Nickel substitution induced effects on gas sensing properties of cobalt ferrite nanoparticles

Ni2+ ion induced unusual conductivity reversal and an enhancement in the gas sensing properties of ferrites based gas sensors, is reported. The Co1-xNixFe2O4 (for x = 0, 0.5 and 1) nanoparticles were synthesized by wet chemical co-precipitation method and gas sensing properties were studied as a function of composition and temperature. The structural, morphological and microstructural characterization revealed crystallite size of in the range 10-20 nm with porous morphology consisting of nano-sized grains. The Energy Dispersive X-ray (EDX) mapping confirms homogeneous distribution of Co, Ni, Fe and O elements in the ferrites. The non-stoichiometry of the inverse spinel type ferrites and the relative concentration of Ni3+/Co3+ defects were studied using X-ray photoelectron spectroscopy. It is found that the addition of Ni2+ ions into cobalt ferrite shows preferred selectivity towards CO gas at high temperature (325 degrees C) and ethanol gas at low temperature (250 degrees C), unlike undoped cobalt ferrite or undoped nickel ferrite, which show similar response for both these gases. Moreover, an unusual conductivity reversal is observed, except cobalt ferrite due to the difference in reactivity of the gases as well as characteristic non-stoichiometry of ferrites. This behavior is highly gas ambient dependent and hence can be well-exploited for selective detection of gases. (C) 2015 Elsevier B.V. All rights reserved.

Maintaining local displacive disorders in Na0.5Bi0.5TiO3 piezoceramics by K0.5Bi0.5TiO3 substitution

A comprehensive global and local structural characterization using X-ray and neutron diffraction, and EXAFS have been performed to investigate the effect of electrical poling on the structure of (1-x)Na0.5Bi0.5TiO3-(x)K0.5Bi0.5TiO3 compositions. While the annealed samples showed definite indication of presence of local displacive disorders in all the compositions studied (0

An Amino Acid Substitution Matrix for Protein Conformation Identification

Amino acid substitution matrices play an essential role in protein sequence alignment, a fundamental task in bioinformatics. Most widely used matrices, such as PAM matrices derived from homologous sequences and BLOSUM matrices derived from aligned segments of PROSITE, did not integrate conformation information in their construction. There are a few structure-based matrices, which are derived from limited data of structure alignment. Using databases PDB_SELECT and DSSP, we create a database of sequence-conformation blocks which explicitly represent sequence-structure relationship. Members in a block are identical in conformation and are highly similar in sequence. From this block database, we derive a conformation-specific amino acid substitution matrix CBSM60. The matrix shows an improved performance in conformational segment search and homolog detection.

Fishing effort validation and substitution possibilities among components: the case study of the VIII division European anchovy fishery

Command and control regulation programs, particularly input constraints, typically fail to achieve stated objectives, because fishermen may substitute unregulated for regulated inputs. It is, thus, essential to have an understanding of the internal structure of production technology. A primal formulation is used to estimate a translog production function at the vessels level that includes fishing effort and fisherman’s skill. The flexibility of the selected functional permits the analysis of the substitution possibilities among inputs by estimating the elasticity of substitution with no prior constraints. Particular attention is paid to the empirical validation of fishing effort as an aggregate input, which implies either, the acceptation of the joint hypothesis that inputs making up effort are weakly separable from the inputs out of the subgroup or considering that effort is an intermediate input produced by a non-separable two stage technology. Cross sectional data from the Spanish purse seine fleet operating in the VIII Division European anchovy fishery provide evidence of limited input substitution possibilities among the inputs making up the empirically validated fishing effort translog micro-production function.

Part I. Efforts directed towards the total synthesis of shionone. Part II. Conversion of estrone to androst-4-EN-3-ONE: a new method for activating the C-9 and C-10 positions of estrogenic steroids for substitution

Part I: An approach to the total synthesis of the triterpene shionone is described, which proceeds through the tetracyclic ketone i. The shionone side chain has been attached to this key intermediate in 5 steps, affording the olefin 2 in 29% yield. A method for the stereo-specific introduction of the angular methyl group at C-5 of shionone has been developed on a model system. The attempted utilization of this method to convert olefin 2 into shionone is described.

Part II: A method has been developed for activating the C-9 and C-10 positions of estrogenic steroids for substitution. Estrone has been converted to 4β,5β-epoxy-10β-hydroxyestr-3-one; cleavage of this epoxyketone using an Eschenmoser procedure, and subsequent modification of the product afforded 4-seco-9-estren-3,5-dione 3-ethylene acetal. This versatile intermediate, suitable for substitution at the 9 and/or 10 position, was converted to androst-4-ene-3-one by known procedures.

Effect of oxygen substitution by halide ions on structure, thermal stability and upconversion fluorescence in Er3(+)/Yb3(+)-codoped germanium-bismuth glasses

For the first time. effect of halide ions (F-, Cl-, Br-, and I-) introduction on structure, thermal stability, and upconversion fluorescence in Er3+/Yb3+-codoped oxide-halide germanium-bismuth glasses has been systematically investigated. The results show that halide ions modified germanium-bismuth glasses have lower maximum phonon energy and phonon density, worse thermal stability. longer measured lifetimes of I-4(l1/2) level, and stronger upconversion emission than germanium-bismuth glass. All these results indicate that halide ions play an important role in the formation of glass network, and have an important influence on the upconversion luminescence. The possible upconversion mechanisms of Er3+ ion are also evaluated. © 2005 Elsevier Ltd. All rights reserved.

Effects of chloride substitution on the chemical and physical properties and the crystallization behavior in heavy metal fluoride glasses

Effect of the substitutions of chloride for fluoride on the chemical and physical properties and the crystallization behavior in heavy metal fluoride glasses has been investigated. The characteristic temperature of the glass does not changed obviously when the fluoride was taken place by chloride. Compared with samples of being free of ErF3, the doping samples are more inclined to be surface crystallization. Optical basicity in the glass system increases with increasing the negative charge provided by the chloride atoms and the absorption peak red shifted is observed in absorption spectra. XRD measurements show that not a single crystalline phase appears in the heated glass samples, which indicate the substitutions of chloride for fluoride with a variety of crystalline precipitation trends. (c) 2007 Elsevier B.V All rights reserved.

Substitution of Artemia with Brachionus in different ratios during larval rearing of Macrobrachium rosenbergii and evaluation of their feed efficacy

Larval growth during stage I-VIII was studied in Macrobrachium rosenbergii. Duration in moult periodicity were recorded-during larval development period, larvae were fed with Brachionus (grown on Baker's yeast and also Brachinous raised through organic manuring in outdoor culture containers). The performance of the feed was evaluated through substitution of Brachionus in the feeding protocol, in lieu of Artemia 1st instar. The Artemia, Brachionus substitution ratio of 75:25 was found to be most efficient. The study also indicates that the comparative growth rate of Brachionus plicatilis is higher in manure loaded tanks than with Baker's yeast. Growth rate "Y'' in culture tank being 0.245 and 0.112 and corresponding duplicating time (Td) too was found to be 2.855 and 6.365 respectively in tanks manured/enriched with pig manure.

Substitution of live feed by formulated diet: effect on the growth and survival of Betta splendens (Regan) fry

The present work evaluates the effectiveness of partial or total replacement of live feed (LF) (Tubifex) together with formulated diet (FD) for Betta splendens. Three hundred Betta splendens fry of uniform size (mean weight 0.19±0.01g) were equally distributed in five treatment groups with three replicates in glass aquaria of 351itre capacity. Fishes were given diets at different ratio of LF and FD viz. T1(C) 100% LF; T2 75% LF, 25% FD; T3 50% LF, 50% FD; T4 25% LF, 75% FD and T5 100% FD and the experiment continued for 105 days. T2 group registered highest (P<0.05) % body weight gain (125.61±0.26) and specific growth rate (2.34±0.02), which was similar to T1 and T3 groups. Lowest FCR was recorded in T2 (2.40±0.11) group, which was similar to Tl, T3 and T4 groups. Highest (P<0.05) PER was observed in T4 (1.00±0.03) group, which was similar to T3 and T5 groups. At the end of experiment, highest % survival was recoded in T1, T2 and T3 groups (96.67±1.67), which was similar to T4 group. From the study, it is concluded that LF can be successfully replaced up to 75% by FD without any adverse effect on the growth and survival of Betta splendens.

Import substitution of combination wire rope. Part 1. Design, production and evaluation of a prototype combination wire rope

Model combination wire ropes with different covering materials were prepared and worked out specification for the prototype. A table model hand operated wire rope twisting machine was also developed for this. Prototype combination wire rope was twisted in collaboration with M/s South India Wire Ropes Ltd., Alwaye. Specification details, properties and field performance of the prototype studied are reported.