An evaluation of shot peening, residual stress and stress relaxation on the fatigue life of AISI 4340 steel

Shot peening is a method widely used to improve the fatigue strength of materials. through the creation of a compressive residual stress field (CRSF) in their surface layers. In the present research the gain in fatigue life of AISI 4340 steel, Used in landing gear. is evaluated under four Shot peening conditions. Rotating bending fatigue tests were conducted and the CRSF was measured by an X-ray tensometry prior and during fatigue tests. It was observed that relaxation of the CRSF occurred due to the fatigue process. In addition, the fractured fatigue specimens were investigated using a scanning electron microscope in order to obtain information about the crack initiation points. The evaluation of fatigue life, relaxation of CRSF and crack sources are discussed. (C) 2002 Elsevier B.V. Ltd. All rights reserved.

Evaluation of shot peening on the fatigue strength of anodized Ti-6Al-4V alloy

The increasingly design requirements for modern engineering applications resulted in the development of new materials with improved mechanical properties. Low density, combined with excellent weight/strength ratio as well as corrosion resistance, make the titanium attractive for application in landing gears. Fatigue control is a fundamental parameter to be considered in the development of mechanical components. The aim of this research is to analyze the fatigue behavior of anodized Ti-6Al-4V alloy and the influence of shot peening pre treatment on the experimental data. Axial fatigue tests (R = 0.1) were performed, and a significant reduction in the fatigue strength of anodized Ti-6Al-4V was observed. The shot peening superficial treatment, which objective is to create a compressive residual stress field in the surface layers, showed efficiency to increase the fatigue life of anodized material. Experimental data were represented by S-N curves. Scanning electron microscopy technique (SEM) was used to observe crack origin sites.

Two challenges for the twenty-first century: achieving financial discipline and putting the internationalization process in order

Includes bibliography

Putting children into poverty statistics

Includes bibliography

Estudo sobre os efeitos de tensões residuais na vida em fadiga da liga de alumínio 6013-T6, em perfil tubular, submetidas a shot peening

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

A influência do shot peening e das anodizações crômica, sulfúrica e dura sobre a resistência à fadiga da liga AL7050-T7451 de uso aeronaútico

Pós-graduação em Engenharia Mecânica - FEG

Influence of shot peening on the fatigue strength of Custom 465 stainless steel for aeronautic application

This project was originated from the national aircraft industry requirements to reduce the use of coated materials with electroplated chromium or cadmium that produce waste, which is harmful to health or the environment. The selected material is a Custom 465 stainless steel used in the aeronautical field due to its high mechanical strength. Considering the load sustained by the wheel axis of the landing gear, the Custom 465 is tested in axial fatigue. The objective is to compare the behavior of the Custom 465 with plated AISI 4340 steel coated with cadmium. X-ray diffraction method was used to determine the residual stress field induced by shot peening.

Estudo do efeito do processo de shot peening na taxa de propagação de trinca por fadiga na liga aeronáutica 2024 - T3

Pós-graduação em Engenharia Mecânica - FEG

Low-carbon operations and production: putting training in perspective

The purpose of this paper is mainly to show how training may support low-carbon operations and production management in a more sustainable organizational context. Design/methodology/approach – A conceptual framework to facilitate the integration between training and low-carbon operations and production is presented. Findings – To accomplish better training in a low-carbon organization, some steps should be followed. Challenges may occur, including the necessity of collaboration across the supply chain. Research limitations/implications – The proposed framework should be applied and improved based on the actual conditions in organizations.

Fourier´s law from a chain of coupled anharmonic oscillators under energy conserving shot noise.

We analyze the transport of heat along a chain of particles interacting through anharmonic potentials consisting of quartic terms in addition to harmonic quadratic terms and subject to heat reservoirs at its ends. Each particle is also subject to an impulsive shot noise with exponentially distributed waiting times whose effect is to change the sign of its velocity, thus conserving the energy of the chain. We show that the introduction of this energy conserving stochastic noise leads to Fourier's law. That is for large system size L the heat current J behaves as J ‘approximately’ 1/L, which amounts to say that the conductivity k is constant. The conductivity is related to the current by J = kΔT/L, where ΔT is the difference in the temperatures of the reservoirs. The behavior of heat conductivity k for small intensities¸ of the shot noise and large system sizes L are obtained by assuming a scaling behavior of the type k = ‘L POT a Psi’(L’lambda POT a/b’) where a and b are scaling exponents. For the pure harmonic case a = b = 1, characterizing a ballistic conduction of heat when the shot noise is absent. For the anharmonic case we found values for the exponents a and b smaller then 1 and thus consistent with a superdiffusive conduction of heat without the shot noise. We also show that the heat conductivity is not constant but is an increasing function of temperature.

Single-shot electron bunch length measurements using a spatial electro-optical autocorrelation interferometer

A spatial, electro-optical autocorrelation (EOA) interferometer using the vertically polarized lobes of coherent transition radiation (CTR) has been developed as a single-shot electron bunch length monitor at an optical beam port downstream the 100 MeV preinjector LINAC of the Swiss Light Source. This EOA monitor combines the advantages of step-scan interferometers (high temporal resolution) [D. Mihalcea et al., Phys. Rev. ST Accel. Beams 9, 082801 (2006) and T. Takahashi and K. Takami, Infrared Phys. Technol. 51, 363 (2008)] and terahertz-gating technologies [U. Schmidhammer et al., Appl. Phys. B: Lasers Opt. 94, 95 (2009) and B. Steffen et al., Phys. Rev. ST Accel. Beams 12, 032802 (2009)] (fast response), providing the possibility to tune the accelerator with an online bunch length diagnostics. While a proof of principle of the spatial interferometer was achieved by step-scan measurements with far-infrared detectors, the single-shot capability of the monitor has been demonstrated by electro-optical correlation of the spatial CTR interference pattern with fairly long (500 ps) neodymium-doped yttrium aluminum garnet (Nd:YAG) laser pulses in a ZnTe crystal. In single-shot operation, variations of the bunch length between 1.5 and 4 ps due to different phase settings of the LINAC bunching cavities have been measured with subpicosecond time resolution.

The Politics of the "New North": Putting History and Geography at Stake in Arctic Futures

References to a “New North” have snowballed across popular media in the past 10 years. By invoking the phrase, scientists, policy analysts, journalists and others draw attention to the collision of global warming and global investment in the Arctic today and project a variety of futures for the region and the planet. While changes are apparent, the trope of a “New North” is not new. Discourses that appraised unfamiliar situations at the top of the world have recurred throughout the twentieth century. They have also accompanied attempts to cajole, conquer, civilize, consume, conserve and capitalize upon the far north. This article examines these politics of the “New North” by critically reading “New North” texts from the North American Arctic between 1910 and 2010. In each case, appeals to novelty drew from evaluations of the historical record and assessments of the Arctic’s shifting position in global affairs. “New North” authors pinpointed the ways science, state power, capital and technology transformed northern landscapes at different moments in time. They also licensed political and corporate influence in the region by delimiting the colonial legacies already apparent there. Given these tendencies, scholars need to approach the most recent iteration of the “New North” carefully without concealing or repeating the most troubling aspects of the Arctic’s past.

Putting the magic in magic bullets: top three global priorities for sexually transmitted infection control

Setting practical priorities for sexually transmitted infection (STI) control is a balance between idealism and pragmatism. Infections transmitted through unsafe sex (chlamydia, gonorrhoea, syphilis, HIV, hepatitis B and human papillomavirus (HPV) infections) rank in the top five causes of the global burden of disease.1 Their distribution in populations is driven by a complex mixture of individual behaviours, social and community norms and societal and historical context. Ideally, we would be able to reduce exposure to unsafe sex to its theoretical minimum level of zero and thus eliminate a significant proportion of the current global burden of disease, particularly in resource-poor settings.2 Ideally, we would have ‘magic bullets’ for diagnosing and preventing STI in addition to specific antimicrobial agents for specific infections.3 Arguably, we have ‘bullets’ that work at the individual level; highly accurate diagnostic tests and highly efficacious vaccines, antimicrobial agents and preventive interventions.4 Introducing them into populations to achieve similarly high levels of effectiveness has been more challenging.4 In practice, the ‘magic’ in the magic bullet can be seen as overcoming the barriers to sustainable implementation in partnerships, larger sexual networks and populations (figure 1).4 We have chosen three (pragmatic) priorities for interventions that we believe could be implemented and scaled up to control STI other than HIV/AIDS. We present these starting with the partnership and moving up to the population level.