Agronomic characteristics, isoflavone content and Kunitz trypsin inhibitor of vegetable soybean genotypes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Characterization of a Coal Fly Ash-Cement Slurry by the Absolute Foam Index

This dissertation established a standard foam index: the absolute foam index test. This test characterized a wide range of coal fly ash by the absolute volume of air-entraining admixture (AEA) necessary to produce a 15-second metastable foam in a coal fly ash-cement slurry in a specified time. The absolute foam index test was used to characterize fly ash samples having loss on ignition (LOI) values that ranged from 0.17 to 23.3 %wt. The absolute foam index characterized the fly ash samples by absolute volume of AEA, defined as the amount of undiluted AEA solution added to obtain a 15-minute endpoint signified by 15-second metastable foam. Results were compared from several foam index test time trials that used different initial test concentrations to reach termination at selected times. Based on the coefficient of variation (CV), a 15-minute endpoint, with limits of 12 to 18 minutes was chosen. Various initial test concentrations were used to accomplish consistent contact times and concentration gradients for the 15-minute test endpoint for the fly ash samples. A set of four standard concentrations for the absolute foam index test were defined by regression analyses and a procedure simplifying the test process. The set of standard concentrations for the absolute foam index test was determined by analyzing experimental results of 80 tests on coal fly ashes with loss on ignition (LOI) values ranging from 0.39 to 23.3 wt.%. A regression analysis informed selection of four concentrations (2, 6, 10, and 15 vol.% AEA) that are expected to accommodate fly ashes with 0.39 to 23.3 wt.% LOI, depending on the AEA type. Higher concentrations should be used for high-LOI fly ash when necessary. A procedure developed using these standard concentrations is expected to require only 1-3 trials to meet specified endpoint criteria for most fly ashes. The AEA solution concentration that achieved the metastable foam in the foam index test was compared to the AEA equilibrium concentration obtained from the direct adsorption isotherm test with the same fly ash. The results showed that the AEA concentration that satisfied the absolute foam index test was much less than the equilibrium concentration. This indicated that the absolute foam index test was not at or near equilibrium. Rather, it was a dynamic test where the time of the test played an important role in the results. Even though the absolute foam index was not an equilibrium condition, a correlation was made between the absolute foam index and adsorption isotherms. Equilibrium isotherm equations obtained from direct isotherm tests were used to calculate the equilibrium concentrations and capacities of fly ash from 0.17 to 10.5% LOI. The results showed that the calculated fly ash capacity was much less than capacities obtained from isotherm tests that were conducted with higher initial concentrations. This indicated that the absolute foam index was not equilibrium. Rather, the test is dynamic where the time of the test played an important role in the results. Even though the absolute foam index was not an equilibrium condition, a correlation was made between the absolute foam index and adsorption isotherms for fly ash of 0.17 to 10.5% LOI. Several batches of mortars were mixed for the same fly ash type increasing only the AEA concentration (dosage) in each subsequent batch. Mortar air test results for each batch showed for each increase in AEA concentration, air contents increased until a point where the next increase in AEA concentration resulted in no increase in air content. This was maximum air content that could be achieved by the particular mortar system; the system reached its air capacity at the saturation limit. This concentration of AEA was compared to the critical micelle concentration (CMC) for the AEA and the absolute foam index.

Trace metal content in Pliocene to Pleistocene sediments of ODP Leg 127 holes

Quaternary sedimentation within the Japan Sea was controlled by the configuration of peripheral sills, seasonal and long-term climatic variability, and the resultant fluctuations in sea level (Tamaki, 1988). Prior to drilling in the area, piston cores recovered from its basins contained Pleistocene sediments having distinctive color and fabric variation. Sedimentological and geochemical studies conducted on those facies indicated that the variability in fabric was the result of fluctuating marine and/or terrigenous influx to the deep-water basins of the Japan Sea (see, for example, Chough, 1984; Matoba, 1984). The sequences recovered during Leg 127 at Sites 794, 795, and 797 contain long, virtually undisturbed sequences (92.3, 123, and 119.9 mbsf [Hole 797B], respectively) of upper Miocene, upper Pliocene, and Pleistocene/Holocene sediments. The majority of these sequences consists of dark-colored (dark brown, green, and black) silty-clays, many of which are enriched in biogenic components (majority silicious, some carbonate) and/or organic matter, some containing pyrite and/or ash. These facies alternate with light-colored silty-clays, some containing ash and some showing signs of bioturbation (for example, Tamaki, Pisciotto, Allan, et al., 1990, p. 425-433). The dark-to-light sequences are present throughout the section, although they are especially dominant throughout the Pleistocene (for a more detailed lithology of Quaternary sequences recovered at Sites 794, 795, and 797, see Follmi et al. 1992 and Tada et al., 1992). This data report provides trace metal information on Pliocene-Pleistocene-Holocene samples at Sites 794,795, and 797. These data can be used (1) to provide information related to the depositional environments of the Japan Sea during the Quaternary period, (2) to permit comparisons between the dark organic-rich sediments recovered from this semi-enclosed basin and those reported for other silled basins (for example, the Mediterranean and Black seas), and (3) to permit comparisons between these sediments and contemporary equivalents found, for instance, beneath areas of high biogenic productivity. By providing such data, one should be able (1) to determine more precisely the processes governing the deposition of sediments with various levels of organic matter within enclosed basins, (2) to compare individual basin-wide processes, (3) to look for and compare the signatures present as a result of climatic fluctuation, and (4) to attempt to identify the presence and/or absence of cyclicity within such sequences.

Trace-element contents in ash samples from DSDP Leg 19 sediments

The Sr, Rb, Ti, and Zr concentrations of 16 volcanic ash samples from Leg 19 of the Deep Sea Drilling Project were determined by X-ray fluorescence. The age of each ash sample had been established previously by faunal criteria and had been confirmed by fission-track dating. Variations in the trace-element concentrations through the past 8 m.y. are clearly seen. Seven of the ashes are older than 4 m.y., have low TiO2 contents, and have Sr concentrations of less than 200 ppm; they are thus similar to tholeiitic basalts of island arcs. Nine ashes are younger than 4 m.y. and are similar in trace-element content to andesite. Magmatic evolution of the Aleutian arc over the past 8 m.y. is clearly shown.

(Table 2) Analyses of prominent ash layers recovered at DSDP Site 18-178, Gulf of Alaska

A sequence of ash layers recovered from site 178 of the Deep Sea Drilling Project in the Gulf of Alaska was studied to determine the nature of highly explosive volcanic eruptions associated with the Aleutian Arc and Alaskan Peninsula during the last 8 m.y. The major-element chemistry of 25 distinct ash layers was determined. When the analyses are plotted on conventional major-element variation diagrams, the unusual, highly evolved, calc-alkalic characteristics of the ashes are apparent. Perhaps more significantly, there is a good correlation of certain indices of the degree of chemical evolution of each ash (SiO2 content and Larsen index) with sample age. Both parameters vary cyclically, with maximum values of both indices occurring at present, 2.5, and about 5.0 m.y. ago. The cause of the cyclic activity, as well as discontinuous volcanic activity reported for other areas by other investigators, is not precisely known. However, we suggest that variable rates of subduction provide a viable hypothesis for discontinuous volcanic activity associated with convergent plate boundaries.