Erratum: Alcohol-aminosilicate hybrid coatings for corrosion protection of galvanized steel in mortar

Artigo completo publicado na revista "Journal of The Electrochemical Society" 161:6 (2014) C349-C362 e disponível no RepositóriUM em: http://hdl.handle.net/1822/33784

Erratum: Erratum: Alcohol-aminosilicate hybrid coatings for corrosion protection of galvanized steel in mortar

Artigo completo publicado na revista "Journal of The Electrochemical Society" 161:6 (2014) C349-C362 e disponível no RepositóriUM em: http://hdl.handle.net/1822/33784. Errata disponível no RepositóriUM em: http://hdl.handle.net/1822/40064. (Publisher’s note: An erratum that addressed the errors in Figure 9 was originally published on Dec. 10, 2014, however the graphs in that erratum were not correct.)

Experimental and numerical studies of hybrid PCM embedded in plastering mortar for enhanced thermal behaviour of buildings

This paper proposes a methodology for improvement of energy efficiency in buildings through the innovative simultaneous incorporation of three distinct phase change materials (here termed as hybrid PCM) in plastering mortars for façade walls. The thermal performance of a hybrid PCM mortar was experimentally evaluated by comparing the behaviour of a prototype test cell (including hybrid PCM plastering mortar) subjected to realistic daily temperature profiles, with the behaviour of a similar prototype test cell, in which no PCM was added. A numerical simulation model was employed (using ANSYS-FLUENT) to validate the capacity of simulating temperature evolution within the prototype containing hybrid PCM, as well as to understand the contribution of hybrid PCM to energy efficiency. Incorporation of hybrid PCM into plastering mortars was found to have the potential to significantly reduce heating/cooling temperature demands for maintaining the interior temperature within comfort levels when compared to normal mortars (without PCM), or even mortars comprising a single type of PCM.

Optimal behavior of responsive residential demand considering hybrid phase change materials

Due to communication and technology developments, residential consumers are enabled to participate in Demand Response Programs (DRPs), control their consumption and decrease their cost by using Household Energy Management (HEM) systems. On the other hand, capability of energy storage systems to improve the energy efficiency causes that employing Phase Change Materials (PCM) as thermal storage systems to be widely addressed in the building applications. In this paper, an operational model of HEM system considering the incorporation of more than one type of PCM in plastering mortars (hybrid PCM) is proposed not only to minimize the customerâ s cost in different DRPs but also to guaranty the habitantsâ  satisfaction. Moreover, the proposed model ensures the technical and economic limits of batteries and electrical appliances. Different case studies indicate that implementation of hybrid PCM in the buildings can meaningfully affect the operational pattern of HEM systems in different DRPs. The results reveal that the customerâ s electricity cost can be reduced up to 48% by utilizing the proposed model.

Development of hybrid composite plate (HCP) for strengthening and repair of RC structures

Tese de Doutoramento em Engenharia Civil

Hybrid hypervisor partially deployed on FPGA

Tese de Doutoramento em Engenharia Eletrónica e Computadores.

Closed hybrid hierarchical reservoirs based on the deconstruction of the cellular native microenvironment

The stem cell niche organization and dynamics provide valuable cues for the development of mimetic environments that could have potential to stimulate the regenerative process. We propose the use of biodegradable biomaterials to produce closed miniaturised structures able to encapsulate different cell types or bioactive molecules. In particular, capsules are fabricated using the so-called layer-by-layer technology, where the consecutive (nano-sized) layers are well stabilized by electrostatic interactions or other weak forces. Using alginate-based spherical templates containing cells or other elements (e.g. proteins, magnetic nanoparticles, microparticles) it is possible to produce liquefied capsules that may entrap the entire cargo under mild conditions. The inclusion of liquefied micropcapsules may be used to produce hierarchical compartmentalised systems for the delivery of bioactive agents. The presence of solid microparticles inside such capsules offers adequate surface area for adherent cell attachment increasing the biological performance of these hierarchical systems, while maintain both permeability and injectability. We demonstrated that the encapsulation of distinct cell types (including mesenchymal stem cells and endothelial cells) enhances the osteogenic capability of this system, that could be useful in bone tissue engineering applications.

Incorporation of hybrid phase change materials in plastering mortars for increased energy efficiency in buildings

Tese de Doutoramento em Engenharia Civil.

Synchronous reproduction may facilitate introgression in a hybrid mussel (Mytilus) population

Mussel populations on the Irish Atlantic coast comprise an interbreeding mixture of the blue mussel, Mytilus edulis (L.) and the Mediterranean mussel, Mytilus galloprovincialis (Lmk.). The occurrence of hybrid genotypes varies between sites but can be as high 80%. This study compares the reproductive cycle of M. edulis, M. galloprovincialis and their hybrids to determine if the extensive hybridisation observed at Irish Atlantic coast sites is linked to spawning synchrony between the two taxa. Mussels (40-45 mm size class) were collected monthly from a sheltered shore in Galway Bay from January to December 2005. Two major spawning events (March- June and September-October) were observed and gametogenesis took place throughout the year. The spawning cycles of the three taxa were largely overlapping. Small differences were observed in the timing of peak spawning which occurred in March and October in M. galloprovincialis and in May-June and September in M.edulis. Spawning of hybrid individuals was intermediate between the parental genotypes. Fecundity was slightly higher in M. galloprovincialis females compared to the other taxa (up to 30% difference, p<0.05). This apparent advantage is not shared by the sexes and is likely being offset by high numbers of hybrid genotypes releasing gametes during peak spawning of M. galloprovincialis. There was no evidence for increased mortality in hybrid males; sex ratios did not deviate from the 1:1 ratio. The results show that in this region of the hybrid zone the timing of reproduction does not present a barrier to gene flow between M. edulis and M. galloprovincialis. Nonetheless, small differences in the timing of peak spawning may increase the likelihood of conspecific fertilisation at certain times of the year. Hybrids outnumber the parental genotypes, undergo complete gametogenesis and show no evidence of depressed fitness (i.e. hybrids are reproductively competent suggesting a high degree of introgression.

A new hybrid in the palm genus Syagrus Mart. / S. F. Glassman.

v.32:no.16(1970)

Gonadal hybrid dysgenesis in Drosophila sturtevanti (Diptera, Drosophilidae)

The occurrence of hybrid dysgenesis was investigated in Drosophila sturtevanti Duda, 1927 using diagnostic crosses similar to those used for induction of dysgenics traits in D. melanogaster. Reciprocal test crosses were made, at 27° C, between an old laboratory strain of D. sturtevanti (COL, from Colombia), assumed to be an M'-like strain, and eight freshly collected strains from several natural populations. The gonadal dysgenesis indices were under 10% in most of crosses, except in hybrids of COL with I27, a strain from Minas Gerais (Brazil), in which the index values were moderate in both directions of crosses (25.71 and 12.87). The smallest productivity was also observed in hybrids of females COL mated to I27 males. No causal relationship between the observed gonadal dysgenesis and mobilization of P element or another transposable element could be effectively established.

Preliminary study of cooperation in hybrid ad-hoc networks

In this paper, we present a first approach to evolve a cooperative behavior in ad hoc networks. Since wireless nodes are energy constrained, it may not be in the best interest of a node to always accept relay requests. On the other hand, if all nodes decide not to expend energy in relaying, then network throughput will drop dramatically. Both these extreme scenarios are unfavorable to the interests of a user. In this paper we deal with the issue of user cooperation in ad hoc networks by developing the algorithm called Generous Tit-For-Tat. We assume that nodes are rational, i.e., their actions are strictly determined by self-interest, and that each node is associated with a minimum lifetime constraint. Given these lifetime constraints and the assumption of rational behavior, we study the added behavior of the network.

Technology shocks and aggregate fluctuations in an estimated hybrid RBC model

This paper contributes to the on-going empirical debate regarding the role of the RBC model and in particular of technology shocks in explaining aggregate fluctuations. To this end we estimate the model’s posterior density using Markov-Chain Monte-Carlo (MCMC) methods. Within this framework we extend Ireland’s (2001, 2004) hybrid estimation approach to allow for a vector autoregressive moving average (VARMA) process to describe the movements and co-movements of the model’s errors not explained by the basic RBC model. The results of marginal likelihood ratio tests reveal that the more general model of the errors significantly improves the model’s fit relative to the VAR and AR alternatives. Moreover, despite setting the RBC model a more difficult task under the VARMA specification, our analysis, based on forecast error and spectral decompositions, suggests that the RBC model is still capable of explaining a significant fraction of the observed variation in macroeconomic aggregates in the post-war U.S. economy.

A vertebrate reproductive system involving three ploidy levels : hybrid origin of triploids in a contact zone of diploid and tetraploid green toads (Bufo viridis subgroup)

The rise and consequences of polyploidy in vertebrates, whose origin was associated with genome duplications, may be best studied in natural diploid and polyploid populations. In a diploid/tetraploid (2n/4n) geographic contact zone of Palearctic green toads in northern Kyrgyzstan, we examine 4ns and triploids (3n) of unknown genetic composition and origins. Using mitochondrial and nuclear sequence, and nuclear microsatellite markers in 84 individuals, we show that 4n (Bufo pewzowi) are allopolyploids, with a geographically proximate 2n species (B. turanensis) being their maternal ancestor and their paternal ancestor as yet unidentified. Local 3n forms arise through hybridization. Adult 3n mature males (B. turanensis mtDNA) have 2n mothers and 4n fathers, but seem distinguishable by nuclear profiles from partly aneuploid 3n tadpoles (with B. pewzowi mtDNA). These observations suggest multiple pathways to the formation of triploids in the contact zone, involving both reciprocal origins. To explain the phenomena in the system, we favor a hypothesis where 3n males (with B. turanensis mtDNA) backcross with 4n and 2n females. Together with previous studies of a separately evolved, sexually reproducing 3n lineage, these observations reveal complex reproductive interactions among toads of different ploidy levels and multiple pathways to the evolution of polyploid lineages.