制备式等电聚焦鉴定湖南产五步蛇蛇毒磷脂酶A_2的等电点及纯度

制备式等电聚焦测得湖南产五步蛇蛇毒磷脂酶Ａ２为单一的吸收峰（ＯＤ２８０），等电点为５．３２，证明了作者前报道的纯化的磷脂酶Ａ２为纯品

In vitro osteoblast response to ferritic stainless steel fiber networks for magneto-active layers on implants

The use of a porous coating on prosthetic components to encourage bone ingrowth is an important way of improving uncemented implant fixation. Enhanced fixation may be achieved by the use of porous magneto-active layers on the surface of prosthetic implants, which would deform elastically on application of a magnetic field, generating internal stresses within the in-growing bone. This approach requires a ferromagnetic material able to support osteoblast attachment, proliferation, differentiation, and mineralization. In this study, the human osteoblast responses to ferromagnetic 444 stainless steel networks were considered alongside those to nonmagnetic 316L (medical grade) stainless steel networks. While both networks had similar porosities, 444 networks were made from coarser fibers, resulting in larger inter-fiber spaces. The networks were analyzed for cell morphology, distribution, proliferation, and differentiation, extracellular matrix production and the formation of mineralized nodules. Cell culture was performed in both the presence of osteogenic supplements, to encourage cell differentiation, and in their absence. It was found that fiber size affected osteoblast morphology, cytoskeleton organization and proliferation at the early stages of culture. The larger inter-fiber spaces in the 444 networks resulted in better spatial distribution of the extracellular matrix. The addition of osteogenic supplements enhanced cell differentiation and reduced cell proliferation thereby preventing the differences in proliferation observed in the absence of osteogenic supplements. The results demonstrated that 444 networks elicited favorable responses from human osteoblasts, and thus show potential for use as magnetically active porous coatings for advanced bone implant applications. © 2012 Wiley Periodicals, Inc.

微量营养物质对毛纺废水生物处理效果的影响

研究了Mg、Mo、Zn、维生素B1以及烟酸等微量营养物质对活性污泥降解CODCr活性的 影响,同时,对微量营养物质作用前后处理系统微生物群落结构进行了比较研究。试验结果表明:毛 纺废水缺乏生物处理系统所需足够的微量营养物质;不同种类和浓度的微量营养物质对活性污泥降 解CODCr活性的影响效果也不相同,Mg、Mo、Zn、雏生素B1和烟酸的最佳浓度分别为5 mg／L, 2 mg／L,1 mg／L,1 mg／L和1 mg／L;其最佳促进效果可使CODCr降解速率分别达到对照系统的 180％、140％、130％,

污水中8种雌激素化合物的定量测定

采用固相萃取-气相色谱-质谱法(GC-MS)测定污水中辛酚(OP)、壬酚(NP)、双酚A(BPA)、己烯雌酚(DES)、雌酮(E1)、17β-雌二醇(E2)、17α-乙炔雌二醇(EE2)和雌三醇(E3)8种具有雌激素活性的化合物。被测组分的加标回收率为(65.4±4.0)%～(110.0±4.5)%,检出限为1.0～7.5ng/L(相对标准偏差为5.2%～15.6%)。经检测,武汉某城市污水处理厂进水中的目标化合物(除EE2外)浓度为6.5～8954.9ng/L;除EE2和E3外,出水中的浓度为3.2～2

Taper-free and vertically oriented Ge nanowires on Ge/Si substrates grown by a two-temperature process

Taper-free and vertically oriented Ge nanowires were grown on Si (111) substrates by chemical vapor deposition with Au nanoparticle catalysts. To achieve vertical nanowire growth on the highly lattice mismatched Si substrate, a thin Ge buffer layer was first deposited, and to achieve taper-free nanowire growth, a two-temperature process was employed. The two-temperature process consisted of a brief initial base growth step at high temperature followed by prolonged growth at lower temperature. Taper-free and defect-free Ge nanowires grew successfully even at 270 °C, which is 90 °C lower than the bulk eutectic temperature. The yield of vertical and taper-free nanowires is over 90%, comparable to that of vertical but tapered nanowires grown by the conventional one-temperature process. This method is of practical importance and can be reliably used to develop novel nanowire-based devices on relatively cheap Si substrates. Additionally, we observed that the activation energy of Ge nanowire growth by the two-temperature process is dependent on Au nanoparticle size. The low activation energy (∼5 kcal/mol) for 30 and 50 nm diameter Au nanoparticles suggests that the decomposition of gaseous species on the catalytic Au surface is a rate-limiting step. A higher activation energy (∼14 kcal/mol) was determined for 100 nm diameter Au nanoparticles which suggests that larger Au nanoparticles are partially solidified and that growth kinetics become the rate-limiting step. © 2011 American Chemical Society.

Defect-free GaAs/AlGaAs Core-shell nanowires on Si substrates

We report straight and vertically aligned defect-free GaAs nanowires grown on Si(111) substrates by metal-organic chemical vapor deposition. By deposition of thin GaAs buffer layers on Si substrates, these nanowires could be grown on the buffer layers with much less stringent conditions as otherwise imposed by epitaxy of III-V compounds on Si. Also, crystal-defect-free GaAs nanowires were grown by using either a two-temperature growth mode consisting of a short initial nucleation step under higher temperature followed by subsequent growth under lower temperature or a rapid growth rate mode with high source flow rate. These two growth modes not only eliminated planar crystallographic defects but also significantly reduced tapering. Core-shell GaAs-AlGaAs nanowires grown by the two-temperature growth mode showed improved optical properties with strong photoluminescence and long carrier life times. © 2011 American Chemical Society.

RESPONSES OF Elodea nuttallii AND Ceratophyllum demersum TO HIGH TEMPERATURE

There were large losses of exotic species Elodea nuttallii during summer in eutrophic lakes of the middle and lower reaches of the Yanatze River, China. To investigate the main causes, the heat tolerance of E. nuttallii was studied and compared with that of native species Ceratopkyllum demersum by using an aquaria system in the laboratory. Under 4500 lx light intensity and 12-h L/12-h D cycle, E. nuttallii cultured in 1/5 Hoaglands solution at 39 degrees C showed a positive growth rate during the first 15 days, and the growth rate was higher than that at 35 degrees C. But after 15 days, the growth rates became negative for those cultured both at 39 and 35 degrees C. However, the growth rate was positive for more than 20 days for those cultured at 25 degrees C. Under the same conditions, the growth rate, productivity and chlorophyll content of E. nuttallii were significantly higher than that of C. demersum. Heat tolerance of E. nuttallii was also stronger than that of C. demersum. The optimal temperature for the growth of the two plants depended on the experimental period: both plants grew at an optimal rate at higher temperature if the experimental period was short; nevertheless the plants achieved optimal growth at a lower temperature if the experiment was conducted for a longer period. At the same light intensity, the heat tolerance of C. demersum in tap water with sediment was markedly stronger than that of E. nuttallii at 39 degrees C. Average growth rate of C. demersum was 4.5 times higher than that of E. nuttallii within 25 days. The positive growth period lasted for less than 25 days for E. nuttallii and for more than 25 days for C. demersum. When they were cultured in 1/5 Hoaglands solution and in tap water with sediment, the growth rate of C. demersum increased from 0.4 to 79.4 mg/d.g fresh weight (FW) within 20 days. E. nuttallii increased from 8.3 to 24.4 mg/d-g FW within 20 days. Both grew better in tap water with sediment than in 1/5 Hoaglands solution. The results demonstrated that the nutritional status of the water other than the high temperature affected the heat tolerance of E. nuttallii during summer. E. nuttallii has great ecological safe risk in China.

Actinomycetes and earthy-musty odorous compounds in brackish fishponds in Tianjin, China

The presence of the odorous compounds, 2-methylisoborneol (MIB) and geosmin, as well as causative microorganisms in brackish intensive cultivation fishponds in Tianjin, China that had a severe earthy-musty odor were evaluated. The results revealed that MIB was the primary odorous compound present in the Tianjin fishponds, with a concentration ranging from 0.53-5302.7 ng.L-1. Furthermore, the concentration of MIB was found to be closely correlated with the gross biomass of actinomycetes in the water, which ranged from 10.67-1528.24 x 10(6) cfu.ml(-1). Therefore, the sequences of the 16 SrRNA and morphological characteristics of the actinomycetes in the brackish fishponds were investigated. The results revealed that the actinomycetes in the brackish fishponds included 9 species of common and dominant actinomycetes belonging to 4 genera. Of these genera, Streptomyces were the dominant species, and Streptomyces, Nocardioides and Micromonospora were the most common species in the fishponds evaluated. Next, the ability of each of the isolated Streptomyces to produce MIB was measured under laboratory culture conditions. Streptomyces Sp2 was found to have a strong ability to produce MIB, which indicates that this strain may be the primary source of the earthy-musty odor reported in brackish intensive cultivation fishponds in Tianjin, China.

A Smart Frequency Presetting Technique for Fast Lock-in LC-PLL Frequency Synthesizer

This paper proposes a smart frequency presetting technique for fast lock-in LC-PLL frequency synthesizer. The technique accurately presets the frequency of VCO with small initial frequency error and greatly reduces the lock-in time. It can automatically compensate preset frequency variation with process and temperature. A 2.4GHz synthesizer with 1MHz reference input was implemented in 0.35 mu m CMOS process. The chip core area is 0.4mm(2). Output frequency of VCO ranges from 2390 to 2600MHz. The measured results show that the typical lock-in time is 3 mu s. The phase noise is -112dBc/Hz at 600KHz offset from center frequency. The test chip consumes current of 22mA that includes the consumption of the I/O buffers.

面向XML文档的细粒度强制访问控制模型

XML文档存放的信息需要受到访问控制策略的保护.现有的一些面向XML文档的访问控制模型都是基于自主访问控制策略或基于角色的访问控制.高安全等级系统需要强制访问控制来保证系统内信息的安全.首先扩展了XML文档模型使其包含标签信息,并给出了扩展后的文档模型需要满足的规则.然后通过讨论XML文档上的4种操作,描述了面向XML文档的细粒度强制访问控制模型的详细内容.该模型基于XML模式技术,它的控制粒度可以达到文档中的元素或者属性.最后讨论了该模型的体系结构和一些实现机制。

面向有差异群体的联合决策方案

公平性、透明性是联合决策的基本安全需求.结合多机构商务合作背景,利用具有同态性质的Paillier公钥密码系统和门限密码技术,提出了面向有差异群体的联合决策策略与方案,并对其安全性进行了分析和证明.

SOA-based actively mode-locked fiber ring laser by forward injecting an external pulse train

An actively mode-locked fiber ring laser based on cross-gain modulation (XGM) in a semiconductor optical amplifier (SOA) is demonstrated to operate stably with a simple configuration. By forward injecting an easily-generated external pulse train, the mode-locked fiber laser can generate an optical-pulse sequence with pulsewidth about 6 ps and average output power about 7.9 mW. The output pulses show an ultra-low RMS jitter about 70.7 fs measured by a RF spectrum analyzer. The use of the proposed forward-injection configuration can realize the repetition-rate tunability from I to 15 GHz for the generated optical-pulse sequences. By employing a wavelength-tunable optical band-pass filter in the laser cavity, the operation wavelength of the designed SOA-based actively mode-locked fiber laser can be tuned continuously in a wide span between 1528 and 1565 nm. The parameters of external-injection optical pulses are studied experimentally to optimize the mode-locked fiber laser. (C) 2009 Elsevier B.V. All rights reserved.