Fate of urea nitrogen applied to a banana crop in the wet tropics of Queensland

This paper reports a study in the wet tropics of Queensland on the fate of urea applied to a dry or wet soil surface under banana plants. The transformations of urea were followed in cylindrical microplots (10.3 cm diameter x 23 cm long), a nitrogen (N) balance was conducted in macroplots (3.85 m x 2.0 m) with N-15 labelled urea, and ammonia volatilization was determined with a mass balance micrometeorological method. Most of the urea was hydrolysed within 4 days irrespective of whether the urea was applied onto dry or wet soil. The nitrification rate was slow at the beginning when the soil was dry, but increased greatly after small amounts of rain; in the 9 days after rain 20% of the N applied was converted to nitrate. In the 40 days between urea application and harvesting, the macroplots the banana plants absorbed only 15% of the applied N; at harvest the largest amounts were found in the leaves (3.4%), pseudostem (3.3%) and fruit (2.8%). Only 1% of the applied N was present in the roots. Sixty percent of the applied N was recovered in the soil and 25% was lost from the plant-soil system by either ammonia volatilization, leaching or denitrification. Direct measurements of ammonia volatilization showed that when urea was applied to dry soil, and only small amounts of rain were received, little ammonia was lost (3.2% of applied N). In contrast, when urea was applied onto wet soil, urea hydrolysis occurred immediately, ammonia was volatilized on day zero, and 17.2% of the applied N was lost by the ninth day after that application. In the latter study, although rain fell every day, the extensive canopy of banana plants reduced the rainfall reaching the fertilized area under the bananas to less than half. Thus even though 90 mm of rain fell during the volatilization study, the fertilized area did not receive sufficient water to wash the urea into the soil and prevent ammonia loss. Losses by leaching and denitrification combined amounted to 5% of the applied N.

Efficient simulation of a Tandem Jackson Network

The two-node tandem Jackson network serves as a convenient reference model for the analysis and testing of different methodologies and techniques in rare event simulation. In this paper we consider a new approach to efficiently estimate the probability that the content of the second buffer exceeds some high level L before it becomes empty, starting from a given state. The approach is based on a Markov additive process representation of the buffer processes, leading to an exponential change of measure to be used in an importance sampling procedure. Unlike changes of measures proposed and studied in recent literature, the one derived here is a function of the content of the first buffer. We prove that when the first buffer is finite, this method yields asymptotically efficient simulation for any set of arrival and service rates. In fact, the relative error is bounded independent of the level L; a new result which is not established for any other known method. When the first buffer is infinite, we propose a natural extension of the exponential change of measure for the finite buffer case. In this case, the relative error is shown to be bounded (independent of L) only when the second server is the bottleneck; a result which is known to hold for some other methods derived through large deviations analysis. When the first server is the bottleneck, experimental results using our method seem to suggest that the relative error is bounded linearly in L.

Simulation of interface states effect on the scanning capacitance microscopy measurement of p-n junctions

A two-dimensional numerical simulation model of interface states in scanning capacitance microscopy (SCM) measurements of p-n junctions is presented-In the model, amphoteric interface states with two transition energies in the Si band gap are represented as fixed charges to account for their behavior in SCM measurements. The interface states are shown to cause a stretch-out-and a parallel shift of the capacitance-voltage characteristics in the depletion. and neutral regions of p-n junctions, respectively. This explains the discrepancy between - the SCM measurement and simulation near p-n junctions, and thus modeling interface states is crucial for SCM dopant profiling of p-n junctions. (C) 2002 American Institute of Physics.

On the importance function in splitting simulation

The splitting method is a simulation technique for the estimation of very small probabilities. In this technique, the sample paths are split into multiple copies, at various stages in the simulation. Of vital importance to the efficiency of the method is the Importance Function (IF). This function governs the placement of the thresholds or surfaces at which the paths are split. We derive a characterisation of the optimal IF and show that for multi-dimensional models the natural choice for the IF is usually not optimal. We also show how nearly optimal splitting surfaces can be derived or simulated using reverse time analysis. Our numerical experiments illustrate that by using the optimal IF, one can obtain a significant improvement in simulation efficiency.

Ethephon promotion of crop abscission for unshaken and mechanically shaken macadamia

Promotion of fruit abscission in macadamia, Macadamia integrifolia (Proteaceae), has potential to reduce costs associated with prolonged harvesting of late-abscising cultivars. Effects of ethephon [(2-chloroethyl) phosphonic acid] on fruit removal force and crop abscission were monitored at 3 stages of the harvest season on both unshaken and mechanically shaken trees of the late-abscising macadamia cultivar A16. Ethephon application, tree shaking, or a combination of the 2 methods, accelerated crop removal from the tree at all stages during harvest. Early harvest before natural abscission resulted in little or no difference in nut-in-shell and kernel weight, kernel recovery and kernel oil content. Delaying ethephon application or tree shaking until commencement of natural abscission resulted in greater crop removal. Fruit removal force declined naturally towards 1 kgf at this stage, and was further reduced by ethephon application. The most effective approach for harvest acceleration was to reduce fruit removal force, before tree shaking, by spraying trees with ethephon.

Establishment of Nilaparvata Iugens Stl in rice crop nurseries: a possible source of outbreaks

We tested the hypothesis that early-planted seedbeds of rioe are mere heavily infested with brown planthopper (BPH) than later seedbeds, and that transplanted plants with lBPH are a source of subsequent population increase and possible outbreaks. The experiments were conducted at CARDI and Takeo province in wet season 2000 and early wet 2 season 200 I. BPH at O. 25. 50, 100, 200 1m were infested onto plants with low and high fertilizer treatments. Rice seeds of varieties moderately and highly susceptible to BPH were sown 3 weeks early, 2 weeks early, at the normal time, and later than normal (5 weeks) and treated with low and high fertilizer rates. At Takeo, the 3< weeks early seedbeds were infested by BPH migration, and both varieties with high fertilizer caught more immigrant insects and subsequently had damaging outbreaks of BPH in the third generation. At CARDl, no seedbeds were infested with immigrant BPH. Seedbeds in areas with continuous cropping of rice have a high risk of BPH attack, Seedlings infested with 200, 100, and 50 BPI[/m2 resulted in death of the plant. Plants with 100 and 200 BPH/m'! were kj[Jed sooner. With 25 BPIVm2 plants were not kllled, but subsequent population increase caused yi eld reduction. Yield loss was high ill higlh fertilizer treated plants. Key words , ,

Benchmarking nitrogen removal suspended-carrier biofilm systems using dynamic simulation

We are witnessing an enormous growth in biological nitrogen removal from wastewater. It presents specific challenges beyond traditional COD (carbon) removal. A possibility for optimised process design is the use of biomass-supporting media. In this paper, attached growth processes (AGP) are evaluated using dynamic simulations. The advantages of these systems that were qualitatively described elsewhere, are validated quantitatively based on a simulation benchmark for activated sludge treatment systems. This simulation benchmark is extended with a biofilm model that allows for fast and accurate simulation of the conversion of different substrates in a biofilm. The economic feasibility of this system is evaluated using the data generated with the benchmark simulations. Capital savings due to volume reduction and reduced sludge production are weighed out against increased aeration costs. In this evaluation, effluent quality is integrated as well.

Dopant extraction from scanning capacitance microscopy measurements of p-n junctions using combined inverse modeling and forward simulation

This article proposes a more accurate approach to dopant extraction using combined inverse modeling and forward simulation of scanning capacitance microscopy (SCM) measurements on p-n junctions. The approach takes into account the essential physics of minority carrier response to the SCM probe tip in the presence of lateral electric fields due to a p-n junction. The effects of oxide fixed charge and interface state densities in the grown oxide layer on the p-n junction samples were considered in the proposed method. The extracted metallurgical and electrical junctions were compared to the apparent electrical junction obtained from SCM measurements. (C) 2002 American Institute of Physics.

Simulation of Oxford University Gun Tunnel performance using a quasi-one-dimensional model

The performance of the Oxford University Gun Tunnel has been estimated using a quasi-one-dimensional simulation of the facility gas dynamics. The modelling of the actual facility area variations so as to adequately simulate both shock reflection and flow discharge processes has been considered in some detail. Test gas stagnation pressure and temperature histories are compared with measurements at two different operating conditions - one with nitrogen and the other with carbon dioxide as the test gas. It is demonstrated that both the simulated pressures and temperatures are typically within 3% of the experimental measurements.

Universal quantum computation and simulation using any entangling Hamiltonian and local unitaries

What interactions are sufficient to simulate arbitrary quantum dynamics in a composite quantum system? We provide an efficient algorithm to simulate any desired two-body Hamiltonian evolution using any fixed two-body entangling n-qubit Hamiltonian and local unitary operations. It follows that universal quantum computation can be performed using any entangling interaction and local unitary operations.

Universal simulation of Hamiltonian dynamics for quantum systems with finite-dimensional state spaces

What interactions are sufficient to simulate arbitrary quantum dynamics in a composite quantum system? Dodd [Phys. Rev. A 65, 040301(R) (2002)] provided a partial solution to this problem in the form of an efficient algorithm to simulate any desired two-body Hamiltonian evolution using any fixed two-body entangling N-qubit Hamiltonian, and local unitaries. We extend this result to the case where the component systems are qudits, that is, have D dimensions. As a consequence we explain how universal quantum computation can be performed with any fixed two-body entangling N-qudit Hamiltonian, and local unitaries.

Pea mania: deranged behaviour in cattle grazing a pea crop (Pisum sativum var arvense)

Hypersensitivity to external stimuli, progressing in some animals to manic behaviour, occurred in a cattle herd that grazed a crop of field peas (Pisum sativum var arvense) in the pre-flowering stage. Haematological and biochemical analyses eliminated hypomagnesaemia and ketosis as diagnoses. Other than two steers euthanased due to injuries sustained during manic episodes, all affected animals survived, recovering over 3 days when moved to alternative pasture. No necropsies were conducted. No microbial pathogens or endophytes were found on or in the plants. A previously reported incident in Victoria in 1987 in cattle grazing peas appeared to be of a similar nature. Environmental factors leading to these incidents were not clearly identified.

Simulation of insect movement with respect to plant architecture and morphogenesis

Developments in computer and three dimensional (3D) digitiser technologies have made it possible to keep track of the broad range of data required to simulate an insect moving around or over the highly heterogeneous habitat of a plant's surface. Properties of plant parts vary within a complex canopy architecture, and insect damage can induce further changes that affect an animal's movements, development and likelihood of survival. Models of plant architectural development based on Lindenmayer systems (L-systems) serve as dynamic platforms for simulation of insect movement, providing ail explicit model of the developing 3D structure of a plant as well as allowing physiological processes associated with plant growth and responses to damage to be described and Simulated. Simple examples of the use of the L-system formalism to model insect movement, operating Lit different spatial scales-from insects foraging on an individual plant to insects flying around plants in a field-are presented. Such models can be used to explore questions about the consequences of changes in environmental architecture and configuration on host finding, exploitation and its population consequences. In effect this model is a 'virtual ecosystem' laboratory to address local as well as landscape-level questions pertinent to plant-insect interactions, taking plant architecture into account. (C) 2002 Elsevier Science B.V. All rights reserved.