Mechanical characterisation of tungsten-1wt.% yttrium oxide as a function of temperature and atmosphere

This study evaluates the mechanical behaviour of an Y2O3-dispersed tungsten (W) alloy and compares it to a pure W reference material. Both materials were processed via mechanical alloying (MA) and subsequent hot isostatic pressing (HIP). We performed non-standard three-point bending (TPB) tests in both an oxidising atmosphere and vacuum across a temperature range from 77 K, obtained via immersion in liquid nitrogen, to 1473 K to determine the mechanical strength, yield strength and fracture toughness. This research aims to evaluate how the mechanical behaviour of the alloy is affected by oxides formed within the material at high temperatures, primarily from 873 K, when the materials undergo a massive thermal degradation. The results indicate that the alloy is brittle to a high temperature (1473 K) under both atmospheres and that the mechanical properties degrade significantly above 873 K. We also used Vickers microhardness tests and the dynamic modulus by impulse excitation technique (IET) to determine the elastic modulus at room temperature. Moreover, we performed nanoindentation tests to determine the effect of size on the hardness and elastic modulus; however, no significant differences were found. Additionally, we calculated the relative density of the samples to assess the porosity of the alloy. Finally, we analysed the microstructure and fracture surfaces of the tested materials via field emission scanning electron microscopy (FE-SEM) and transmission electron microscopy (TEM). In this way, the relationship between the macroscopic mechanical properties and micromechanisms of failure could be determined based on the temperature and oxides formed

Cure of human carcinoma xenografts by a single dose of pretargeted yttrium-90 with negligible toxicity

A covalent conjugate (NR-LU-10/SA) was prepared between streptavidin (SA) and NR-LU-10, a mAb that binds an antigen expressed on the surface of most human carcinomas. NR-LU-10/SA was injected into nude mice bearing human tumor xenografts. Injection of biotinylated galactosyl-human serum albumin reduced the circulating levels of conjugate by 95%. Subsequent administration of 90Y-1,4,7,10-tetraazacyclododecane-1,4,7,10-tetraacetic acid-biotin achieved peak uptake at the tumor within 2 hr while >80% of the radioactivity was eliminated in the urine. A single dose of 600–800 μCi of 90Y-1,4,7,10-tetraazacyclododecane-1,4,7,10-tetraacetic acid-biotin produced cures in 10/10 mice with established (>200 mm3) s.c. human small cell lung or colon cancer xenografts and 8/10 cures in mice with human breast cancer xenografts without significant toxicity.

The metallurgy of yttrium and the rare earth metals.

"Materials Central, Contract No. AF33(616)-5905, Project No. 7351."

Utilization of yttrium in gettering oxygen and nitrogen in columbium base materials /

Work performed at CANEL.

Removal of nuclear bomb debris, Strontium 90-Yttrium 90, and Cesium 137-Barium 137 from water with Corps of Engineers mobile water-treating equipment /

Mode of access: Internet.

Rare earth element and yttrium variability in South East Queensland waterways

We present data for the rare earth elements and yttrium (REY) in the National Research Council of Canada natural river water reference material SLRS-4 and 19 natural river waters from small catchments in South-East Queensland, Australia, by a direct ICP-MS method. The 0.22 mu m filtered river water samples show a large degree of variability in both the REY concentration, e.g., La varies from 13 to 1157 ppt, and shape of the alluvial-sediment-normalised REY patterns with different samples displaying light, middle or heavy rare earth enrichment. In addition, a spatial study was undertaken along the freshwater section of Beerburrum Creek, which demonstrates that similar to 75% of the total REYs in this waterway are removed prior to estuarine mixing without evidence of fractionation.

Aquatic geochemistry of the rare earth elements and yttrium in the Pioneer River catchment, Australia

The rare earth elements are strong provenance indicators in geological materials, yet the potential for tracing provinciality in surface freshwater samples has not been adequately tested. Rare earth element and yttrium concentrations were measured at 33 locations in the Pioneer River catchment, Mackay, central Queensland, Australia. The rare earth element patterns were compared on the basis of geological, topographical and land-use features in order to investigate the provenancing potential of these elements in a small freshwater system. The rare earth element patterns of streams draining single lithological units with minor land modification show strongly coherent normalised behaviour, with a loss of coherence in agricultural locations. Evidence is reported for an anthropogenic Gd anomaly that may provide a useful hydrological tracer in this region since the introduction of magnetic resonance imaging in 2003. Several samples display a superchondritic Y/Ho mass ratio (up to 44), which is not explainable within the constraints imposed by local geology. Instead, it is suggested that the additional Y is derived from a marine source, specifically marine phosphorites, which are a typical source of fertiliser phosphorus. The data indicate that, under some circumstances, scaled and normalised freshwater rare earth patterns behave conservatively.

Effect of over-doped yttrium on the microstructure, mechanical properties and thermal properties of a Zr-based metallic glass

The effects of over-doped yttrium on the microstructure, mechanical properties and thermal behaviour of an oxygen-contaminated Zr51Cu20.7Ni12Al16.3 bulk metallic glass are studied systematically. It has been found that, when yttrium doping is beyond the optimum doping, the glass-forming ability enhancement effect induced by yttrium addition decreases and the mechanical properties are adversely affected. In this study, a new phase with an orthorhombic structure (a = 0.69 nm, b = 0.75 nm and c = 0.74 nm) is identified in the yttrium over-doped alloys. (c) 2006 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Microstructures and electrolytic properties of yttrium-doped ceria electrolytes: Dopant concentration and grain size dependences

The microstructures and electrolytic properties of YxCe1-xO2-x/2 (x = 0.10-0.25) electrolytes with average grain size in the range 90 nm-1.7 mu m were systematically investigated. Through detailed transmission electron microscopy characterization, nanosized domains were observed. The relationship of the domains, the doping level and grain sizes were determined, and their impacts on the electrolytic properties were systematically studied. It was found that the formation of domains has a negative impact on the electrolytic properties, so that electrolytic properties can be adjusted through careful control of domain formation, doping level and grain size. (c) 2006 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Enhanced glass-forming ability of a Zr-based bulk metallic glass with yttrium doping

A significant enhancement in glass formation in a newly developed Zr51Cu20.7Ni12Al16.3 alloy has been achieved by yttrium doping. With just 0.5 at.% yttrium doping, the critical diameter of the as-cast alloys for glass formation has been increased from 3 mm to at least 10 mm. In the undoped, large-sized alloys, massive oxygen stabilized crystalline phases are observed but disappear in yttrium doped alloys. Very small amounts of stable alpha-Y2O3 phases found in the yttrium doped alloys, and their negligible effect on the metallic glasses' properties, provide a superior solution to achieve metallic glasses with a high glass formability. (c) 2006 Elsevier B.V. All rights reserved.

Structure and thermal properties of yttrium alumino-phosphate glasses

The structure and thermal properties of yttrium alumino-phosphate glasses, of nominal composition (Y2O3)(0.31-z)(Al2O3)(z)(P2O5)(0.69) with 0 less than or similar to z less than or similar to 0.31, were studied by using a combination of neutron diffraction, Al-27 and P-31 magic angle spinning nuclear magnetic resonance, differential scanning calorimetry and thermal gravimetric analysis methods. The Vickers hardness of the glasses was also measured. The data are compared to those obtained for pseudo-binary Al2O3-P2O5 glasses and the structure of all these materials is rationalized in terms of a generic model for vitreous phosphate materials in which Y3+ and Al3+ act as modifying cations that bind only to the terminal (non-bridging) oxygen atoms of PO4 tetrahedra. The results are used to help elucidate the phenomenon of rare-earth clustering in phosphate glasses which can be reduced by substituting Al3+ ions for rare-earth R3+ ions at fixed modifier content.