Effects of periphyton grown on bamboo substrates on growth and production of Indian major carp, rohu (Label rohita Ham.)

The effects of periphyton, grown on bamboo substrates, on growth and production of Indian major carp, rohu, Labeo rohita (Hamilton), were studied in 10 ponds during July to October '95 at the Bangladesh Agricultural University, Mymensingh. Five ponds were provided with bamboo substrates (treatment I) and the rests without bamboo substrates (treatment II). It was revealed that there had been no discernible difference in the water quality parameters between treatments. A large number of plankton (30 genera) showed periphytic nature and colonized on the bamboo substrates. The growth and production of fish was significantly (p<0.05) higher in the ponds with bamboo substrates as compared to the ponds without substrates. The net production of rohu in treatment I was about 1.7 times higher than that of treatment II. Fish production was as much as 1899 kg/ha over a culture period of 4 months in the periphyton-based production system.

Comments on "micro-scale abrasive wear testing of PVD coatings on curved substrates"

Previously published expressions for the wear volume in the micro-scale abrasion test for curved specimen surfaces (K.L. Rutherford and I.M. Hutchings, Tribology Letters 2 (1996) 1-11) were based upon erroneous assumptions about the wear-scar geometry. Accurate volumes have now been computed, and the errors in the use of the original analytical equations are shown to be negligibly small (<0.5% error) for all practical cases. © J.C. Baltzer AG, Science Publishers.

Actions of two serine proteases from Trimeresurus jerdonii venom on chromogenic substrates and fibrinogen

Jerdonobin and jerdofibrase are two serine proteases purified from the venom of Trimeresurus jerdonii. The Michaelis constant K-m and the catalytic rate constant K-cat of jerdonobin or jerdofibrase on three chromogenic substrates, H-D-Pro-Phe-Arg-pNA (S2302), H-D-Phe-pipecolyl-Arg-pNA (S2238), and H-D-Val-Leu-Lys-pNA (S2251) were obtained from lineweaver-Burk plots. Jerdofibrase could hydrolyze all three substrates, but jerdonobin had no detectable activity on S2251, suggesting a relatively broader substrate specificity for jerdofibrase than jerdonobin. By SDS-PAGE, jerdofibrase preferentially degraded Bbeta-chain of fibrinogen. It also degraded Aalpha-chain of fibrinogen with relatively slow activity, but did not act on the gamma-chain. In contrast, jerdonobin did not degrade fibrinogen within 12 h. Fibrinopeptides liberation test, identified by HPLC, showed jerdonobin released fibrinopeptide A and a small amount of fibrinopeptide B. Unlike jerdonobin, jerdofibrase mainly released fibrinopeptide B. These results indicate that the two enzymes differ in their ability to hydrolyze chromogenic substrates and in their actions on fibrinogen. (C) 2002 Elsevier Science Inc. All rights reserved.

Amorphous silicon display backplanes on plastic substrates

Amorphous silicon thin-film transistors and pixel driver circuits for organic light-emitting diode displays have been fabricated on plastic substrates. Pixel circuits demonstrate sufficient current delivery and long-term stable operation. © 2005 IEEE.

Calculating transport AC losses in stacks of high temperature superconductor coated conductors with magnetic substrates using FEM

In this paper, the authors investigate the electromagnetic properties of stacks of high temperature superconductor (HTS) coated conductors with a particular focus on calculating the total transport AC loss. The cross-section of superconducting cables and coils is often modeled as a two-dimensional stack of coated conductors, and these stacks can be used to estimate the AC loss of a practical device. This paper uses a symmetric two dimensional (2D) finite element model based on the H formulation, and a detailed investigation into the effects of a magnetic substrate on the transport AC loss of a stack is presented. The number of coated conductors in each stack is varied from 1 to 150, and three types of substrate are compared: non-magnetic weakly magnetic and strongly magnetic. The non-magnetic substrate model is comparable with results from existing models for the limiting cases of a single tape (Norris) and an infinite stack (Clem). The presence of a magnetic substrate increases the total AC loss of the stack, due to an increased localized magnetic flux density, and the stronger the magnetic material, the further the flux penetrates into the stack overall. The AC loss is calculated for certain tapes within the stack, and the differences and similarities between the losses throughout the stack are explained using the magnetic flux penetration and current density distributions in those tapes. The ferromagnetic loss of the substrate itself is found to be negligible in most cases, except for small magnitudes of current. Applying these findings to practical applications, where AC transport current is involved, superconducting coils should be wound where possible using coated conductors with a non-magnetic substrate to reduce the total AC loss in the coil. © 2011 Elsevier B.V. All rights reserved.

High efficiency liquid crystal lasers giving "white light" emission from arrays and flexible substrates

The self-organization of the helical structure of chiral nematic liquid crystals combined with their sensitivity to electric fields makes them particularly interesting for low-threshold, wavelength tunable laser devices. We have studied these organic lasers in detail, ranging from the influence specific macroscopic properties, such as birefringence and order parameter, have on the output characteristics, to practical systems in the form of two-dimensional arrays, double-pass geometries and paintable lasers. Furthermore, even though chiral nematics are responsive to electric fields there is no facile means by which the helix periodicity can be adjusted, thereby allowing laser wavelength tuning, without adversely affecting the optical quality of the resonator. Therefore, in addition to studying the liquid crystal lasers, we have focused on finding a novel method with which to alter the periodicity of a chiral nematic using electric fields without inducing defects and degrading the optical quality factor of the resonator. This paper presents an overview of our research, describing (i) the correlation between laser output and material properties,(ii) the importance of the gain medium,(iii) multicolor laser arrays, and (iv) high slope efficiency (>60%) silicon back-plane devices. Overall we conclude that these materials have great potential for use in versatile organic laser systems.

High-efficiency InGaN/GaN quantum well structures on large area silicon substrates

The growth techniques which have enabled the realization of InGaN-based multi-quantum-well (MQW) structures with high internal quantum efficiencies (IQE) on 150mm (6-in.) silicon substrates are reviewed. InGaN/GaN MQWs are deposited onto GaN templates on large-area (111) silicon substrates, using AlGaN strain-mediating interlayers to inhibit thermal-induced cracking and wafer-bowing, and using a SiN x interlayer to reduce threading dislocation densities in the active region of the MQW structure. MQWs with high IQE approaching 60% have been demonstrated. Atomic resolution electron microscopy and EELS analysis have been used to study the nature of the important interface between the Si(111) substrate and the AlN nucleation layer. We demonstrate an amorphous SiN x interlayer at the interface about 2nm wide, which does not, however, prevent good epitaxy of the AlN on the Si(111) substrate. Copyright © 2012 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.