Impacto de drogas antiplaquetárias na doença e no reparo periodontal experimental em ratos

Pós-graduação em Odontologia - FOAR

Avaliação histopatológica da luxação extrusiva em molares de ratos

Pós-graduação em Odontologia - FOA

Interações entre diferentes espécies de Candida na candidose experimental em modelos de invertebrados e vertebrados

Pós-graduação em Biopatologia Bucal - ICT

Avaliação histológica do processo de reparação do tecido ósseo do rato frente à aplicação de um adesivo à base de cianoacrilato

This research objective was to verify the tissues reactions obtained, in surgical experimental bone defect, after the etil cyanoacrylate chemical adhesive application in rats parietal bones. 1t was investigated the acceptance or no acceptance of the tissues surround the bone defect in which was placed the etil cyanoacrylate and the control bone defect. The specimens were submitted to light microscopic analysis. 24 adults rats were used (Rattus norvergicus, albinus, Wistar) with the average weight to 300 gr. and were divided in two groups: treated and control. After the bone defects were realized, etil cyanoacrylate was placed over one of the defects at the parietal bone (treated group). On the other defect nothing was placed and it was used like control group. After 24 hours, 3,5,7,30 and sixty days after surgery, for animals of each group were sacrificed. The bone samples were removed and fixed in 10% formalin during 72 hours and analyzed using light microscopy. The results showed that the acute inflammatory responses was more observed at lhe treated group than the control group. The chemical adhesive was observed until 60 days follow the surgery and the tissues around it present normal appearance. The chemical adhesive, etil cyanaocrylate, did not impede at the bone repair process

Comparison of the performance of natural latex membranes prepared with different procedures and PTFE membrane in guided bone regeneration (GBR) in rabbits

This work assessed the performance of membranes made of natural latex extracted from Hevea brasiliensis prepared with three different methods: polymerized immediately after collection without the use of ammonia (L1); polymerized after preservation in ammonia solution (L2); and polymerized after storage in ammonia, followed by Soxhlet technique for the extraction of substances (L3). Polytetrafluoroethylene (PTFE) membrane was used as control. Two 10-mm diameter bone defects were surgically made in the calvaria of thirty adult male New Zealand rabbits. Defects (total n = 60) were treated with guided bone regeneration (GBR) using L1, L2, L3 or PTFE membranes (n = 15 for each membrane). Ten animals were euthanized after 7, 20 and 60 days postoperatively so that five samples (n = 5) of each treatment were collected at each time, and bone regeneration was assessed microscopically. The microscopic analysis revealed defects filled with blood clot and new bone formation at the margins of the defect in all 7-day samples, while 20-day defects were mainly filled with fibrous connective tissue. After 60 days defects covered with L1 membranes showed a significantly larger bone formation area in comparison to the other groups (P < 0.05, ANOVA, Tukey). Additionally, bone tissue hypersensitization for L1 and PTFE membranes was also investigated in six additional rabbits. The animals were subjected to the same surgical procedure for the confection of one 10-mm diameter bone defect that was treated with L1 (n = 3) or PTFE (n = 3). Fifty-three days later, a second surgery was performed to make a second defect, which was treated with the same type of membrane used in the first surgery. Seven days later, the animals were euthanized and samples analyzed. No differences among L1 and PTFE samples collected from sensitized and non-sensitized animals were found (P > 0.05, Kruskal-Wallis). Therefore, the results demonstrated that latex membranes presented performance comparable to PTFE membranes, and that L1 membranes induced higher bone formation. L1 and PTFE membranes produced no hypersensitization in the bone tissue.

Genotoxicity and cytotoxicity induced by municipal effluent in multiple organs of Wistar rats

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Structural properties of beds packed with agro-industrial solid by-products applicable for solid-state fermentation: Experimental data and effects on process performance

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Antimicrobial photodynamic therapy in rat experimental candidiasis: evaluation of pathogenicity factors of Candida albicans

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Treatment of osteochondral injuries with platelet gel

OBJECTIVES: Treatments for injured articular cartilage have not advanced to the point that efficient regeneration is possible. However, there has been an increase in the use of platelet-rich plasma for the treatment of several orthopedic disorders, including chondral injuries. Our hypothesis is that the treatment of chondral injuries with platelet gel results in higher-quality repair tissue after 180 days compared with chondral injuries not treated with gel.METHODS: A controlled experimental laboratory study was performed on 30 male rabbits to evaluate osteochondral injury repair after treatment with or without platelet gel. Osteochondral injuries were surgically induced in both knees of each rabbit at the medial femoral condyle. The left knee injury was filled with the platelet gel, and the right knee was not treated. Microscopic analysis of both knee samples was performed after 180 days using a histological grading scale.RESULTS: The only histological evaluation criterion that was not significantly different between treatments was metachromasia. The group that was treated with platelet gel exhibited superior results in all other criteria (cell morphology, surface regularity, chondral thickness and repair tissue integration) and in the total score.CONCLUSION: The repair tissue was histologically superior after 180 days in the study group treated with platelet gel compared with the group of untreated injuries.

Desenvolvimento e avaliação das atividades antioxidante e despigmentante in vitro de emulsões múltiplas a/o/a contendo dipalmitato kójico

Currently, there has been a growing concern for men and women with the appearance of the face and body, driven primarily by aesthetic standards set by the media. For this, the pharmaceutical and cosmetic industries have conducted numerous research projects aiming at the development of formulations that mitigate the aging and some skin disorders such as hipercromies. One of the most frequent pathologies of skin is melasma, a manifestation of hyperpigmentation caused by hipermelanogenesis symmetrical and progressive, caused usually by hormonal irregularities, exposure to sunlight and genetic factors. In addition to sunscreen, the treatment is indicated the use of depigmenting substances, among them the kojic dipalmitate (DK), which is cleaved into kojic acid (5- hydroxy-2-hydroxy-methyl-4H-piran-4-one) by esterase after absorption by the skin cells. The kojic acid inhibits the action of tyrosinase as a chelator of ions and promotes the reduction of eumelanin and its precursor monomer. To promote a controlled release and improve the stability of the system, the DK can be incorporated into multiple emulsions, that is, complex systems composed of two emulsifications, where the two types of emulsions (W/O and O/W or O/W and W/O) exist simultaneously, forming emulsions of type W/O/W or O/W/O. This work aimed to incorporate the DK in emulsion W/O/W, physical-chemical systems obtained and to evaluate the antioxidant and depigmenting action in vitro of the developed formulations. The physico-chemical characterization was performed by microscopic analysis, quantification and size distribution, determination of pH, conductivity, zeta potential and bioadhesive test of the formulations. The droplet size in accordance with the use of light microscopy and dynamic light scattering is approximately 1μm. The pH, electrical conductivity and bioadhesion have not changed with the addition... (Complete abstract click electronic access below)

Análise fractal de fraturas em regime linear elástico: modo I de carregamento

For the development of this graduate work of fractal fracture behavior, it is necessary to establish references for fractal analysis on fracture surfaces, evaluating, from tests of fracture tenacity on modes I, II and combined I / II, the behavior of fractures in fragile materials, on linear elastic regime. Fractures in the linear elastic regime are described by your fractal behavior by several researchers, especially Mecholsky JJ. The motivation of that present proposal stems from work done by the group and accepted for publication in the journal Materials Science and Engineering A (Horovistiz et al, 2010), where the model of Mecholsky could not be proven for fractures into grooved specimens for tests of diametric compression of titania on mode I. The general objective of this proposal is to quantify the distinguish surface regions formed by different mechanisms of fracture propagation in linear elastic regime in polymeric specimens (phenolic resin), relating tenacity, thickness of the specimens and fractal dimension. The analyzed fractures were obtained from SCB tests in mode I loading, and the acquisition of images taken using an optical reflection microscope and the surface topographies obtained by the extension focus method of reconstruction, calculating the values of fractal dimension with the use of maps of elevations. The fractal dimension was classified as monofractal dimension (Df), when the fracture is described by a single value, or texture size (Dt), which is a macroscopic analysis of the fracture, combined with the structural dimension (Ds), which is a microscopic analysis. The results showed that there is no clear relationship between tenacity, thickness and fractal values for the material investigated. On the other hand it is clear that the fractal values change with the evolution of cracks during the fracture process ... (Complete abstract click electronic access below)

Adesão de Paracoccidioides brasiliensis e outros fungos anemófilos a teias de aranhas: implicações para a identificação de nichos microbianos no ambiente

The dimorphic pathogenic fungus, Paracoccidioides brasiliensis (Pb), is the etiological agent of paracoccidioidomycosis (PCM), the most important systemic mycosis in Latin America. While the yeast phase can be isolated from patients affected by paracoccidioidomycosis, dogs and naturally infected armadillos; several elements related to the ecology of the saprophytic phase of the pathogen, which is responsible for the production of infective propagules, are poorly understood, hampering the adoption of preventive measures. The demonstration of the high incidence of Pb infection in the 9- banded armadillo, Dasypus novemcinctus, has opened new perspectives for the identification of the pathogen’s habitat. At the opening of the armadillos’ burrows, spider webs are commonly found. The objective of this study was to evaluate the presence of Pb in spider webs samples related to the habitat of armadillos. Spider web samples were collected at Lageado Farm, Botucatu/SP and prepared for microscopic, molecular and mycological analyses. Microscopic analysis showed that different fungi were closely attached to spider web samples. Nested-PCR reaction showed positive amplification for Pb in 4 samples, with identity confirmed by amplicon sequencing. Fungal colonies also included members of Aspergillus, Blastobotrys, Penicillium, Candida, and Sporothrix genera, which are related to opportunistic disease and primary infections of great medical importance. In vitro adhesion tests of mycelia and yeast form of Pb to the spider webs were also performed, in order to analyze the possible physical attraction between fungal cells and the spider web protein network. The results showed a clear adherence of fungal particles to spider webs. In the current literature, there are no studies reporting adhesive properties of microorganisms to spider webs... (Complete abstract click electronic access below)

O gênero acadêmico: resumos nas áreas de Antropologia, Linguística e Ciência Política

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biological Hydrogen production from environmental sample in tropical countries

The hydrogen gas is regarded as clean and renewable energy source, since it generates only water during combustion when used as fuel. It shows 2.75 times more energy content than any hydrocarbon and it can be converted into electrical, mechanical energy or heat. Inoculum sources have been successfully tested for hydrogen biological production in temperate climate countries as sludge treatment plants sewage, sludge treatment plant wastewater, landfill sample, among others. However, hydrogen biologic production with inoculum from environmental samples such as sediment reservoirs, especially in tropical countries like Brazil, is rarely investigated. Reservoirs and fresh water lake sediment may contain conditions for the survival of a wide variety of microorganisms which use different carbon sources mainly glucose and xylose, in the fermentation. Glucose is an easily biodegradable, present in most of the industrial effluents and can be obtained abundantly from agricultural wastes. A wide variety of wastewater resulting from agriculture, industry and pulp and paper processed from wood may contain xylose in its constitution. Such effluent contains glucose and xylose concentrations of about 2 g/L. In this sense, this work verified hydrogen biological production in anaerobic batch reactor (1L), at 37 ° C, initial pH 5.5, headspace with N2 (100%), Del Nery medium, vitamins and peptone (1 g/L), fed separately with glucose (2g/L) and xylose (2 g/L). The inoculum was taken from environmental sample (sediment reservoir Itupararanga - Ibiúna - SP-Brazil). It was previously purified in serial dilutions at H2 generation (10-5, 10-7, 10-10), and heat treated (90º C - 10 min) later to inhibited the H2 consumers. The maximum H2 generations obtained in both tests were observed at 552 h, as described below. At the reactors fed with glucose and xylose were observed, respectively, 9.1 and 8.6 mmol H2/L, biomass growth (0.2 and 0.2 nm); consumption of sugar concentrations 53.6% (1.1 glucose g/L) and 90.5% (1.8 xylose g/L); acetic acid generation (124.7 mg/L and 82.7 mg/L), butyric acid (134.0 mg/L and 230.4 mg/L) and there wasn’t methane generation in the reactors. Microscopic analysis of biomass in anaerobic reactors showed the predominance of Gram positive rods and rods with endospores, whose morphology is characteristic of H2-generating bacteria, in both tests. These species were selected from the natural environment. In DGGE analysis performed difference were observed between populations from inoculum and in tests. This analysis confirmed that some species of bacteria were selected which remained under the conditions imposed on the experiment. The efficiency of the pre-treatment of inoculum and the imposition of pH 5.5 inhibited methane-producing microorganisms and the consumers of H2. Therefore, the experimental conditions imposed allowed the attainment of bacterial consortium of producer H2 taken from an environmental sample with concentration of xylose and glucose similar to the ones of the industrial effluents.

Efeitos da dieta enriquecida com frutos das palmeiras Euterpe oleracea Mart. e Mauritia flexuosa L.f. na inflamação intestinal em ratos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)