Advanced DC link capacitor technology application for a stiff voltage-source inverter

Problem of DC link size in a stiff voltage-source inverter for electric drive is described in the paper. Advantages of advanced film capacitor technology over conventional one for DC link application are reviewed. Conventional DC link capacitor selection methods are questioned in view of advanced capacitor technology utilization in stiff voltage-source inverter. For capacitor selection maximum ripple rms current point is shown. DC link ripple current spectrum analysis under modern PWM techniques is presented. Some capacitor selection recommendations are given. The analysis has been aided greatly by computer modeling in PSpice. ©2005 IEEE.

A fully integrated 660 MHz low-swing energy-recycling DC-DC converter

A fully integrated 0.18 μm DC-DC buck converter using a low-swing "stacked driver" configuration is reported in this paper. A high switching frequency of 660 MHz reduces filter components to fit on chip, but this suffers from high switching losses. These losses are reduced using: 1) low-swing drivers; 2) supply stacking; and 3) introducing a charge transfer path to deliver excess charge from the positive metal-oxide semiconductor drive chain to the load, thereby recycling the charge. The working prototype circuit converts 2.2 to 0.75-1.0 V at 40-55 mA. Design and simulation of an improved circuit is also included that further improves the efficiency by enhancing the charge recycling path, providing automated zero voltage switching (ZVS) operation, and synchronizing the half-swing gating signals. © 2009 IEEE.

Wave energy emulator and AC/DC rectifiers for direct drive wave energy converters

This paper describes a solid state electrical emulator devised for laboratory testing of power conditioning electronics for direct drive linear wave energy converters (DDLWEC). Two rectification strategies are considered; a uni-directional boost topology, and an H-bridge which may be controlled in either uni- or bidirectional modes.

The Ic behavior of 2G YBCO tapes under DC/AC magnetic fields at various temperatures

In order to design a High Temperature Superconducting (HTS) machine that is able to operate safely and reliably, studies on the characterization of Second Generation (2G) HTS tapes are of paramount importance. This paper presents an experimental setup to measure critical current of 2G HTS tapes in high DC magnetic fields (up to 5 Tesla) with an AC current ripple superimposed, as well as various temperatures ranging from 25 K to 77 K. The 2G tape measured is the SGS12050 coated conductor made by SuperPower. The critical current is measured by a flux vector with reference to the widest sample face from 0 to 90 degrees in 10 degree steps. Smaller steps are required close to 0 . A Variable Temperature Insert (VTI) is utilized to control temperature change. © 2010 IEEE.

SoC energy savings = reduce+reuse+recycle: A case study using a 660MHz DC-DC converter with integrated output filter

This paper advocates 'reduce, reuse, recycle' as a complete energy savings strategy. While reduction has been common to date, there is growing need to emphasize reuse and recycling as well. We design a DC-DC buck converter to demonstrate the 3 techniques: reduce with low-swing and zero voltage switching (ZVS), reuse with supply stacking, and recycle with regulated delivery of excess energy to the output load. The efficiency gained from these 3 techniques helps offset the loss of operating drivers at very high switching frequencies which are needed to move the output filter completely on-chip. A prototype was fabricated in 0.18μm CMOS, operates at 660MHz, and converts 2.2V to 0.75-1.0V at ∼50mA.1 © 2008 IEEE.

Energy recovery from high-frequency clocks using DC-DC converters

Large digital chips use a significant amount of energy to distribute a multi-GHz clock. By discharging the clock network to ground every cycle, the energy stored in this large capacitor is wasted. Instead, the energy can be recovered using an on-chip DC-DC converter. This paper investigates the integration of two DC-DC converter topologies, boost and buck-boost, with a high-speed clock driver. The high operating frequency significantly shrinks the required size of the L and C components so they can be placed on-chip; typical converters place them off-chip. The clock driver and DC-DC converter are able to share the entire tapered buffer chain, including the widest drive transistors in the final stage. To achieve voltage regulation, the clock duty cycle must be modulated; implying only single-edge-triggered flops should be used. However, this minor drawback is eclipsed by the benefits: by recovering energy from the clock, the output power can actually exceed the additional power needed to operate the converter circuitry, resulting in an effective efficiency greater than 100%. Furthermore, the converter output can be used to operate additional power-saving features like low-voltage islands or body bias voltages. ©2008 IEEE.

A 660MHz ZVS DC-DC converter using gate-driver charge-recycling in 0.18μm CMOS with an integrated output filter

The design and manufacture of a prototype chip level power supply is described, with both simulated and experimental results. Of particular interest is the inclusion of a fully integrated on-chip LC filter. A high switching frequency of 660MHz and the design of a device drive circuit reduce losses by supply stacking, low-swing signaling and charge recycling. The paper demonstrates that a chip level converter operating at high frequency can be built and shows how this can be achieved, using zero voltage switching techniques similar to those commonly used in larger converters. Both simulations and experimental data from a fabricated circuit in 0.18μm CMOS are included. The circuit converts 2.2V to 0.75∼1.0V at ∼55mA. ©2008 IEEE.

溶藻细菌DC-L14的分离、鉴定与溶藻特性

从滇池蓝藻水华集聚区分离获得一株溶藻细菌DC-L14,经16SrDNA序列分析鉴定为Lysinibacillus fusiformis;小白鼠毒性试验初步显示该菌株未产生小白鼠中毒毒素;该菌能使铜锈微囊藻905聚集成团,沉于瓶底,最终黄化;该菌作用4d,使惠氏微囊藻107、绿色微囊藻102、水华束丝藻和水华鱼腥藻的叶绿素a下降率最高为70.1%,最低为65.5%,平均为67.2%;当细菌处于稳定生长期时溶藻效果最强,共培养4d能使铜锈微囊藻905的叶绿素a含量下降82.1%;离心沉降后检测,发现菌体本身无

溶藻细菌DC-L5的分离、鉴定及其溶藻特性

从滇池蓝藻水华集聚区分离获得一株溶藻细菌DC-L5,通过形态及16S rDNA测序分析鉴定为短小芽孢杆菌。用小白鼠进行生物安全实验,小白鼠无中毒症状。研究表明当细菌处于对数生长期时溶藻效果最强,共培养5d使铜锈微囊藻的叶绿素a含量下降83.33%,使惠氏微囊藻、绿色微囊藻、水华束丝藻和水华鱼腥藻4种蓝藻叶绿素a下降率最高为67.6%,最低为58.5%,平均为62.25%。离心沉降后,发现沉淀菌体和无菌上清液对铜锈微囊藻都有溶藻效果,但溶藻效果不及原菌液,推测DC-L5可能是通过直接接触使藻细胞凝聚下沉及进

Use of 2G coated conductors for efficient shielding of DC magnetic fields

This paper reports the results of an experimental investigation of the performance of two types of magnetic screens assembled from YBa2Cu3O7-d (YBCO) coated conductors. Since effective screening of the axial DC magnetic field requires the unimpeded flow of an azimuthal persistent current, we demonstrate a configuration of a screening shell made out of standard YBCO coated conductor capable to accomplish that. The screen allows the persistent current to flow in the predominantly azimuthal direction at a temperature of 77 K. The persistent screen, incorporating a single layer of superconducting film, can attenuate an external magnetic field of up to 5 mT by more than an order of magnitude. For comparison purposes, another type of screen which incorporates low critical temperature quasi-persistent joints was also built. The shielding technique we describe here appears to be especially promising for the realization of large scale high-Tc superconducting screens.

DC and AC Shielding properties of bulk high-tc

We have studied numerically and experimentally the magnetic flux penetration in high-Tc superconducting tube subjected to a uniform magnetic field parallel to its long axis. This study is carried in view of designing low-frequency magnetic shields by exploiting the diamagnetic properties of high-Tc superconducting ceramics. We have measured the field attenuation for applied magnetic fields in the frequency range 5 mHz-0.1 Hz by Hall probe measurements and at audio frequencies using a sensing coil. A simple 1D analysis using the Kim critical state model was found to be able to reproduce the experimental data satisfactorily. We have also determined the phase shift between the internal and the applied field both experimentally and numerically. Finally, we have studied the sweep rate dependence of the magnetic shielding properties, using data recorded either at several constant sweep rates dB /dt or at several AC fields of various amplitudes and frequencies. Both methods agree with each other and lead to a n-value of the E ∼ Jn law equal to ∼40 at 77 K. © 2009 IEEE.

DC current rectification using indium-gallium zinc oxide-based selfswitching diodes

Self-switching diodes have been fabricated within a single layer of indium-gallium zinc oxide (IGZO). Current-voltage (I-V) measurements show the nanometer-scale asymmetric device gave a diode-like response. Full current rectification was achieved using very narrow channel widths of 50nm, with a turn-on voltage, Von, of 2.2V. The device did not breakdown within the -10V bias range measured. This single diode produced a current of 0.1μA at 10V and a reverse current of less than 0.1nA at -10V. Also by adjusting the channel width for these devices, Von could be altered; however, the effectiveness of the rectification also changed. © 2013 IEEE.

Analysis of paralytic shellfish toxins in Aphanizomenon DC-1 from Lake Dianchi, China

Lake Dianchi is in Yunnan Province in southwestern China. In recent years, significant cyanobacterial blooms have occurred in this lake nearly every year because of eutrophication. Monitoring data for the past 5 years acquired by our research group showed that phytoplankton composition alternated between species of Microcystis sp. during warm seasons and those of Aphanizomenon sp. during cool seasons. In March 2003, when phytoplankton composition was highly dominated by Aphanizomenon sp., samples were taken from the lake for toxin detection and immediate strain isolation. A mouse bioassay with extracts from the lyophilized field material showed obvious intoxication from paralytic shellfish poisons (PSPs), and all mice died within 30 min. Further analysis of both field and isolated algal strain Aphanizomenon DC-1 by the postcolumn HPLC-FLD method confirmed its PSP-producing ability The analogues found in the extracts from the field material were neoSTX, dcSTX, and dcGTX3, with contents of 2.279, 1.135, and 0.547 ng/mg DW, respectively. Under laboratory culture condition, toxin content in the Aphanizomenon strain DC-1 varied greatly during different growth phases, with two peaks: in the early-exponential and late-stationary growth phases. When the culture grew at a relatively high rate during the mid- to late-exponential growth phase, toxin content declined gradually. Moreover, the types of toxin in the DC-1 strain varied greatly during a single culture cycle. The HPLC results showed that dcSTX was the only toxin isomer detected throughout the culture period, and its level remained stable. On the other hand, dcGTX2 and GTX4 were the major toxins during the early-exponential and stationary phases, respectively. This article presents the first data on the identification and detection of paralytic shellfish toxins from cyanobacteria in Lake Dianchi. As far as we know, this is also the first report of this type of toxin in inland water bodies in China. Our study indicates the threat associated with PSP toxins in Lake Dianchi and suggests that necessary measures and programs for control are urgently needed to prevent the spread of toxic cyanobacterial blooms. (c) 2006 Wiley Periodicals, Inc.