18-Year Follow-up of Dens Invaginatus: Retrograde Endodontic Treatment

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Calvarial Autogenous Bone Graft for Maxillary Ridge and Sinus Reconstruction for Rehabilitation With Dental Implants

Autogenous bone grafting is the gold-standard technique for bone augmentation procedures prior to implant placement. If the amount of available intraoral donor bone is insufficient, it is necessary to harvest bone graft from extraoral sites, such as calvaria. Although this technique is well established, only a few case reports show the histological analysis of the grafted bone at the moment of implant placement. This article reports the case of a 48-year-old female patient with a critical atrophic maxillary ridge reconstructed using autogenous calvarial bone graft prior to implant placement, with clinical and histological evaluation. Bone was collected under general anesthesia from the parietal bone. The outer cortical originated the bone blocks, and the medullar bone layer between was collected to be used in the sinus augmentation procedure, together with 5 of the bone blocks triturated. Six months after bone augmentation, 8 implants were placed in the grafted area and 2 biopsies were retrieved (anterior and the posterior regions), allowing the visualization of the bone-remodeling process in the grafted areas. The patient had a stable recovery. Our results showed that although necrotic bone could still be seen in the outer layer of the grafted area, the interface between this necrotic bone and the already remodeled bone was consistent with biocompatibility. Two-year radiographic evaluation showed success of the grafts and the implants in supporting an esthetic and functionally stable prosthesis. Summarizing, calvarial bone grafts are a viable alternative for the attainment of adequate bone volume prior to implant placement.

A famacocinética e os efeitos sedativos e comportamentais dos cloridratos de xilazina e de detomidina, administrados por diferentes vias, em asininos Nordestinos (Equus sinus)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Alveolar ridge and maxillary sinus augmentation using rhBMP-2: a systematic review

Purpose: The aim of this systematic review was to evaluate clinical and safety data for recombinant human bone morpho-genetic protein-2 (rhBMP-2) in an absorbable collagen sponge (ACS) carrier when used for alveolar ridge/maxillary sinusaugmentation in humans.Materials and Methods: Clinical studies/case ser ies published 1980 through June 2012 using rhBMP-2/ACS were searched.Studies meeting the following criteria were considered eligible for inclusion: >10 subjects at baseline and maxillary sinus oralveolar ridge augmentation not concomitant with implant placement.Results: Seven of 69 publications were eligible for review. rhBMP-2/ACS yielded clinically meaningful bone formationfor maxillary sinus augmentation that would allow placement of regular dental implants without consistent differencesbetween rhBMP-2 concentrations. Never theless, the statistical analysis showed that sinus augmentation following autog-enous bone graft was significantly greater (mean bone height: 1.6 mm, 95% CI: 0.5–2.7 mm) than for rhBMP-2/ACS(rhBMP-2 at 1.5 mg/mL). In extraction sockets, rhBMP-2/ACS maintained alveolar ridge height while enhancing alve olarridge width. Safety reports did not represent concerns for the proposed indications.Conclusions: rhBMP-2/ACS appears a promising alternative to autogenous bone grafts for alveolar ridge/maxillary sinusaugmentation; dose and carrier optimization may expand its efficacy, use, and clinical application.

Frontal sinus obliteration with iliac crest bone grafts: review of 8 cases

This study evaluated postoperative results of 8 cases of frontal sinus fractures treated by frontal sinus obliteration with autogenous bone from the anterior iliac crest. Patients and methods: The medical charts of patients sequentially treated for frontal sinus fractures by obliteration with autogenous cancellous iliac crest bone in the Oral and Maxillofacial Surgery Division of this institution were reviewed. From those, eight had complete records and adequately described long-term follow-up. All were operated by the same surgical team. Those patients were recalled and independently evaluated by 2 examiners. Radiographs and/or CT scans were available for this evaluation. Associated fractures and complications were noted. The average postoperative follow-up was 7 years, ranging from 3 to 16 years. The main complication was infection. Four patients (50%) had uneventful long-term follow-ups and four (50%) experienced complications requiring reoperation. Based on the studied sample studied the authors conclude that the obliteration with autogenous bone presented a high percentage of complications in this series.

Frontal sinus obliteration with iliac crest bone grafts

This study evaluated postoperative results of 8 cases of frontal sinus fractures treated by frontal sinus obliteration with autogenous bone from the anterior iliac crest.

Ability of different methods to fill retrograde cavities with MTA.

The Mineral Trioxide Aggregate (MTA) has excellent biological property. However, its consistency makes it difficult to be inserted into retrograde cavities. Objective:To evaluate the ability of different methods to fill retrograde cavities with MTA. Material and methods: Root canals of thirty single-rooted resin teeth were prepared and filled. After the cut of 3 mm short of apical third, retrograde cavities with 3 mm deep were prepared using an ultrasound device and retrotips (CVD, São José dos Campos, SP, Brazil). The retrograde preparation was evaluate by using an operative microscope (D.F. Vasconcellos, São Paulo, SP, Brazil). The teeth were randomly divided into three groups (n = 10), according to the method: 1) condenser (Trinity, São Paulo, SP, Brazil); 2) MTA applicator (Angelus, Londrina, Brazil) + condenser; 3) condenser associated with ultrasound (CVD, São José dos Campos, SP, Brazil). After the filling of retrograde cavities with white MTA (Angelus, Londrina, Brazil), teeth were radiographed using a digital system (Kodak RVG 6000, Rochester, NY, USA). The images were analyzed by UTHSCSA Image Tool 3.0 software. The percentage of filling was calculated by the proportion between the total area of retrograde cavity and the filled area. The radiographic density mean of each third of retrograde cavity filled with MTA was measured by using the histogram tool of the software. The results were submitted to ANOVA and Tukey tests, with 5% of significance. Results: There was no difference in percentage of filling among the groups (p > 0.05) (approximately 85%). By comparing the thirds, the condenser and MTA applicator groups showed higher density for apical and middle third than cervical third (p < 0.05). The ultrasound group presented similar density among the thirds. Conclusion: The filling ability was similar for the studied methods. Ultrasound promoted better distribution of MTA in retrograde cavity, but did not increase the density of material.

Maxillary sinus lift without grafting, and simultaneous implant placement: a prospective clinical study with a 51-month follow-up

A prospective clinical study of maxillary sinus lift procedures in the posterior region of the maxilla, using only blood clot as filling material, was conducted. Seventeen patients underwent a maxillary sinus lift procedure; 20 maxillary sinus regions were operated on and a total of 25 implants were placed. The sinus mucosa was lifted together with the anterior wall of the osteotomized maxilla and supported by the implants placed. Computed tomography (CT) scans were obtained immediately postoperative (T-initial) and at 3 (T-1) and 51(T-2) months postoperative for the measurement of linear bone height and bone density (by grey tones). Only one implant was lost in the first stage (96% success). After dental prosthesis placement and during up to 51 months of follow-up, no implant was lost (100% success, second stage). The difference in mean bone height between T-initial (5.94 mm) and T-1 (13.14 mm), and between T-initial and T-2 (11.57 mm), was statistically significant (both P < 0.001); comparison between T-1 and T-2 also presented a statistical difference (P < 0.001). Bone density had increased at the end of the period analyzed, but this was not statistically significant (P > 0.05). Thus, the maxillary sinus lift technique with immediate implant placement, filling with blood clot only, may be performed with a high success rate.

Renal perfusion evaluation by alternating current biosusceptometry of magnetic nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sequential healing of the elevated sinus floor after applying autologous bone grafting: an experimental study in minipigs

AimTo describe the sequential healing after elevation of the maxillary sinus mucosa applying the lateral access technique with the use of autogenous bone grafting without membrane to occlude the osteotomy access.Material and methodsImmediately after the elevation of the maxillary sinus Schneiderian membrane, applying the lateral access technique in 10 minipigs, autologous bone was harvested from the lateral aspect of the mandibular molar region and ground into particles with a bone mill. The space under the Schneiderian membrane was filled with this graft. No membranes were placed onto the access osteotomy. The healing was evaluated after 15, 30, 90 and 180days. Paraffin sections were prepared and analyzed histologically.ResultsAfter 15days of healing, the elevated area was mainly filled with provisional matrix, newly formed bone and some remnants of bone chips, and appeared reduced in volume compared with that at the time of surgery. After 30days of healing, further shrinkage of the height of the elevated space was found, with similar percentages of the different tissue components. After 90 and 180days, the area underneath the Schneiderian membrane appeared reduced in volume and condensed toward the base of the sinus. The bone tissues appeared to be more mature, both for the mineralized and the non-mineralized portions, while connective tissue occupied 20% of the space, most likely related to the lack of the use of a membrane occluding the access at the time of surgery.ConclusionsSuboptimal healing outcomes with respect to augmentation of the space under the sinus floor membrane were documented when autologous bone chips were used as a filler and no membrane was applied to cover the access.

Stable retrograde orbits around the triple system 2001 SN263

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of a dexmedetomidine constant rate infusion and atropine on changes in global perfusion variables induced by hemorrhage followed by volume replacement in isoflurane-anesthetized dogs

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of autogenous bone and beta-tricalcium phosphate in maxillary sinus lifting: a prospective, randomized, volumetric computed tomography study

The correction of bone defects can be performed using autogenous or alloplastic materials, such as beta-tricalcium phosphate (β-TCP). This study compared the changes in bone volume (CBV) after maxillary sinus lifting using autogenous bone (n=12), autogenous bone associated with β-TCP 1:1 (ChronOS; DePuy Synthes, Paoli, CA, USA) (n=9), and β-TCP alone (n=11) as grafting material, by means of cone beam computed tomography (CBCT). CBV was evaluated by comparing CBCT scans obtained in the immediate postoperative period (5-7 days) and at 6 months postoperative in each group using OsiriX software (OsiriX Foundation, Geneva, Switzerland). The results showed an average resorption of 45.7±18.6% for the autogenous bone group, 43.8±18.4% for the autogenous bone+β-TCP group, and 38.3±16.6% for the β-TCP group. All bone substitute materials tested in this study presented satisfactory results for maxillary sinus lifting procedures regarding the maintenance of graft volume during the healing phase before the insertion of implants, as assessed by means of CBCT.