Fulvalene cyclopentadienyl titanium and zirconium(III) and -(IV) complexes. X-Ray crystal structure of [{Ti(η5-C5H5) Cl}2 (μ-O)(μ-η5-η5-C10H8)]

The reaction of the fulvalene titanium(III) hydride [{Ti(η5-C5H5)(μ-H)}2(μ-η5-η5-C10H8)] (1) with chlorine leads to [{Ti(η5-C5H5)(μ-Cl)}2(μ-η5-η5-C10H8)] (3) and [{Ti(η5-C5H5)Cl2}2(μ-η5-η5-C10H8)] (4). The reaction of 3 with azobenzene, in wet toluene, gives [{Ti(η5-C5H5)Cl}2(μ-O)(μ-η5-η5-C10H8)] (5) and 1,2-diphenyl hydrazine. The alkylation of 4 and the analogous zirconium complex [{Zr(η5-C5H55)Cl2}2(μ-η5-η5-C10H8)] (2) with LiCH2SiMe3 or LiCH3 permits isolation of the tetraalkyl derivatives [{M(η5-C5H5)(CH2SiMe3)2}2(μ-η5-η5-C10H8)] (M  Ti (6); Zr (8)) and [{Ti(η5-C5H5)(CH3)2}2(μ-η5-η5C10H8)] (7). All the new fulvalene compounds were characterized by IR, and 1H and 13C NMR spectroscope, and mass spectra and 5 by X-ray diffraction. The structure of 5 is very similar to that of the comparable TiIV compound [{Ti(η5-C5H5)2Cl}2(μ-O)] except for the smaller TiOTi angle (159.4° against 173.81°) and a significant deviation from linearity.

Formation of isopolyoxometallate(VI) anions in the reaction between M(CO)6 (M = W, Mo) and acetic acid: X-ray crystal structure of [W3(μ3-O)2(μ2η2-O2CCH3)6(H2O)3]2[W10O32·solvent

W(CO)6 reacts with a mixture of acetic acid/acetic anhydride to give [W3 (μ3-O)2(μ2η2-O2CCH3)6(H2O)3](CH3CO2)2 (1), which was converted by HClO4 to [W3 (μ3-O)2(μ2η2-O2CCH3)6(H2O)3](ClO4)2 (2). Addition of CH3CO2Na to the above reaction mixture, and prolonged exposure of the solution to air, results in the formation of the WIV/WVI complex salt [W3(μ3-O)2(μ2η2-O2CCH3)6(H2O)3]2[W10O32]·solvent (3). Complex 3 was also prepared by reacting 1 with Na2WO4·2H2O in acetic acid, and it has been characterized by X-ray crystallography. Addition of [CH3(CH2)3]4N(ClO4) to the reaction filtrate remaining after the preparation of [Mo2(μ-O2CCH3)4][from Mo(CO)6, CH3CO2H and (CH3CO)2O], followed by exposure to air, gives ([CH3(CH2)3]4N)2[Mo6O19] (4).

A simplified, high-yield synthesis, and crystal structure of [tris{bis(2,4,6-triisopropylphenyl)tin}]

The species [{Sn(C2H2iPr3-2,4,6)2}3] has been obtained in a simple, essentially quantitative, synthesis from SnCl2 and ArLi in diethyl ether at low temperature. The crystal structure analysis confirms the trimeric nature of the molecular units but reveals some unusual features. The crystal contains the unusual feature of an asymmetric unit that consists of three units of [{SnAr2}3] in P21/c; the molecular unit is a scalene triangle, showing high consistency between the three molecules, in contrast to analogous trimeric species of silicon or germanium. The SnSn bonds are lengthened (average value 2.942 Å) owing to steric crowding.

Synthesis of the first-membered ring compound containing three tin atoms and one oxygen. The crystal structure of the species [O{Sn(C6H3Et2-2,6)2}3]

Aerial oxidation of the novel homocyclic tetratin species [{SnAr2}3SnArBr] (1) [1] (Ar  C6H3Et2-2,6) affords the tritin heterocycle [O{Sn(C6H3Et2-2,6)2}3] (2), which has been crystallographically characterised; 2 is the first reported oxatristannacyclobutane, and the first heterocyclic tin species having both tintin and tinheteroatom bonds.

Synthesis and crystal structure of a novel octa-aqua bridged star-shaped Ni4K complex

A penta-nuclear. star-shaped hetero-metallic compound containing a unique Ni4KO8 core has been synthesized. The X-ray single crystal structure analysis reveals that in the complex, [K(Ni(LH)(2))(4)(OH2)(8)](Br)(ClO4)(8)center dot 11H(2)O (LH=(CH3)(2)HN+(CH2)(3)N=CHC6H4O-) the eight coordinate central K+ ion is encapsulated by four terminal [Ni(LH)(2)](2+) units through the double water bridges between K+ and each Ni(II) ions.

Synthesis, chemical, electrochemical characterization of oxomolybdenum(V) complexes of 2-(3,5-dimethyl pyrazol-1-yl) benzothiazole ligand: crystal structure of ligand and oxomolybdenum(VI) complex and density functional theory (DFT) calculation

This work reports the ligational behavior of the neutral bidentate chelating molecule 2-(3,5-dimethyl pyrazol-1-yl) benzothiazole towards the oxomolybdenum(V) center. Both mononuclear complexes of the type (MoOX3L)-O-V and binuclear complexes of the formula (Mo2O4X2L2)-O-V (where X = Cl, Br) are isolated in the solid state. The complexes are characterized by elemental analyses, various spectroscopic techniques (UV-Vis IR), magnetic susceptibility measurement at room temperature, and cyclic voltammetry for their redox behavior at a platinum electrode in CH3CN. The mononuclear complexes (MoOX3L)-O-V are found to be paramagnetic while the binuclear complexes Mo2O4X2L2 are diamagnetic. Crystal and molecular structure of the ligand and the dioxomolybdenum complex (MoO2Br2L)-O-VI (obtained from the complex MoOBr3L during crystallization) have been solved by single crystal X-ray diffraction technique. Relevant DFT calculations of the ligand and the complex (MoO2Br2L)-O-VI are also carried out.

X‑ray crystal structure of rac-[Ru(phen)2dppz]2+ with d(ATGCAT)2 shows enantiomer orientations and water ordering

We report an atomic resolution X-ray crystal structure containing both enantiomers of rac-[Ru(phen)2dppz]2+ with the d-(ATGCAT)2 DNA duplex (phen = phenanthroline; dppz = dipyridophenazine). The first example of any enantiomeric pair crystallized with a DNA duplex shows different orientations of the Λ and Δ binding sites, separated by a clearly defined structured water monolayer. Job plots show that the same species is present in solution. Each enantiomer is bound at a TG/CA step and shows intercalation from the minor groove. One water molecule is directly located on one phenazine N atom in the Δ-enantiomer only.

Detection of nitroaromatic vapours with diketopyrrolopyrrole thin films: exploring the role of structural order and morphology on thin film properties and fluorescence quenching efficiency

Sensitive optical detection of nitroaromatic vapours with diketo-pyrrolopyrrole thin films is reported for the first time and the impact of thin film crystal structure and morphology on fluorescence quenching behaviour demonstrated.

Laurdan Spectrum Decomposition as a Tool for the Analysis of Surface Bilayer Structure and Polarity: a Study with DMPG, Peptides and Cholesterol

The highly hydrophobic fluorophore Laurdan (6-dodecanoyl-2-(dimethylaminonaphthalene)) has been widely used as a fluorescent probe to monitor lipid membranes. Actually, it monitors the structure and polarity of the bilayer surface, where its fluorescent moiety is supposed to reside. The present paper discusses the high sensitivity of Laurdan fluorescence through the decomposition of its emission spectrum into two Gaussian bands, which correspond to emissions from two different excited states, one more solvent relaxed than the other. It will be shown that the analysis of the area fraction of each band is more sensitive to bilayer structural changes than the largely used parameter called Generalized Polarization, possibly because the latter does not completely separate the fluorescence emission from the two different excited states of Laurdan. Moreover, it will be shown that this decomposition should be done with the spectrum as a function of energy, and not wavelength. Due to the presence of the two emission bands in Laurdan spectrum, fluorescence anisotropy should be measured around 480 nm, to be able to monitor the fluorescence emission from one excited state only, the solvent relaxed state. Laurdan will be used to monitor the complex structure of the anionic phospholipid DMPG (dimyristoyl phosphatidylglycerol) at different ionic strengths, and the alterations caused on gel and fluid membranes due to the interaction of cationic peptides and cholesterol. Analyzing both the emission spectrum decomposition and anisotropy it was possible to distinguish between effects on the packing and on the hydration of the lipid membrane surface. It could be clearly detected that a more potent analog of the melanotropic hormone alpha-MSH (Ac-Ser(1)-Tyr(2)-Ser(3)-Met(4)-Glu(5)-His(6)-Phe(7)-Arg(8)-Trp(9)-Gly(10)-Lys(11)-Pro(12)-Val(13)-NH(2)) was more effective in rigidifying the bilayer surface of fluid membranes than the hormone, though the hormone significantly decreases the bilayer surface hydration.

Heterobimetallic compounds [Ru(eta(5)-Cp)(dppf)X] (X = Cl, Br, I and N(3)): synthesis, electrochemical analysis, and the crystal structure of [Ru(eta(5)-Cp)(dppf)I] [dppf=1,1`-bis(diphenylphosphino)ferrocene]

A series of new ruthenium-iron based derivatives [Ru(eta(5)-Cp)(dppf)Cl] (1), [Ru(eta(5)-Cp)(dppf)Br] (2), [Ru(eta(5)-Cp)(dppf)I] (3) and [Ru(eta(5)-Cp)(dppf)N(3)] (4) were obtained by reactions of [Ru(eta(5)-Cp)(PPh(3))(2)Cl] with 1,1`-bis(diphenylphosphino) ferrocene (dppf) and characterized by IR, NMR ((1)H, (13)C and (31)P), (57)Fe Mossbauer spectroscopy and cyclic voltammetry. Additionally, the compound (3) was structurally characterized by X-ray crystallography, and the results were as follows: orthorhombic, Pbca, a = 18.2458(10), b = 20.9192(11), c = 34.4138(19) a""<<, alpha = beta = gamma = 90A degrees, V = 13135.3(12) a""<<(3) and Z = 16.

Crystal structure of the IL-22/IL-22R1 complex and its implications for the IL-22 signaling mechanism

Interleukin-22 (IL-22) is a member of the interleukin-10 cytokine family, which is involved in anti-microbial defenses, tissue damage protection and repair, and acute phase responses. Its signaling mechanism involves the sequential binding of IL-22 to interleukin-22 receptor 1 (IL-22R1), and of this dimer to interleukin-10 receptor 2 (IL-10R2) extracellular domain. We report a 1.9 A crystal structure of the IL-22/IL-22R1 complex, revealing crucial interacting residues at the IL-22/IL-22R1 interface. Functional importance of key residues was confirmed by site-directed mutagenesis and functional studies. Based on the X-ray structure of the binary complex, we discuss a molecular basis of the IL-22/IL-22R1 recognition by IL-10R2.

Synthesis and characterization of a new copper(II) complex with nadolol, an aminoalcoholic beta-blocker. Crystal structure of Na[Cu(nadololate)(CO(3))] center dot H(2)O

This work reports the synthesis and characterization of a new copper complex with nadolol, a beta-blocker aminoalcohol. The stoichiometry found was Na[Cu(nadololate)(CO(3))] center dot H(2)O. Electronic and vibrational spectroscopy analysis was performed, and the crystal structure of Na[Cu(nadololate)-(CO(3))] center dot H(2)O was determined by X-ray diffraction.

Crystal structure of garciniaphenone and evidences on the relationship between keto-enol tautomerism and configuration

Garciniaphenone (=rel-(1R,5R,7R)-3-benzoyl-4-hydroxy-8,8-dimethyl-1,7-bis(3-methylbut-2-en-1-yl)bicyclo[3.3.1]non-3-ene-2,9-dione; 1). a novel natural product, was isolated from a hexane extract of Garcinia brasiliensis fruits. The crystal structure of 1 as well as the selected geometrical and Configurational features were compared with those of known related polyprenylated benzophenones. Garciniaphenone is the first representative of polyprenylated benzophenones without a prenyl substituent at C(5). Notably, the absence of a 5-prenyl substituent has an impact on the molecular geometry. The tautomeric form of 1 in the solid state was readily established by a residual-electronic-density map generated by means of a difference Fourier analysis, and there is an entirely delocalized six-membered chelate ring encompassing the keto-enol moiety. The configuration at C(7) was used to rationalize the nature of the keto-enol tautomeric form within 1. The intermolecular array in the network is maintained by nonclassical intermolecular H-bonds.