Stability Testing of Spray- and Spouted Bed-Dried Extracts of Passiflora alata

The aim of this research was to perform a stability testing of spray- and spouted bed-dried extracts of Passiflora alata Dryander (Passion flower) under stress storage conditions. Spouted bed- and spray-dried extracts were characterized by determination of the average particle diameter (dP), apparent moisture content (XP), total flavonoid content (TF), and vitexin content. Smaller and more irregular particles were generated by the spouted bed system due to a higher attrition rate (surface erosion) inside the dryer. The SB dryer resulted in an end product with higher concentration of flavonoids (approximate to 10%) and lower moisture content (1.6%, dry basis) than the spray dryer, even with both dryers working at similar inlet drying air temperature and ratio between the extract feed flow rate to drying air flow rate (Ws/Wg). Samples of the spouted bed- and spray-dried extracts were stored at two different temperatures (34 and 45 degrees C) and two different relative humidities (52 and 63% RH for 34 degrees C; 52 and 60% RH for 45 degrees C) in order to perform the stability testing. The dried extracts were stored for 28 days and were analyzed every 4 days. The flavonoid vitexin served as the marker compound, which was assayed during the storage period. Results revealed shelf lives ranging from 9 to 184 days, depending on the drying process and storage conditions.

Research, knowledge and design

The discussion about relations between research and design has a number of strands, and presumably motivations. Putting aside the question whether or not design or “creative endeavour” should be counted as research, for reasons to do with institutional recognition or reward, the question remains how, if at all, is design research? This question is unlikely to have attracted much interest but for matters external to Architecture within the modern university. But Architecture as a discipline now needs to understand research much better than in the past when ‘research’ was whatever went on in building science, history or people/environment studies. In this paper, I begin with some common assumptions about design, considered in relation to research, and suggest how the former can constitute or be a mode of the latter. Central to this consideration is an understanding of research as the production of publicly available knowledge. The method is that of conceptual analysis which is much more fruitful than is usually appreciated. This work is part of a larger project in philosophy of design, in roughly the analytical tradition.

Public policy in knowledge-based economies: Foundations and frameworks

Knowledge is a product of human social systems and, therefore, the foundations of the knowledge-based economy are social and cultural. Communication is central to knowledge creation and diffusion, and Public Policy in Knowledge-Based Economies highlights specific social and cultural conditions that can enhance the communication, use and creation of knowledge in a society.The purpose of this book is to illustrate how these social and cultural conditions are identified and analysed through new conceptual frameworks. Such frameworks are necessary to penetrate the surface features of knowledge-based economies - science and technology - and disclose what drives such economies.This book will provide policymakers, analysts and academics with the fundamental tools needed for the development of policy in this little understood and emerging area.

Knowledge and willingness to pay for the conservation of wildlife species: Experimental results evaluating Australian tropical species

The nature of an experiment involving 204 residents is outlined and the results are reported and analysed. Two consecutive surveys of the respondents provide data about their stated knowledge of 23 wildlife species present in tropical Australia, most of which exclusively occur there. In addition, these surveys provide data about the willingness of respondents to pay for the conservation of those species belonging to three taxa; reptiles, mammals, and birds. Thus it is possible to compare the respondents’ stated knowledge of the species with their willingness to pay for their conservation, and to draw relevant inferences from this. From the initial survey and these associations, interesting relationships can be observed between those variables (knowledge and willingness to pay). The second survey was completed after the respondents’ knowledge of the species was experimentally increased and became more balanced. This is shown to result in increased dispersion (greater discrimination) in willingness to contribute to conservation of the different species in the set of wildlife species considered. Both theoretical and policy conclusions are drawn from the results.

Knowledge of birds and willingness to pay for their conservation: An Australian case study

This case study concentrates on the extent of knowledge of members of the Australian public of Australia’s tropical bird species and their willingness to pay for their conservation. In order to place this issue in context, it first provides background information on the status of Australian bird species, focusing attention on species that occur in tropical Australia. Then, using survey results, this study considers the hypothesis that the public’s relative support for the conservation of different bird species depends on its comparative knowledge of their existence and status. Based on experimental results from a sample of residents of Brisbane, Queensland (Australia), it is found that their knowledge of bird species that occur exclusively in the Australian tropics (including tropical Queensland) is very poor compared to those that also occur in the Brisbane area and are relatively common. Experimental results indicate that when respondents in the sample had an option to allocate $1,000 between ten bird species listed in the survey, it resulted in a greater allocation of funds to the better known and more common species than when they were provided with balanced information about all the selected species. With balanced information the average allocation to bird species confined mostly to the Australian tropics, particularly those threatened or endangered, increased. The general consequences of this for policies for the conservation of birds are discussed.

Western Australian primary school teachers knowledge about childhood asthma and its management

A total of 164 primary school teachers from Perth, Western Australia anonymously completed a survey of their knowledge and attitudes about asthma. These teachers were active in assisting children with asthma management but most (91.5%) felt that they did not know enough about asthma. Attitudes toward children with asthma were positive; 97% agreed that such children should be encouraged to participate in sporting activities. Specific knowledge about asthma management and medications was, however, poor. This large sample of Western Australian teachers knew more than their European counterparts but asthma training is needed and should be targeted at improving knowledge of both regular and emergency treatments for asthma.

Linearly-increasing-stress testing of carbon steel in 4 N NaNO3 and in Bayer liquor

This paper reports the application of linearly increasing stress testing (LIST) to the study of stress corrosion cracking (SCC) of carbon steel in 4 N NaNO3 and in Bayer liquor. LIST is similar to the constant extension-rate testing (CERT) methodology with the essential difference that the LIST is load controlled whereas the CERT is displacement controlled. The main conclusion is that LIST is suitable for the study of the SCC of carbon steels in 4 N NaNO3 and in Bayer liquor. The low crack velocity in Bayer liquor and a measured maximum stress close to that of the reference specimen in air both indicate that a low applied stress rate is required to study SCC in this system. (C) 1998 Chapman & Hall.

Improving wheat simulation capabilities in Australia from a cropping systems perspective - II. Testing simulation capabilities of wheat growth

To simulate cropping systems, crop models must not only give reliable predictions of yield across a wide range of environmental conditions, they must also quantify water and nutrient use well, so that the status of the soil at maturity is a good representation of the starting conditions for the next cropping sequence. To assess the suitability for this task a range of crop models, currently used in Australia, were tested. The models differed in their design objectives, complexity and structure and were (i) tested on diverse, independent data sets from a wide range of environments and (ii) model components were further evaluated with one detailed data set from a semi-arid environment. All models were coded into the cropping systems shell APSIM, which provides a common soil water and nitrogen balance. Crop development was input, thus differences between simulations were caused entirely by difference in simulating crop growth. Under nitrogen non-limiting conditions between 73 and 85% of the observed kernel yield variation across environments was explained by the models. This ranged from 51 to 77% under varying nitrogen supply. Water and nitrogen effects on leaf area index were predicted poorly by all models resulting in erroneous predictions of dry matter accumulation and water use. When measured light interception was used as input, most models improved in their prediction of dry matter and yield. This test highlighted a range of compensating errors in all modelling approaches. Time course and final amount of water extraction was simulated well by two models, while others left up to 25% of potentially available soil water in the profile. Kernel nitrogen percentage was predicted poorly by all models due to its sensitivity to small dry matter changes. Yield and dry matter could be estimated adequately for a range of environmental conditions using the general concepts of radiation use efficiency and transpiration efficiency. However, leaf area and kernel nitrogen dynamics need to be improved to achieve better estimates of water and nitrogen use if such models are to be use to evaluate cropping systems. (C) 1998 Elsevier Science B.V.

The Swiss heroin trials: testing alternative approaches

Over half a million heroin misusers receive oral methadone maintenance treatment world-wide1 but the maintenance prescription of injectable opioid drugs, like heroin, remains controversial. In 1992 Switzerland began a large scale evaluation of heroin and other injectable opiate prescribing that eventually involved 1035 misusers. 2 3 The results of the evaluation have recently been reported.4 These show that it was feasible to provide heroin by intravenous injection at a clinic, up to three times a day, for seven days a week. This was done while maintaining good drug control, good order, client safety, and staff morale. Patients were stabilised on 500 to 600 mg heroin daily without evidence of increasing tolerance. Retention in treatment was 89% at six months and 69% at 18 months.4 The self reported use of non-prescribed heroin fell signifianctly, but other drug use was minimally affected. The death rate was 1% per year, and there were no deaths from overdose among participants . . . [Full text of this article]

Young children, adolescents and alcohol - Part I: Exploring knowledge and awareness of alcohol and related issues

This article explores young children's and adolescents' views pertaining to: knowledge and awareness of alcohol and alcohol related issues; social situations in which. alcohol use is present; orientation to alcohol risk; perceived and actual alcohol use; social image and reputation; and short and long term health beliefs in relation to alcohol. Forty focus groups were conducted with 240 primary school students (118 males and 122 females) and 24 focus groups were conducted with 192 high school students (90 males and 102 females); the total being 64 focus groups comprising 432 school students. Participants ages ranged from five years three months to 16 years 10 months. The videotaped discussions revealed that approximately 75% of the primary school-aged children and almost all of the high school students reported that they had tasted alcohol. Parents were primarily responsible for providing the alcohol. Virtually all participants recognised and were able to correctly name a selection of alcoholic and non-alcoholic beverages, and levels of knowledge and awareness of the health and safety aspects of alcohol were relatively mixed. Presentation of bottles and cans was reported as being important in attracting young persons. These data suggest there is an urgent need for research addressed to the development of prevention/intervention education curriculum materials for use with primary school-aged children.

The knowledge gap: A perspective on trade, industry, technology and policy from pre-war Australian music technology manufacturing (1903-30)

Australia struggles to achieve economic competitiveness, prevent expansion of the trade deficit and develop value-added production despite applications of policy strategies from protectionism to trade liberalisation. This article argues that these problems were emerging at the turn of the century, and that an investigation of music technology manufacturing in the first two decades of this century reveals fundamental problems in the conduct of relevant policy analysis. Analysis has focused on the trade or technology gap which is only symptomatic of an underlying knowledge gap. The article calls for a knowledge policy approach which can allow protection without the negative effects of isolation from global markets and without having to resort to unworkable utopian free-trade dogma. A shift of focus from a 'goods traded' view to a knowledge transaction (or diffusion) perspective is advocated.

Formal derivation of finite state machines for class testing

Previous work on generating state machines for the purpose of class testing has not been formally based. There has also been work on deriving state machines from formal specifications for testing non-object-oriented software. We build on this work by presenting a method for deriving a state machine for testing purposes from a formal specification of the class under test. We also show how the resulting state machine can be used as the basis for a test suite developed and executed using an existing framework for class testing. To derive the state machine, we identify the states and possible interactions of the operations of the class under test. The Test Template Framework is used to formally derive the states from the Object-Z specification of the class under test. The transitions of the finite state machine are calculated from the derived states and the class's operations. The formally derived finite state machine is transformed to a ClassBench testgraph, which is used as input to the ClassBench framework to test a C++ implementation of the class. The method is illustrated using a simple bounded queue example.