Nesting and use of pollen resources by Tetrapedia diversipes Klug (Apidae) in Atlantic Forest areas (Rio de Janeiro, Brazil) in different stages of regeneration

Nesting and use of pollen resources by Tetrapedia diversipes Klug (Apidae) in Atlantic Forest areas (Rio de Janeiro, Brazil) in different stages of regeneration. The nesting in trap-nests and use of pollen sources in larval food by Tetrapedia diversipes Klug, 1810 (Apidae) was compared between regenerating areas of Atlantic Forest. The study was conducted between April 2008 and October 2009 at União Biological Reserve, Rio de Janeiro, Brazil. T. diversipes nested in 66 trap-nests and showed a peak of nesting during the months of highest rainfall. The most frequent pollen type in brood cells during the wet season was Dalechampia sp. 1. During the dry season, the type Ludwigia sp. was the most frequent, followed by Dalechampia sp. 2. The high frequency of Dalechampia and Ludwigia species in the larval food, observed in both habitats and in the two seasons could be considered relevant for T. diversipes, suggesting highly selective diet based primarily on two plant species unrelated, but similar in size of pollen grains.

Increase of grain and green matter of corn by liming

Despite the fact that aluminum toxicity to crops is eliminated near soil water pH of 5.5, lime recommendation in many regions aims to increase soil pH up to 6.0 or even higher. For highly buffered soils, high rates of limestone are required to raise the pH from 5.5 to 6.0, resulting in additional, sometimes unnecessary, costs. The objective of this study was to evaluate the effect of soil pH on corn yield in a very acid Hapludox. The experiment was carried out in Lages, Southern Brazil, from 1992 to 1996. The soil had water pH of 4.7, Al3+ of 33 mmol c kg-1, O.M. of 45 g kg-1 and lime requirement to pH 6.0 of 9.0 t ha-1. Dolomitic limestone at rates of 0, 4.5, 9.0, 13.5 and 18.0 t ha-1 (equivalent to pure CaCO3) was incorporated into the soil down to 17 cm depth, in 1992. Liming increased linearly the values of soil pH (from 4.7 to 6.6) and Ca and Mg, eliminated Al3+ with rates of 9.0 t ha-1 or higher, decreased slightly Al-CuCl2, Fe and Cu, and did not affect Zn and Mn. Maximum average corn yield for grain (7.9 t ha-1) and for green matter for silage (GM) (59 t ha-1) was obtained, respectively, at soil pH of 6.0 (12 t ha-1 of limestone) and of 6.1 (14 t ha-1 of limestone); maximum economic efficiency for grain was obtained at pH 5.6 (7.5 t ha-1 of limestone). Maximum yield increments due to liming were 17% for grain and 20% for GM.

Quantitative analysis of crystal/grain sizes and their distributions in 2D and 3D

We review methods to estimate the average crystal (grain) size and the crystal (grain) size distribution in solid rocks. Average grain sizes often provide the base for stress estimates or rheological calculations requiring the quantification of grain sizes in a rock's microstructure. The primary data for grain size data are either 1D (i.e. line intercept methods), 2D (area analysis) or 3D (e.g., computed tomography, serial sectioning). These data have been used for different data treatments over the years, whereas several studies assume a certain probability function (e.g., logarithm, square root) to calculate statistical parameters as the mean, median, mode or the skewness of a crystal size distribution. The finally calculated average grain sizes have to be compatible between the different grain size estimation approaches in order to be properly applied, for example, in paleo-piezometers or grain size sensitive flow laws. Such compatibility is tested for different data treatments using one- and two-dimensional measurements. We propose an empirical conversion matrix for different datasets. These conversion factors provide the option to make different datasets compatible with each other, although the primary calculations were obtained in different ways. In order to present an average grain size, we propose to use the area-weighted and volume-weighted mean in the case of unimodal grain size distributions, respectively, for 2D and 3D measurements. The shape of the crystal size distribution is important for studies of nucleation and growth of minerals. The shape of the crystal size distribution of garnet populations is compared between different 2D and 3D measurements, which are serial sectioning and computed tomography. The comparison of different direct measured 3D data; stereological data and direct presented 20 data show the problems of the quality of the smallest grain sizes and the overestimation of small grain sizes in stereological tools, depending on the type of CSD. (C) 2011 Published by Elsevier Ltd.

Iowa Grain Facilities Map, July 1, 2009

Iowa Grain Facilities Map

Iowa Grain Facilities Map, July 1, 2010

Iowa Grain Facilities Map

Respiratory effects of an exposure to grain dust among grain workers in the Vaud region (Switzerland)

Introduction: Bioaerosols such as grain dust, via biologically active agents, elicit local inflammation and direct immunological reactions within the human respiratory system. Workplace-dependent exposure to grain dust (GD) may thus induce asthma, chronic bronchitis, and hypersensitivity pneumonitis. The aim of this study is to assess the clinical impact of occupational exposure to GD and to determine quantitative biological markers of bioaerosol exposure in grain workers. Methods: This longitudinal study has been conducted from summer 2012, to summer 2013, comprising 6 groups of 30 active workers with different GD exposure patterns (4 groups of grain workers, 2 control groups). After obtaining informed consent, two evaluations at high- and low-exposing seasons take place, during which an occupational history and a detailed medical history are questionnaire-assessed, lung function is evaluated by spirometry, airway inflammation is measured by exhaled nitric oxide (eNO), and specific blood IgG and IgE are titrated. The preliminary results presented hereafter are those of two of the four exposed groups, namely harvesters and mill workers, compared to the control groups, at first assessment (n=100). Results: Mean age is 38.4 [years]; 98% are male. Exposed groups differ from controls (p<0.05) in daily contact with animals (57% vs. 40%) and active smoking (39% vs. 11%). Grain workers have more respiratory (50%), nasal (57%), ocular (45%), dermatologic (36%) and systemic (20%) occupational symptoms than controls (6.4%, 19%, 16%, 6.4%, 1.6% respectively, p<0.05). Lower mean peak-expiratory-flow (PEF) values (96.1 ± 18.9 vs. 108.2 ± 17.4 [% of predicted], p<0.05) and eNO values (13.9 ± 9.6 vs. 20.5 ± 14.7 [ppm], p<0.05) are observed in the exposed groups. Conclusion: Preliminary results show a higher prevalence of clinical symptoms and a lower mean PEF value in the exposed groups. Detailed supplementary analyses are pending.

Relationships between grain yield and accumulation of biomass, nitrogen and phosphorus in common bean cultivars

Shoot biomass is considered a relevant component for crop yield, but relationships between biological productivity and grain yield in legume crops are usually difficult to establish. Two field experiments were carried out to investigate the relationships between grain yield, biomass production and N and P accumulation at reproductive stages of common bean (Phaseolus vulgaris) cultivars. Nine and 18 cultivars were grown on 16 m² plots in 1998 and 1999, respectively, with four replications. Crop biomass was sampled at four growth stages (flowering R6, pod setting R7, beginning of pod filling R8, and mid-pod filling R8.5), grain yield was measured at maturity, and N and P concentrations were determined in plant tissues. In both years, bean cultivars differed in grain yield, in root mass at R6 and R7 stages, and in shoot mass at R6 and R8.5, whereas at R7 and R8 differences in shoot mass were significant in 1998 only. In both years, grain yield did not correlate with shoot mass at R6 and R7 and with root mass at R6. Grain yield correlated with shoot mass at R8 in 1999 but not in 1998, with shoot mass at R8.5 and with root mass at R7 in both years. Path coefficient analysis indicated that shoot mass at R8.5 had a direct effect on grain yield in both years, that root mass at R7 had a direct effect on grain yield in 1998, and that in 1999 the amounts of N and P in shoots at R8.5 had indirect effects on grain yield via shoot mass at R8.5. A combined analysis of both experiments revealed that biomass accumulation, N and P in shoots at R6 and R7 as well as root mass at R6 were similar in both years. In 1998 however bean accumulated more root mass at R7 and more biomass and N and P in shoots at R8 and R8.5, resulting in a 57 % higher grain yield in 1998. This indicates that grain yield of different common bean cultivars is not intrinsically associated with vegetative vigor at flowering and that mechanisms during pod filling can strongly influence the final crop yield. The establishment of a profuse root system during pod setting, associated with the continuous N and P acquisition during early pod filling, seems to be relevant for higher grain yields of common bean.

Grain yield, net blotch and scald of barley in Finnish official variety trials

Selostus: Ohrasato ja verkko- ja rengaslaikku virallisissa lajikekokeissa

Influence of fungicide seed treatment on soybean nodulation and grain yield

Biological N2 fixation is a major factor contributing to the increased competitiveness of Brazilian soybeans on the international market. However, the contribution of this process may be limited by adverse conditions to symbiotic bacteria, such as fungicide seed treatments. This study aimed to evaluate the effects of the fungicides carbendazim + thiram and carboxin + thiram on soybean nodulation, plant growth and grain yield. Two field experiments were carried out in the Cerrado region of the State of Roraima, in a soil with a low organic matter content and no soybean bradyrhizobia. In 2005, seeds were treated with fungicide carbendazim + thiram and commercial inoculants containing the Bradyrhizobium elkanii strains SEMIA 5019 and SEMIA 587 and B. japonicum strains SEMIA 5079 and SEMIA 5080. In 2006, soybean seeds were treated with the fungicides carbendazim + thiram or carboxin + thiram and inoculated separately with each one of the four strains. The plants were evaluated for number of nodules and dry weight, shoot dry weight and total N accumulated in shoots 35 days after plant emergence, while grain yield and N grain content were determined at harvest. Both fungicides reduced soybean nodulation, especially in the presence of B. elkanii strains. The fungicide carbendazim + thiram reduced nodulation by about 50 % and grain yield by more than 20 % (about 700 kg ha-1), in the treatment inoculated with of strain SEMIA 587.

Germinability of Norway spruce and scots pine pollen exposed to open air

Summary

Strategy of specification of management areas: rice grain yield as related to soil fertility

It is well-known nowadays that soil variability can influence crop yields. Therefore, to determine specific areas of soil management, we studied the Pearson and spatial correlations of rice grain yield with organic matter content and pH of an Oxisol (Typic Acrustox) under no- tillage, in the 2009/10 growing season, in Selvíria, State of Mato Grosso do Sul, in the Brazilian Cerrado (longitude 51º24' 21'' W, latitude 20º20' 56'' S). The upland rice cultivar IAC 202 was used as test plant. A geostatistical grid was installed for soil and plant data collection, with 120 sampling points in an area of 3.0 ha with a homogeneous slope of 0.055 m m-1. The properties rice grain yield and organic matter content, pH and potential acidity and aluminum content were analyzed in the 0-0.10 and 0.10-0.20 m soil layers. Spatially, two specific areas of agricultural land management were discriminated, differing in the value of organic matter and rice grain yield, respectively with fertilization at variable rates in the second zone, a substantial increase in agricultural productivity can be obtained. The organic matter content was confirmed as a good indicator of soil quality, when spatially correlated with rice grain yield.

Graphoepitaxy of CeO2 on MgO and its application to the fabrication of 45° grain boundary Josephson junctions of YBa2Cu3O7-x

We communicate a detailed study of the epitaxial growth of CeO2 on MgO. The key feature of the growth is the dependence of the in¿plane orientation of the CeO2 epitaxial layer on the MgO surface morphology. Atomic force microscopic (AFM) measurements, x¿ray analyses, as well as high¿resolution transmission electron microscopy (HRTEM) investigations reveal that on rough substrates a cube¿on¿cube growth of CeO2 on MgO occurs while on smooth substrates the CeO2 unit cell is rotated around the surface normal by 45° with respect to the MgO unit cell when the deposition rate is low (~0.3 Å/s) during the first stages of growth. This growth mechanism can be used for a defined fabrication of 45° grain boundaries in the CeO2 layer by controlling the surface roughness of the MgO substrate. This report demonstrates that these 45° grain boundaries may be used to fabricate YBa2Cu3O7¿x Josephson junctions.

Feeding whole grain with pelleted diets to growing broiler chickens

Selostus: Kokojyväviljan syöttäminen broilereille rakeisen rehun seassa