Underwater Acoustics and Cavitating Flow of Water Entry

The fluid mechanics of water entry is studied through investigating the underwater acoustics and the supercavitation. Underwater acoustic signals in water entry are extensively measured at about 30 different positions by using a PVDF needle hydrophone. From the measurements we obtain (1) the primary shock wave caused by the impact of the blunt body on free surface; (2) the vapor pressure inside the cavity; (3) the secondary shock wave caused by pulling away of the cavity from free surface; and so on. The supercavitation induced by the blunt body is observed by using a digital high-speed video camera as well as the single shot photography. The periodic and 3 dimensional motion of the supercavitation is revealed. The experiment is carried out at room temperature.

High-resolution spatial processing in underwater acoustics /

Mode of access: Internet.

The ambient soundscape of inland waters in Seattle, Washington: bridge traffic as a source of urban underwater noise pollution?

Senior thesis written for Oceanography 445

A preliminary account and review of the simple methods for determining the operational parameters of fishing gear, underwater, with notes on its application

An account and review of the simple methods for determining the operational parameters of fishing gear, underwater, such a tilt of otter boards (outwards or inwards, forwards or afterwards), vertical height of net, its horizontal spread, angle of divergence at bosom, spread between wing tips, angle of inclination of danlenos, butterfly, slope of legs and sweep-line has been given. The relationship of distance between the otter boards spread and the vertical height of net has been obtained as generally linear. The possibilities of regulating the vertical height of net (dependent variate) and spread of otter boards (independent variate) for increasing the fishing efficiency has been discussed. The angle of attack of oval shaped otter boards used during the operations still remain undetermined, however, it has been explained how the best angle of attack for increasing the efficiency of gear can be obtained by regulating the ratio of depth to warp for a given net. The inadequacy of the mere indices of catch per hour of trawling in comparing the relative efficiency of trawls in gear research studies has been indicated. The importance of estimating the operational parameters and its application to commercial fisheries depending upon the distribution pattern of fish and in gear research has been discussed. The efficiency of the jelly bottle method has been compared statistically with the observations made on the trawl gear underwater with instruments.

Underwater Target Localization, Tracking and Classification

Underwater target localization and tracking attracts tremendous research interest due to various impediments to the estimation task caused by the noisy ocean environment. This thesis envisages the implementation of a prototype automated system for underwater target localization, tracking and classification using passive listening buoy systems and target identification techniques. An autonomous three buoy system has been developed and field trials have been conducted successfully. Inaccuracies in the localization results, due to changes in the environmental parameters, measurement errors and theoretical approximations are refined using the Kalman filter approach. Simulation studies have been conducted for the tracking of targets with different scenarios even under maneuvering situations. This system can as well be used for classifying the unknown targets by extracting the features of the noise emanations from the targets.

Nonlinear acoustics, 1954 to 1983.

"Approved for public release, distribution unlimited."

Hydroaccoustic pinging as a diver tool for underwater navigation in surveying Puget Sound Eelgrass (Zostera marina) densities

Senior thesis written for Oceanography 445

Análise da viabilidade de aplicações de monitoramento e controle utilizando redes acústicas submarinas.

A acústica submarina vem sendo estudada por décadas, mas redes submarinas com transmissão acústica e protocolos específicos para a comunicação neste meio são campos de pesquisa que estão iniciando. Recentemente alguns simuladores, baseados no NS-2, foram desenvolvidos para o estudo destas redes. Este trabalho avalia através de simulações a viabilidade de aplicações genéricas de monitoramento e controle em redes acústicas submarinas. São propostas e utilizadas três topologias básicas para redes acústicas submarinas: linha, quadro e cubo e dois protocolos MAC: Broadcast e R-MAC. Em nossas análises comparamos esses dois protocolos em relação ao consumo total de energia e o atraso total na rede. Os resultados mostram que essas topologias associadas aos protocolos MAC atendem as necessidades e as peculiaridades da grande maioria das aplicações de monitoramento e controle que utilizam redes acústicas submarinas. O objetivo deste estudo não foi determinar qual a melhor topologia ou o melhor tipo de protocolo de acesso ao meio, mais sim determinar qual a configuração de rede mais indicada para determinada aplicação levando em consideração as características da cada uma delas.

EXPERIMENTAL INVESTIGATION OF LINEAR BUBBLE DYNAMICS IN A VISCOELASTIC XANTHAN GEL

Oceanic bubble plumes caused by ship wakes or breaking waves disrupt sonar communi- cation because of the dramatic change in sound speed and attenuation in the bubbly fluid. Experiments in bubbly fluids have suffered from the inability to quantitatively characterize the fluid because of continuous air bubble motion. Conversely, single bubble experiments, where the bubble is trapped by a pressure field or stabilizing object, are limited in usable frequency range, apparatus complexity, or the invasive nature of the stabilizing object (wire, plate, etc.). Suspension of a bubble in a viscoelastic Xanthan gel allows acoustically forced oscilla- tions with negligible translation over a broad frequency band. Assuming only linear, radial motion, laser scattering from a bubble oscillating below, through, and above its resonance is measured. As the bubble dissolves in the gel, different bubble sizes are measured in the range 240 – 470 μm radius, corresponding to the frequency range 6 – 14 kHz. Equalization of the cell response in the raw data isolates the frequency response of the bubble. Compari- son to theory for a bubble in water shows good agreement between the predicted resonance frequency and damping, such that the bubble behaves as if it were oscillating in water.

AN IMPEDANCE TUBE FOR THE IN-SITU CLASSIFICATION OF BUBBLY LIQUIDS

It is well documented that the presence of even a few air bubbles in water can signifi- cantly alter the propagation and scattering of sound. Air bubbles are both naturally and artificially generated in all marine environments, especially near the sea surface. The abil- ity to measure the acoustic propagation parameters of bubbly liquids in situ has long been a goal of the underwater acoustics community. One promising solution is a submersible, thick-walled, liquid-filled impedance tube. Recent water-filled impedance tube work was successful at characterizing low void fraction bubbly liquids in the laboratory [1]. This work details the modifications made to the existing impedance tube design to allow for submersed deployment in a controlled environment, such as a large tank or a test pond. As well as being submersible, the useable frequency range of the device is increased from 5 - 9 kHz to 1 - 16 kHz and it does not require any form of calibration. The opening of the new impedance tube is fitted with a large stainless steel flange to better define the boundary condition on the plane of the tube opening. The new device was validated against the classic theoretical result for the complex reflection coefficient of a tube opening fitted with an infinite flange. The complex reflection coefficient was then measured with a bubbly liquid (order 250 micron radius and 0.1 - 0.5 % void fraction) outside the tube opening. Results from the bubbly liquid experiments were inconsistent with flanged tube theory using current bubbly liquid models. The results were more closely matched to unflanged tube theory, suggesting that the high attenuation and phase speeds in the bubbly liquid made the tube opening appear as if it were radiating into free space.

An autonomous system for ocean acoustic tomography

Vertical line arrays (VLA) are a widely used apparatus in underwater acoustics with applications in sonar prediction, underwater communications and acoustic tomography, among others. Recent developments in digital electronics and communications allow for off-the-shelf development of VLA systems, with a large number of embedded acoustic and non-acoustic sensors able to fulfill application requirements, as opposed to single or few receiver configurations available until only a few years ago. Very often, the flexibility in water column sampling is achieved by splitting the VLA into modules that can be assembled according to the application. Such systems can be deployed and recovered from small vessels with a shorthanded crew, and make it possible for research labs with reduced budgets and operational means (ships and manpower) to gain control over the whole development process, from data acquisition to post-processing.

Assessing the Influence of Acoustic Variation on the Acquisition of Bathymetric Surveying Data

[author abstract] The field of hydrographic surveying is inherently important to achieving a true understanding of the world that underlies the vast bodies of water that cover the earth. In this study I will determine the uncertainties of depth estimates of the seafloor that relate to the survey design and sound velocity. The survey design and collection of sound velocity were all conducted of the coast of Vancouver Island, B.C. near the entrance of the Strait of Juan de Fuca. The assessment will show how the change in sound velocity over time will influence the bathymetric reading, if not corrected for. The differences in bathymetric depth readings will show a correlation to the changes in sound velocity.

PSWT Based Linear Predictive Coding and Development of a Parallel Multiple Subsequence Structure for DWT Computation

During 1990's the Wavelet Transform emerged as an important signal processing tool with potential applications in time-frequency analysis and non-stationary signal processing.Wavelets have gained popularity in broad range of disciplines like signal/image compression, medical diagnostics, boundary value problems, geophysical signal processing, statistical signal processing,pattern recognition,underwater acoustics etc.In 1993, G. Evangelista introduced the Pitch- synchronous Wavelet Transform, which is particularly suited for pseudo-periodic signal processing.The work presented in this thesis mainly concentrates on two interrelated topics in signal processing,viz. the Wavelet Transform based signal compression and the computation of Discrete Wavelet Transform. A new compression scheme is described in which the Pitch-Synchronous Wavelet Transform technique is combined with the popular linear Predictive Coding method for pseudo-periodic signal processing. Subsequently,A novel Parallel Multiple Subsequence structure is presented for the efficient computation of Wavelet Transform. Case studies also presented to highlight the potential applications.