Determination of the thermal parameters of high-power batteries by local heat

A new approach to the determination of the thermal parameters of high-power batteries is introduced here. Application of local heat flux measurement with a gradient heat flux sensor (GHFS) allows determination of the cell thermal parameters in di_erent surface points of the cell. The suggested methodology is not cell destructive as it does not require deep discharge of the cell or application of any charge/discharge cycles during measurements of the thermal parameters of the cell. The complete procedure is demonstrated on a high-power Li-ion pouch cell, and it is verified on a sample with well-known thermal parameters. A comparison of the experimental results with conventional thermal characterization methods shows an acceptably low error. The dependence of the cell thermal parameters on state of charge (SoC) and measurement points on the surface was studied by the proposed measurement approach.

Obtaining functional parametric models using active vision strategies

This paper addresses the problem of determining which 3D shape is present, and more importantly, the dimensions of the shape in a scene. This is performed in an active vision system because it reduces the complexity of the problem through the use of gaze stabilization, choice of foveation point, and selective processing by adaptively processing regions of interest. In our case, only a small number of equations and parameters are needed for each shape and these are incorporated into functional descriptions of the shapes.

Learning aggregation weights from 3-tuple comparison sets

An important task in multiple-criteria decision making is how to learn the weights and parameters of an aggregation function from empirical data. We consider this in the context of quantifying ecological diversity, where such data is to be obtained as a set of pairwise comparisons specifying that one community should be considered more diverse than another. A problem that arises is how to collect a sufficient amount of data for reliable model determination without overloading individuals with the number of comparisons they need to make. After providing an algorithm for determining criteria weights and an overall ranking from such information, we then investigate the improvement in accuracy if ranked 3-tuples are supplied instead of pairs. We found that aggregation models could be determined accurately from significantly fewer 3-tuple comparisons than pairs. © 2013 IEEE.

Estudo comparativo entre estereotomografia e da tomografia da onda NIP: aplicação em dados sintéticos e reais

A determinação de um acurado modelo de velocidades é um requisito fundamental para a realização do imageamento sísmico. Métodos novos como a Estereotomografia préempilhamento e a Tomografia da onda NIP são ferramentas poderosas e bastante sugestivas para este propósito. Basicamente, a Estereotomografia pré-empilhamento se baseia no conceito de eventos localmente coerentes interpretados como reflexões primárias e associados com pares de segmentos de raios, que tem um mesmo ponto de reflexão em profundidade. Na Tomografia da onda NIP um evento sísmico é representado por uma onda hipotética NIP, que está relacionada a um ponto de reflexão em profundidade. Os atributos da onda NIP são determinados no decorrer do Empilhamento de Superfície de Reflexão Comum (empilhamento CRS). Este trabalho tem como objetivo, fazer um estudo comparativo de ambos os métodos de determinação do modelo de velocidades em profundidade. Assim, é realizada uma revisão dos fundamentos teóricos de ambos os métodos tomográficos, destacando as principais diferenças e aplicando estas aproximações em um dado sintético e um dado real marinho (linha sísmica 214-2660 da Bacia do Jequitinhonha). Para avaliar os modelos de velocidades encontrados pelas aproximações, foi utilizada a migração pré-empilhamento em profundidade do tipo Kirchhoff e também as famílias de imagem comum (CIG). Os resultados mostraram que ambos os métodos tomográficos fornecem modelos de velocidades representativos. Contudo, constatou-se que a estereotomografia tem melhor desempenho em meios com variações laterais de velocidades, porém, aplicável somente em dados pré-empilhados com alta razão sinal/ruído.

Latent residual analysis in binary regression with skewed link

Model diagnostics is an integral part of model determination and an important part of the model diagnostics is residual analysis. We adapt and implement residuals considered in the literature for the probit, logistic and skew-probit links under binary regression. New latent residuals for the skew-probit link are proposed here. We have detected the presence of outliers using the residuals proposed here for different models in a simulated dataset and a real medical dataset.

A generalized Markov sampler

A recent development of the Markov chain Monte Carlo (MCMC) technique is the emergence of MCMC samplers that allow transitions between different models. Such samplers make possible a range of computational tasks involving models, including model selection, model evaluation, model averaging and hypothesis testing. An example of this type of sampler is the reversible jump MCMC sampler, which is a generalization of the Metropolis-Hastings algorithm. Here, we present a new MCMC sampler of this type. The new sampler is a generalization of the Gibbs sampler, but somewhat surprisingly, it also turns out to encompass as particular cases all of the well-known MCMC samplers, including those of Metropolis, Barker, and Hastings. Moreover, the new sampler generalizes the reversible jump MCMC. It therefore appears to be a very general framework for MCMC sampling. This paper describes the new sampler and illustrates its use in three applications in Computational Biology, specifically determination of consensus sequences, phylogenetic inference and delineation of isochores via multiple change-point analysis.

Three-phase model of consumers' behaviours : a synthesis of the theory of planned behaviour, self-determination theory and planning

Using a longitudinal study, an overall behavioural model with three related phases (cognitive, motivational and volitional phase) across three studies was examined to identify the factors that most prominently drive consumer environmental behaviour. This thesis provides empirical evidence to support the behavioural model in an environmental consumption context and shows a new avenue for promoting consumer environmental behaviour.

Determination of the optically equivalent model in three-dimensional photoelasticity

Any stressed photoelastic medium can be reduced to an optically equivalent model consisting of a linear retarder, with retardation 1 and principal axis at azimuth 1, and a pure rotator of power 2. The paper describes two simple methods to determine these quantities experimentally. Further, a method is described to overcome the problem of rotational effects in scattered-light investigations. This new method makes use of the experimentally determined characteristic parameters

A model for mammalian male determination based on a passive Y chromosome

A model is suggested for mammalian male determination based on interactions postulated to occur among an autosomal repressor gene, an X-linked male-determining gene termed Tdx, and multiple copies of certain DNA sequences on the Y chromosome that do not code for any protein. The repressor, synthesised in limited amounts, has higher affinity for the Y-linked sequences than for Tdx and its affinity for Tdx is greater than that of RNA polymerase. In XY cells the Y effectively binds all available repressor, permitting transcription of Tdx to occur. In XX cells, since competition from the Y-linked high-affinity sequences is absent, the repressor binds to Tdx and prevents transcription. As a result of this competition between Tdx and the Y-linked high-affinity sites for limiting concentrations of the autosomal repressor, the product of the Tdx gene (TDX) is synthesized in the male but not in the female. It is suggested that in determination of the male sex, the role of the Y chromosome is to serve as a sink for the Tdx repressor. The proposed interactions provide a plausible explanation for the genetic properties of several anomalies of sexual development in mouse, man, and other mammals. The model suggests that the postulated multiple, highaffinity sequences on the Y chromosome of the mouse are included among the DNA sequences referred to as the Sxr-Bkm sequences.

Determination of the optically equivalent model in three-dimensional photoelasticity

Any stressed photoelastic medium can be reduced to an optically equivalent model consisting of a linear retarder, with retardation delta1 and principal axis at azimuth phgr1, and a pure rotator of power phgr2. The paper describes two simple methods to determine these quantities experimentally. Further, a method is described to overcome the problem of rotational effects in scattered-light investigations. This new method makes use of the experimentally determined characteristic parameters.

Determination of plastic properties by instrumented spherical indentation: Expanding cavity model and similarity solution approach

The present paper aims to develop a robust spherical indentation-based method to extract material plastic properties. For this purpose, a new consideration of-piling-up effect is incorporated into the expanding cavity model; an extensive numerical study on the similarity Solution has also been performed. As a consequence, two semi-theoretical relations between the indentation response and material plastic properties are derived, with which plastic properties of materials can be identified from a single instrumented spherical indentation curve, the advantage being that this approach no longer needs estimations of contact radius with given elastic modulus. Moreover, the inconvenience in using multiple indenters with different tip angles can be avoided. Comprehensive sensitivity analyses show that the present algorithm is reliable. Also, by experimental verification performed oil three typical materials, good agreement of the material properties between those obtained from the reverse algorithm and experimental data is obtained.

Determination Of Plastic Properties By Instrumented Spherical Indentation: Expanding Cavity Model And Similarity Solution Approach

The present paper aims to develop a robust spherical indentation-based method to extract material plastic properties. For this purpose, a new consideration of-piling-up effect is incorporated into the expanding cavity model; an extensive numerical study on the similarity Solution has also been performed. As a consequence, two semi-theoretical relations between the indentation response and material plastic properties are derived, with which plastic properties of materials can be identified from a single instrumented spherical indentation curve, the advantage being that this approach no longer needs estimations of contact radius with given elastic modulus. Moreover, the inconvenience in using multiple indenters with different tip angles can be avoided. Comprehensive sensitivity analyses show that the present algorithm is reliable. Also, by experimental verification performed oil three typical materials, good agreement of the material properties between those obtained from the reverse algorithm and experimental data is obtained.

Determination of fractional energy loss of waves in nearshore waters using an improved high-order Boussinesq-type model

Fractional energy losses of waves due to wave breaking when passing over a submerged bar are studied systematically using a modified numerical code that is based on the high-order Boussinesq-type equations. The model is first tested by the additional experimental data, and the model's capability of simulating the wave transformation over both gentle slope and steep slope is demonstrated. Then, the model's breaking index is replaced and tested. The new breaking index, which is optimized from the several breaking indices, is not sensitive to the spatial grid length and includes the bottom slopes. Numerical tests show that the modified model with the new breaking index is more stable and efficient for the shallow-water wave breaking. Finally, the modified model is used to study the fractional energy losses for the regular waves propagating and breaking over a submerged bar. Our results have revealed that how the nonlinearity and the dispersion of the incident waves as well as the dimensionless bar height (normalized by water depth) dominate the fractional energy losses. It is also found that the bar slope (limited to gentle slopes that less than 1:10) and the dimensionless bar length (normalized by incident wave length) have negligible effects on the fractional energy losses.