Seasonal variation in the proximate composition of rock oyster Saccostrea cucullata from Bombay coast

Changes in proximate composition of soft tissue of rock oyster Saccostrea cucullata inhabiting a polluted station at Bandra (stn. B) and a relatively clean area at Mudh Island (stn. M) were studied. An average protein content of 48.88 plus or minus 3.73 and 53.68 plus or minus 3.59% were recorded respectively for oysters from stns. M and B and the difference was significant. Mean carbohydrate content in oysters from stn. M amounted to 14.69 plus or minus 3.22 whereas at stn. B it was 8.70 plus or minus 1.61 and the difference was found highly significant. However, appreciable variation between stations was not observed in lipid and carbon content in oysters. Suitable periods for harvesting of these organisms are suggested.

Phosphate treatment of frozen prawns. Pt. 1. Screening of various phosphates for prevention of drip loss

Various phosphates and their mixtures were screened for their efficiency of preventing drip loss in frozen prawns. The effectiveness of the phosphates decreased in the following order: Sodium tripolyphosphate — Sodium pyrophosphate — Sodium hexametaphosphate Sodium metaphosphate — Sodium dihydrogen phosphate; the last two being ineffective. Even though thaw drip loss was reduced by the above treatments the organoleptic quality of the thawed as well as cooked products was unsatisfactory, discoloration being the major defect. A solution of a mixture of 12% sodium tripolyphosphate and 8.6% sodium dihydrogen phosphate or 2% citric acid in water when used as dip prevented thaw drip loss, improved cooked yield and organoleptic quality without adversely affecting the biochemical characteristics. Commercial scale trials showed that the results are highly reproducible.

Abrasive wear of steel during rolling-sliding contact with rock counterfaces

In many mining operations (e.g. excavation, drilling, tunnelling, rock crushing) metallic components are forced against abrasive rocks in a complex motion. This study examines the relative importance of combined rolling and sliding motion in the two-body abrasive wear of a low carbon tempered martensitic steel against rock counterfaces. A novel wear test rig has been used to vary the amount of rolling and sliding motion between a rotating steel cylinder and a counter-rotating sandstone (highly abrasive) or limestone (much less abrasive) disc. Weight-loss measurements reveal that the wear rate of the steel increases as the amount of motion against the rock counterface is reduced from pure sliding to approximately 50% sliding (and approximately 50% rolling). Scanning electron microscopy shows that when the amount of motion is reduced from pure sliding to approximately 50% sliding the topographical and sub-surface physical properties of the worn steel and rock surfaces are modified.

Copper, zinc, iron and manganese in sediments and in the rock oyster Saccostrea cucullata in Mumbai coast

Sediment and oyster (Saccostrea cucullata) samples were collected at Dhanda, a fishing village in Mumbai, Maharashtra. The samples were analysed for copper, zinc, iron and manganese contents. Metal concentrations in the sediments and bioaccumulated levels in oysters were correlated. There is no positive correlation between the total sedimentary levels of metals analysed and the bioaccumulated levels of respective metals in oyster. A positive correlation between the bioavailable fractions of zinc, iron and manganese, and the bioaccumulated levels exists. Copper, however, shows a negative correlation with respect to the bioaccumulated levels.

Distribution and growth biology of rock oyster Saccostrea cucullata in the Oman Sea

Distribution and growth biology of rock oyster (Saccostrea cucullata) in the northern shores of Oman sea have been struied. During this one-year study, samples have been taken monthly from ten different stations. quantity of vertical distribution of this species was obseredl in the mid - intertidal zone. After determining the spread pattern, the following subjects were studied: - Growth parameters - Distionction of the "cohorts" - Determination of "spawning Season" - Condition of the "Gonado Somatic Index" - Sex ratio - Length of the species during the first year of maturation. - Identification and determination of percentage of "Biofouler Organisms." Results obtained from the above - mentioned studies show that considering a growth factor (k) of 0.52, the value of "Loo " for this species is equal to 114 (mm).Five to six different age groups were observed among the samples taken. In the areas where this study was conducted, this species grows 24 to 30 (mm) in the first year of its life this growth rate is lower in the higher - aged grpups relative to the lewer - aged groups, so that the longest size classes grow between 4 to 6 (mm) per year. • The maxinum Value of the "Condition Index" is in the pozm area and the minimum value of it belongs to Darak and Tang areas. Along with the increase in the growth of gonads the above mentioned condition index increases gradually simultaneous with the onset of spawning. Also, study of the influence of environmental factors on the maturation process suggests that the most important factors affecting maturation and spawing are temperature and salinity. The study of GSI shows that this species has a coordinated bimodal spawing trend, with its spring peak in june and its autumn peak, being still higher than the spring peak, in september. The recruitment curve confirms the above spawning peaks with its peaks occuring after a delay of one month or maximum two months in comparison to the spawning peaks. The results of calcuation of "Sex Ratio" of this species in each area show that sex ratio is 1:1. Among the first size classes that reach maturity, nearly 67% of the samples are male and the remaining 33% are female. with the increase in the shell size, the percentage of males decreases and the percentage of females increases. , The above facts prove the protandrous nature of this species the diagram showing the sizes of the first samples which reach maturity suggests that more than 50% of the samples mature after their length exceeds 36 (mm). The shortest mature sample was found to have a length of 22(mm). After studying "Biofouler Organism" nine different invertebrate groups were indentified. Barnacles and Tunicates have the highest and lowest percentages respectively. According to zonal observations, Barnacles and polychacta do the greatest damage to this species.

Imaging the failure of a rock-fill dam following liquefaction

Rock-fill dams are popular in developing countries due to their ease of construction and use of local materials. They are used to store water and to provide flood defences. The presence of such dams in earthquake-prone regions poses risks, particularly from ground liquefaction. In this paper, results from physical model tests on dams with different configurations are presented. Model dams with impermeable cores including sheet pile walls and clay cores were tested and the effect of reservoir water was investigated. High-speed photography was used to capture the response of the model dams allowing the movement of foundation soil below the dam to be established. It is concluded that the stiffness of the impermeable core has a significant influence on the ultimate deformation of the dam. The presence of reservoir water led to increased downstream movements of the dam and differential settlements between the upstream and downstream sides.