Oxygen plasma treatment of sisal fibers and polypropylene: Effects on mechanical properties of composites

Polypropylene powder and sisal fibers were oxygen plasma treated, and the mechanical properties of their composites were tested. Two main effects were investigated: the incorporation of oxygen polar groups in the polypropylene surface and the surface degradation and chain scission of both polypropylene and sisal fibers. Prior to these treatments, three reactor configurations were tested to investigate the best condition for both effects to occur in PP film. Results showed that polypropylene-cellulose adhesion forces are about an order of magnitude higher for PP film treatments at 13.56 MHz than at 40 kHz owing to much higher chain scission at lower frequencies, although it probably also occurs at high frequency and high power. Polypropylene powder treated with oxygen plasma in optimum conditions for polar group incorporation did not result in improvement in any composite mechanical property, probably owing to the polymer melting. Sisal fibers and PP powder treated In conditions of surface degradation did not improve flexural or tensile properties but resulted in higher impact resistance, comparable to the improvement obtained with the addition of compatibilizer.

Morphological, mechanical properties and biodegradability of biocomposite thermoplastic starch and polycaprolactone reinforced with sisal fibers

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Degradabilidade ruminai da fibra em detergente neutro e do nitrogênio insolúvel em detergente neutro da silagem de milho e do farelo de soja, em bovinos da raça nelore

The nylon bag in situ degradation thecnique was employed to study the ruminai degradability of the neutral detergent fiber and neutral detergent insoluble nitrogen of the corn silage and soybean meal in four rumen fistulated Nellore steers, averaging 36 months of age and 520 kg of liveweight. A randomized completelcs block experimental design was used, where the animals constituted the blocks. It was used diets with two levels of concentrate: 20 and 40%.The forage used in the diets was corn silage, and the concentrate ingredients were: soybean meal, cottonseed meal, corn grain and sorghum grain. The NIDN degradation rate of the corn silage and the soybean meal showed a decrease of 32,1% and of 46,0 % as a function of the higher concentrate level of the diet, but the effective and potential degradability of this fraction were not affected. Concerning to the NDF, the soluble fraction, potentially degradable and undegrable , were not affected by the increase on the diet concentrate level, but for the corn silage, there were 21,8% of reduction on the effective degradability of NDF. The use of lag time promoted higher degradability values for the studied fraction. The obtained values for some evaluated parameters, different from that assumed by CNCPS, showed the necessity of more data about brazilian used feeds, for model adjustments.

Digestibilidade e tempo de trânsito gastrintestinal de dietas contendo níveis crescentes de fibra bruta para pacu

This work aimed to evaluate the effect of increasing dietary fiber levels on the digestibility and gastrointestinal transit time (GTT) for pacu. The digestibility trial used 288 pacu in a completely randomized design, fed in aquaria and transferred to a modified Guelf-type feces collector, using the partial sampling method. The inert marker on the diets was chromic oxide (1%) to establish the diet digestibility. In the GTT assay, 288 pacu were distributed in 24 aquaria in a completely randomized design. Fish were fed with two colored diets - green and white - and feces color was determined after abdominal pressure. The white and green diets used 1% of titanium and chromic oxides, respectively. Total GTT was determined when all fish showed green feces. The apparent digestibility coefficients and GTT of diets decreased as dietary fiber levels increased. These results indicated that 9% dietary fiber can be used in pacu diets without negative effects on energy, protein, crude fiber and ether extract digestibility and GTT.

Influência de diferentes sistemas adesivos na resistência de união de pinos de fibra à dentina intrarradicular

Objective: To evaluate the influence of three adhesive systems on the bond strength of fiber post luted to root dentine. The hypothesis was that the bond strength is influenced by the adhesive system. Method: The canals of thirty single-root bovine roots (16mm in length) were prepared using the preparation drill (FGM) until 12mm. 14 mm of each root was embedded with acrylic resin and the specimens were allocated into three groups (n=10), considering the factor adhesive (3 levels): Gr1- Scotchbond Multipurpose Plus (3M ESPE), Gr2- One Step (Bisco) and Gr3- Excite DSC (Ivoclar Vivadent). The adhesive systems were applied using a microbrush, according to the manufacture's recommendations. The fiber posts (White Post DC, FGM) were luted with dual resin cement (All-Cem,FGM). After, the cores with composite resin (Llis, FGM) were made and each set of root/post/core was submitted to the mechanical cycling (Erios, Brazil) (10 6 cycles, 84N, 4 Hz, inclination of 45 o, 37 oC, water). Each specimen was cut in 4 samples (1.8mm in thickness), which were submitted to the push-out test in a universal testing machine (ServoPulser - Shimadzu) (50Kgf, 1mm/min). The data (MPa) were analyzed using ANOVA (1-way) and Tukey test (5%). Results: The factor adhesive (P=0.00352) influenced the bond strength significantly (ANOVA). Gr1 (6.8±3.8 MPa) a presented higher bond strength values than Gr2 (3.1±1.5 MPa) b and similar to Gr3 (4.4±3.3) a,b. Moreover, Gr3 and Gr2 were similar between them (Tukey). The hypothesis was accepted. Conclusion: Based on the results it was concluded that chemical and dual polymerization adhesive system should be used for the adhesive luting fiber post procedures.

Consumo, digestibilidade aparente e balanço de nitrogênio em ovelhas alimentadas com diferentes níveis de fibra em detergente neutro

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

La exportación de productos básicos desde América Latina: el caso de la fibra de algodón

Incluye Bibliografía

Sensor em fibra óptica aplicado à caracterização de atuadores piezoelétricos flextensionais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Emprego de fibra de cana-de-açúcar na alimentação de cães

Pós-graduação em Medicina Veterinária - FCAV

Efeito da fibra solúvel e insolúvel e do teor de proteína sobre a saciedade e respostas hormonais em gatos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeito da ingestão de amido, fibra e energia na resposta glicêmica pós-prandial e saciedade em cães

Pós-graduação em Medicina Veterinária - FCAV

Examen preliminar de las posibilidades de producción de filamento continuo y de fibra corta de rayón en Centroamérica

Incluye Bibliografía

Producción de filamento continuo y de fibra corta de rayón

Incluye Bibliografía

Influência do sistema de cimentação adesiva e da fonte de luz fotoativadora na resistência à extrusão de pinos de fibra de vidro

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito do pré-tratamento da dentina radicular com clorexidina e etanol na retenção de pinos de fibra de vidro cimentados com cimento resinoso

Pós-graduação em Ciências Odontológicas - FOAR