Status of the coral reef ecosystems in the U.S. Caribbean and Gulf of Mexico: Florida, Flower Garden Banks, Puerto Rico, Navassa and USVI

This chapter covers coral reef areas under the jurisdiction of the USA in the Wider Caribbean: Florida; Flower Garden Banks; Puerto Rico; U.S. Virgin Islands; and Navassa. The following information is condensed from six chapters of The State of Coral Reef Ecosystems of the United States and Pacific Freely Associated States: 2008. Access to the full text of this comprehensive report is available at: http://ccma.nos.noaa.gov/stateofthereefs.

Resources of the Wadge and Pedro Banks

Sri Lanka's interest in trawler fishing dates back to 1902 when a Colombo merchant attempted to operate a trawler off Sri Lanka's waters. The next attempt was made in 1907. These attempts did not proceed any further. Between 1920 and 1923 a very comprehensive survey of the littoral waters around the island was carried out. One of the principal aims of the survey was to investigate the possibility of trawler fishing in the seas around. Malpas (1926) and Pearson and Malpas (1926) reporting the results of the survey indicated that the Wadge and Pedro banks were the only areas available for commercial trawler operations and indicated that the fish resources in the two banks could be profitably exploited. Commercial exploitation of the Wadge bank commenced in 1928 and a fishery is now firmly established in the bank. The Marine Biologist and the Director of fisheries in their administration reports and Sivalingam and Medcof (1957) and the author (1965) have reported on the progress of the Wadge bank fishery. Some of the trends indicated by an analysis of the records of the commercial trawling operations are further discussed in this paper.

The Pearl Banks inspection: April, 1970

The last major pearl fishery in the Gulf of Mannar was held in February-March, 1958, when about 4.5 million oysters were collected from the south-west Cheval Paar by dredging. (Sivalingam 1961). Subsequently, two smaller fisheries, one in 1960 and another in 1961 took place. In these two fisheries one million oysters and four hundred thousand oysters respectively were collected from the Cheval paar by dredging. (De Fonselm 1953). Inspections of the Banks were carried out in 1962, 1963, 1964 and 1965. (Balasuriya 1964 and Silva 1965 and 66). Since then inspections were not possible due to one of two reasons or both the non-availability of operational dredges and a suitable vessel for this type of work.The "Pesalai" a 235-ton stern trawler was made available by the Ceylon Fisheries Corporation management for the 1970 inspection. Two new 6-foot dredges turned out by the Government Factory were also available for this work. However, the survey was limited to 3 days-the period for which the vessel had been released. It was further limited to those areas of the banks over 6 fathoms in depth because of the risk in operating a large vessel in shallower depths.

Integrated billing mechanisms in the Internet of Things to support information sharing and enable new business opportunities

The Internet of Things (IOT) concept and enabling technologies such as RFID offer the prospect of linking the real world of physical objects with the virtual world of information technology to improve visibility and traceability information within supply chains and across the entire lifecycles of products, as well as enabling more intuitive interactions and greater automation possibilities. There is a huge potential for savings through process optimization and profit generation within the IOT, but the sharing of financial benefits across companies remains an unsolved issue. Existing approaches towards sharing of costs and benefits have failed to scale so far. The integration of payment solutions into the IOT architecture could solve this problem. We have reviewed different possible levels of integration. Multiple payment solutions have been researched. Finally we have developed a model that meets the requirements of the IOT in relation to openness and scalability. It supports both hardware-centric and software-centric approaches to integration of payment solutions with the IOT. Different requirements concerning payment solutions within the IOT have been defined and considered in the proposed model. Possible solution providers include telcos, e-payment service providers and new players such as banks and standardization bodies. The proposed model of integrating the Internet of Things with payment solutions will lower the barrier to invoicing for the more granular visibility information generated using the IOT. Thus, it has the potential to enable recovery of the necessary investments in IOT infrastructure and accelerate adoption of the IOT, especially for projects that are only viable when multiple benefits throughout the supply chain need to be accumulated in order to achieve a Return on Investment (ROI). In a long-term perspective, it may enable IT-departments to become profit centres instead of cost centres. © 2010 - IOS Press and the authors. All rights reserved.

SoC energy savings = reduce+reuse+recycle: A case study using a 660MHz DC-DC converter with integrated output filter

This paper advocates 'reduce, reuse, recycle' as a complete energy savings strategy. While reduction has been common to date, there is growing need to emphasize reuse and recycling as well. We design a DC-DC buck converter to demonstrate the 3 techniques: reduce with low-swing and zero voltage switching (ZVS), reuse with supply stacking, and recycle with regulated delivery of excess energy to the output load. The efficiency gained from these 3 techniques helps offset the loss of operating drivers at very high switching frequencies which are needed to move the output filter completely on-chip. A prototype was fabricated in 0.18μm CMOS, operates at 660MHz, and converts 2.2V to 0.75-1.0V at ∼50mA.1 © 2008 IEEE.

Species richness in a riparian plant community along the banks of the Xiangxi River, the Three Gorges region

The distribution of vascular plant species richness along an altitudinal gradient and their relationships with environmental variables, including slope, aspect, bank (flooding) height, and river width of the Xiangxi River, Hubei Province, were examined. Total vascular plant species richness changed with elevation: it increased at lower elevations, reached a maximum in the midreaches and decreased thereafter. In particular, tree and herbaceous species richness were related to altitude. Correlation analysis (Kendall's tau) between species richness and environmental variables indicated that the change in species richness in the riparian zone was determined by riparian environmental factors and characteristics of regional vegetation distribution along the altitudinal gradient. The low species richness at lower elevations resulted from seasonal flooding and human activities - agriculture and fuel collection - and the higher. Species richness ill (he midreaches reflected transitional zones ill natural vegetation types that had had little disturbance. These results oil species distribution in the riparian community could he utilized as a reference for restoration efforts to improve water quality of the emerging reservoir resulting from the Three Gorges Hydroelectric Dam project.

Bottom-up modelling of energy demand and technical energy savings potential in the Irish residential sector

The International Energy Agency has repeatedly identified increased end-use energy efficiency as the quickest, least costly method of green house gas mitigation, most recently in the 2012 World Energy Outlook, and urges all governing bodies to increase efforts to promote energy efficiency policies and technologies. The residential sector is recognised as a major potential source of cost effective energy efficiency gains. Within the EU this relative importance can be seen from a review of the National Energy Efficiency Action Plans (NEEAP) submitted by member states, which in all cases place a large emphasis on the residential sector. This is particularly true for Ireland whose residential sector has historically had higher energy consumption and CO2 emissions than the EU average and whose first NEEAP targeted 44% of the energy savings to be achieved in 2020 from this sector. This thesis develops a bottom-up engineering archetype modelling approach to analyse the Irish residential sector and to estimate the technical energy savings potential of a number of policy measures. First, a model of space and water heating energy demand for new dwellings is built and used to estimate the technical energy savings potential due to the introduction of the 2008 and 2010 changes to part L of the building regulations governing energy efficiency in new dwellings. Next, the author makes use of a valuable new dataset of Building Energy Rating (BER) survey results to first characterise the highly heterogeneous stock of existing dwellings, and then to estimate the technical energy savings potential of an ambitious national retrofit programme targeting up to 1 million residential dwellings. This thesis also presents work carried out by the author as part of a collaboration to produce a bottom-up, multi-sector LEAP model for Ireland. Overall this work highlights the challenges faced in successfully implementing both sets of policy measures. It points to the wide potential range of final savings possible from particular policy measures and the resulting high degree of uncertainty as to whether particular targets will be met and identifies the key factors on which the success of these policies will depend. It makes recommendations on further modelling work and on the improvements necessary in the data available to researchers and policy makers alike in order to develop increasingly sophisticated residential energy demand models and better inform policy.