Poly (vinyl alcohol) hydrogel membrane as electrolyte for direct borohydride fuel cells

A direct borohydride fuel cell (DBFC) employing a poly (vinyl alcohol)hydrogel membrane electrolyte (PHME) is reported. The DBFC employs an AB(5) Misch metal alloy as anode and a goldplated stainless steel mesh as cathode in conjunction with aqueous alkaline solution of sodium borohydride as fuel and aqueous acidified solution of hydrogen peroxide as oxidant. Room temperature performances of the PHME-based DBFC in respect of peak power outputs; ex-situ cross-over of oxidant, fuel,anolyte and catholyte across the membrane electrolytes; utilization efficiencies of fuel and oxidant, as also cell performance durability are compared with a similar DBFC employing a NafionA (R)-117 membrane electrolyte (NME). Peak power densities of similar to 30 and similar to 40 mW cm(-2) are observed for the DBFCs with PHME and NME, respectively. The crossover of NaBH4 across both the membranes has been found to be very low. The utilization efficiencies of NaBH4 and H2O2 are found to be similar to 24 and similar to 59%, respectively for the PHME-based DBFC; similar to 18 and similar to 62%, respectively for the NME-based DBFC. The PHME and NME-based DBFCs exhibit operational cell potentials of similar to 1 center dot 2 and similar to 1 center dot 4 V, respectively at a load current density of 10 mA cm(-2) for similar to 100 h.

6,8-Dibromo-5-hydroxy-4-oxo-2-phenyl-4H-chromen-7-yl acetate

In the title compound, C17H10Br2O5, the chromene ring is almost planar with minimal puckering [total puckering amplitude = 0.067 (4) angstrom]. The dihedral angle between chromeme ring system and phenyl ring is 3.7 (2)degrees. The crystal structure is stabilized by intermolecular C-H center dot center dot center dot O interactions and an intramolecular O-H center dot center dot center dot O hydrogen bond also occurs.

Transformation reactions of α-pinene—I : Reactions of ethyl (−)-2,2-dimethyl-3-ketocyclobutyl acetate

Some transformation reactions of α-pinene to give 4- and 3-membered ring compounds, not hitherto obtained from this source, are described. The study furnished a convenient method of preparation of the optically active cyclobutanone IVa, the title compound which served as the key substrate for all the transformations reported.

Raman spectrum of crystalline cadmium acetate dihydrate

The Raman spectrum of a single crystal of cadmium acetate dihydrate has been recorded for the first time using λ 2537 excitation. Twenty-three lines have been observed out of which ten have been attributed to the internal oscillations of the acetate ion, nine to the lattice modes, two to low-frequency hydrogen bond vibrations. A line at 308 cm.−1 and the continuum 3250–3560 cm.−1 have been assigned to the Cd-O6 and internal vibrations of the water molecules.

Seawater Durability of Epoxy/Vinyl Ester Reinforced with Glass/Carbon Composites

Seawater aging response was investigated in marine-grade glass/epoxy, glass/vinyl ester, carbon/epoxy and carbon/vinyl ester composites with respect to water uptake, interlaminar shear strength, flexural strength, tensile strength, and tensile fracture surface observations. The reduction of mechanical properties was found to be higher in them initial stages which showed saturation in the longer durations of seawater immersion. The flexural strength and ultimate tensile strength (UTS) dropped by about 35% and 27% for glass/epoxy, 22% and 15% for glass/vinyl ester, 48% and 34% for carbon/epoxy 28%, and 21% carbon/vinyl ester composites respectively. The water uptake behavior of epoxy-based composites was inferior to that of the vinyl system.

Steroids and related natural products. VII. Boron trifluoride etherate-lithium aluminum hydride reduction of smilagenin acetate

Reduction of smilagenin acetate (Va) using a boron trifluoride etherate-lithium aluminum hydride reagent, followed by hydrogen peroxide oxidation and acetylation, was found to yield: 3β-ethoxysmilagenin (Vb), 3β-ethoxydihydrosmilagenin acetate (VIa), dihydrosmilagenin diacetate (VIb), and a complex mixture of partially acetylated products. Similar reaction conditions were employed to convert dihydrodiosgenin (II) to dihydrochlorogenin (III). Boron trifluoride etherate-lithium aluminum hydride reduction of 3β-acetoxy-5α-cholestane and 3β-acetoxy-5α-lanostane (VIIIa) was shown to yield the corresponding 3β-ethoxy (e.g., VIIIb) derivatives.

Isomerisations of substituted β-keto-esters - Part II. Isomerisation of ethyl 1-ethoxycarbonyl 2oxocyclopentyl acetate into 2, 3-diethoxycarbonylcyclohexanone

A mechanism for the isomerisation of ethyl 1-ethoxycarbonyl-2-oxocyclopentylacetate (I) into a cyclohexane β-keto-ester as proceeding through an intermediate bicyclic /gb-diketone (VII) has been considered as an alternative mechanism to one earlier suggested.1 The determination of the structure of the isomerised β-keto-ester as 2, 3-diethoxycarbonylcyclohexanone (V) has provided support for the earlier mechanism.

Reaction of beta-haloenones with tetrathiomolybdate: Synthesis of vinyl disulfides

beta -Haloenones react readily with benzyltriethylammonium tetrathiomolybdate to form the corresponding vinyl disulfides in good yields.

Direct Writing of Copper Film Patterns by Laser-Induced Decomposition of Copper Acetate

Direct writing of patterns is being widely attempted in the field of microelectronic circuit/device manufacture. Use of this technique eliminates the need for employing photolithographic process. Laser induced direct writing can be achieved by (i) Photochemical reaction [i] , (ii) Evaporation from target material [2], and (iii) decomposition.Micron size features of palladium and copper through decomposition of palladium acetate and copper formate respectively on quartz and silicon using Argon ion laser have been reported [3,4] .In this commuication we report a technique for both single line and large area depositon of copper through decomposition of copper acetate,(CH3COO)2Cu, on alumina substrates.Nd:YAG laser known for its reliability and low maintenance cost as compared to excimer and other gas lasers is used. This technique offers an attractive and economical alternative for manufacture of thin film microcircuits.

Synthesis of ethyl arylacetates by means of Friedel-Crafts reactions of aromatic compounds with ethyl alpha-chloro-alpha-(ethylthio)acetate catalysed by ytterbium triflate

An efficient Friedel-Crafts alkylation of aromatic compounds with ethyl alpha -chloro-alpha-(ethylthio)acetate catalysed by ytterbium triflate, followed by desulfurisation of the product provides a convenient methodology for the synthesis of ethyl arylacetates of aromatic and heteroaromatic compounds. (C) 2000 Elsevier Science Ltd. All rights reserved.