Physical properties of ODP Leg 178 sites

We have reanalyzed the porosity, bulk density, and seismic velocity information collected from continental rise Sites 1095, 1096, and 1101 during the drilling of Ocean Drilling Program (ODP) Leg 178 (Fig. F1). The purpose is to provide a comprehensive composite digital set of data readily available for future studies aimed at well-seismic correlation. The work originates from the occurrence of overlapping sets of physical parameters and acoustic velocity collected by different methods (downhole logging, core logging, laboratory determination, and derivation from seismic data) and from different holes at the same site. These data do not always provide the same information because of difficulties encountered at each specific hole or methodological differences. In addition, a basic correlation between these parameters and onsite multichannel seismic (MCS) data is presented.

(Table 1) Physical properties of basalts from DSDP Legs 69 and 70

Physical properties of basalts from Deep Sea Drilling Project Sites 504 and 505, south of the Costa Rica Rift, including wet-bulk density, water content, sonic velocity, and thermal conductivity, were measured on board D/V Glomar Challenger during Legs 69 and 70. The mean wet-bulk density is 2.90±0.06 g/cm**3, porosity 5.0±2.2%, sonic velocity 5.75±0.30 km/s, and thermal conductivity 1.67±0.09 W/m°K. Basalts from this young ocean crust (5.9 m.y.) have relatively low porosity and consequently high density and sonic velocity, as compared to average DSDP basalts. Some systematic trends in depth variation of physical properties were found: down to Core 40 in Hole 504B, grain densities were lower than those deeper in the hole, whereas porosity in the upper section was higher. This can be attributed either to differences in the flow type or in the nature of alteration of basalts at the different levels in the hole.