909 resultados para PESQUISA (MÉTODOS ESTATÍSTICOS)
Resumo:
Work organized in shifts, either for technological, social or economic imposition, allows the best use of means of production, increasing the overall productivity of the enterprises. At the same time, this type of work harms the individual productive capacity of workers, particularly those involved in the night shift. The objective of this work was to assess the behaviour of production in a continuous line and subjected to work organized in shifts. Through the statistical method of analysis of variance, Spearman's test and Tukey's method, was analysed the distribution of the productivity index measured in three fixed shifts of work in a glass company. The productivity index, provided by the integrated management system of the company, refers to the ratio of actual productivity to total productivity. The statistical analysis shows that factors of production, such as allocation of workers, do not interfere with productivity, showing an unexpected pattern, where the average productivity for the three shifts are close and the correlation between the number of workers on the line and productivity is low. The conditions of production had an adverse work environment with exposure to noise, heat, vaporized mist of lubricating oil and risk of accidents. The findings show that the calculation of productivity in use is limited and its use in company’s production control may produce distortions. It is proposed to examine alternative calculations methods that consider the overall productivity
Resumo:
The Guaraní aquifer has relevant importance both as a source of water for several urban centres and the development of agriculture and livestock. In recharge areas the aquifer is free and, therefore, subject to contamination of effluents and tailings deposited on soils that cover it. Thus, it becomes crucial not only its protection at all levels, as the knowledge of its degree of natural vulnerability. The present work used geostatistics modeling techniques to study the natural vulnerability of the Guaraní aquifer in the city of Rio Bonito, State of São Paulo, southeastern Brazil, where the Guarani aquifer is exposed. These techniques, extensively used in evaluation studies of mineral deposits and oil tanks, can be adapted to produce a spatial classification or a regionalisation of probabilistic indices of vulnerability. By ordinary kriging method maps of vulnerability classification were obtained. To determine the vulnerability of the aquifer was employed the Aquifer Vulnerability Index (AVI), which requires knowledge of unsaturated zone thickness and permeability. The final product was a map with probabilistic index of vulnerability of the Guaraní aquifer, which presented values between 0 to 0.33 years, framing the area studied in AVI class extremely high vulnerability
Resumo:
Classical statistical techniques which necessarily assume that all sampling units are random and independent were always used in the timber industry. Geostatistics considers that certain phenomena are characterized by spatial dependence: values of sampling units closer to each other tend to be more similar than values of sampling units farther away. This study aimed to characterize the spatial variability of the finishing (dyer) in the upper and lower surfaces of four edge glued panels by using geostatistical methods using geoR. Semivariograms were constructed for the analysis of spatial dependence. The spherical mathematical model was the best fit to the semivariograms generated, and was done the interpolation of the data (kriging) in samples where the distribution of dyer presents spatial dependence. In the bottom surfaces of two panels where the spatial dependence was detected geostatistical methods characterized a very large spatial variability due to the heterogeneous application of the finishing
Resumo:
The evaluation of soil permeability throughout the weathering profile is one of the most important features to be considered in environmental studies. This study, developed from field testing and analysis of data obtained by geostatistical methods, aims at mapping the permeability around the Ribeirão Claro river. The intent is to simulate an accident with toxic liquids where soil permeability is of fundamental importance. Another purpose of the research was to determine the minimum time that, in the event of an accident, a possible contaminant to reach the water table level and be routed to the nearest drain, in this case, the Ribeirao V Claro river constitutes fundamental information. The studied area of approximately 4 km² is located within the UNESP-Rio Claro campus, consisting of colluvial soil from Fm. Rio Claro superimposed on residual soil of Fm. Corumbataí. The method used to determine the permeability is the concentric cylinders performed on a sampling grid with 64 points containing spacing of 5 meters EW and 10 meters NS. In the places of permeability tests were collected samples for laboratory determination of the percentage of fines. From particle size analysis was performed and analysis statistical and geostatistical on this data. The histogram was based on the statistical studies, and the semivariograms were based on geostatistical estimation methods. Based on the comparison between the maps and the data obtained, it was determined that the percentage of fines in colluvial surface soil has little influence on permeability, which the proximity to the Ribeirao Claro river, the eastern portion, a factor that influences the distribution of permeability values
Resumo:
This work presents procedures for getting data to estimate grant flow by means of statistical and hydrological methods, acquired during the graduate course, of some streams in the watersheds of Aguapeí and Peixe rivers, in order to make available this data set to Sao Paulo State water and electrical energy department – DAEE and to the Committees of Aguapeí and Peixe watersheds. This study was performed using discharge data and the were a selection process to identify some faults in the historical series. Finally it was calculated the 7-day moving averages, Q7 and some characteristics discharges like Q90 and Q95. Taking into account the average discharge en seven days in a 10-year recurrence interval, it was estimated the grant flow of some streams. Data were generated for six posts inside the Aguapei and Peixe watersheds
Resumo:
A determinação da composição corporal pode ser utilizada para evidenciar diversos fatores entre eles a dieta, o uso de drogas, a incidência de patologias, diferenças genética, nível de treinamento, gênero e idade. No modelo de natação para ratos a composição corporal pode ter um papel determinante na intensidade de exercício, uma vez que os animais utilizados podem apresentar diferentes densidades corporais. Nesse sentido, o objetivo do presente projeto baseia-se na possibilidade de desenvolver uma equação para estimar o volume corporal de ratos sedentários a partir da relação linear entre peso e volume corporais (r=1,00) encontrada em estudos anteriores. Dessa forma, tornando prático e viável o uso da densidade corporal para precisa determinação da intensidade de exercício em estudos que utilizam a natação como ergômetro de exercício animal. Para isso serão utilizados 105 Rattus norvegicus albinus da linhagem Wistar, os quais serão avaliados em um estudo longitudinal que consiste em avaliações a cada 30 dias, a partir dos 60 até 240 dias de idade, para a determinação do volume corporal através de pesagens hidrostáticas, do índice de lee e análise da composição química da carcaça. Com isso, espera-se poder derivar uma equação para estimar o volume corporal dentro de toda a faixa de idade utilizada ou, no caso não seja encontrada uma relação linear entre peso e volume corporais entre ratos de diferentes idades, o desenvolvimento de várias equações para estimar o volume corporal em faixas etárias. Além disso, a composição química da carcaça dos mais será determinada na tentativa de validar o método de pesagem hidrostática e buscar eventuais correlações entre os parâmetro corporais (volume corporal, peso corporal, índice de lee e densidade) e os componentes de gordura, massa magra, água e proteína dos animais
Resumo:
This graduate work approaches the study of Statistical Process Control - SPC, in a stage production of an industrial frame, aiming to use the tool of statistical process control (SPC) to assess the process capability. Where the process needs improvement as well not meet the specifications. Assessing the needs that the company needs to improve quality management, and the difficulties they present during the implementation of the CEP. The present study is to use the method of case study. The results are presented through study, and checking the capacity and stability of the process using control charts XbarraR. The process demonstrated the need for improvements in process and quality management. At the end of the work are presented suggestions for improving the quality system of the company
Resumo:
Pós-graduação em Agronomia (Ciência do Solo) - FCAV
Resumo:
Pós-graduação em Agronomia (Produção Vegetal) - FCAV
Resumo:
Pós-graduação em Agronomia (Entomologia Agrícola) - FCAV
Resumo:
Pós-graduação em Genética e Melhoramento Animal - FCAV
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Engenharia de Produção - FEB
Resumo:
Pós-graduação em Agronomia (Ciência do Solo) - FCAV
Resumo:
Pós-graduação em Agronomia (Produção Vegetal) - FCAV