A new open-framework zinc arsenate [C4N3H16](2)[Zn-5(AsO4)(4)(HAsO4)(2)]

A three-dimensional zinc arsenate with an interrupted zeolitic framework (-IIO), [C4N3H16](2)[Zn-5(AsO4)(4)(HAsO4)(2)], I has been synthesized solvothermally. The structure is built up from ZnO4, AsO4 and HAsO4 tetrahedral units connected alternatively through their vertices forming the 3-D structure possessing one-dimensional channels bound by 10 T-atoms (T = Zn, As), The framework density of the structure is 10.4 T-atoms which indicates considerable openness in its structure. (C) 2009 Elsevier B.V. All rights reserved.

Adducts of bis(acetylacetonato)zinc(II) with 1,10-phenanthroline and 2,2'-bipyridine

In each of the zinc(II) complexes bis(acetylacetonato-kappa(2)O,O')(1,10-phenanthroline-kappa(2)N,N')zinc(II), [Zn(C(5)H(7)O(2))(2)(C(12)H(8)N(2))], (I), and bis(acetylacetonato-kappa(2)O,O')(2,2'-bipyridine-kappa(2)N,N')zinc(II), [Zn(C(5)H(7)O(2))(2)(C(10)H(8)N(2))], (II), the metal center has a distorted octahedral coordination geometry. Compound (I) has crystallographically imposed twofold symmetry, with Z' = 0.5. The presence of a rigid phenanthroline group precludes intramolecular hydrogen bonding, whereas the rather flexible bipyridyl ligand is twisted to form an intramolecular C-H...O interaction [the chelated bipyridyl ligand is nonplanar, with the pyridyl rings inclined at an angle of 13.4 (1) degrees]. The two metal complexes are linked by dissimilar C-H...O interactions into one-dimensional chains. The present study demonstrates the distinct effects of two commonly used ligands, viz. 1,10-phenanthroline and 2,2'-bipyridine, on the structures of metal complexes and their assembly.

Dielectric anomaly in Li-doped zinc oxide thin films grown by sol-gel route

Sol-gel route was employed to grow polycrystalline thin films of Li-doped ZnO thin films (Zn1-xLixO, x=0.15). Polycrystalline films were obtained at a growth temperature of 400-500 degrees C. Ferroelectricity in Zn0.85Li0.15O was verified by examining the temperature variation of the real and imaginary parts of dielectric constant, and from the C-V measurements. The phase transition temperature was found to be 330 K. The room-temperature dielectric constant and dissipation factor were 15.5 and 0.09 respectively, at a frequency of 100 kHz. The films exhibited well-defined hysteresis loop, and the values of spontaneous polarization (P-s) and coercive field were 0.15 mu C/cm(2) and 20 kV/cm, respectively, confirming the presence of ferroelectricity.

Piezoelectric zinc oxide thin film for MEMS application: A comparative study

We report here, the study carried out on piezoelectric thin film for MEMS/Microsensor applications. The study includes characterization of sputtered thin film using indirect methods and comparison of behavior using cantilever technique for the confirmation of piezoelectric property. A suitable experimental setup was designed and fabricated for subjecting the cantilever to vibrate. The data was recorded for piezoelectric thin films deposited with different compositions. It is clearly evident that the direct method is inexpensive and easier for determining the quality of the deposited piezoelectric thin film.

Mixed saturated-unsaturated alkyl-chain assemblies: Solid solutions of zinc stearate and zinc oleate

The linear saturated stearic acid and the bent mono-unsaturated oleic acid do not mix and form solid solutions. However, the zinc salts of these acids can. From X-ray diffraction and DSC measurements we show that the layered zinc stearate and zinc oleate salts form a homogeneous solid solution at all composition ratios. The solid solutions exhibit a single melting endotherm, with the melting temperature varying linearly with composition but with the enthalpy change showing a minimum. By monitoring features in the infrared spectra that are characteristic of the global conformation of the hydrocarbon chain, and hence can distinguish between stearate and oleate chains, it is shown that solid solution formation is realized by the introduction of gauche defects in a fraction of the stearate chains that are then no longer linear. This fraction increases with oleate concentration. It has also been possible from the spectroscopic measurements to establish a quantitative relation between molecular conformational order and the thermodynamic enthalpy of melting of the solid solutions.

Diet and physical activity behaviour in nurses: A qualitative study

Issue addressed: Previous research has shown that approximately 60% of nurses in Australia are overweight or obese, insufficiently active and have an unhealthy diet. The aim of this study was to gain an understanding of nurses’ determinants contributing to these behaviours. This will inform a needs assessment for a future workplace health promotion program (WHPP) in this group. Methods: Four focus group discussions (n = 17) were conducted with a convenience sample of nurses aged 25–59 years from three hospitals in the Brisbane metropolitan area. Questions addressed barriers and motivation towards diet and physical activity (PA), and suggestions for future WHPP. Data were analysed with Nvivo10 following a thematic analysis with a realistic approach using Self-determination theory as a framework. Results: Work environment was the main barrier for healthy diet behaviours. Long working hours and lack of breaks challenged nurses’ self-control and self-regulation when making dietary choices. Fatigue was the main barrier for PA. However, relaxation, feeling energised before work and better sleep after working night shifts motivated nurses to do PA. Social environment at work seemed to be an effective external motivation to encourage healthy diet and regular PA. Goal-setting, self-monitoring and social support at work were identified as potential WHHP strategies. Conclusion: The workplace and job demands negatively impacts nurses’ lifestyle behaviours. Future interventions should include social support from colleagues, which could motivate nurses to make healthier food choices at work and be more active outside work.

A novel fibre-coated sorbent for rapid removal of heavy metals from wastewater. Sorption of Zinc(II) from dilute aqueous solutions in the presence of high concentrations of common salts

The commercial acrylic fibre "Cashmilon" was partially hydrolyzed to convert a fraction of its nitrile (-CN) groups to carboxylic acid (-COOH) groups and then coated with polyethylenimine (PEI) resin and cross-linked with glutaraldehyde to produce a novel gel-coated fibrous sorbent with multiple functionalities of cationic, anionic and chelating types, and significantly faster sorption kinetics than bead-form sorbents. The sorption properties of the fibrous sorbent were measured using Zn(II) in aqueous solution as the sorbate to determine the effects of pH and the presence of common ions in the solution on the sorption capacity. The rate of sorption on the gel-coated fibre was measured in comparison with that on Amberlite IRA-68 weak-base resin beads, to demonstrate the marked difference between fibre and bead-form sorbents in their kinetic behaviour.

A novel fibre-coated sorbent for rapid removal of heavy metals from wastewater. Sorption of Zinc(II) from dilute aqueous solutions in the presence of high concentrations of common salts

The commercial acrylic fibre "Cashmilon" was partially hydrolyzed to convert a fraction of its nitrile (-CN) groups to carboxylic acid (-COOH) groups and then coated with polyethylenimine (PEI) resin and cross-linked with glutaraldehyde to produce a novel gel-coated fibrous sorbent with multiple functionalities of cationic, anionic and chelating types, and significantly faster sorption kinetics than bead-form sorbents. The sorption properties of the fibrous sorbent were measured using Zn(II) in aqueous solution as the sorbate to determine the effects of pH and the presence of common ions in the solution on the sorption capacity. The rate of sorption on the gel-coated fibre was measured in comparison with that on Amberlite IRA-68 weak-base resin beads, to demonstrate the marked difference between fibre and bead-form sorbents in their kinetic behaviour.

Studies in the polarographic behaviour of zinc-amino acid complexes

1. The polarographic behaviour of amino-acid complexes of zinc has been studied using seven amino acids as complexing agents. 2. The effect of varying the pH of the base solution and the concentration of amino-acid anion on the polarographic behaviour of zinc in these solutions have indi cated the formation of twelve amino-acid complexes. The stability constants could not be calculated due to the irreversible nature of the waves. 3. The effect of sodium hydroxide, sodium carbonate, and ammonia on the polarographic behaviour of zinc has been investigated. The results can be interpreted as due to the formation of mixed complexes in many systems. 4. Amino-acid base solutions have been found to be suitable for the polarographic estimation of zinc.

Content of zinc, iron and their absorption inhibitors in Nicaraguan common beans (Phaseolus vulgaris L.).

Protein-energy malnutrition and mineral deficiencies are two of the three forms of nutritional deficiencies that affect most developing countries due to inadequate access to food and diets based on a sole crop. Common bean (Phaseolus vulgaris L.) is the staple crop of Nicaragua and it has the potential to improve the nutritional status of the poorest group of the nation. Its high content of both protein and nonhaem iron provides many nutrients, but inhibitors also may prevent absorption of iron and zinc by the human consumer. A proper production chain must be followed to ensure the best grain quality for the consumer. To achieve food security, both production and high nutritional content must be maintained. Four nationally important accessions of common bean, with different harvesting dates, were selected to be submitted to two treatments: to evaluate the impact of storage conditions on the end quality of the grain. The duration of the study was six months with sampling every six weeks, and the two treatments were controlled one stored at 40°C and 75 RH %, and the other was stored in in-situ conditions. Proximate and mineral composition was evaluated as well as tannin, phytate and bioavailability. Significant differences among different accessions were found, being the most significant in protein, Fe and Zn content, tannins and phytate. Protein values ranged from 21-23%. Iron content was 61-81 mg/kg but only 3-4% was bioavailable. Zinc content was 21-25 mg/kg and 10-12% was bioavailable. The concentration of phytate ranged from 8.6-9.6 mg/g while tannin values ranged within 37.7-43.8 mg/g. Storage at high temperatures was demonstrated to have an impact on certain nutritional compounds and proved detrimental to final grain quality. Soluble sugar content and tannin content decreased after six months in both storage conditions, IDF decreased in the in-situ and SDF in the stress. The iron content and bioavailability in INTA Biofortificado were not as outstanding as expected, so experiments should be conducted to compare its iron uptake and delivery with other cultivars.

Electron-metallographic studies of precipitation in an aluminium-zinc-magnesium alloy

The mechanism of sub-microscopic precipitation in an Al-Zn-Mg alloy selected for its maximum response to ageing has been studied by a standardized oxide-replica technique in a 100 kV. Philips Electron Microscope. Contrary to earlier conclusions, examination of the oxide replicas has been shown to reveal details of the precipitation process almost as clearly as the thin-foil transmission technique. The reported formation of spherical Guinier-Preston zones followed by the development of a Widmanstaetten pattern of precipitated platelets has been confirmed. The zones have, however, been shown to grow into the platelets and not to dissolve in the matrix as reported earlier. The precipitation process has been correlated with the Hardness/Ageing Time curve and the structure of the precipitates has also been discussed.

High cholesterol diet and esterification of cholesterol by the intestinal mucosa of rats

Young male rats maintained on a diet containing 1% cholesterol were sacrificed at the end of 1st, 2nd, 3rd, 5th, and 7th week. Acetone powders prepared from their intestinal mucosa and pancreas were tested for the synthetic and hydrolytic activities for Vitamin A and cholesterol esters. The esterifying activity of the mucosal enzymes for both Vitamin A and cholesterol increased progressively up to the end of the 5th week; the increase in esterification of cholesterol was more marked with respect to saturated fatty acids, as compared to the unsaturated ones. The pancreatic enzymes remained unaffected. It is suggested that one of the reasons for the accumulation of cholesterol esters in animal tissues may be the increased esterification of the sterol in the mucosa induced by dietary cholesterol.

Lattice vibrations and specific heat of zinc blende

The dispersion relations, frequency distribution function and specific heat of zinc blende have been calculated using Houston's method on (1) A short range force (S. R.) model of the type employed in diamond by Smith and (2) A long range model assuming an effective charge Ze on the ions. Since the elastic constant data on ZnS are not in agreement with one another the following values were used in these calculations: {Mathematical expression}. As compared to the results on the S. R. model, the Coulomb force causes 1. A splitting of the optical branches at (000) and a larger dispersion of these branches; 2. A rise in the acoustic frequency branches the effect being predominant in a transverse acoustic branch along [110]; 3. A bridging of the gap of forbidden frequencies in the S. R. model; 4. A reduction of the moments of the frequency distribution function and 5. A flattening of the Θ- T curve. By plotting (Θ/Θ0) vs. T., the experimental data of Martin and Clusius and Harteck are found to be in perfect coincidence with the curve for the short range model. The values of the elastic constants deduced from the ratio Θ0 (Theor)/Θ0 (Expt) agree with those of Prince and Wooster. This is surprising as several lines of evidence indicate that the bond in zinc blende is partly covalent and partly ionic. The conclusion is inescapable that the effective charge in ZnS is a function of the wave vector {Mathematical expression}.