植物对环境污染的磁学响应机理研究

With development of industry and acceleration of urbanization, problems of air quality as well as their influences on human health have recently been regarded highly by current international communities and governments. Generally, industrializations can result in exhausting of a lot of industry gases and dusts, while urbanization can cause increasing of modern vehicles. Comparing with traditional chemical methods, magnetic method is simple, rapid, exact, low-cost and non-destructive for monitoring air pollution and has been widely applied in domestic and international studies. In this thesis, with an aim of better monitoring air pollution, we selected plants (highroad-side perennial pine trees (Pinus pumila Regel) along a highroad linking Beijing City and the Capital International Airport, and tree bark and tree ring core samples (willow, Salix matsudana) nearby a smelting industry in northeast Beijing) for magnetic studies. With systemic magnetic measurements on these samples, magnetic response mechanism of contamination（e.g. tree leaves, tree ring）to both short- and long-term environmental pollution has been constructed, and accordingly the pollution range, degree and process of different time-scale human activities could be assessed. A series of rock magnetic experiments of tree leaves show that the primary magnetic mineral of leaf samples was identified to be magnetite, in pseudo-single domain (PSD) grain size range of 0.2-5.0 μm. Magnetite concentration and grain size in leaves are ascertained to decrease with increasing of sampling distance to highroad asphalt surface, suggesting that high magnetic response to traffic pollution is localized within a distance of about 2 m away from highroad asphalt surface. On the other hand, highroad-side trees and rainwater can effectively reduce the concentration of traffic pollution-induced particulate matters (PMs) in the atmosphere. This study is the first time to investigate the relationship of smelting factory activities and vicissitudes of environment with tree rings by magnetic methods. Results indicate that magnetic particles are omnipresent in tree bark and trunk wood. Magnetic techniques including low-temperature experiment, successive acquisition of IRM, hysteresis loops and SIRM measurements suggest that magnetic particles are predominated by magnetite in pseudo-single domain state. Comparison of magnetic properties of tree trunk and branch cores collected from different directions and heights implies that collection of magnetic particles depends on both sampling direction and height. Pollution source-facing tree trunk wood contains significantly more magnetic particles than other sides. These indicate that magnetic particles are most likely intercepted and collected by tree bark first, then enter into tree xylem tissues by translocation during growing season, and are finally enclosed in a tree ring by lignifying. Correlation between magnetic properties such as time-dependent SIRM values of tree ring cores and the annual steel yields of the smelting factory is significant. Considering the dependence of magnetic properties in sampling directions, heights, and ring cores, we proposed that magnetic particles in the xylem cannot move between tree rings. Accordingly, the SIRM and some other magnetic parameters of tree ring cores from the source-facing side could be contributed to historical study of atmospheric pollution produced by heavy metal smelting activities, isoline diagrams of SIRM values of all the tree rings indicate that air pollution is increasing worse. We believed that a synthetic rock magnetic study is an effective method for determining concentration and grain size of ferromagnets in the atmospheric PMs, and then it should be a rapid and feasible technique for monitoring atmospheric pollution.

Neolignans, styrylpyrones and flavonoids from an Aniba species

The trunk wood and barks from an Aniba species contain four esters of benzoic acid with cinnamyl alcohol, five benzofuran neolignans, licarin-A, burchellin, cis-burchellin, burchellin-rearranged and cis-burchellin-rearranged, one tetrahydrofuran neolignan, aristolignin, three bicyclooctane guianin-type neolignans, (7S, 8S, 1'R, 5'R)-4-hydroxy-3,3'-dimethoxy-4',6'-dioxo-8.1', 7.5'-neolignan-Delta: 1,3,5,2',8' and the new (7S, 8S, 1'R, 4'R, 5'S)-4'-hydroxy-3,4,3'-trimethoxy-6'-oxo-8.1', 7.5'-neolignan-Delta: 1,3,5,2',8' and (7S, 8S, 1'R, 4'R, 5'S)-4,4'-dihydroxy-3,3'-dimethoxy-6'-oxo-8.1', 7.5'-neolignan-Delta: 1,3,5,2',8', one new bicyclooctane canellin-type neolignan (7S, 8S, 1'S, 4'R, 5'R, 6'S)-4',6'-dihydroxy-3,4-dimethoxy-3'-oxo-8.1', 7.5'-neolignan-Delta: 1,3,5,8', two styrylpyrones, 4-methoxy-6-(11,12-dimethoxy-trans-styryl)-2-pyrone and 6-(11,12-methylenedioxy-trans-styryl)-4-methoxy-2-pyrone, two styrylpyrone dimers: 4'-methoxy-8-(11,12-dimethoxyphenyl)-7-[6-(4-methoxy-2-pyronyl)-6-(E)-styryl-1'-oxabicyclo[4,2,0]octa-4'-en-2'-one and the new 11,12-dimethoxyphenyl-7,7'-di-[6-(4-methoxy-2-pyronyl)]-cyclobutane and six flavonoids, 3,5-dihydroxy-7,4'-dimethoxyflavone, 5-hydroxy-3,7,4'-trimethoxyflavone, 3,5,4'-trihydroxy-7-methoxyflavone, 2,3-dihydro-5-hydroxy-7,4'-dimethoxyflavone, 2,3-dihydro-3,5-dihydroxy-7-methoxyflavone, 2,3-dihydro-3,5-dihydroxy-7,4'-dimethoxyflavone and a new flavan, 6,7,3',4',5'-pentamethoxyflavan. (C) 1997 Elsevier B.V. Ltd.

Neolignans from Aniba citrifolia

The trunk wood of Aniba citrifolia contains hydrobenzofuranoid and bicyclo[3.2.1]octanoid neolignans. © 1984.

Hexahydrobenzofuranoid neolignans from an Aniba species

The trunk wood of an Amazonian Aniba species contains three novel neolignans: (2R, 3R, 3aS, 5R)-3a-allyl-5-methoxy-2-(3,4,5-trimethoxyphenyl)-3-methyl-2,3,3a,4,5,6-hexahydro-6-oxobenzofuran (canellin-D), (2R,3R,3aS,5R)-3a-allyl-5,7-dimethoxy-2-(3-methoxy-4,5-methylenedioxyphenyl)-3-methyl-2,3,3a,4,5,6-hexahydro-6-oxobenzofuran (canellin-E) and (2S,3S,3aS,5R)-3a-allyl-5-methoxy-2-(3-methoxy-4,5-methylenedioxyphenyl)-3-methyl-2,3,3a,4,5,6-hexahydro-6-oxobenzofuran (armenin-C). The absolute stereochemistries of these and of all other known hexahydro-6-oxobenzofurans were determined by CD comparisons with model compounds. © 1984.

Falls in Parkinson's disease : kinematic evidence for impaired head and trunk control

Changes in stride characteristics and gait rhythmicity characterize gait in Parkinson's disease and are widely believed to contribute to falls in this population. However, few studies have examined gait in PD patients who fall. This study reports on the complexities of walking in PD patients who reported falling during a 12-month follow-up. Forty-nine patients clinically diagnosed with idiopathic PD and 34 controls had their gait assessed using three-dimensional motion analysis. Of the PD patients, 32 (65%) reported at least one fall during the follow-up compared with 17 (50%) controls. The results showed that PD patients had increased stride timing variability, reduced arm swing and walked with a more stooped posture than controls. Additionally, PD fallers took shorter strides, walked slower, spent more time in double-support, had poorer gait stability ratios and did not project their center of mass as far forward of their base of support when compared with controls. These stride changes were accompanied by a reduced range of angular motion for the hip and knee joints. Relative to walking velocity, PD fallers had increased mediolateral head motion compared with PD nonfallers and controls. Therefore, head motion could exceed “normal” limits, if patients increased their walking speed to match healthy individuals. This could be a limiting factor for improving gait in PD and emphasizes the importance of clinically assessing gait to facilitate the early identification of PD patients with a higher risk of falling.

Developmental and structural features of secretory canals in root and shoot wood of Copaifera langsdorffii Desf. (Leguminosae-Caesalpinioideae)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Source-driven remobilizations of nutrients within stem wood in Eucalyptus grandis plantations

Nutrient remobilizations in tree ligneous components have been little studied in tropical forests. A complete randomized block design was installed in Brazilian eucalypt plantations to quantify the remobilizations of phosphorus (P), potassium (K), calcium (Ca), magnesium (Mg), and sodium (Na) within stem wood. Three treatments were studied: control with neither K nor Na addition (C), 3 kmol ha-1 K applied (+K), and 3 kmol ha-1 Na applied (+Na). Biomass and nutrient contents were measured in the stem wood of eight trees destructively sampled at 1, 2, 3 and 4 years after planting in each treatment and annual rings were localized on discs of wood sampled every 3 m in half of the trees. Chemical analyses and wood density measurements were performed individually for each ring per level and per tree sampled. Nutrient remobilizations in annual rings were calculated through mass balance between two successive ages. Our results show that nutrient remobilizations within stem wood were mainly source-driven. Potassium and Na additions largely increased their concentration in the outer rings as well as the amounts remobilized in the first 2 years after the wood formation. The amount of Na remobilized in annual rings was 15 % higher in +Na than in +K the fourth year after planting despite a 34 % higher production of stem wood in +K leading to a much higher nutrient sink. A partial substitution of K by Na in the remobilizations within stem wood might contribute to enhancing Eucalyptus grandis growth in K-depleted soils. © 2013 Springer-Verlag Berlin Heidelberg.

X-ray Microdensitometry Applied to Determination of Wood Density Variation of Eucalyptus grandis W. Hill trees

This study aimed to analyze the variation of wood density in the radial and longitudinal trunk of Eucalyptus grandis trees. Six 23 years old trees were selected and cross sections were cut in three longitudinal positions (DBH, 3.70, 6.10 m) of the log. The results showed that the apparent density of wood (i) increases in the radial direction, characterizing the juvenile wood and mature wood, (ii) no significant variation in base-top log direction was observed. Based on the radial profiles of density, the mature wood of Eucalyptus grandis can be applied in the manufacture of products with higher aggregated value (PMVAs).

Particle number and mass emission factors from combustion of wood samples collected from Queensland forest

Knowledge of particle emission characteristics associated with forest fires and in general, biomass burning, is becoming increasingly important due to the impact of these emissions on human health. Of particular importance is developing a better understanding of the size distribution of particles generated from forest combustion under different environmental conditions, as well as provision of emission factors for different particle size ranges. This study was aimed at quantifying particle emission factors from four types of wood found in South East Queensland forests: Spotted Gum (Corymbia citriodora), Red Gum (Eucalypt tereticornis), Blood Gum (Eucalypt intermedia), and Iron bark (Eucalypt decorticans); under controlled laboratory conditions. The experimental set up included a modified commercial stove connected to a dilution system designed for the conditions of the study. Measurements of particle number size distribution and concentration resulting from the burning of woods with a relatively homogenous moisture content (in the range of 15 to 26 %) and for different rates of burning were performed using a TSI Scanning Mobility Particle Sizer (SMPS) in the size range from 10 to 600 nm and a TSI Dust Trak for PM2.5. The results of the study in terms of the relationship between particle number size distribution and different condition of burning for different species show that particle number emission factors and PM2.5 mass emission factors depend on the type of wood and the burning rate; fast burning or slow burning. The average particle number emission factors for fast burning conditions are in the range of 3.3 x 1015 to 5.7 x 1015 particles/kg, and for PM2.5 are in the range of 139 to 217 mg/kg.

Seeing the Wood for the Trees: A Critical Evaluation of Methods to Estimate the Parameters of Stochastic Differential Equations

Maximum-likelihood estimates of the parameters of stochastic differential equations are consistent and asymptotically efficient, but unfortunately difficult to obtain if a closed-form expression for the transitional probability density function of the process is not available. As a result, a large number of competing estimation procedures have been proposed. This article provides a critical evaluation of the various estimation techniques. Special attention is given to the ease of implementation and comparative performance of the procedures when estimating the parameters of the Cox–Ingersoll–Ross and Ornstein–Uhlenbeck equations respectively.

My mother is water, my father is wood

'my mother is water, my father is wood' was an installation comprised of two large cork discs mounted on the gallery floor and wall, overlaid with images of photographic and archival research evidence, and a turned wood sculptural object. It also included a short video work on a miniature screen embedded in the upright disc. The work explored the language of natural elements and the structure of genealogical research to discuss the Scandinavian history of Queensland and my own family. The work was selected by the directors of LEVEL ARI in Brisbane for inclusion in their 2011 exhibitions program.