Study on mixed Langmuir-Blodgett film of tri-(2,4-di-t-amylphenoxy)-(8-quinolinolyl)copper phthalocyanine and water-soluble fullerenols

Mixed Langmuir-Blodgett films of tri-(2,4-di-t-amylphenoxy)-(8-quinolinolyl) copper phthalocyanine and water-soluble fullerenols are prepared. Their behavior at the air-water interface and the monolayer morphology are studied. (C) 1998 Elsevier Science Limited. All rights reserved.

Gas phase derivations of endohedral metallofullerenes by ion-molecular reactions

Gas phase ion-molecular reactions of endohedral metallofullerenes with the self-chemical ionization ion system of vinyl acetate, benzene and acetone in the ion source of the mass spectrometer have been studied. Several derivatized endohedral metallofullerene cations [M@C-82-C2H3O](+), [M-2@C-80-C2H3O](+), [M@C-82-C6H6](+) and [M@C-82-CO-CH3](+) are observed as the major products. The experimental results indicate that endohedral metallofullerenes have active gas phase reactivities and can be efficiently derivatized by some small organic cations.

Unusual polymerization behavior of water-soluble fullerenols in laser desorption ionization time-of-flight mass spectrometry

Laser desorption ionization time-of-flight mass spectrometry has been used to study the water-soluble multi-hydroxyl C-60 derivatives - fullerenols. The mass spectra exhibit unusual polymerization behavior of fullerenols. (C) 1997 by John Wiley & Sons, Ltd.

Two-step-method extraction of endohedral metallofullerenes

A new and efficient extraction method of endohedral metallofullerenes, especially of rare-earth elements encapsulated metallofullerenes, has been reported in this paper. Soxhlet-extraction of raw soot with toluene was used in the first step to wash away most accompanying C-60, C-70. Then pyridine was chosen as solvent to obtain high-temperature and high pressure extract. Two kinds of extract were analysed by DEI-MS and LDI-MS, the results indicate that this two-step method can provide the extract which has the highest fraction of endohedral metallofullerenes. So it will greatly simplify the following separation and purification processes of metallofullerenes.

Synthesis and characterization of acetacetic derivatives of flullerene

Acetacetic derivatives of fullerene were obtained by the reaction of C-60 with acetacetic ester, after separation with silica gel column chromatography, in good yields. Fullerenols with 13-15 hydroxyl groups were-isolated as the by-products of this reaction. Detailed experimental conditions and the structural characterizations of these new compounds were discussed.

A new method for the preparation of fullerol

Reaction of C-60 with excessive potassium in toluene at refluxing temperature results in black precipitate KaC60 with high conversion, which can completely be hydrolyzed to prepare the fullerol. Investigations including FT-IR. H-1 NMR C-13 NMR, UV-Vis and FABMS of the product were reported.

Synthesis and extraction of lanthanofullerenes and its DEIMS, ESR characterizations

The synthesis for lanthanofullerenes was studied by activating the La2O3 containing graphite rod in situ and back-burning the carbide-rich cathode deposite, La@C-2n are efficiently extracted in high temperature toluene, among them, La@C-74 as a new species is added into the soluble lanthanofullerenes, The toluene extraction is first characterized by desorption electron impact (DEI) mass spectrometry, The ESR spectrum of the extraction at room temperature is also discussed.

FORMATION OF [C60C5H5] ADDUCT CATIONS AND THEORETICAL-STUDY OF THE ISOMERS

We study here the reactions between C-60 and planar C5H5+ cations that lead to the formation of [C60C5H5](+) adduct cations in the chemical ionization source of the mass spectrometer. The structures, stabilities and charge locations of some possible isomers of [C60C5H5](+): sigma-adduct, pi-complex, [1,4]- and [1,2]-addition cations, are studied by AM1 semiempirical molecular orbital calculations. We find that the most stable is the sigma-addition cation. Another interesting and stable structure is the pi-complex cation which is bonded by the electrostatic interaction at the inter-ring distance of 1.589 Angstrom with the C-5v symmetry. The C5H5+ cyclopentadienium cation seems to be an ''inverted umbrella'' sitting on a five-membered ring of the C-60 cage.

Heterogeneities in fullerene nanoparticle aggregates affecting reactivity, bioactivity, and transport.

Properties of nanomaterial suspensions are typically summarized by average values for the purposes of characterizing these materials and interpreting experimental results. We show in this work that the heterogeneity in aqueous suspensions of fullerene C(60) aggregates (nC(60)) must be taken into account for the purposes of predicting nanomaterial transport, exposure, and biological activity. The production of reactive oxygen species (ROS), microbial inactivation, and the mobility of the aggregates of the nC(60) in a silicate porous medium all increased as suspensions were fractionated to enrich with smaller aggregates by progressive membrane filtration. These size-dependent differences are attributed to an increasing degree of hydroxylation of nC(60) aggregates with decreasing size. As the quantity and influence of these more reactive fractions may increase with time, experiments evaluating fullerene transport and toxicity end points must take into account the evolution and heterogeneity of fullerene suspensions.

OXIDATION OF CHLORIDE TO CHLORINE BY CERIC IONS MEDIATED BY THE 3 FORMS OF CRYSTALLINE CARBON

C-60 is more effective than graphite or diamond as a redox catalyst for the oxidation of chloride to chlorine by cerie ions.

Deep eutectic solvents based on N-methylacetamide and a lithium salt as suitable electrolytes for lithium-ion batteries

In this work, we present a study on the physical and electrochemical properties of three new Deep Eutectic Solvents (DESs) based on N-methylacetamide (MAc) and a lithium salt (LiX, with X = bis[(trifluoromethyl)sulfonyl]imide, TFSI; hexafluorophosphate, PF; or nitrate, NO). Based on DSC measurements, it appears that these systems are liquid at room temperature for a lithium salt mole fraction ranging from 0.10 to 0.35. The temperature dependences of the ionic conductivity and the viscosity of these DESs are correctly described by using the Vogel-Tammann-Fulcher (VTF) type fitting equation, due to the strong interactions between Li, X and MAc in solution. Furthermore, these electrolytes possess quite large electrochemical stability windows up to 4.7-5 V on Pt, and demonstrate also a passivating behavior toward the aluminum collector at room temperature. Based on these interesting electrochemical properties, these selected DESs can be classified as potential and promising electrolytes for lithium-ion batteries (LIBs). For this purpose, a test cell was then constructed and tested at 25 °C, 60 °C and 80 °C by using each selected DES as an electrolyte and LiFePO (LFP) material as a cathode. The results show a good compatibility between each DES and LFP electrode material. A capacity of up to 160 mA h g with a good efficiency (99%) is observed in the DES based on the LiNO salt at 60 °C despite the presence of residual water in the electrolyte. Finally preliminary tests using a LFP/DES/LTO (lithium titanate) full cell at room temperature clearly show that LiTFSI-based DES can be successfully introduced into LIBs. Considering the beneficial properties, especially, the cost of these electrolytes, such introduction could represent an important contribution for the realization of safer and environmentally friendly LIBs. © 2013 the Owner Societies.

Thermodynamically stable amorphous drug dispersions in amorphous hydrophilic polymers engineered by hot melt extrusion.

In this study thermodynamically stable dispersions of amorphous quinine, a model BCS class 2 therapeutic agent, within an amorphous polymeric platform (HPC), termed a solid-in-solid dispersion, were produced using hot melt extrusion. Characterisation of the pre-extrudates and extrudates was performed using hyper-differential scanning calorimetry (DSC), powder X-ray diffraction (PXRD) and Raman spectroscopy. Water uptake by the raw materials was determined using dynamic vapour sorption (DVS) analysis. Furthermore, the presence or absence of crystalline drug following storage at 25 °C/60% relative humidity and 40 °C/75% relative humidity in a sealed glass jar, and at 40 °C/75% relative humidity in an open glass jar for 3 months was determined using PXRD. Amorphous quinine was generated in situ during extrusion from both quinine base (5%, 10%, 20% w/w drug loading) and from quinine hydrochloride (5%, 10% w/w drug loading) and remained thermodynamically stable as a solid-in-solid dispersion within the HPC extrudates. When processed with HPC, quinine hydrochloride (20% w/w) was converted to amorphous quinine hydrochloride. Whilst stable for up to 3 months when stored under sealed conditions, this amorphous form was unstable, resulting in recrystallisation of the hydrochloride salt following storage for 1 month at 40 °C/75% relative humidity in an open glass jar. The behaviour of the amorphous quinine hydrochloride (20% w/w) HPC extrudate was related, at least in part, to the lower stability and the hygroscopic properties of this amorphous form.

Drug Polymer Thermodynamic Phase Diagrams in the Selection of Optimal API-Polymer Compositions for Amorphous Solid Dispersions

Purpose The aim of this work was to examine, for amorphous solid dispersions, how the thermal analysis method selected impacts on the construction of thermodynamic phase diagrams, and to assess the predictive value of such phase diagrams in the selection of optimal, physically stable API-polymer compositions. Methods Thermodynamic phase diagrams for two API/polymer systems (naproxen/HPMC AS LF and naproxen/Kollidon 17 PF) were constructed from data collected using two different thermal analysis methods. The “dynamic” method involved heating the physical mixture at a rate of 1 &[deg]C/minute. In the "static" approach, samples were held at a temperature above the polymer Tg for prolonged periods, prior to scanning at 10 &[deg]C/minute. Subsequent to construction of phase diagrams, solid dispersions consisting of API-polymer compositions representative of different zones in the phase diagrams were spray dried and characterised using DSC, pXRD, TGA, FTIR, DVS and SEM. The stability of these systems was investigated under the following conditions: 25 &[deg]C, desiccated; 25 &[deg]C, 60 % RH; 40 &[deg]C, desiccated; 40 &[deg]C, 60 % RH. Results Endset depression occurred with increasing polymer volume fraction (Figure 1a). In conjunction with this data, Flory-Huggins and Gordon-Taylor theory were applied to construct thermodynamic phase diagrams (Figure 1b). The Flory-Huggins interaction parameter (&[chi]) for naproxen and HPMC AS LF was + 0.80 and + 0.72, for the dynamic and static methods respectively. For naproxen and Kollidon 17 PF, the dynamic data resulted in an interaction parameter of - 1.1 and the isothermal data produced a value of - 2.2. For both systems, the API appeared to be less soluble in the polymer when the dynamic approach was used. Stability studies of spray dried solid dispersions could be used as a means of validating the thermodynamic phase diagrams. Conclusion The thermal analysis method used to collate data has a deterministic effect on the phase diagram produced. This effect should be considered when constructing thermodynamic phase diagrams, as they can be a useful tool in predicting the stability of amorphous solid dispersions.

Looking at The Future of Canadian Copyright in The Rear View Mirror

"L’auteur présente une analyse générale de l’évolution historique et des développements récents du régime des droits d’auteur au Canada. Avec le développement des nouvelles technologies de l’information, et plus spécifiquement de l’Internet, le régime canadien des droits d’auteur nécessiterait d’importantes réformes. L’auteur déplore toutefois les modifications récentes issues de la loi C-60. En effet, selon lui, ces changements ne correspondent pas au régime international proposé par l’Organisation Mondiale de Propriété Intellectuelle. En fait, ceux-ci cadrent beaucoup plus avec la perspective américaine de protection limitative des droits d’auteur. Michael Geist trace d’abord l’historique du développement du régime de protection des droits d’auteur au Canada. Il souligne notamment les modifications législatives importantes de la fin des années 1980 et 1990 qui visaient à renforcer les règles de reconnaissance et de protection des droits que les auteurs canadiens possèdent sur leurs œuvres. Parallèlement, à ces modifications législatives, la Cour Suprême du Canada s’est aussi prononcée sur la question des droits d’auteur en interprétant limitativement la portée de ce régime, facilitant ainsi l’accès des œuvres artistiques au domaine public. L’auteur souligne les divergences et les contradictions entre la conception législative et celle jurisprudentielle de la fonction du régime canadien des droits d’auteur. Le législateur canadien a récemment proposé une nouvelle modification du régime de droits d’auteurs qui consisterait en l’extension des délais obligatoire avant qu’une œuvre couverte par le régime ne soit incluse dans le domaine public. Michael Geist s’oppose à une telle modification et soutient qu’elle entraînerait de nombreuses conséquences négatives pour les auteurs et les artistes canadiens. En effet, cette modification limiterait l’accès des auteurs aux oeuvres antérieures, elle entraverait les opportunités et les capacités commerciales des œuvres canadiennes et restreindrait les domaines de recherche académique. L’auteur aborde par la suite la problématique reliée aux ""Mesures de Protection Techniques"" et à la législation qui les encadre. En analysant les problèmes causés par ces mesures aux États-Unis, il présente leurs effets nuisibles pour les domaines fondamentaux de la liberté de parole et de la recherche académique. Les réformes possibles du régime canadien des droits d’auteur se situent dans une perspective plus ouverte du régime de protection et de promotion des œuvres canadiennes. Ces réformes auraient l’avantage de promouvoir et de protéger les œuvres canadiennes tout en évitant les problèmes causés par les mesures trop limitatives. À ce sujet, l’auteur propose l’établissement d’une bibliothèque digitale nationale, l’abrogation des droits d’auteur de la couronne et un nouveau régime permettant l’utilisation du matériel radiodiffusé de la Société Radio-Canada."