Preparation and characterization of palladium-based composite membranes by electroless plating and magnetron sputtering

Pd and Pd-Ag (24 wt.%) alloy composite membrane were prepared by electroless plating and magnetron sputtering, respectively. The membranes were characterized by scanning electron microscopy (SEM) and H-2 permeation measurement. Commercial microfiltration ceramic membrane were coated with gamma-Al2O3-based layer by the sol-gel method and used as substrate of Pd and Pd-Ag alloy film. Both the as-prepared membranes were shown: to be He gas-tight at room temperature with a thickness of <1 mu m. Permeation results showed that H-2 permeation through these composite membranes is mainly dominated by the surface chemistry of H-2 on or/and in the membranes. The membranes exhibited a high permeation rate of H-2 and a H-2/N-2 permselectivity of higher than 60 in the optimized operation conditions. (C) 2000 Elsevier Science B.V. All rights reserved.

Enhancement of boron removal in treatment of spent rinse from a plating operation using RO

Boron removal is a critical issue in the production of drinking water and of ultra-pure water in the electronics industry. Boron rejection in a RO process is typically in the range of 40-60%. The objective of this study was to distinguish the factor contributing to enhanced boron rejection in reclamation of a spent rinse stream from a plating operation. The effects of different known components used in the feed on boron removal were investigated in the laboratory. The results indicated that glycolic acid and antifoulants could not individually enhance boron rejection in a RO process. A high boron rejection of 95% was achieved as the concentration of iron in the feed was 10 times higher than that of boron, which might be due to formation of a complex between iron oxide and boron. The finding was confirmed in a pilot study.

Hormesis - Stimulation Of Colony Growth In Campanularia-Flexuosa (Hydrozoa) By Copper Cadmium And Other Toxicants

It is shown experimentally that subinhibitory concentrations of a number of toxic, or other agents that are typically inhibitory (copper, cadmium, tributyl tin fluoride, reduced salinity), may stimulate the growth of colonies of the hydroid Campanularia flexuosa, exhibiting a phenomenon known as hormesis. It is suggested that the stimulation of growth is not due to the specific properties of the different toxicants, but to an adaptive response of the hydroid to the inhibitory effect that they have in common. Growth is regulated by a control mechanism and it is proposed that the increased growth is a consequence of overcorrections to low levels of an inhibitory challenge. Examination of the toxicological literature shows that hormesis is a more common occurrence that is generally supposed, and it is suggested that the explanation given here might apply in other cases of hormesis.

Simulating The Impact Of Technological-Change On Dissolved Cadmium Distribution In The Severn Estuary

An estuarine model is described which computes the dispersive and advective properties of the Severn Estuary. It was calibrated and validated using 50 measured salinity distributions and then used to predict the magnitude and sitings of the major inputs of dissolved cadmium levels throughout the estuary. The results provided an impetus for implementing tighter controls on effluents and for improving estimates of cadmium discharges from industrial sources. The model has also been used to investigate the sensitivity of the estuarine system to changes in dispersion; by considering large reductions in the dispersion coefficients it is hoped that the results might be indicative of the environmental consequences following the construction of a tidal power generating scheme.