Fabrication and spectral properties of Nd3+-doped yttrium lanthanum oxide transparent ceramics

Transparent 1 at% Nd3+:Y1.9La0.1O3 ceramics were fabricated with nanopowders prepared by carbonate coprecipitation method. The powder compacts were sintered in H-2 atmosphere at 1550 degrees C for 30 h. The Nd3+:Y1.9La0.1O3 ceramics display uniform grains of about 50 mu m and high transparency. The highest transmittance of the ceramics reaches 67%. The strongest absorption peak is in the wavelength of 820 nm with absorption cross section of 2.48 x 10(-20) cm(2). The absorption is still high at LD wavelength 806 nm with absorption cross section of 1.78 x 10(-20) cm(2) and broad full width at half maximum (FWHM) of about 6.3 nm. The strongest emission peak was centered at 1078 nm with large stimulated emission cross section of 9.63 x 10(-20) cm(2) and broad FWHM of about 7.8 nm. The broad absorption and emission bandwidth of Nd3+:y(1.9)La(0.1)O(3) transparent ceramics are favorable to achieve the miniaturized LD pumping apparatus and ultrashort modelocked pulse laser output, respectively. (c) 2007 Elsevier B.V. All rights reserved.

Luminescence behavior of Yb(3+)heavy-doped yttrium lanthanum oxide transparent ceramics

Yb3+ heavy-doped yttrium lanthanum oxide transparent ceramics were fabricated and their spectroscopic properties were investigated. The absorption bands of (YbxY0.9-xLa0.1)(2)O-3 (x = 0.05-0.15) ceramics are broad at wavelength of 900-1000 nm. The absorption cross-sections centered at 974 nm and the emission cross-sections at 1031 nm of Yb3+ ion are 0.89-1.12 x 10(-20) cm(2) and 1.05 x 10(-20) cm(2) respectively. The up-conversion luminescence intensity of Yb3+-doped yttrium lanthanum oxide ceramics increased firstly, then decreased with the increase of Yb3+ ion content. (C) 2008 Elsevier B.V. All rights reserved.

Observations on the inhibitory effect of sodium chloride on molds met with in smoked fishery products

Even though smoke curing is a very elegant method of preserving fish, the resultant products have only a very restricted shelf-life, unless stored under refrigerated conditions. The main source of spoilage is the early setting in of a vigorous growth of moulds. This problem is of a serious nature even in temperate climatic conditions. In full and universal recognition of the gravity of the problem, the FAO conference on herring technology held in September 1950 at Bergen in Norway has recommended the problem of "means of prevention of mould growth in smoked products" for future research study. This note records an interesting observation made at this Laboratory on the inhibitory action of sodium chloride on the development of mould in smoked fishery products.

Genotoxic effect of nickel chloride and zinc sulphate on fish Hypophthalmichthys molitrix

The present investigation is to assess the genotoxic potential of nickel chloride and zinc sulphate on gill cells of silver carp Hypophthalmichthys molitrix. Fishes were exposed in sublethal concentration of nickel chloride 5. 7 mg/1 and zinc sulphate 6.8 mg/1, and sampled at 10, 20 and 30 days. Nickel chloride and zinc sulphate treated fishes exhibited an apparent increase in the aberration frequency and a decrease in the mitotic index as compared to control. Acentric fragment, chromatid break, endoreduplication, chromatid gap, centromeric fusion, ploidy, sticky plate, dicentric chromosome, clumping and partial sticky plates were some of the abnormalities observed. The chromosomal aberrations in the treated fishes were significant compared to control.

Penetration of sodium chloride during prolonged salting of fish

This work deals with adsorption of salt and expulsion of moisture in Synagris japonicus, Sciaenids sp. and Lactarius lactarius during prolonged salting. The fish used in this study were procured fresh and handled immediately. They were gutted, gilled, cleaned well and salted. Results indicated that larger salt proportions and higher temperature of salting both accelerate the rates of absorption of salt and shedding of moisture by fish muscle during salt curing.

Lake Mahega: a mesothermic, sulphato-chloride lake in western Uganda

In May, 1971, Lake Mahega had pronounced mesothermy (40.W C at one metre). Solar heating of a bloom of baeteria and the blue-green alga, Synechococcus bacillaris Butch., probably caused the high temperature. A total ionic concentration gradient increasing from 192,600 mg 1itre-1 at the surface to 415,200 mg•litre- 1 at three metres stabilized the thermally inverted water. Nearly equal amounts of chloride and sulphate accounted for about 90% of the anionic composition. Sodium was the major cation. Crystals or the triple salt, northupite (Na2 CO3. MgCO3. NaCl) and of thenardite (Na2SO4) were mixed with the surface sediment. We believe it is possible that primary northupite depnsition is occurring. Lake Mahega is also the first mesothermic, sulphato-chloride lake reported for East Africa.

Evaluation and modeling of lanthanum diffusion in TiN/La 2O 3/HfSiON/SiO 2/Si high-k stacks

In this study, TiN/La 2O 3/HfSiON/SiO 2/Si gate stacks with thick high-k (HK) and thick pedestal oxide were used. Samples were annealed at different temperatures and times in order to characterize in detail the interaction mechanisms between La and the gate stack layers. Time-of-flight secondary ion mass spectrometry (ToF-SIMS) measurements performed on these samples show a time diffusion saturation of La in the high-k insulator, indicating an La front immobilization due to LaSiO formation at the high-k/interfacial layer. Based on the SIMS data, a technology computer aided design (TCAD) diffusion model including La time diffusion saturation effect was developed. © 2012 American Institute of Physics.

Anisotropic behaviour in the magnetic field dependence of the low temperature electrical resistance of calcium-doped lanthanum manganate thin films grown by RF magnetron sputtering

We report about the magnetoresistive properties of calcium-doped lanthanum manganate thin films grown by RF magnetron sputtering on single crystalline LaAlO3 and MgO substrates. Two orientations of the magnetic field with respect to the electrical current have been studied: (i) magnetic field in the plane of the film and parallel to the electrical current, and (ii) magnetic field perpendicular to the plane of the film. The film grown on LaAlO 3 is characterised by an unusual magnetoresistive behaviour when the magnetic field is applied perpendicular to the film plane: the appearance of two bumps in the field dependence of the resistance is shown to be related to the occurrence of anisotropic magnetoresistive effects in manganate films. © 2004 Elsevier B.V. All rights reserved.