Bulk composition and clay mineralogy at DSDP Legs 56 and 57

Altogether 513 samples from sediments of Cretaceous to Pleistocene age from DSDP Legs 56 and 57 were examined by x-ray methods. The main constituents are clay minerals, quartz, feldspar, opaline silica, and volcanic glass. The sediment composition reflects the position of the sites in relation to the main source area, the Japanese Island Arc. For example, relatively coarse-grained material rich in quartz and feldspar was deposited closest to the islands, whereas finer-grained material rich in clay minerals (mainly smectite and illite, with lesser amounts of kaolinite and chlorite) was deposited farther seaward. Vertical fluctuations in the composition of the sediments show the same trend in all sites and are caused mainly by a fluctuating contribution of biogenic silica with time. A trend reversal in the chlorite/kaolinite ratio at Site 438 supports the conclusion that the subsidence of the Oyashio ancient landmass took place during the middle Miocene. That ratio also indicates a northwest drift in the position of Site 436 by sea floor spreading. Oscillations of the illite/smectite ratio during the Pleistocene at Site 436 show the variations of climate during this period. During early diagenesis potassium is fixed in smectite. With increasing depth of burial a smectite-illite mixed layer is formed, with increasing illite layering. At Sites 434, 440, and 441, stepwise changes confirm intensive tectonic process at the midslope terrace and the lower inner slope of the Japan Trench.

Age and oxygen isotope data for bulk carbonate from DSDP Sites 41-366 and 72-516 and ODP Sites 111-677A and 130-807

A numerical model which describes oxygen isotope exchange during burial and recrystallization of deep-sea carbonate is used to obtain information on how sea surface temperatures have varied in the past by correcting measured d18O values of bulk carbonate for diagenetic overprinting. Comparison of bulk carbonate and planktonic foraminiferal d18O records from ODP site 677A indicates that the oxygen isotopic composition of bulk carbonate does reflect changes in sea surface temperature and d18O. At ODP Site 690, we calculate that diagenetic effects are small, and that both bulk carbonate and planktonic foraminiferal d18O records accurately reflect Paleogene warming of high latitude surface oceans, biased from diagenesis by no more than 1°C. The same is likely to be true for other high latitude sites where sedimentation rates are low. At DSDP sites 516 and 525, the effects of diagenesis are more significant. Measured d18O values of Eocene bulk carbonates are more than 2? lower at deeply buried site 516 than at site 525, consistent with the model prediction that the effects of diagenesis should be proportional to sedimentation rate. Model-corrections reconcile the differences in the data between the two sites; the resulting paleotemperature reconstruction indicates a 4°C cooling of mid-latitude surface oceans since the Eocene. At low latitudes, the contrast in temperature between the ocean surface and bottom makes the carbonate d180 values particularly sensitive to diagenetic effects; most of the observed variations in measured d18O values are accounted for by diagenetic effects rather than by sea surface temperature variations. We show that the data are consistent with constant equatorial sea surface temperatures through most of the Cenozoic, with the possible exception of the early Eocene, when slightly higher temperatures are indicated. We suggest that the lower equatorial sea surface temperatures for the Eocene and Oligocene reported in other oxygen isotope studies are artifacts of diagenetic recrystallization, and that it is impossible to reconstruct accurately equatorial sea surface temperatures without explicitly accounting for diagenetic overprinting.

(Table 2) Composition of the deapest pore fluids from ODP Holes 168-1030B and 168-1031A

On the eastern flank of the Juan de Fuca Ridge, reaction between upwelling basement fluid and sediment alters hydrothermal fluxes of Ca, SiO2(aq), SO4, PO4, NH4, and alkalinity. We used the Global Implicit Multicomponent Reactive Transport (GIMRT) code to model the processes occurring in the sediment column (diagenesis, sediment burial, fluid advection, and multicomponent diffusion) and to estimate net seafloor fluxes of solutes. Within the sediment section, the reactions controlling the concentrations of the solutes listed above are organic matter degradation via SO4 reduction, dissolution of amorphous silica, reductive dissolution of amorphous Fe(III)-(hydr)oxide, and precipitation of calcite, carbonate fluorapatite, and amorphous Fe(II)-sulfide. Rates of specific discharge estimated from pore-water Mg profiles are 2 to 3 mm/yr. At this site the basement hydrothermal system is a source of NH4, SiO2(aq), and Ca, and a sink of SO4, PO4, and alkalinity. Reaction within the sediment column increases the hydrothermal sources of NH4 and SiO2(aq), increases the hydrothermal sinks of SO4 and PO4, and decreases the hydrothermal source of Ca. Reaction within the sediment column has a spatially variable effect on the hydrothermal flux of alkalinity. Because the model we used was capable of simulating the observed pore-water chemistry by using mechanistic descriptions of the biogeochemical processes occurring in the sediment column, it could be used to examine the physical controls on hydrothermal fluxes of solutes in this setting. Two series of simulations in which we varied fluid flow rate (1 to 100 mm/yr) and sediment thickness (10 to 100 m) predict that given the reactions modeled in this study, the sediment section will contribute most significantly to fluxes of SO4 and NH4 at slow flow rates and intermediate sediment thickness and to fluxes of SiO2(aq) at slow flow rates and large sediment thickness. Reaction within the sediment section could approximately double the hydrothermal sink of PO4 over a range of flow rates and sediment thickness, and could slightly decrease (by

Stable carbon and oxygen isotope ratios of carbonates of ODP Site 103-639

A Tithonian sequence of shallow-water limestones, intercalated with siliciclastics and overlain by dolomite, was recovered during drilling at ODP Site 639 on the edge of a tilted fault block. The carbonates were strongly affected by fracturing, dolomitization, dedolomitization, and compaction. The chronology and nature of the fractures, fracture infilling, and diagenesis of the host rock are established and correlated for both the limestone and the dolomite. A first phase of dolomitization affected limestone that was already, at least partially, indurated. In the limestone unit, fractures were filled by calcite and dolomite; most of the dolomite was recrystallized into calcite, except for the upper part. In the dolomitic unit, the first-formed dolomite was progressively recrystallized into saddle dolomite, as fractures were simultaneously activated. The dolomitic textures become less magnesian (the molar ratio mMg/mCa goes from 1.04-0.98 to 0.80), and the d18O (PDB) ranges from -10 per mil to -8 per mil. The varying pores and fissures are either cemented by a calcic saddle dolomite (mMg/mCa ranging from 0.95 to 0.80) or filled with diverse internal sediments of detrital calcic dolomite, consisting of detrital dolomite silt (d18O from -9 per mil to -7 per mil) and laminated yellow filling (with different d18O values that range from -4 per mil to +3 per mil). These internal sediments clearly contain elements of the host rock and fragments of saddle crystals. They are covered by marls with calpionellids of early Valanginian age, which permits dating of most of the diagenetic phases as pre-Valanginian. The dolomitization appears to be related to fracturing resulting from extensional tectonics; it is also partially related to an erosional episode. Two models of dolomitization can be proposed from the petrographic characteristics and isotopic data. Early replacement of aragonite bioclasts by sparite, dissolution linked to dolomitization, and negative d18O values of dolomite suggest a freshwater influence and 'mixing zone' model. On the other hand, the significant presence of saddle dolomite and repeated negative d18O values suggest a temperature effect; because we can dismiss deep burial, hydrothermal formation of dolomite would be the most probable model. For both of these hypotheses, the vadose filling of cavities and fractures by silt suggests emersion, and the different, and even positive, d18O values of the last-formed yellow internal sediment could suggest dolomitization of the top of the sequence under saline to hypersaline conditions. Fracturing resulting in the reopening of porosity and the draining of dolomitizing fluids was linked to extensional tectonics prior to the tilting of the block. These features indicate an earlier beginning to the rifting of the Iberian margin than previously known. Dolomitization, emersion, and erosion correspond to eustatic sea-level lowering at the Berriasian/Valanginian boundary. Diagenesis, rather than sedimentation, seems to mark this global event and to provide a record of the regional tectonic history.

Geochemistry of Neogene-Quaternary sediments in ODP Site 105-645

Subcontinuously cored early(?)-middle Miocene to recently deposited sediments from ODP Site 645 were studied texturally, mineralogically, and geochemically. The entire sequence contains minerals and associated chemical elements that are chiefly of detrital origin. In particular, the clay minerals, which include smectite, kaolinite, chlorite, and illite, are detrital. No obvious evidence of diagenesis with depth, of burial, of volcanism, or of hydrothermal alteration was observed. The sedimentary textures, clay mineralogy, and <2-µm fraction geochemistry of the early middle Miocene sediments (630 to 1147 mbsf) suggest the pronounced but variable influence of a southward bottom current. Two clay facies are defined. The lower one, Cj (780 to 1147 mbsf), is characterized by the great abundance of discrete smectite (with less than 15% illite interlayers), probably detrital in origin, and reworked older, discrete, smectite-rich sediments. The upper clay facies, C2 (630 to 780 mbsf), shows a net decrease of the fully expandable clay abundances, with a great abundance of mixed-layer, illite-smectite clays (60 to 80% of illite interlayers). Such clay assemblages can be inherited from paleosoils or older sedimentary rocks. An important change occurs at 630 mbsf (clay fraction) or 600 mbsf (sedimentary texture), which may be explained by the beginning of continental glaciation (630 mbsf, ~9 Ma) and the onset of ice rafting in Baffin Bay (600 mbsf, ~8 Ma). Above this level, the characteristics and modifications of the clay assemblages are controlled climatically and can be explained by the fluctuations of (1) ice-rafting, (2) speed of weak bottom currents, and (3) some supply by mud turbiditic currents. Three clay facies (C3, C4, and C5) can be defined by the abrupt increases of the inherited chlorite and illite clays.

(Table T1) Composition of clay minerals from ODP Leg 204 sediments

This report describes the results of semiquantitative analysis of clay mineral composition by X-ray diffraction. The samples consist of hemipelagic mud and mudstone cored from Hydrate Ridge during Leg 204 of the Ocean Drilling Program. We analyzed oriented aggregates of the clay-sized fractions (<2 µm) to estimate relative percentages of smectite, illite, and chlorite (+ kaolinite). For the most part, stratigraphic variations in clay mineral composition are modest and there are no significant differences among the seven sites that were included in the study. On average, early Pleistocene to Holocene trench slope and slope basin deposits contain 29% smectite, 31% illite, and 40% chlorite (+ kaolinite). Late Pliocene to early Pleistocene strata from the underlying accretionary prism contain moderately larger proportions of smectite with average values of 38% smectite, 27% illite, and 35% chlorite (+ kaolinite). There is no evidence of clay mineral diagenesis at the depths sampled. The expandability of smectite is, on average, equal to 64%, and there are no systematic variations in expandability as a function of burial depth or depositional age. The absence of clay mineral diagenesis is consistent with the relatively shallow sample depths and corresponding maximum temperatures of only 24°-33°C.