Transfer of Dietary Plant Natural Flavor Compounds From Essential Oils to Maternal Fluids in Pigs

Fetal flavor conditioning during the perinatal stage could be essential at the time of the weaning to reduce the stress and improve the feed intake in pigs. The transfer of flavor compounds from maternal diet to amniotic fluid and milk has been shown in behavioral experiments, but not through analytical procedures such as gas chromatography–mass spectrometry (GC–MS). The aim of the experiment was to trace the principal essential oils compounds supplied in the diet in maternal fluids. Twenty Large White sows around their 104th gestational day were allocated to individual farrowing crates. Two groups of 10 sows were fed either a standard gestation diet or the same diet supplemented with a mix of 8 essential oils at a rate of 1kg/ton during the last 10 days of gestation. At approximately the 113th gestational day, animals were individually treated with 10mg of Lutalyse IM was to induce farrowing. Fresh amniotic fluid was collected during the farrowing in 100-mL glass bottles and immediately stored at −20 °C freezer. During the second lactation day, 10–20 IU of Oxytocin IM was administered to each sow to facilitate collection of milk samples in 20-mL glass bottles. The samples were stored at −20 °C until analyzed by GC–MS. The presence of significant amounts of principal components of all the essential oils except one were found in the milk and amniotic fluid samples of the treated sows relative to the control sows. Our data prove the transfer of selected dietary flavors to maternal fluids and sets the scenario for further trials to manipulate postweaning behavior in piglets.

Inhibition of the biosynthesis of isoprenoid compounds by phenolic acids in the rat brain

The incorporation of [2-14C]mevalonate into nonsaponifiable lipids by rat brain homogenates is inhibited by phenolic acids derived from tyrosine. The phenyl acids derived from phenylalanine are inhibitory only at very high concentrations compared with phenolic acids. The brain is more sensitive to inhibition by the phenolic acids than the liver. These studies indicate a possible role for phenolic acids in the impairment of cerebral sterol metabolism in phenylketonuria.

Separation β-apocarotenals and related compounds by reversed-phase paper and thin-layer chromatography

Abstract is not available.

Combinations of plant-derived compounds against Campylobacter in vitro

Campylobacter occur in fresh retail poultry products as a result of their colonization of the gastro-intestinal tract of chickens during growth. Feed additives could be used for suppression of Campylobacter levels in the chickens prior to slaughter. To address this opportunity, feed manufacturers are targeting natural antimicrobials from plant material as new forms of consumer-accepted feed additives. However, to be practical, these natural antimicrobials must be effective at low concentrations. The current study has validated an improved laboratory method to study minimal inhibitory concentrations of plant compounds and their combinations against Campylobacter. The assay was shown to be valid for testing lipid-soluble and water-soluble plant extracts and byproducts from the food industry. The study screened 29 extracts or plant-derived compounds and their mixtures for anti-Campylobacter activity using a laboratory assay. Combinations of oregano, lactic acid, and sorghum byproduct showed effective synergy in anti-Campylobacter activity. The synergies allowed a large reduction in the concentration of the individual compounds needed to kill the bacteria with an 80% reduction in concentration being achieved for oregano essential oil. The assay gives rise to further opportunities for the testing of a greater range of combinations of plant-derived compounds and other natural antimicrobials. The method is robust, simple, and easily automated, and it could be used to adjust the cost of feed formulations by reducing costs associated with antimicrobial feed additives.

Dipole moments and structure of organophosphine and organoarsine compounds

The formal charge distributions in and the dipole moments of some organophosphines and arsines have been calculated, and the dipole moments of (p-chlorophenyl)dichlorophosphine (2.28 D) and (p-bromophenyl)dichlorophosphine (2.04 D) have been determined in benzene at 35° C. The differences between the observed and the calculated moments are explained in terms of dπ---pπ back-bonding and hyperconjugative effects in alkylhaloarsines. The mesomeric effects operating in the aromatic systems are evaluated by comparing the moments with those for the corresponding aliphatic systems. In unsaturated compounds the differences are attributed to mesomeric effects involving the expansion of arsenic valence shell.

Improved damping capacity and machinability of graphite particle-aluminum alloy composites

The damping capacity of cast graphitic aluminum alloy composites has been measured using a torsion pendulum at a constant strain amplitude. It was found that flake-graphite particles dispersed in the matrix of aluminum alloys increased the damping capacity; the improvement was greater, the higher the amount of graphite dispersed in the matrix. At sufficiently high graphite contents the damping capacity of graphitic aluminum composites approaches that of cast iron. The ratio between the damping capacity and the density of graphitic aluminum alloys is higher than cast iron, making them very attractive as light-weight, high-damping materials for possible aircraft applications. Machinability tests on graphite particle-aluminum composites, conducted at speeds of 315 sfm and 525 sfm, showed that the chip length decreased with the amount of graphite of a given size. When the size of graphite was decreased, at a given machining speed, the chip length decreased. Metallographic examination shows that graphite particles act as chip breakers, and are frequently sheared parallel to the plane of the

Homogeneous hydrogenations ofα, β-unsaturated compounds using pentacyanocobaltate (II) anion as catalyst system

Hydrogenation of someα, β-unsaturated carbonyl compounds using potassium pentacyanocobaltate (II), K3Co(CN)5, as a homogeneous catalyst has been investigated. Thus, hydrogenation of 1-carvone (I), mesityl oxide (4), 2-cyclohexenone (8) and benzalacetone (6) afforded the corresponding dihydrocompounds. Hydrogenation ofβ-ionone (10) afforded a mixture of theα, β-dihydrocompounds (14) and (15). In all these cases, it was observed that the reaction proceeded to completion only in the presence of added base. Hydrogenation of 5α-androst-l-en-17β-ol-3-one acetate (19) afforded the saturated compound, 5α-androst-17β-ol-3-one (20) in 60% yield. It was found that other steroid enones and dienones were not reduced by this catalyst system.

The nonplanar peptide unit III. Quantum chemical calculations for related compounds and experimental X-ray diffraction data

The possible nonplanar distortions of the amide group in formamide, acetamide, N-methylacetamide, and N-ethylacetamide have been examined using CNDO/2 and INDO methods. The predictions from these methods are compared with the results obtained from X-ray and neutron diffraction studies on crystals of small open peptides, cyclic peptides, and amides. It is shown that the INDO results are in good agreement with observations, and that the dihedral angles N and defining the nonplanarity of the amide unit are correlated approximately by the relation N = -2, while C is small and uncorrelated with . The present study indicates that the nonplanar distortions at the nitrogen atom of the peptide unit may have to be taken into consideration, in addition to the variation in the dihedral angles (,), in working out polypeptide and protein structures.

Wrought aluminum-nickel alloys for high strength-high conductivity applications

Aluminum-Nickel alloys ranging from 0.06 pct to 6.1 pct (by wt) Ni have been developed for high strength-high conductivity applications. These alloys were produced by solidification in a permanent mold followed by homogenization, hot extrusion or hot rolling and cold drawing to wire form. This sequence of fabrication a) led to the production of fine fibrous dispersoids of NiAl3 as part of the Al-NiAl3 eutectic during the initial casting operation, b) permitted the retention of fine fibrous dispersiods of NiAl3 produced during casting without any significant coarsening during processing and c) led to uniform dispersion and general alignment of these fibrous dispersoids along a given direction in the product without any measurable fiber-matrix separation, extensive fiber-fragmentation or crack production in the matrix. These alloys can be processed to wire form as easily as aluminum and when processed by the above sequence, possess very attractive combination of high strength-high electrical conductivity. Tensile strengths range from 173 N/mm2 (at 0.6 pct Ni) to 241 N/mm2 (at 6.1 pct Ni) in combination with corresponding conductivity values between 62 pct IACS and 55.5 pct IACS. The wires also possess attractive yield strength; for instance, the 0.2 pct off-set strength of Al-6.1 pct Ni wire is 213 N/mm2. Using simple composite rules, the estimated strength and the conductivity of NiAl3 fibers were found to be 1380 N/mm2 and 18 pct IACS respectively, in these wires.

Dielectric and Electron Spin Resonance Spectroscopic Studies of Glassy Crystalline States of Organic Compounds

Dielectric studies of the glassy crystalline states of cyclohexanol, cyclohexanone, and camphor obtained by upercooling the plastic crystalline phase demonstrate the presence of characteristic a- and p-relaxations. The parameters of the a-relaxation fit the Vogel-Tammann-Fulcher (VTF) equation. ESR spin-probe studies of the glassy crystalline phase of cyclohexanol show that there is a marked decrease in the correlation time above the glasslike transition temperature. The present studies suggest the similarity between glassy crystals having long-range orientational disorder and glasses which are known to betra nslationally disordered.

Nuclear quadrupole resonance in coordination compounds

Abstract is not available.

Studies on transport phenomena during solidification of an aluminum alloy in the presence of linear electromagnetic stirring

Numerical and experimental studies on transport phenomena during solidification of an aluminum alloy in the presence of linear electromagnetic stirring are performed. The alloy is electromagnetically stirred to produce semisolid slurry in a cylindrical graphite mould placed in the annulus of a linear electromagnetic stirrer. The mould is cooled at the bottom, such that solidification progresses from the bottom to the top of the cylindrical mould. A numerical model is developed for simulating the transport phenomena associated with the solidification process using a set of single-phase governing equations of mass. momentum, energy. and species conservation. The viscosity variation of the slurry, used in the model, is determined experimentally using a rotary viscometer. The set of governing equations is solved using a pressure-based finite volume technique, along with an enthalpy based phase change algorithm. The numerical study involves prediction of temperature, velocity, species and solid fraction distribution in the mould. Corresponding solidification experiments are performed, with time-temperature history recorded at key locations. The microstructures at various temperature measurement locations in the solidified billet are analyzed. The numerical predictions of temperature variations are in good agreement with experiments, and the predicted flow field evolution correlates well with the microstructures observed at various locations.