienced. There is a strong indication from the survey respondents indicating that they are most likely to learn about inclusive design from policy guides produced by their Local Authorities and from their colleagues.

BIM: innovation in design management, influence and challenges of implementation

The construction industry is widely being criticised as a fragmented industry. There are mounting calls for the industry to change. The espoused change calls for collaboration as well as embracing innovation in the process of design, construction and across the supply chain. Innovation and the application of emerging technologies are seen as enablers for integrating the processes ‘integrating the team’ such as building information modelling (BIM). A questionnaire survey was conducted to ascertain change in construction with regard to design management, innovation and the application of BIM as cutting edge pathways for collaboration. The respondents to the survey were from an array of designations across the construction industry such as construction managers, designers, engineers, design coordinators, design managers, architects, architectural technologists and surveyors. There was a general agreement by most respondents that the design team was responsible for design management in their organisation. There is a perception that the design manager and the client are the catalyst for advancing innovation. The current state of industry in terms of incorporating BIM technologies is posing a challenge as well as providing an opportunity for accomplishment. BIM technologies provide a new paradigm shift in the way buildings are designed, constructed and maintained. This paradigm shift calls for rethinking the curriculum for educating building professionals, collectively.

Multilevel analysis of hepatitis A infection in children and adolescents: a household survey in the Northeast and Central-west regions of Brazil

Background The objectives were to estimate the prevalence of hepatitis A among children and adolescents from the Northeast and Midwest regions and the Federal District of Brazil and to identify individual-, household- and area-levels factors associated with hepatitis A infection. Methods This population-based survey was conducted in 20042005 and covered individuals aged between 5 and 19 years. A stratified multistage cluster sampling technique with probability proportional to size was used to select 1937 individuals aged between 5 and 19 years living in the Federal capital and in the State capitals of 12 states in the study regions. The sample was stratified according to age (59 and 10- to 19-years-old) and capital within each region. Individual- and household-level data were collected by interview at the home of the individual. Variables related to the area were retrieved from census tract data. The outcome was total antibodies to hepatitis A virus detected using commercial EIA. The age distribution of the susceptible population was estimated using a simple catalytic model. The associations between HAV infection and independent variables were assessed using the odds ratio and corrected for the random design effect and sampling weight. Multilevel analysis was performed by GLLAMM using Stata 9.2. Results The prevalence of hepatitis A infection in the 59 and 1019 age-group was 41.5 and 57.4, respectively for the Northeast, 32.3 and 56.0, respectively for the Midwest and 33.8 and 65.1 for the Federal District. A trend for the prevalence of HAV infection to increase according to age was detected in all sites. By the age of 5, 31.5 of the children had already been infected with HAV in the Northeast region compared with 20.0 in the other sites. By the age of 19 years, seropositivity was 70 in all areas. The curves of susceptible populations differed from one area to another. Multilevel modeling showed that variables relating to different levels of education were associated with HAV infection in all sites. Conclusion The study sites were classified as areas with intermediate endemicity area for hepatitis A infection. Differences in age trends of infection were detected among settings. This multilevel model allowed for quantification of contextual predictors of hepatitis A infection in urban areas.

Socio-economic variables influence the prevalence of inadequate nutrient intake in Brazilian adolescents: results from a population-based survey

Objective: To estimate the prevalence of inadequate nutrient intake among adolescents and the association between socio-economic variables and nutritional status. Design: Cross-sectional study with a population-based sample. Settings: The usual nutrient intake distribution was estimated using the Iowa State University method. The Estimated Average Requirement cut-off point method was used to determine the proportion of adolescents with inadequate intake for each nutrient, according to sex, income, parental educational level and nutritional status. Subjects: Twenty-four-hour dietary recalls were applied in 525 male and female Brazilian adolescents aged 14-18 years. Results: The highest prevalence of inadequate nutrient intake was observed for vitamin E (99% in both sexes). For male and female adolescents, the prevalence of inadequate intake was: Mg, 89% and 84%; vitamin A, 78% and 71 %; vitamin C, 79% and 53%; and vitamin B(6), 21% and 33%, respectively. The prevalence of inadequate intake for niacin, thiamin, riboflavin, Se, Cu and vitamin B(12) was <15 %. Individuals in the lower income and lower parental educational level strata had the highest risk of having inadequate intake for P, riboflavin and vitamins A, B(6) and B(12). Compared with non-overweight individuals, overweight individuals had a higher risk of inadequate intake for Mg, vitamin A, P, thiamin and riboflavin. Conclusions: The present study found a high prevalence of inadequate intake of nutrients that are recognised as being protective against chronic diseases. Adolescents in the lower income and lower parental educational level strata were less likely to have their nutrient intake requirements met.

Patterns of food acquisition in Brazilian households and associated factors: a population-based survey

Objective: To identify food acquisition patterns in Brazil and relate them to the sociodemographic characteristics of the household. Design: A cross-sectional national Household Budget Survey (HBS). Principal component factor analysis was used to derive food patterns (factors) on the basis of the acquisition of food classified into thirty-two food groups. Setting: The source of data originates from the 2002-2003 HBS carried out by the Brazilian Institute of Geography and Statistics between June 2002 and July 2003 using a representative sample of all Brazilian households. Subject: A total of 48 470 households allocated into 443 strata of households that were geographically and socio-economically homogeneous as a study unit. Results: We identified two patterns of food acquisition. The first, named `dual`, was characterized by dairy, fruit, fruit juice, vegetables, processed meat, soft drinks, sweets, bread and margarine, and by inverse correlations with Brazilian staple foods. In contrast, the second pattern, named `traditional`, was characterized by rice, beans, manioc, flour, milk and sugar. The `dual` pattern was associated with higher household educational level, income and the average age of adults on the strata, whereas the `traditional` presented higher loadings in less-educated households and in the rural setting. Conclusions: Dietary patterns described here suggest that policies and programmes to promote healthy eating need to consider that healthy and non-healthy foods may be integral in the same pattern.

A Survey on Graphical Methods for Classification Predictive Performance Evaluation

Predictive performance evaluation is a fundamental issue in design, development, and deployment of classification systems. As predictive performance evaluation is a multidimensional problem, single scalar summaries such as error rate, although quite convenient due to its simplicity, can seldom evaluate all the aspects that a complete and reliable evaluation must consider. Due to this, various graphical performance evaluation methods are increasingly drawing the attention of machine learning, data mining, and pattern recognition communities. The main advantage of these types of methods resides in their ability to depict the trade-offs between evaluation aspects in a multidimensional space rather than reducing these aspects to an arbitrarily chosen (and often biased) single scalar measure. Furthermore, to appropriately select a suitable graphical method for a given task, it is crucial to identify its strengths and weaknesses. This paper surveys various graphical methods often used for predictive performance evaluation. By presenting these methods in the same framework, we hope this paper may shed some light on deciding which methods are more suitable to use in different situations.

Primitive art as it relates to contemporary design

For the most part, my project has been of an individually rewarding nature due to an extensive amount of reading and studio work. My paper functions as the major means of communication of my own experiences and findings. It is an attempt to share with others the ideas which I have found particularly stimulating and worthwhile during the course of the year. In other words, the written portion does not intend to summarize all of the phases of primitive art which I have studied during the past year; rather, it is indicative of the type of pursuit with which I became involved. It is neither a historical survey nor a specific and thorough study of one area of primitive art. Instead, my paper is a series of essays focusing upon primitive art in general, and upon some of the aspects of primitive art with which I became concerned in particular.

Design e imagem de marca: um estudo sobre a embalagem como elemento na construção de imagem de marca de cerveja

A tese estuda a embalagem como um elemento na construção da imagem da marca, apresenta uma revisão teórica sobre os temas marca e imagem de marca, design e embalagem e, por fim, cerveja. Foi realizado um estudo qualitativo com profissionais do setor e outro quantitativo com o consumidor. A percepção do consumidor é analisada segundo o envolvimento demonstrado com o produto bem como com relação à sua atitude (hedônica ou utilitarista). Foram analisados 484 questionários, com o uso da MANOVA, mostrando que envolvimento é um fator importante na percepção da embalagem, enquanto a atitude é quase irrelevante.

A survey of radiographic measurement estimation in assessment of dental implant length.

The aim of this study is to survey radiographic measurement estimation in the assessment of dental implant length according to dentists' confidence. A 19-point questionnaire with closed-ended questions was used by two graduate students to interview 69 dentists during a dental implant meeting. Included were 12 questions related to over- and underestimation in three radiographic modalities: panoramic (P), conventional tomography (T), and computerized tomography (CT). The database was analyzed by Epi-Info 6.04 software and the values from two radiographic modalities, P and T, were compared using a chi2 test. The results showed that 38.24% of the dentists' confidence was in the overestimation of measurements in P, 30.56% in T, and 0% in CT. On the other hand, considering the underestimated measurements, the percentages were 47.06% in P, 33.33% in T, and 1.92% in CT. The frequency of under- and overestimation were statistically significant (chi2 = 6.32; P = .0425) between P and T. CT was the radiographic modality with higher measurement precision according to dentists' confidence. In conclusion, the interviewed dentists felt that CT was the best radiographic modality when considering the measurement estimation precision in preoperative dental implant assessment.

Knowledge-based risk management: Survey on Brazilian software development enterprises

A risks management, carried on in an effective way, leads the software development to success and may influence on the organization. The knowledge takes part of such a process as a way to help taking decisions. This research aimed to analyze the use of Knowledge Management techniques to the Risk Management in software projects development and the possible influence on the enterprise revenue. It had, as its main studying subject, Brazilian incubated and graduated software developing enterprises. The chosen research method was the Survey type. Multivariate statistical methods were used for the treatment and analysis of the obtained results, this way identifying the most significant factors, that is, enterprise's achievement constraining factors and those outcome achievement ones. Among the latter we highlight the knowledge methodology, the time of existence of the enterprise, the amount of employees and the knowledge externalization. The results encourage contributing actions to the increasing of financial revenue. © 2013 Springer-Verlag.

Usabilidade de software: estudo de recomendações básicas para verificação do nível de conhecimento dos alunos dos cursos de Design Gráfico e Sistemas de Informação da UNESP/Bauru

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Painéis de bambu, uso e aplicações: uma experiência didática nos cursos de design em Bauru, São Paulo

Pós-graduação em Design - FAAC

Design/empresa/sociedade

O presente trabalho se propôs a estudar, através de um levantamento sobre o estado da arte do ensino do design no Brasil, da sua prática pelos designers e da visibilidade das condições daí resultantes, discutir eventuais estratégias que tornem tanto o ensino como os seus produtos condizentes com a realidade nacional sem perda da universalidade. Os resultados estão fortemente subsidiados pelo estágio de pós-doutorado cumprido na Universidade de Arte e Design de Helsinque entre agosto de 2006 e maio de 2007

Design e usabilidade: interação, satisfação e afetividade em objetos de aprendizagem

Pós-graduação em Design - FAAC