Semiquantitative occurence of various minerals in sediment core CRP-2A

The mineralogy of the lower Oligocene to Quaternary sediments of core CRP-2/2A drilled on the continental shelf of McMurdo Sound in Ross Sea, Antarctica, was examined by the X-ray diffraction method. Quartz, plagioclase feldspar and K-feldspar are the most important non-clay minerals. Pyroxene and amphibole occur in minor amounts throughout the core. The composition of the sediments points to an origin in the Transantarctic Mountains for the majority of the detrital components. There, the plutonic and metamorphic rocks of the basement, the sediments of the Beacon Supergroup and the volcanic rocks of the Ferrar Group could serve as possible source lithologies. The distribution of the detrital minerals reflects a long-term history of successive erosion and valley incision. During the deposition of the lower part of the core, the detrital minerals were probably mainly derived from the sediments of the Beacon Supergroup, as indicated by the high quartz but relatively low feldspar abundances. In the upper c. 350 m of the core, the influence of a source in the basement became stronger and results in lower quartz contents but increasing abundance of feldspar. Some diagenetic alteration of the sediments is indicated by the occurrence of zeolites below c. 320 mbsf and of opal-CT above c. 320 mbsf.

Group treatment of multicompany wastes : the Taunton silver project /

Mode of access: Internet.

Diagenesis and aquifer characteristics of the Sherwood Sandstone Group in North Nottinghamshire

The Sherwood Sandstone Group forms an important aquifer in Eastern England, which in North Nottinghamshire comprises the Nottingham Castle and Lenton Sandstone Formations. The aquifer is formed by an alluvial red-bed sequence dominated by medium-coarse grained sandstones which are texturally immature to submature and have only been subjected to shallow burial diagenesis. These sandstones reached the mature stage of the meso diagenetic regime, and four stages are recognized in their diagenetic history depending upon the physical/chemical processes prevailing and the subsequent effect on porosity and permeability. Stage "One" represents changes including dissolution of unstable silicates, clay replacement, red colouration and precipitation of authigenic minerals (quartz, feldspar, illite, l/S, kaolinite, dolomite, ferroan calcite, calcite). The net result of these changes was porosity reduction. Stage "Two" included changes due to mechanical compaction which resulted in minor porosity reduction. Stage "Three" was the main phase of secondary porosity enhancement. Stage "Four" represents changes taking place in the present groundwater where porosity and permeability may have been increased by dissolution and partly reduced by kaolinite precipitation. Porosity measured by water-resaturation and Hg-injection gave average values of 25.63% and 24.85% respectively. The results are comparable and showed marked correlation especially in highly porous/permeable rocks. Porosity measurements from photomicrographs were markedly offset from laboratory results. Horizontal Kw ranged between 1.43 x 10-5 and 1.13 x 10-1 mm/sec, with an average of  1.68 x 10-2 mm/sec. The estimated KHg ranged between 7.29 x 10-6 and 6.99 x 10-2 mm/sec with an average of 1.47 x 10-2 mm/sec. Both results are significantly correlated for highly porous/permeable rocks. The hydraulic properties are highly dependent upon the diagenetic properties (as most of the pores present are of secondary origin) as well as the pore size distribution. The chemistry of these groundwaters indicates that they are under-saturated with respect to dolomite, calcite, K-feldspar, l/S clay, and montmorillonite. The precipitation of kaolinite,and to a lesser extent illite, is favoured in the present groundwater regime.

Geochemistry and minerals at DSDP Legs 68-70 Holes

The compositions of natural glasses and phenocrysts in basalts from Deep Sea Drilling Project Sites 501, 504, and 505, near the Costa Rica Rift, constitute evidence for the existence of a periodically replenished axial magma chamber that repeatedly erupted lavas of remarkably uniform composition. Magma compositions were affected by three general components: (1) injected magmas carrying (in decreasing order of abundance) Plagioclase, olivine, and chrome-spinel phenocrysts (spinel assemblage); (2) injected magmas carrying Plagioclase, clinopyroxene, and olivine phenocrysts, but no spinel (clinopyroxene assemblage); and (3) moderately evolved hybrids in the magma chamber itself. The compositions of the injected phenocrysts and minerals in glomerocrysts are as follows: Plagioclase - An85-94; olivine - Fo87-89; clinopyroxene - high Cr2O3 (0.7-1.1%), endiopside (Wo42En51Fs7), and aluminous chromian spinel (Cr/Cr + Al = 0.3). These minerals resemble those thought to occur in upper mantle sources (9 kbars and less) of ocean-ridge basalts and to crystallize in magmas near those sources. In the magma chamber, more sodic Plagioclase (An79-85), less magnesian olivine (Fo81-86) and low-Cr2O3 (0.1-0.4%) clinopyroxene formed rims on these crystals, grew as other phenocrysts, and formed cumulus segregations on the walls and floors of the magma chamber. In the spinel-assemblage magmas, magnesiochromite (Cr/Cr + Al = 0.4-0.5) also formed. Some cumulus segregations were later entrained in lavas as xenoliths. The glass compositions define 16 internally homogeneous eruptive units, 13 of which are in stratigraphic order in a single hole, Hole 504B, which was drilled 561.5 meters into the ocean crust. These units are defined as differing from each other by more than analytical uncertainty in one or more oxides. However, many of the glass groups in Hole 504B show virtually no differences in TiO2 contents, Mg/Mg + Fe2+, or normative An/An + Ab, all of which are sensitive indicators of crystallization differentiation. The differences are so small that they are only apparent in the glass compositions; they are almost completely obscured in whole-rock samples by the presence of phenocrysts and the effects of alteration. Moreover, several of the glass units at different depths in Hole 504B are compositionally identical, with all oxides falling within the range of analytical uncertainty, with only small variations in the rest of the suite. The repetition of identical chemical types requires (1) very regular injection of magmas into the magma chamber, (2) extreme similarity of injected magmas, and (3) displacement of very nearly the same proportion of the magmas in the chamber at each injection. Numerical modeling and thermal considerations have led some workers to propose the existence of such conditions at certain types of spreading centers, but the lava and glass compositions at Hole 504B represent the first direct evidence revealed by drilling of the existence of a compositionally nearly steady-state magma chamber, and this chapter examines the processes acting in it in some detail. The glass groups that are most similar are from clinopyroxene-assemblage lavas, which have a range of Mg/Mg + Fe2"1" of 0.59 to 0.65. Spinel-assemblage basalts are less evolved, with Mg/Mg + Fe2+ of 0.65 to 0.69, but both types have nearly identical normative An/An + Ab (0.65-0.66). However, the two lava types contain megacrysts (olivine, Plagioclase, clinopyroxene) that crystallized from melts with Mg/Mg + Fe2+ values of 0.70 to 0.72. Projection of glass compositions into ternary normative systems suggests that spinel-assemblage magmas originated deeper in the mantle than clinopyroxene-assemblage magmas, and mineral data indicate that the two types followed different fractionation paths before reaching the magma chamber. The two magma types therefore represent neither a low- nor a high-pressure fractionation sequence. Some of the spinel-assemblage magmas may have had picritic parents, but were coprecipitating all of the spinel-assemblage phenocrysts before reaching the magma chamber. Clinopyroxene-assemblage magmas did not have picritic parents, but the compositions of phenocrysts suggest that they originated at about 9 kbars, near the transition between plagioclase peridotite and spinel peridotite in the mantle. Two glass groups have higher contents of alkalis, TiO2, and P2O5 than the others, evidently as a result of the compositions of mantle sources. Eruption of these lavas implies that conduits and chambers containing magmas from dissimilar sources were not completely interconnected on the Costa Rica Rift. The data are used to draw comparisons with the East Pacific Rise and to consider the mechanisms that may have prevented the eruption of ferrobasalts at these sites.

(Table II, page 668-669) Distribution of elements between minerals soluble in 1M Hydroxylamine hydrochloride (Reducible); in 1m HCL (Acid-soluble) and in the insoluble residue of manganese nodules

Attempts to classify pelagic sediments have been based either on appearance and composition, or on the ultimate origin of the components. In particular it appears feasible to distinguish minerals which crystallized in sea-water from those which formed in magmas, in hydrothermal solution, or by weathering under acidic conditions. It is the case of iron and manganese oxide mineral aggregates which constitute one of the major types of rock encountered on the ocean floor; according to Menard (unpublished) about 10% of the pelagic area of the Pacific is covered by such nodules. The nodules consist of intimately intergrown crystallites of different minerals among those identified, besides detrital minerals and organic matter, are opal, goethite, rutile, anatase, barite, nontronite, and at least three manganese oxide minerals of major importance. Arrhenius and Korkisch (1959) have attempted to separate from each other the different minerals constituting the nodules, in order to establish the details of their structure and the localization of the heavy metal ions. The results demonstrate (Table II) that copper and nickel are concentrated in the manganese oxide phases concentrated in the reducible fraction. Cobalt, part of the nickel and most of the chromium are distributed between these and the acid-soluble group of the non-manganese minerals, dominated by goethite and disordered FeOOH.

Minerals and vitamin B9 in dried plants vs. infusions: assessing absorption dynamics of minerals by membrane dialysis tandem in vitro digestion

Vitamins and mineral elements are among the most important phytochemicals due to their important role in the maintenance of human health. Despite these components had already been studied in different plant species, their full characterization in several wild species is still scarce. In addition, the knowledge regarding the in vivo effects of phytochemicals, particularly their bioaccessibility, is still scarce. Accordingly, a membrane dialysis process was used to simulate gastrointestinal conditions in order to assess the potential bioaccessibility of mineral elements in different preparations of Achillea millefolium (yarrow), Laurus nobilis (laurel) and Taraxacum sect. Ruderalia (dandelion). The retention/passage dynamics was evaluated using a cellulose membrane with 34 mm pore. Dandelion showed the highest levels of all studied mineral elements (except zinc) independently of the used formulations (dried plant or infusion), but yarrow was the only species yielding minerals after the dialysis step, either in dried form, or as infusion. In fact, the ability of each evaluated element to cross the dialysis membrane showed significant differences, being also highly dependent on the plant species. Regarding the potential use of these plants as complementary vitamin B9 sources, the detected values were much lower in the infusions, most likely due to the thermolability effect.

Raman spectroscopy of the molybdate minerals chillagite (tungsteinian wulfenite-I4), stolzite, scheelite, wolframite and wulfenite

Raman spectra of chillagite, wulfenite, stolzite, scheelite and wolframite were obtained at 298 and 77 K using a Raman microprobe in combination with a thermal stage. Chillagite is a solid solution of wulfenite and stolzite. The spectra of these molybdate minerals are orientation dependent. The band at 695 cm-1 is interpreted as an antisymmetric bridging mode associated with the tungstate chain. The bands at 790 and 881 cm-1 are associated with the antisymmetric and symmetric Ag modes of terminal WO2 whereas the origin of the 806 cm-1 band remains unclear. The 4(Eg) band was absent for scheelite. The bands at 353 and 401 cm-1 are assigned as either deformation modes or as r(Bg) and (Ag) modes of terminal WO2. The band at 462 cm-1 has an equivalent band in the infrared at 455 cm-1 assigned as as(Au) of the (W2O4)n chain. The band at 508 cm-1 is assigned as sym(Bg) of the (W2O4)n chain.

An infrared spectroscopic study of the some Autunite minerals

A series of selected autunites with phosphate as the anion have been studied using infrared spectroscopy. Each autunite mineral has its own characteristic spectrum. The spectra for different autunites with the same composition are different. It is proposed that this difference is due to the structure of water and hydrated cations in the interlayer region between the uranyl phosphate sheets. This structure is different for different autunites. The position of the water hydroxyl stretching bands is related to the strength of the hydrogen bonds as determined by hydrogen bond distance. The highly ordered structure of water is also observed in the water HOH bending modes where a high wavenumber bands are observed. The phosphate and uranyl stretching vibrations overlap and are obtained by curve resolution.

Raman spectroscopy of the copper chloride minerals nantokite, eriochalcite and claringbullite - implications for copper corrosion

The application of Raman spectroscopy to the study of the copper chloride minerals nantokite, eriochalcite and claringbullite has enabled the vibrational modes for the CuCl, CuOH and CuOH2 to be determined. Nantokite is characterised by bands at 205 and 155 cm-1 attributed to the transverse and longitudinal optic vibrations. Nantokite also has an intense band at 463 cm-1, eriochalcite at 405 and 390 cm-1 and claringbullite at 511 cm-1. These bands are attributed to CuO stretching modes. Water librational bands at around 672 cm-1 for eriochalcite have been identified and hydroxyl deformation modes of claringbullite at 970, 906 and 815 cm-1 are observed. Spectra of the three minerals are so characteristically different that the minerals are readily identified by Raman spectroscopy. The minerals are often determined in copper corrosion products by X-ray diffraction. Raman spectroscopy offers a rapid, in-situ technique for the identification of these corrosion products.