膦酸酯稀土催化体系高顺－1，4－聚丁二烯橡胶的充油效应及充油橡胶的性能

以芳烃含量约３８％的油品作填充油，对用膦酸酯（２－乙基己基膦酸单２－乙基己酯）稀土催化体系合成的高顺－１，４－聚丁二烯橡胶的充油效应及充油橡胶的性能进行了研究。结果表明，随着充油量的增加，充油生胶的可塑性增大，混炼行为和流动性得以改善，而屈服强度、拉伸强度和扯断伸长率均下降；充油硫化胶的３００％定伸应力、硬度、撕裂强度、回弹性、生热和磨耗等均降低，永久变形与抗湿滑性增加，拉伸强度大约在充油量为７０份时出现极大值。综合考虑，充油量以６０～７０份为宜。

镧系金属化合物催化苯乙烯和双烯烃的共聚──苯乙烯和异戊二烯共聚合制备高顺式－1，4嵌段共聚物

采用稀土催化体系Ｎｄ（Ｆ_３ＣＯ_２）_３－ＢｒＣ_５Ｈ_（１１）－Ｒ_ｍＡｌＨ_（３－ｍ）（Ｎｄ－Ｂｒ－Ａｌ），以甲苯为溶剂，在５０℃恒温水浴中进行苯乙烯（Ｓｔ）和异戊二烯（Ｉｐ）共聚合。结果表明，由Ａｌ（Ｏｃｔ）－３组成的催化体系可制备以顺式－１，４结构为主的共聚物；在后者组成的催化体系中，当Ａｌ／Ｎｄ＝５（摩尔比，下同），Ｂｒ／Ｎｄ＝５时，聚合活性最高。经ＩＲ，ＮＭＲ检测表征了共聚物的微观结构。同时，用π－烯丙基型配位机理和返扣配位机理对实验结果进行了定性解释。

异丙基膦酸单（1－已基－4－乙基）辛酯从硫酸介质中萃取分离钪、铁和镥

报道了异丙基膦酸单（１一已基一４一乙基）辛酯（ＰＴ一２）的正庚烷溶液在硫酸介质中对Ｓｃ３＋、Ｆｅ３＋、Ｌｕ３＋萃取平衡的影响，结果表明，通过控制酸度可以使三种元素分高。确定了Ｓｃ３＋的萃取机理，低酸度下为阳离子交换反应，高酸度下为溶剂化反应，中等酸度下两种反应并存。研究了饱和萃合物的ＩＲ、ＮＭＲ谱。讨论了温度对萃取平衡的影响，低酸度和高酸度下均为放热反应。

环化顺1,4丁二烯异戊二烯无规共聚物的表征

已知,聚异戊二烯或聚丁二烯等1,3-双烯聚合物可在路易斯酸催化剂作用下按阳离子型机理进行分子内环化反应,所得“环化橡胶”,做为可光敏固化的新材料,在光刻胶、光保护膜、胶粘剂等方面得到广泛应用。文献还表明,环化顺1,4聚双烯产物比环化其它结构的聚双烯产物具更好的使用性能。鉴于合成高分子材料中共聚物往往较均聚物呈现

有机磷化合物的质谱研究 Ⅹ.1,2-二苯基-3,3-二烷基-2,5-二氧-1,4,2-二氮磷杂环戊烷的EI质谱研究

应用EI质谱和联动扫描技术研究了13个有机磷杂环化合物,讨论了主要离子的形成过程,分子离子在EI条件下的各种重排反应和取代基对不同解离反应产物离子相对强度的影响。

裂解色谱法研究环化顺-1,4-丁二烯-异戊二烯无规共聚物

如同顺-1,4-聚丁二烯(PBd)和聚异戊二烯(PIP),在一定的催化条件下,顺-1,4-丁二烯-异戊二烯无规共聚物(PBI,简称丁戊无规共聚物)可生成环化顺-1,4-丁戊无规共聚物(CP-BI)。作者曾报道用裂解色谱法表征环化顺-1,4-聚丁二烯(CPBd),本文对不同组成的CPBI和PBI进行了裂解色谱比较研究。 表1所列试样由实验室合成。用CDS pyro-probe 190型裂解器,SP-2305E型气相色谱仪,FID。裂解温度700℃,裂解时间5秒,色谱柱4mm×3m不锈钢柱,填充20%SE-30固定相(101白色担体),柱温106℃,载气氮气40mL/min。试样量约30μg,放于石英管内,后者再插入

A HIGH-RESOLUTION SOLID-STATE NMR-STUDY OF THE MISCIBILITY, MORPHOLOGY, AND TOUGHENING MECHANISM OF POLYSTYRENE WITH POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

An extended Goldman-Shen pulse sequence was used to observe indirectly the proton spin diffusion in the blends of polystyrene (PS) with poly(2,6-dimethyl-1,4-phenylene oxides) (PPO). The results indicate that the average distance between PS and PPO is less than 5 angstrom in the intimately mixed phase, but there are heterogeneous domains on a 100-angstrom scale. The data of spin relaxation of carbons, T1(C), for homopolymers and their blends suggest that there is a strong pi-pi electron conjugation interaction between the aromatic rings of PS and those of PPO, while the aromatic rings of PPO drive the aromatic rings of PS to move cooperatively. It is the cooperative motion that markedly improves the impact strength of PS.

SYNTHESIS AND CRYSTAL-STRUCTURE OF NEODYMIUM COMPLEX OF 1-METHYL-1, 4, 7, 10-TETRAAZACYCLODODECANE

The complex [Nd(L)(CH3CN)(CF3SO3)3] has been synthesized. Where L = 1-methyl-1, 4, 7, 10-tetraazacycldodecane. The crystal structure of the complex has been determined by a four-circle X-ray diffractometer to a final deviation factor B value of 0.0370 and R(w) value of 0.0385 respectively. The crystal is triclinic system, space group P1BAR with a = 0.8738(2), b = 1.2870(3), c = 1.2900(3) nm, alpha = 85.63(2), beta = 87.25(2), gamma = 78.30(2)-degrees, V = 1.41571 (60) nm3, Z = 2, D(c) = 1.92 g/cm3. The neodymium ion is eight-coordinated to forming a distorted square antiprism.

EPITAXIAL CRYSTALLIZATION OF TRANS-1,4-POLYBUTADIENE ON HIGHLY ORIENTED ISOTACTIC POLY(PROPYLENE) FILMS

Epitaxial crystallization of trans-1,4-polybutadiene (PBD) on highly oriented isotactic poly(propylene) (iPP) has been investigated at different crystallization temperatures and rates. From electron microscopy and electron diffraction, it is confirmed that epitactic growth of the low-temperature modification (monoclinic) with microcrystals of PBD on the iPP films takes place with their chain directions about +/- 50-degrees apart. No epitaxial relationship occurs between the high-temperature modification (hexagonal) of PBD and the iPP substrate. Thermal analyses of PBD-PP layered films indicate that the epitaxy has an important effect on the formation of the high-temperature modification of PBD.

Ni顺1.4一聚丁二烯的形态结构

本文选用不同微观结构、不同分子量、支化度及不同交联度的Ni-PB,用电子显微镜研究了其室温的聚集状态及低温下的结晶行为。讨论了其结构与性能的关系。

在AlEtCl_2—CH_2=CH—CH_2Cl体系作用下顺-1,4聚丁二烯的环化研究

本文以AIEtCl_2—CH_2=CH—CH_2Cl体系进行了镍系顺-1,4聚丁二烯的环化研究。讨论了催化剂组成、配比、母胶浓度等对环化反应的影响。对产物性能、结构进行了初步表征。

1-甲基-1,4,7,10-四氮杂环十二烷镧配合物的合成及晶体结构

合成了1-甲基-1,4,7,10-四氮杂环十二烷(L)配体。在乙腈中培养了La(L)(CH_3CN)-(H_2O)(CF_3SO_3)_3配合物单晶,测定了其红外光谱和质子核磁共振谱。用X射线衍射方法测定了配合物的晶体结构,该晶体属于单斜晶系,P2_1/n空间群,a=0.9700(2)nm,b=1.5966(2)nm,c=1.9085(1)nm,β=104.71(3)°,V=2.8588(50)nm~3。配合物中镧为9配位,其配位多面体为扭曲的单帽四方反棱柱体。

COMPATIBILIZING EFFECT OF POLY(ETHYLENE OXIDE)-B-POLYSTYRENE-B-POLY(ETHYLENE OXIDE) IN PHENOLPHTHALEIN POLY(ETHER ETHER KETONE) POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

The morphology and mechanical behaviour of phenolphthalein poly(ether ether ketone) (PEK-C)/poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) blends has been investigated. A poly(ethylene oxide)-b-polystyrene-b-poly(ethylene oxide) (PEO-PS-PEO) triblock copolymer was used as compatibilizer. It was found that PEO-PS-PEO has a compatibilizing effect on the PEK-C/PPO blends. The addition of PEO-PS-PEO to the blends greatly improves phase dispersion and interfacial interfacial adhesion and also enhances the ultimate tensile strength and Young's modulus at compositions ranging from 30 to 70% PEK-C. However, all the values of the ultimate tensile strength within the whole composition range are lower than those expected by simple additivity, probably owing to the poor mechanical properties of PEO-PS-PEO copolymer.

辐射交联顺-1,4-聚丁二烯的网络结构特性和力学性能

本文根据Flory的溶胀理论和橡胶弹性理论,考察了顺-1 4-聚丁二烯辐射交联产物的化学网络和物理缠结网络结构特性及其对固体力学性能的影响。结果表明,交联产物的物理缠结网络密度远远大于化学交联网络密度。随着辐照剂量的增大,化学交联密度增高,物理缠结数下降。探讨了交联、缠结密度与Mooney-Rivlin方程的常数项C_1和C_2的关系。C_1来自化学交联网络的贡献;C_2来自物理缠结的贡献。物理缠结网络主要贡献于交联物体在小形变下的起始弹性模量G_0;化学交联网络则主要贡献于交联物体在大形变下的非线性弹性,即断裂强度(?)_B。