Friction losses of Newtonian and non-Newtonian fluids flowing in laminar regime in a helical coil

This study aimed to carry out experimental work to determine, for Newtonian and non-Newtonian fluids, the friction factor (fc) with simultaneous heat transfer, at constant wall temperature as boundary condition, in fully developed laminar flow inside a vertical helical coil. The Newtonian fluids studied were aqueous solutions of glycerol, 25%, 36%, 43%, 59% and 78% (w/w). The non-Newtonian fluids were aqueous solutions of carboxymethylcellulose (CMC), a polymer, with concentrations of 0.2%, 0.3%, 0.4% and 0.6% (w/w) and aqueous solutions of xanthan gum (XG), another polymer, with concentrations of 0.1% and 0.2% (w/w). According to the rheological study done, the polymer solutions had shear-thinning behavior and different values of viscoelasticity. The helical coil used has an internal diameter, curvature ratio, length and pitch, respectively: 0.00483 m, 0.0263, 5.0 m and 11.34 mm. It was concluded that the friction factors, with simultaneous heat transfer, for Newtonian fluids can be calculated using expressions from literature for isothermal flows. The friction factors for CMC and XG solutions are similar to those for Newtonian fluids when the Dean number, based in a generalized Reynolds number, is less than 80. For Dean numbers higher than 80, the friction factors of the CMC solutions are lower those of the XG solutions and of the Newtonian fluids. In this range the friction factors decrease with the increase of the viscometric component of the solution and increase for increasing elastic component. The change of behavior at Dean number 80, for Newtonian and non-Newtonian fluids, is in accordance with the study of Ali [4]. There is a change of behavior at Dean number 80, for Newtonian and non-Newtonian fluids, which is in according to previous studies. The data also showed that the use of the bulk temperature or of the film temperature to calculate the physical properties of the fluid has a residual effect in the friction factor values.

Influence of grease rheology on thrust ball bearings friction torque

The friction torque and the operating temperatures in a thrust ball bearing were measured for seven different types of greases, including three biodegradable greases having low toxicity. These friction torque tests were performed using a modified Four-Ball machine. Rheological evaluations of the lubricating greases were made using a rheometer. Bleed oils were extracted from the greases and the dynamic viscosities were measured. In order to compare the performance of the lubricant greases in terms of friction, the grease characteristics were related to experimental results, showing that the interaction between thickener and base oil have strong influences in the bearing friction torque.

Fractional order inductive phenomena based on the skin effect

The Maxwell equations play a fundamental role in the electromagnetic theory and lead to models useful in physics and engineering. This formalism involves integer-order differential calculus, but the electromagnetic diffusion points towards the adoption of a fractional calculus approach. This study addresses the skin effect and develops a new method for implementing fractional-order inductive elements. Two genetic algorithms are adopted, one for the system numerical evaluation and another for the parameter identification, both with good results.

Experimental measuring procedure for the friction torque in rolling bearings

The reduction of the power loss generated in mechanical transmissions and the use of low friction biodegradable lubricants has been attracting considerable attention in recent times. Therefore, it is necessary to develop methods to test and evaluate the performance of such lubricants and compare them with conventional ones. In this sense, a Four-Ball Machine was modified allowing the test of rolling bearings. A 51107 thrust ball bearing was used to test two different greases and the corresponding base oils. Friction torque and operating temperatures were continuously monitored to quantify the power loss and the heat evacuation for each lubricant tested. Copyright © 2010 John Wiley & Sons, Ltd.

Friction and wear in thrust ball bearings lubricated with biodegradable greases

Thrust ball bearings lubricated with several different types of grease, including three biodegradable low-toxicity greases, were tested in a modified four-ball machine in order to evaluate the bearing friction torque. At the end of each test, grease samples were obtained and analysed through ferrography, allowing the quantification and evaluation of the bearing wear. In order to compare the grease performance in terms of friction and wear, a correlation between the grease characteristics (base oil, bleed oil, thickener structure, and rheological parameters) and the experimental results was established.

Emissions of nanoparticles during friction stir welding (FSW) of aluminium alloys

Friction stir welding (FSW) is now well established as a welding process capable of joining some different types of metallic materials, as it was (1) found to be a reliable and economical way of producing high quality welds, and (2) considered a "clean" welding process that does not involve fusion of metal, as is the case with other traditional welding processes. The aim of this study was to determine whether the emission of particles during FSW in the nanorange of the most commonly used aluminum (Al) alloys, AA 5083 and AA 6082, originated from the Al alloy itself due to friction of the welding tool against the item that was being welded. Another goal was to measure Al alloys in the alveolar deposited surface area during FSW. Nanoparticles dimensions were predominantly in the 40- and 70-nm range. This study demonstrated that microparticles were also emitted during FSW but due to tool wear. However, the biological relevance and toxic manifestations of these microparticles remain to be determined.

Multiple skin neoplasms in subjects under 40 years of age in Goiania, Brazil

OBJECTIVE To describe the trend for malignant skin neoplasms in subjects under 40 years of age in a region with high ultraviolet radiation indices.METHODS A descriptive epidemiological study on melanoma and nonmelanoma skin cancers that was conducted in Goiania, Midwest Brazil, with 1,688 people under 40 years of age, between 1988 and 2009. Cases were obtained fromRegistro de Câncer de Base Populacional de Goiânia(Goiania’s Population-Based Cancer File). Frequency, trends, and incidence of cases with single and multiple lesions were analyzed; transplants and genetic skin diseases were found in cases with multiple lesions.RESULTS Over the period, 1,995 skin cancer cases were observed to found, of which 1,524 (90.3%) cases had single lesions and 164 (9.7%) had multiple lesions. Regarding single lesions, incidence on men was observed to have risen from 2.4 to 3.1/100,000 inhabitants; it differed significantly for women, shifting from 2.3 to 5.3/100,000 (Annual percentage change – [APC] 3.0%, p = 0.006). Regarding multiple lesions, incidence on men was observed to have risen from 0.30 to 0.98/100,000 inhabitants; for women, it rose from 0.43 to 1.16/100,000 (APC 8.6%, p = 0.003). Genetic skin diseases or transplants were found to have been correlated with 10.0% of cases with multiple lesions – an average of 5.1 lesions per patient. The average was 2.5 in cases without that correlation.CONCLUSIONS Skin cancer on women under 40 years of age has been observed to be increasing for both cases with single and multiple lesions. It is not unusual to find multiple tumors in young people – in most cases, they are not associated with genetic skin diseases or transplants. It is necessary to avoid excessive exposure to ultraviolet radiation from childhood.

Friction torque in grease lubricated thrust ball bearings

Thrust ball bearings lubricated with several different greases were tested on a modified Four-Ball Machine, where the Four-Ball arrangement was replaced by a bearing assembly. The friction torque and operating temperatures in a thrust ball bearing were measured during the tests. At the end of each test a grease sample was analyzed through ferrographic techniques in order to quantify and evaluate bearing wear. A rolling bearing friction torque model was used and the coefficient of friction in full film lubrication was determined for each grease, depending on the operating conditions. The experimental results obtained showed that grease formulation had a very significant influence on friction torque and operating temperature. The friction torque depends on the viscosity of the grease base oil, on its nature (mineral, ester, PAO, etc.), on the coefficient of friction in full film conditions, but also on the interaction between grease thickener and base oil, which affected contact replenishment and contact starvation, and thus influenced the friction torque.

Fractional describing function of systems with nonlinear friction

This paper studies the describing function (DF) of systems consisting in a mass subjected to nonlinear friction. The friction force is composed in three components namely, the viscous, the Coulomb and the static forces. The system dynamics is analyzed in the DF perspective revealing a fractional-order behaviour. The reliability of the DF method is evaluated through the signal harmonic content and the limit cycle prediction.

Electrical skin phenomena: a fractional calculus analysis

The internal impedance of a wire is the function of the frequency. In a conductor, where the conductivity is sufficiently high, the displacement current density can be neglected. In this case, the conduction current density is given by the product of the electric field and the conductance. One of the aspects of the high-frequency effects is the skin effect (SE). The fundamental problem with SE is it attenuates the higher frequency components of a signal.

Schistosoma mansoni: importance of skin and pulmonary phases to concomitant immunity in albino mice

Fourteen-day-old schistosomula obtained from mice previously infected were surgically transferred to the portal vein of receptor mice. Another group of mice was infected with cercariae by transcutaneous route. After 90 days, those groups were challenged with 100 cercariae, transcutaneously, as well as a control group. Two weeks later the animals were perfused and mature and immature worms counted separately. Statistically significant differences were observed in the recovery of immature worms, when the control group was compared with those twice infected. No statistical difference was detected between the group infected transcutaneously, and that infected by worm inoculation in portal vein. Results demonstrated that suppression of skin and lung migration of the parasite does not interfere with the development of the so called concomitant immunity.

Fractional describing function of systems with Coulomb friction

This paper studies the describing function (DF) of systems constituted by a mass subjected to nonlinear friction. The friction force is decomposed into two components, namely, the viscous and the Coulomb friction. The system dynamics is analyzed in the DF perspective revealing a fractional-order behavior. The reliability of the DF method is evaluated through the signal harmonic contents.

Schistosoma mansoni: acquired immunity in mice after the use of oxamniquine at the evolutive skin and pulmonary phases

Mice infected with 350 cercariae of Schistosoma mansoni (LE strain) were treated with oxamniquine, at the dose of 400 mg/kg, 24, 48, 72, and 96 h after infection. Forty days after the treatment, the animals were submitted to a challenge infection with 80 cercariae, through the abdominal and ear skins. The number of immature worms in the animal groups treated 24 and 96 h after the first infection was found to be lower than that in the control group, thus showing that the death of schisto-somes by chemotherapy, at the skin and pulmonary phases, causes an acquired resistance state.

Preliminary study on the production of functionally graded materials by friction stir processing

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do grau de Mestre em Engenharia Mecânica

Effect of skin colour and selected physical characteristics on Schistosoma mansoni dependent morbidity

The effect of the colour group on the morbidity due to Schistosoma mansoni was examined in two endemic areas situated in the State of Minas Gerais, Brazil. Of the 2773 eligible inhabitants, 1971 (71.1%) participated in the study: 545 (27.6%) were classified as white, 719 (36.5%) as intermediate and 707 (35.9%) as black. For each colour group, signs and symptoms of individuals who eliminated S.mansoni eggs (cases) were compared to those who did not present eggs in the faeces (controls). The odds ratios were adjusted by age, gender, previous treatment for schistosomiasis, endemic area and quality of the household. There was no evidence of a modifier effect of colour on diarrhea, bloody faeces or abdominal pain. A modifier effect of colour on hepatomegaly was evident among those heaviest infected (> 400 epg): the adjusted odds ratios for palpable liver at the middle clavicular and the middle sternal lines were smaller among blacks (5.4 and 6.5, respectively) and higher among whites (10.6 and 12.9) and intermediates (10.4 and 10.1, respectively). These results point out the existence of some degree of protection against hepatomegaly among blacks heaviest infected in the studied areas.