Production of low methoxyl pectin using immobilized pectin methylesterase silica from acerola (Malpighia glabra L.)

The aim of this work was to develop an efficient reactor for the production of low methoxyl pectin, using pectinmethylesterase (PME, EC 3.1.1.11) from acerola immobilized on silica. The immobilized enzyme was used in up to 50 successive bioconversion runs at 50 degrees C with an efficiency loss of less than 20%. The fixed-bed reactor (6.0 x 1.5 cm) was prepared using PME immobilized in glutaraldehyde-activated silica operated at 50 degrees C with an optimum flow rate of 10 mL h(-1). The bioconversion yield was shown to strongly depend on the nature of the enzymatic preparation. An efficiency of 44% was achieved when concentrated PME was used, compared with only 30% with purified PME, both after an 8-h run. The process described could provide the basis for the development of a commercial-scale process. (c) 2006 Society of Chemical Industry.

A multi-cell variable frequency interleaved ZCS boost rectifier digitally controlled by FPGA

This paper presents a multi-cell single-phase high power factor boost rectifier in interleave connection, operating in critical conduction mode, employing a soft-switching technique, and controlled by Field Programmable Gate Array (FPGA). The soft-switching technique is based on zero-current-switching (ZCS) cells, providing ZC (zero-current) turn-on and ZCZV (zero-current-zero-voltage) turn-off for the active switches, and ZV (zero-vohage) turn-on and ZC (zero-current) turn-off for the boost diodes. The disadvantages related to reverse recovery effects of boost diodes operated in continuous conduction mode (additional losses, and electromagnetic interference (EMI) problems) are minimized, due to the operation in critical conduction mode. In addition, due to the interleaving technique, the rectifier's features include the reduction in the input current ripple, the reduction in the output voltage ripple, the use of low stress devices, low volume for the EMI input filter, high input power factor (PF), and low total harmonic distortion (THD) in the input current, in compliance with the IEC61000-3-2 standards. The digital controller has been developed using a hardware description language (VHDL) and implemented using a XC2S200E-SpartanII-E/Xilinx FPGA device, performing a true critical conduction operation mode for all interleaved cells, and a closed-loop to provide the output voltage regulation, like as a preregulator rectifier. Experimental results are presented for a implemented prototype with two and with four interleaved cells, 400V nominal output voltage and 220V(rms) nominal input voltage, in order to verify the feasibility and performance of the proposed digital control through the use of a FPGA device.

Szego polynomials and the truncated trigonometric moment problem

We show how Szego polynomials can be used in the theory of truncated trigonometric moment problem.

A Lagrangian bound for many-to-many assignment problems

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Performance of Cultivars for Production of Green Corn in Different Planting Dates in Passos Region, MG

The aim of this work was evaluating the performance of several cultivars of green corn for consumption 'in natura' in different planting dates. The first planting date was on May 26th, and the others, every 40 days. The hybrids (treatments) were: AG-1051, Agroeste 1567, BM-3061, Prezoto-32D10, PL-6880, BX-1382 and GNZ-2004. The following characteristics were evaluated: production, commercial ears weight without husk, commercial ears number, commercial ears diameter and length, male flowering, plant height and height of ear corn insertion. The cultivars AG1051, Agroeste 1567 and BM 3061 presented the best results compared to the others and they should be used in green corn production for ` in natura' consumption in Passos County, MG.

Acute exposure of a glyphosate-based herbicide affects the gills and liver of the Neotropical fish, Piaractus mesopotamicus

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Cadmium and exposure to stress increase aggressive behavior

Environmental toxicants and stress influence the health and behavior of people from different parts of the world. In the present study, aggressive behavior was evaluated in rats exposed to cadmium (Cd) for four weeks and subjected to immobilization stress (IS) based on the resident/intruder paradigm. Latency to the first bite (LB), total number of attacks (NA), total duration of attack manifestations (DAM), and a composite aggression score (CAS) were used to assess aggressiveness. Cadmium concentrations in the blood and the brain were determined. We observed that the parameters of aggressiveness were not altered by either Cd or IS when administered separately. However, animals exposed to Cd + IS had increased NA, DAM, and CAS. Cadmium was detected in the blood and the brain after treatment and Cd + IS exposure modified Cd distribution in these tissues. These results suggest that exposure to low levels of Cd associated with stress may lead to increased aggressiveness in rats. (C) 2011 Elsevier B.V. All rights reserved.

Interaction between total-etch and self-etch adhesives and conventional and self-adhesive resin cements

The aim of this study was to compare the bond strength to enamel between resin cements combined with total-etch and self-etch adhesive systems and a self-adhesive cement. Eighty bovine incisors had their buccal surface ground flat exposing a plane area in the enamel. Eighty Artglass resin cylinders measuring 3 mm in diameter and 4 mm in height were fabricated. The teeth were divided into eight groups of 10 teeth each and the resin cylinders were cemented with different adhesive systems and resin cements; G1: RelyX Unicem (self-adhesive cement); G2: H 3PO 4 + Single Bond + RelyX ARC; G3: AdheSE + Variolink II; G4: H 3PO 4 + Excite + Variolink II; G5: Xeno III + Enforce; G6: H 3PO 4 + Prime&Bond NT + Enforce; G7: Biatite Primers 1 and 2 + Bistite II DC; G8: H 3PO 4 + Bistite Primers 1 and 2 + Bistite II DC. After application of the adhesives, the cylinders were cemented according to manufacturer instructions. The specimens were submitted to 2000 thermal cycles at a temperature ranging from 5±5°C to 55±5°C, and shear bond strength was then tested at a variety of 1 mm/min. The data were analyzed by ANOVA and the Tukey's test (á=5%), obtaining a p value of 0.00. The following mean (±standard deviation) bond strength values were observed for each group: G1: 5.14(±0.99)a; G3: 16.23(±4.69)b; G7: 17.82(±3.66)b; G5: 18.48(±2.88)bc; G8: 20.15(±4.12)bc; G4: 22.85(±3.08)cd; G2: 24.96(±2.89)d; G6: 26.07(±1.69)d. Groups followed by the same letters did not differ significantly. For most of the resin cements tested, the application of adhesive systems using acid etching resulted in a higher bond strength when compared to the self-etch adhesive systems and to the self-adhesive cement.

El Salvador: impacto socioeconómico, ambiental y de riesgo por la baja presión asociada a la tormenta tropical Ida en noviembre de 2009

Incluye Bibliografía

Políticas de viviendas de interés social orientadas al mercado: experiencias recientes con subsidios a la demanda en Chile, Costa Rica y Colombia

Incluye Bibliografía

Moral judgment competence of medical students: a transcultural study

The authors conducted a cross-sectional short-term study using Lind's Moral Judgment Test (MJT) to compare moral judgment competence (C-score) among students from a medical school in the Northeast region of Brazil and a medical school in the Northern region of Portugal. This study compares the C-scores of groups in the first and eighth semesters of study within each medical school and groups from corresponding semesters between the two medical schools. This study also evaluates the influence of such factors as age and gender on moral competence. A regression of moral judgment competence among the students in their eighth semester versus the students in the first semester of Brazilian medical school (p < 0.001) and a stagnation of moral competence among students in their eighth semester versus the first semester students in the Portuguese medical school (p = 0.06) were observed. For both the first semester and eighth semester groups, the students in the Portuguese medical school had higher C-scores than the students in the Brazilian medical school. In the analysis of the students' performances in terms of MJT dilemmas, the phenomenon of moral segmentation was observed in all of the groups, and the students performed better on the worker's dilemma than on the doctor's dilemma. Among students in the same semester of study, older students had lower C-scores. There was generally no significant difference between men's and women's C-scores. © 2013 Springer Science+Business Media Dordrecht.

Los desafíos de fin de siglo y la problemática juvenil rural en América Latina

Incluye Bibliografía

Dendritic thickness: a morphometric parameter to classify mouse retinal ganglion cells

To study the dendritic morphology of retinal ganglion cells in wild-type mice we intracellularly injected these cells with Lucifer yellow in an in vitro preparation of the retina. Subsequently, quantified values of dendritic thickness, number of branching points and level of stratification of 73 Lucifer yellow-filled ganglion cells were analyzed by statistical methods, resulting in a classification into 9 groups. The variables dendritic thickness, number of branching points per cell and level of stratification were independent of each other. Number of branching points and level of stratification were independent of eccentricity, whereas dendritic thickness was positively dependent (r = 0.37) on it. The frequency distribution of dendritic thickness tended to be multimodal, indicating the presence of at least two cell populations composed of neurons with dendritic diameters either smaller or larger than 1.8 µm ("thin" or "thick" dendrites, respectively). Three cells (4.5%) were bistratified, having thick dendrites, and the others (95.5%) were monostratified. Using k-means cluster analysis, monostratified cells with either thin or thick dendrites were further subdivided according to level of stratification and number of branching points: cells with thin dendrites were divided into 2 groups with outer stratification (0-40%) and 2 groups with inner (50-100%) stratification, whereas cells with thick dendrites were divided into one group with outer and 3 groups with inner stratification. We postulate, that one group of cells with thin dendrites resembles cat ß-cells, whereas one group of cells with thick dendrites includes cells that resemble cat a-cells.