Appraisal of water resources in the east central Florida region

The rapidly expanding population and economic growth in the seven counties of the East Central Florida Regional Planning Council as shown in Figure 1, herein called the East Central Florida Region or the Region, has resulted in increasing demands on its water resources. Although there is abundant water in the Region as a whole, the water in some areas of the Region is of unacceptable quality for most uses. As the population increases the demand for water will become much greater and the available supply may be reduced by pollution and increased drainage necessitated by urbanization and other land development- Ground-water supplies can be increased by capturing and storing water underground that now drains to the sea or evaporates from swamp areas. Research is needed, however, to develop artificial-recharge methods that are feasible and which will preserve or improve the quality of water in the aquifer. (PDF contains 57 pages)

The mechanical effects of water flow on fish eggs and larvae

The impact of mechanical stresses upon ichthyoplankton entrained in power plant cooling systems has long been considered negligible. Arguments and evidence exist, however, to show that such a supposition is not universally true, especially in nuclear power plants. The mechanisms of mechanical damage can be detailed in terms of pressure change, acceleration, and shear stress with in the fluid flow field. Laboratory efforts to quantify the effects of mechanical stress have been very sparse. A well-planned bioassay is urgently needed. (PDF has 11 pages.)

The Influence of Viscosity and Surface Tension on Atomization of Water/Methanol and Diesel Emulsions

This paper shows the result of experimental studies of the influence of viscosities, surface tensions on atomization characteristics of water/methanol and diesel emulsions. Three emulsifying agents Y01, Y02 and Y03, with viscosity of 1.32 ～ 1.5 Pa·s and HLB values of 5.36, 4.83 and 4.51 respectively was produced by Span 80 and Tween 60. In the W/O emulsions, the aqueous phase is between 10% and 50%; the agent concentration added is 0.8 ～ 8.0%. The viscosity of the emulsions is 0.003 ～ 0.02 Pa·s, and the surface tension is 0.04 ～ 0.1 N/m. The types and concentrations of agents and the aqueous phase ( < 50%) significantly influence the viscosity of the emulsions and the Sauter Mean Diameter, measured by Malvern Particle Analyzer SERIES 2600.

Reuse of software components orientated to iOS mobile devices

Within the next few pages, I will try to give a wide description of the project that I have been doing for IK4-Ikerlan. For the last six months, I have been working in developing a socket-based application for Apple devices. These devices work under the iOS operative system, which is programmed in Objective-C, a language similar to C. Although I did not have the chance to develop this application for Apple TV, I was able to create an application for iPhone and another one for iPad. The only difference between both applications was the screen resolution, but we decided to make them separately, as it would be really hard to combine both resolutions, and wallpapers, everything in the same workspace. Finally, it is necessary to add that the main goal was not to create a new application for iOS, but to translate an Android application into iOS. To achieve this, it is required to translate Java code into Objective- C, which is the language used to develop applications for all kinds of Apple devices. Fortunately, there is a tool created by Google, which helped us with this exercise. This tool is called j2ObjC, and it is still being developed.

Effect Of Water On Brittle Fracture Of Sio2 By Molecular Dynamics Study

The influence of water on the brittle behavior of beta-cristobalite is studied by means of molecular dynamics (MD) simulation With the TTAM potential. Crack extension of mode 1 type is observed as the crack opening is filled LIP With water. The critical stress intensity factor K-lc(MD) is used to characterize the crack extension of MD simulation. The surface energy of SiO2 covered with layers of water is calculated at temperature of 300 K. Based oil the Griffith fracture criterion, the critical stress intensity factor K-lc(Griffith) is calculated, and it is in good agreement with that of MD simulation. (C) 2008 Elsevier B.V. All rights reserved.

Transport Properties And Induced Voltage In The Structure Of Water-Filled Single-Walled Boron-Nitrogen Nanotubes

Density functional theory/molecular dynamics simulations were employed to give insights into the mechanism of voltage generation based on a water-filled single-walled boron-nitrogen nanotube (SWBNNT). Our calculations showed that (1) the transport properties of confined water in a SWBNNT are different from those of bulk water in view of configuration, the diffusion coefficient, the dipole orientation, and the density distribution, and (2) a voltage difference of several millivolts would generate between the two ends of a SWBNNT due to interactions between the water dipole chains and charge carriers in the tube. Therefore, this structure of a water-filled SWBNNT can be a promising candidate for a synthetic nanoscale power cell as well as a practical nanopower harvesting device.

Transport properties and induced voltage in the structure of water-filled single-walled boron-nitrogen nanotubes

Density functional theory/molecular dynamics simulations were employed to give insights into the mechanism of voltage generation based on a water-filled single-walled boron-nitrogen nanotube (SWBNNT). Our calculations showed that (1) the transport properties of confined water in a SWBNNT are different from those of bulk water in view of configuration the diffusion coefficient the dipole orientation and the density distribution and (2) a voltage difference of several millivolts would generate between the two ends of a SWBNNT due to interactions between the water dipole chains and charge carriers in the tube. Therefore this structure of a water-filled SWBNNT can be a promising candidate for a synthetic nanoscale power cell as well as a practical nanopower harvesting device.

Herbicidan control of water hyacinth at Ere, Ogun State: implications for fish production

A brief account is given of a pilot demonstration of the chemical control of water hyacinth (Eichhornia crassipes) at Ere (a channel) in Nigeria using the herbicide glyphosphate. Results suggest that there was an increase in the nutrient content of the channel after herbicide application. This implied an upsurge of available food for fish and other aquatic organisms within the channel after the herbicide application. The decaying water hyacinth mass which sinks into the medium is likely to boost nutrient content, promoting the growth of fish and other aquatic animals. It is concluded that herbicidal control of water hyacinth is possible, especially under specialists' management with the conservation of fish and other non-target aquatic organisms alongside improved fish production

A comparative assessment of the methods of control of water hyacinth infestation with regards to fish production

Water hyacinth (Eichhornia crassipes) has been subject of three control methods since its arrival into the Nigerian freshwater lagoon system in 1984 - mechanical, chemical and biological. An assessment of these three methods seems to suggest that mechanical and chemical control methods, both of which being costly, must be applied either solely or integrated to combat the present level of considerable infestation in Nigeria. The biological control methods are advisable for slow, sustained control and can only cope with low levels of infestation. It is thus concluded that the preliminary control method should be mechanical or chemical to effectively abate the nuisance plant, followed by biological control once infestation levels have been sufficiently reduced

The variation of water quality in the outdoor concrete tank and earthen pond

The paper reports on the study carried out at the Federal College of Freshwater Fisheries and Technology (Nigeria) and the Hatchery Complex in 1997. The physico-chemical parameters of an earthen fish pond and concrete tank were analysed. The abundance and distribution of phytoplankton and zooplankton were recorded. A total of eight species of phytoplankton were observed. These species can be classified as Chlorophyceae (green algae), Bacillariophyceae (diatom algae) and Cyanophyta (blue-green algae). Eight zooplankton species were observed in the pond and 6 in the tank. Moina was observed and recorded as the most abundant cladoceran species in the tank