Thin Maintenance Surfaces for Municipalities, TR-507, 2007

As streets age, officials must deal with rehabilitating and reconstructing these pavements to maintain a safe and comfortable ride. In light of nationwide budget shortfalls, cost-effective methods of extending pavement service life must be developed or the overall condition of street systems will continue to fall. Thin maintenance surfaces (TMSs) are a set of cost-effective preventive maintenance surfacing techniques that can be used to extend the life of bituminous pavement—pavement built with hot mix asphalt, hot mix asphalt overlays of portland cement concrete pavements, built-up seal coat (chip seal), stabilized materials, or a combination of these. While previous phases of TMS research have provided information about the uses of thin maintenance surfaces in rural settings, urban areas have different road maintenance challenges that should be considered separately. This research provides city street officials with suggestions for TMS techniques that street departments can easily test and include into their current programs. This research project facilitated the construction of TMS test sections in Cedar Rapids, Council Bluffs, and West Des Moines (all urban settings in Iowa). Test section sites and surfaces were selected to suit the needs of municipalities and were applied to roads with an array of various distresses and maintenance needs. Condition surveys of each test section were performed before construction, after construction, and after the first winter to record the amount and severity of existing distress and calculate the pavement condition index. Because conditions of the test sections varied greatly, determining which surface was most successful by comparing case studies was not feasible. However, some general conclusions can be made from this research. TMSs are suitable preventive maintenance techniques for a municipal street department’s program for preserving existing pavements. Careful attention should be paid to proper planning, quality control during construction, aggregate and binder selection, and aggregate embedment in order to support successful TMS application.

Aggregates for Thin Maintenance Surfaces, TR-435, 2003

Important qualities of aggregates used for thin maintenance surface (TMS) include an aggregates wear and skid resistance, shape, gradation, and size. The wear and skid resistance of an aggregate influences the lifetime of the individual aggregate particles, and thus the lifetime of the TMS. A TMS’s effectiveness is impacted by the shape, gradation, and size of the aggregate used for the surfacing material along with the lifetime of the aggregate.

Asphalt Binders for Thin Maintenance Surfaces, TR-435, 2003

Asphalt is used as a binder for thin maintenance surface (TMS) applications because of two key properties, it is waterproof and it adheres relatively well to the aggregate. Since asphalt is too stiff at room temperature to apply to the road surface, it is usually applied as either a cutback asphalt or an asphalt emulsion. The asphalt emulsions can be further divided into high float emulsions, cationic emulsions or polymer-modified binders, which are emulsions with polymers added to them. These types of binders are discussed further below.

Assessment of Impervious Surfaces in an Urban Watershed

Summary of the Urban Watershed Management Assistance tool to assess the impact of impervious surfaces.

Cadmium-free quantum dots in aqueous solution: potential for fingermark detection, synthesis and an application to the detection of fingermarks in blood on non-porous surfaces

The use of quantum dots (QDs) in the area of fingermark detection is currently receiving a lot of attention in the forensic literature. Most of the research efforts have been devoted to cadmium telluride (CdTe) quantum dots often applied as powders to the surfaces of interests. Both the use of cadmium and the nano size of these particles raise important issues in terms of health and safety. This paper proposes to replace CdTe QDs by zinc sulphide QDs doped with copper (ZnS:Cu) to address these issues. Zinc sulphide-copper doped QDs were successfully synthesized, characterized in terms of size and optical properties and optimized to be applied for the detection of impressions left in blood, where CdTe QDs proved to be efficient. Effectiveness of detection was assessed in comparison with CdTe QDs and Acid Yellow 7 (AY7, an effective blood reagent), using two series of depletive blood fingermarks from four donors prepared on four non-porous substrates, i.e. glass, transparent polypropylene, black polyethylene and aluminium foil. The marks were cut in half and processed separately with both reagents, leading to two comparison series (ZnS:Cu vs. CdTe, and ZnS:Cu vs. AY7). ZnS:Cu proved to be better than AY7 and at least as efficient as CdTe on most substrates. Consequently, copper-doped ZnS QDs constitute a valid substitute for cadmium-based QDs to detect blood marks on non-porous substrates and offer a safer alternative for routine use.

Estimating soybean crop areas using spectral-temporal surfaces derived from MODIS images in Mato Grosso, Brazil

The objective of this work was to evaluate the application of the spectral-temporal response surface (STRS) classification method on Moderate Resolution Imaging Spectroradiometer (MODIS, 250 m) sensor images in order to estimate soybean areas in Mato Grosso state, Brazil. The classification was carried out using the maximum likelihood algorithm (MLA) adapted to the STRS method. Thirty segments of 30x30 km were chosen along the main agricultural regions of Mato Grosso state, using data from the summer season of 2005/2006 (from October to March), and were mapped based on fieldwork data, TM/Landsat-5 and CCD/CBERS-2 images. Five thematic classes were considered: Soybean, Forest, Cerrado, Pasture and Bare Soil. The classification by the STRS method was done over an area intersected with a subset of 30x30-km segments. In regions with soybean predominance, STRS classification overestimated in 21.31% of the reference values. In regions where soybean fields were less prevalent, the classifier overestimated 132.37% in the acreage of the reference. The overall classification accuracy was 80%. MODIS sensor images and the STRS algorithm showed to be promising for the classification of soybean areas in regions with the predominance of large farms. However, the results for fragmented areas and smaller farms were less efficient, overestimating soybean areas.

Alcohol use and frailty in community-dwelling older persons aged 65 to 70 years.

Background: Alcohol use has beneficial as well as adverse consequences on health, but few studies examined its role in the development of age-related frailty. Objectives: To describe the cross-sectional and longitudinal association between alcohol intake and frailty in older persons. Design: The Lausanne cohort 65+ population-based study, launched in 2004. Setting: Community. Participants: One thousand five hundred sixty-four persons aged 65-70 years. Measurements: Annual data collection included demographics, health and functional status, extended by a physical examination every 3 years. Alcohol use (AUDIT-C), and Fried's frailty criteria were measured at baseline and 3-year follow-up. Participants were categorized into robust (0 frailty criterion) and vulnerable (1+ criteria). Results: Few participants (13.0%) reported no alcohol consumption over the past year, 57.8% were light-to-moderate drinkers, while 29.3% drank above recommended thresholds (18.7% "at risk" and 10.5% "heavy" drinkers). At baseline, vulnerability was most frequent in non-drinkers (43.0%), least frequent in light-to-moderate drinkers (26.2%), and amounted to 31.9% in "heavy" drinkers showing a reverse J-curve pattern. In multivariate analysis, compared to light-to-moderate drinkers, non-drinkers had twice higher odds of prevalent (adjOR: 2.24; 95%CI:1.39-3.59; p=.001), as well as 3-year incident vulnerability (adjOR: 2.00; 95%CI:1.02-3.91; p=.043). No significant association was observed among "at risk" and "heavy" drinkers. Conclusion: Non-drinkers had two-times higher odds of prevalent and 3-year incident vulnerability, even after adjusting for their baseline poorer health status. Although residual confounding is still possible, these results likely reflect a healthy survival effect among drinkers while those who experienced health- or alcohol-related problems stopped drinking earlier.

Quantitative Guidelines for Thin Maintenance Surfaces, TR-435, 2003

What follows are the refined guidelines from the Thin Maintenance Surface: Phase II Report. For that report, test sections were created and monitored along with some existing test sections. From the monitoring and evaluation of these test sections, literature reviews, and the experience and knowledge of the authors, the following guidelines were created. More information about thin maintenance surfaces and their uses can be found in the above-mentioned report.

Prevalence of frailty in middle-aged and older community-dwelling Europeans living in 10 countries.

BACKGROUND: Frailty is an indicator of health status in old age. Its frequency has been described mainly for North America; comparable data from other countries are lacking. Here we report on the prevalence of frailty in 10 European countries included in a population-based survey. METHODS: Cross-sectional analysis of 18,227 randomly selected community-dwelling individuals 50 years of age and older, enrolled in the Survey of Health, Aging and Retirement in Europe (SHARE) in 2004. Complete data for assessing a frailty phenotype (exhaustion, shrinking, weakness, slowness, and low physical activity) were available for 16,584 participants. Prevalences of frailty and prefrailty were estimated for individuals 50-64 years and 65 years of age and older from each country. The latter group was analyzed further after excluding disabled individuals. We estimated country effects in this subset using multivariate logistic regression models, controlling first for age, gender, and then demographics and education. RESULTS: The proportion of frailty (three to five criteria) or prefrailty (one to two criteria) was higher in southern than in northern Europe. International differences in the prevalences of frailty and prefrailty for 65 years and older group persisted after excluding the disabled. Demographic characteristics did not account for international differences; however, education was associated with frailty. Controlling for education, age and gender diminished the effects of residing in Italy and Spain. CONCLUSIONS: A higher prevalence of frailty in southern countries is consistent with previous findings of a north-south gradient for other health indicators in SHARE. Our data suggest that socioeconomic factors like education contribute to these differences in frailty and prefrailty.

Evolution of Gait Performance and Fear of Falling after a 10-Week Program of Exercise Training in Community Dwelling Older People

A pilot study was conducted to determine the effect of a 10-week, low intensity, exercise training program on fear of falling and gait in fifty (mean age 78.1 years, 79% women) community-dwelling volunteers. Fear of falling (measured by falls self-efficacy) and gait performance were assessed at baseline and one week after program completion. At follow-up, participants modestly improved their falls self-efficacy and gait speed. To investigate whether this effect differed according to participants' fear of falling, secondary analyses stratified by subject's baseline falls efficacy were performed. Subjects with lower than average falls efficacy improved significantly their falls efficacy and gait performance, while no significant change occurred in the others. Small but significant improvements occurred after this pilot training program, particularly in subjects with low baseline falls efficacy. These results suggest that measures of falls efficacy might be useful for better targeting individuals most likely to benefit from similar training programs.

Real-time Imaging and Mosaicking of Planar Surfaces

Laajojen pintojen kuvaaminen rajoitetussa työskentelytilassa riittävällä kuvatarkkuudella voi olla vaikeaa. Kuvaaminen on suoritettava osissa ja osat koottava saumattomaksi kokonaisnäkymäksi eli mosaiikkikuvaksi. Kuvauslaitetta käsin siirtelevän käyttäjän on saatava välitöntä palautetta, jotta mosaiikkiin ei jäisi aukkoja ja työ olisi nopeaa. Työn tarkoituksena oli rakentaa pieni, kannettava ja tarkka kuvauslaite paperi- ja painoteollisuuden tarpeisiin sekä kehittää palautteen antamiseen menetelmä, joka koostaaja esittää karkeaa mosaiikkikuvaa tosiajassa. Työssä rakennettiin kaksi kuvauslaitetta: ensimmäinen kuluttajille ja toinen teollisuuteen tarkoitetuista osista. Kuvamateriaali käsiteltiin tavallisella pöytätietokoneella. Videokuvien välinen liike laskettiin yksinkertaisella seurantamenetelmällä ja mosaiikkikuvaa koottiin kameroiden kuvanopeudella. Laskennallista valaistuksenkorjausta tutkittiin ja kehitetty menetelmä otettiin käyttöön. Ensimmäisessä kuvauslaitteessa on ongelmia valaistuksen ja linssivääristymien kanssa tuottaen huonolaatuisia mosaiikkikuvia. Toisessa kuvauslaitteessa nämä ongelmat on korjattu. Seurantamenetelmä toimii hyvin ottaen huomioon sen yksinkertaisuuden ja siihen ehdotetaan monia parannuksia. Työn tulokset osoittavat, että tosiaikainen mosaiikkikuvan koostaminen megapikselin kuvamateriaalista on mahdollista kuluttajille tarkoitetulla tietokonelaitteistolla.

Poisoning effect of s on pd surfaces

In this study we observe the poisoning effect of S to the adsorption and dissociation of 02 molecule on Pd surfaces. To perform this study we used Viennaab initio Simulation Package (VASP) and Spanish Initiative for Electronic structure with thousands of Atoms (SIESTA) ab initio softwares. To describe all Pd surfaces we selected the (100), and (211) surfaces, because we need very reactive and simple surfaces. Before studying the poison¬ing effect of S we had to study the dissociation of 02 on the surfaces. We discovered that on the (100) surface the hollow site is the most reactive site, but at room temperature the steric hinderace effect occurs very easily. If the molecule has enough vibrational energyit will dissociate. On the (211) surface the (100) micro facet's hollow site is the most reactive site and the molecule dissociates in the site without any barrier, and the molecule drifts from the terrace to this site. An S atom sticks on the Pd (100) surface in the hollow site. It affects the d-band density of states of the nearests Pd atoms; It moves the center of the d-band downin energy, when the bond between the Pd atom and the 0 atom is more antibonding. In the hollow site the S atom also blocks the dissociation site of the molecule. On the Pd(211) surface the energetically favourable site of the S atom is the(100) microfacet's hollow site. There it blocks the most reactive site, but its effect to the Pd atoms next to it is not significant.