Effects of intranasal administration of synthetic (4-28)human atrial natriuretic peptide to normal volunteers.

The effects of intranasal administration of increasing doses of synthetic human natriuretic peptide (4-28 hANP) were studied in six healthy volunteers. The peptide was administered as a nasal spray at doses of 50, 100, 200, and 500 micrograms in ascending order at 48-h intervals. Vehicle was administered by the same route randomly between any two of the doses. Intranasal hANP administration had no effect on either blood pressure, heart rate (HR), or hematocrit. Diuresis did not change consistently, whereas natriuresis tended to rise with vehicle as well as with hANP administration. This was attributed to the infusion of isotonic saline during the experiment. There was no significant increase in plasma ANP levels after intranasal administration of any of the different doses. Thus, no evidence that the atrial natriuretic peptide tested (4-28 hANP) can cross the nasal mucosal barrier was found.

Membrane interaction of polymyxin B and synthetic analogues studied in biomimetic systems: implications for antibacterial action

Membrane-active antimicrobial peptides, such as polymyxin B (PxB), are currently in the spotlight as potential candidates toovercome bacterial resistance. We have designed synthetic analogs ofPxB in order to determine the structural requirements for membraneaction. Since the mechanism of action of PxB involves interaction withboth the outer membrane and the cytoplasmic membrane of Gramnegative bacteria, we have used an approach based on mimicking theouter layers of these membranes using monolayers, Langmuir-Blodgettfilms and unilamelar vesicles, and applying a battery of biophysicalmethods in order to dissect the different events of membraneinteraction. Collectively, results indicate that the PxB analogues act inthe bacterial membrane by the same mechanism than PxB, and that cationic amphipathicity determines peptide activity.

Protection against Plasmodium falciparum challenge induced in Aotus monkeys by liver-stage antigen-3-derived long synthetic peptides.

The vaccine potential of Plasmodium falciparum liver stage antigen-3 (LSA3) was investigated in Aotus monkeys using two long synthetic peptides corresponding respectively to an N-terminal non-repeat peptide (NRP) and repeat 2 (R2) region of the LSA3, adjuvanted by ASO2. Both 100-222 (NRP) and 501-596 repeat peptides induced effector B- and T-cell responses in terms of antigen-driven antibodies and/or specific IFN-gamma secretion. Animals challenged with P. falciparum sporozoites were protected following immunization with either the NRP region alone or the NRP combined with the R2 repeat region, as compared with controls receiving the adjuvant alone. These results indicate that the NRP may be sufficient to induce full, sterile protection and confirm the vaccine potential of LSA3 previously demonstrated in chimpanzees and in Aotus.

Oxygen isotope sector zoning in natural hydrothermal quartz

Oxygen isotope measurements using SIMS and laser-fluorination methods confirm the presence of concentric and sector zoning in low-temperature (200 degrees C to < 400 degrees C) hydrothermal quartz from Alpine veins. While concentric zoning is most readily explained by changes in the chemical composition of the fluid or temperature of crystallization, the reasons for sector zoning are more difficult to explain. Relative enrichment in (18)O for crystallographically different sectors of quartz corresponds to m > r > z. Sector zoning is, however, largely limited to the exterior zones of crystals and/or to crystals with large Al (> 1000 ppm) and trace element contents, probably formed at temperatures < 250 degrees C. Differences in delta(18)O between the prismatic (m) relative to the rhombohedral (r and z) growth sectors of up to 2 parts per thousand can be explained by a combination of a face-related crystallographic and/or a growth rate control. In contrast, isotopic sector zoning of up to about 1.5 parts per thousand amongst the different rhombohedral faces increases in parallel with the trace element content and is likely to represent disequilibrium growth. This is indicated by non-systematic, up to 2 parts per thousand, differences within single growth zones and the irregular, larger or smaller, delta(18)O values (of several permil) of the exterior compared to the inner zones of the same crystals. Disequilibrium growth may be related to the large trace element content incorporated into the growing quartz at lower temperatures (< 250 degrees C) and/or be related to fluid-vapour separation, allowing crystal growth from both a vapour as well as a liquid phase.

Medicinal application of long synthetic peptide technology.

This review covers the latest developments of long synthetic peptide technology for the rapid identification and development of malaria vaccine candidates and immunological modulators. A brief description of the two most common solid-phase synthetic procedures, together with the latest advances in optimisation of peptide chain assembly and analytical instrumentation, is given, with special attention to non-specialists. Several examples of vaccine candidates developed in the authors' or their collaborators' laboratories are also provided.

Long synthetic peptides for the production of vaccines and drugs: a technological platform coming of age.

Long synthetic peptides (LSPs) have a variety of important clinical uses as synthetic vaccines and drugs. Techniques for peptide synthesis were revolutionized in the 1960s and 1980s, after which efficient techniques for purification and characterization of the product were developed. These improved techniques allowed the stepwise synthesis of increasingly longer products at a faster rate, greater purity, and lower cost for clinical use. A synthetic peptide approach, coupled with bioinformatics analysis of genomes, can tremendously expand the search for clinically relevant products. In this Review, we discuss efforts to develop a malaria vaccine from LSPs, among other clinically directed work.

Asphalt Stabilization (Asphadur)/Reduction of Reflection Cracks (Monsanto Bidim Synthetic Fabric), HR-511, 1979

ASPHALT STABILIZATION (ASPHADUR): Asphadur (now called 3M Additive 5990) was incorporated into asphaltic concrete on a lane delineation, AC resurfacing, project in Council Bluffs. The experimental feature was included in the eastbound lanes of Interstate 480, beginning at the bridge over the Missouri River and ending at the bridge over North 41st Street. The project was constructed in October 1979. The objective of the project was to investigate the manufacturer's claims of improved strength, stability and durability of an asphalt mix. REDUCTION OF REFLECTION CRACKS (MONSANTO BIDIM SYNTHETIC FABRIC): A lane delineation project was constructed in the eastbound lanes of Interstate 480 in Council Bluffs. A synthetic fabric, Monsanto Bidim C-28, was placed between the portland cement concrete and two inches of Type A asphaltic concrete resurfacing containing Asphadur. The experimental feature began at the bridge over the Missouri River and ended at the bridge over North 41st Street. The project was constructed in October 1979. The objective of this experimental project was to determine the effectiveness of the fabric in reducing reflective cracking in an asphaltic concrete overlay.

Synthetic Fabric to Improve Structural Capacity in Asphalt Overlays, HR-516, 1984

Iowa's first field application of synthetic engineering fabrics was on research project HR-158, "Prevention of Reflective Cracking in Asphalt Overlays". This research placed in September 1971 used three different engineering fabrics. A final report concluding generally favorable performance was distributed in May 1977. There have been a number of Iowa engineering fabric installations since that initial project.

Spectral induced polarization: Laboratory measurements on sandy quartz samples of varied pore characteristics

Understanding the influence of pore space characteristics on the hydraulic conductivity and spectral induced polarization (SIP) response is critical for establishing relationships between the electrical and hydrological properties of surficial sedimentary deposits. Here, we present the results of laboratory SIP measurements on saturated quartz samples with granulometric characteristics ranging from fine sand to fine gravel. We alter the pore characteristics using three principal methods: (i) variation of the grain sizes, (ii) changing the degree of compaction, and (iii) changing the level of sorting. We then examine how these changes affect both the SIP response and the hydraulic conductivity. In general, the results indicate a clear connection between the applied changes in pore characteristics and the SIP response. In particular, we observe a systematic correlation between the hydraulic conductivity and the relaxation time of the Cole-Cole model describing the observed SIP effect for the whole range of considered grain sizes.

Synthetic sex pheromone of citrus leafminer in Brazilian citrus groves

The objective of this work was to determine the best conditions of use of the synthetic sex pheromone of Phyllocnistis citrella Stainton for monitoring this species in citrus groves in northeastern Brazil. Pheromone doses (0.0, 0.1, 1, 10 and 100 μg) and longevity (1, 15, 29, 43 and 57-day-old lures) and trap height (0.5, 1.5 and 2.5 m), color (green, red, and white) and model influence on P. citrella males capture were evaluated. The doses of 10 and 100 μg of the synthetic sex pheromone - a 3:1 blend of (Z,Z,E)-7,11,13-hexadecatrienal and (Z,Z)-7,11-hexadecadienal - attracted the greatest number of P. citrella males. Traps baited with these two both dosages continued to capture P. citrella males at a comparable rate for over eight weeks in citrus groves. Although there was no significant decrease in activity of both dosages until 57 days of exposure to the environment, the higher dose, as time passed, attracted significantly more P. citrella males than the lower dose. There were no significant differences in male capture in traps with synthetic sex pheromone placed at 1.5 and 2.5 m height, wich had the better results. Trap color and model did not affect male capture.

Diagnostic and prognostic value of antibodies against chimeric fibrin/filaggrin citrullinated synthetic peptides in rheumatoid arthritis

Introduction: Evidence suggests that citrullinated fibrin(ogen) may be a potential in vivo target of anticitrullinated protein/peptide antibodies (ACPA) in rheumatoid arthritis (RA). We compared the diagnostic yield of three enzyme-linked immunosorbent assay (ELISA) tests by using chimeric fibrin/filaggrin citrullinated synthetic peptides (CFFCP1, CFFCP2, CFFCP3) with a commercial CCP2-based test in RA and analyzed their prognostic values in early RA. Methods: Samples from 307 blood donors and patients with RA (322), psoriatic arthritis (133), systemic lupus erythematosus (119), and hepatitis C infection (84) were assayed by using CFFCP- and CCP2-based tests. Autoantibodies also were analyzed at baseline and during a 2-year follow-up in 98 early RA patients to determine their prognostic value. Results: With cutoffs giving 98% specificity for RA versus blood donors, the sensitivity was 72.1% for CFFCP1, 78.0% for CFFCP2, 71.4% for CFFCP3, and 73.9% for CCP2, with positive predictive values greater than 97% in all cases. CFFCP sensitivity in RA increased to 80.4% without losing specificity when positivity was considered as any positive anti-CFFCP status. Specificity of the three CFFCP tests versus other rheumatic populations was high (> 90%) and similar to those for the CCP2. In early RA, CFFCP1 best identified patients with a poor radiographic outcome. Radiographic progression was faster in the small subgroup of CCP2-negative and CFFCP1-positive patients than in those negative for both autoantibodies. CFFCP antibodies decreased after 1 year, but without any correlation with changes in disease activity. Conclusions: CFFCP-based assays are highly sensitive and specific for RA. Early RA patients with anti-CFFCP1 antibodies, including CCP2-negative patients, show greater radiographic progression.

Oxygen-isotope thermometry of quartz-calcite veins - Unraveling the thermal-tectonic history of the subgreenschist facies Morcles nappe (Swiss Alps)

Combined structural analysis and oxygen isotope thermometry of syntectonic quartz-calcite fibrous veins can be used to correlate the thermal history of deformed rocks,vith specific structural and tectonic events. Results are presented for the Mercies nappe in the western Helvetic Alps, Switzerland, where mineral parageneses, illite `'crystallinity,'' and fluid inclusion chemistry record an apparent peak metamorphic temperature gradient that increased across the Morcles nappe from anchizonal conditions in the foreland to epizonal conditions in its hinterland root zone. Twenty-seven quartz-calcite veins were analyzed in this study in order to determine the temperatures of veining during formation and deformation of the nappe, Peak metamorphic temperatures ranged from approximate to 260 to 290 degrees C in the shallower, foreland localities and to approximate to 330 to 350 degrees C in the deeper, more hinterland localities at the end of S1-foliation formation, related to large-scale folding. Temperatures gradually decreased throughout the nappe during subsequent development of the S2 foliation and S3 crenulation cleavage, Uplift and erosion of the overlying nappe pile resulted in slow cooling of the Morcles nappe during the waning stages of the Alpine Orogeny. The dominant foliation-forming deformation of the Morcles nappe occurred at elevated temperatures over the course of 10 to 15 Ma. Combined structure-oxygen isotope analyses of quartz-calcite veins yield better temperature and temporal constraints on the thermal histories of subgreenschist vein-bearing tectonites than do other geothermometers.

Synthetic calibrators for the analysis of total metanephrines in urine: revisiting the conditions of hydrolysis.

BACKGROUND: The quantification of total (free+sulfated) metanephrines in urine is recommended to diagnose pheochromocytoma. Urinary metanephrines include metanephrine itself, normetanephrine and methoxytyramine, mainly in the form of sulfate conjugates (60-80%). Their determination requires the hydrolysis of the sulfate ester moiety to allow electrochemical oxidation of the phenolic group. Commercially available urine calibrators and controls contain essentially free, unhydrolysable metanephrines which are not representative of native urines. The lack of appropriate calibrators may lead to uncertainty regarding the completion of the hydrolysis of sulfated metanephrines, resulting in incorrect quantification. METHODS: We used chemically synthesized sulfated metanephrines to establish whether the procedure most frequently recommended for commercial kits (pH 1.0 for 30 min over a boiling water bath) ensures their complete hydrolysis. RESULTS: We found that sulfated metanephrines differ in their optimum pH to obtain complete hydrolysis. Highest yields and minimal variance were established for incubation at pH 0.7-0.9 during 20 min. CONCLUSION: Urinary pH should be carefully controlled to ensure an efficient and reproducible hydrolysis of sulfated metanephrines. Synthetic sulfated metanephrines represent the optimal material for calibrators and proficiency testing to improve inter-laboratory accuracy.