Potential of adjuvants to reduce drift in agricultural spraying

The reduction of pesticide spraying drift is still one of the major challenges in Brazilian agriculture. The aim of this study was to evaluate the potential of different adjuvant products, such as surfactants, drift retardants, mineral oil and vegetable oil for reducing drift in agricultural spraying. The experiment consisted of quantifying drift of sprayings of 18 adjuvants dissolved in water under controlled conditions in a wind tunnel. Tests were performed in triplicates with spraying nozzles type Teejet XR8003 VK, pressure of 200kPa and medium drops. Solutions sprayed were marked with Brilliant Blue dye at 0.6% (m v-1). The drift was collected using polyethylene strips transversally fixed along the tunnel at different distances from the nozzle and different heights from the bottom part of the tunnel. Drift deposits were evaluated by spectrophotometry in order to quantify deposits. The adjuvants from chemical groups of mineral oil and drift retardant resulted in lower values of drift in comparison with surfactants and water. The results obtained in laboratory show that the selection of appropriate class and concentration of adjuvants can significantly decrease the risk of drift in agricultural spraying. However, the best results obtained in laboratory should be validated with pesticide under field conditions in the future.

Periodic inspection of sprayers: diagnostic to the northern of Paraná

To optimize the use of pesticides, several countries have carried out periodic inspections in agricultural sprayers. In Brazil, knowing the conditions of this machinery canguide researches and investments in guidelines for its use and maintenance. The objective of this study was to verify the state of sprayer maintenance used in the North of the state of Paraná, in Brazil. Several sprayer items were evaluated, such as: presence, status and scale of the manometer, status of the hose, status of the anti-drip component, presence of leaks, status of the bar, status of the filters, state of the spraying nozzles and errors in the targeted flow rate. Machines were named as approved when there was no failure in any item evaluated. The factor that caused the biggest level of reprove among the machines was incorrect scale of manometers, which reproved 84.55% of the machines evaluated. Other outstanding factor was the incorrect flow rate in 75.5% of the tested machines. Only one unit was approved from the total of 110 evaluated sprayers.

Spray adjuvant characteristics affecting agricultural spraying drift

This study defined the main adjuvant characteristics that may influence or help to understand drift formation process in the agricultural spraying. It was evaluated 33 aqueous solutions from combinations of various adjuvants and concentrations. Then, drifting was quantified by means of wind tunnel; and variables such as percentage of droplets smaller than 50 μm (V50), 100 μm (V100), diameter of mean volume (DMV), droplet diameter composing 10% of the sprayed volume (DV0.1), viscosity, density and surface tension. Assays were performed in triplicate, using Teejet XR8003 flat fan nozzles at 200 kPa (medium size droplets). Spray solutions were stained with Brilliant Blue Dye at 0.6% (m/ v). DMV, V100, viscosity cause most influence on drift hazardous. Adjuvant characteristics and respective methods of evaluation have applicability in drift risk by agricultural spray adjuvants.

Distribution pattern, surface tension and contact angle of herbicides associated to adjuvants on spraying and control of Ipomoea hederifolia under rainfall incidence

ABSTRACTScarlet Morning Glory is considered to be an infesting weed that affects several crops and causes serious damage. The application of chemical herbicides, which is the primary control method, requires a broad knowledge of the various characteristics of the solution and application technology for a more efficient phytosanitary treatment. Therefore this study aimed to characterize the effect of rainfall incidence on the control of Ipomoea hederifolia, considering droplet size, surface tension, contact angle of droplets formed by herbicides liquid on vegetal and artificial surfaces, associated to adjuvants and the volumetric distribution profile of the spray jet. The addition of the adjuvants to the herbicide spraying liquid improved the application quality, as it influenced the angle formed by the spray by broadening the deposition band of the spray nozzle and thus the possible distance between the nozzles on spray boom and due the changes at droplet size, which contribute to a safety application. The rainfall occurrence affected negatively the weed control with the different spraying liquids and also the dry matter weight, suggesting that the phytosanitary product applied was washed off.

Uniformity of liquid distribution in the canopy of the bean plant, using the spectrophotometric analysis

Fungal diseases are important factors limiting common bean yield. White mold is one of the main diseases caused by soil pathogens. The objective of this study was to quantify the distribution of a fungicide solution sprayed into the canopy of bean plants by spectrophotometry, using a boom sprayer with and without air assistance. The experiment was arranged in a 2 x 2 x 2 factorial (two types of nozzles, two application rates, and air assistance on and off) randomized block design with four replications. Air assistance influenced the deposition of solution on the bean plant and yield increased significantly with the increased rate of application and air assistance in the boom sprayer.

Parameters of electrostatic spraying and its influence on the application efficiency

When the electrostatic spraying is used correctly, it provides advantages over conventional systems, however many factors can affect the system efficiency. Therefore, the objective of this study was to evaluate the charge/mass ratio (Q/M) at different spraying distances (0, 1, 2, 3, 4 and 5 m), and the liquid deposition efficiency on the target. Evaluating the Q/M ratio the Faraday cage method was used and to evaluate the liquid deposition efficiency the artificial targets were positioned longitudinally and transversely to the spray jet. It was found that the spraying distance affects the Q/M ratio, consequently, the liquid deposition efficiency. For the closest distance to the target the Q/M ratio was 4.11 mC kg-1, and at distances of 1, 2, 3, 4 and 5 m, the ratio decreased to 1.38, 0.64, 0.31, 0.17 and 0.005 mC kg-1, respectively. For the liquid deposition, the electrostatic system was affected by the target orientation and spraying distance. The target transversely to the jet of liquid did not improve the liquid deposition, but longitudinally increased the deposition up to 3 meters of distance.

THE CONTROL OF ANOPHELINE MOSQUITOS BY THE SPRAYING OF DELTAMETHRIN ON RAFFIA CURTAINS USED IN MINERS' HUTS IN AREAS ENDEMIC FOR MALARIA

The residual potential of an aqueous solution of Deltamethrin (FW 25 mg i.a./m2) was evaluated on raffia curtains. These are sheets of synthetic material used in the construction of huts to house miners. Experiments were conducted during 420 days and the curtains were always rolled up in the daytime and unrolled in late afternoon. Data analyzed by logarithmic regression indicated that raffia treated with Deltamethrin had higher mortality indices than that covered with DDT. The residual capacity of Deltamethrin on raffia was high. The mortality percentage was above 85% after 360 days and dropped to about 50% at 420 days. The effect of DDT was reduced after 180 days and reached zero by the end of the experiment. Based on the results of these experiments, it is recommended that Deltamethrin be used to spray raffia curtains in mining regions and other areas that are endemic for malaria.

Spraying food sources with pyrethroid to control peridomestic triatomines

Introduction We attempted to supplement traditional insecticide spraying by treating peridomiciliar food sources with a powder formulation. Methods Two groups of houses were treated with deltamethrin suspension concentrate (SC), one of which had its primary peridomestic food sources treated with deltamethrin 2P. Results Triatoma brasiliensis was the most commonly captured triatomine. Birds, dogs and rodents were the major food sources identified by the precipitin reaction; 554 domestic animals received powder treatment. A sharp reduction in infestation rates was observed in the two groups up to 360 days after spraying. Conclusion The combination SC + 2P did not improve the control of triatomines.

Effect of day time on foliar spraying of several levels of nitrogen fertilizer, NPKS solutions and its components, on common bean leaves

An experiment was carried out in order to determine the effect of day time of foliar spraying of several levels of nitrogen fertilizers, N-P-K-S station, and its components on common bean leaves. Results, based on the visual observations, indicated the maximum levels of each fertilizer that did not cause injuries and showed that the foliar spraying early in the morning is the best day time.

Effect of deltamethrin spraying on the sandfly populations in a focus of American cutaneous leismaniasis

The effect of deltamethrin of the sandfly population in a focus of American Cutaneous Leishmaniasis in Viana, Espírito Santo State is desvribed. The phlebotomine population density was determined inside and outside houses during a one year period in a treated and untreated area. The results showed a significant reduction in the number of sandflies inside houses in the treated area compared with both the untreated area and the same area before sparying. Despite having a residual action for 12 months after spraying the insecticide was ineffective outside houses. It is concluded therefore that deltamethrin is an efficient insecticide for reducing the number of phlebotomine sandflies inside houses.

An attempt to control Phlebotomine sand flies (Diptera: Psychodidae) by residual spraying with deltamethrin in a Colombian village

An attempt was made to control phlebotomine sand flies biting indoors in a rural community near Cali, Colombia, using the residual insecticide "K-Othrine" (deltamethrin) sprayed on the inside walls of houses. Twelve houses were divided into matched pairs based on physical characteristics, one house in each pair being left untreated while the inside walls of the other were sprayed with 1 deltamethrin at a concentration of 500 mg a.i./m2. Sand flies were sampled each week using protected human bait and sticky trap collections for four months after spraying. The number of sand flies (Lutzomyia youngi) collected on sticky traps was significantly lower (P = 0.004) in the untreated houses than in the treated ones with which they were matched. This difference was not significant for L. columbiana; the other anthropophilic species were not present in large numbers. The numbers collected on human bait in treated and untreated houses were not significantly different for either species. Activity of the insecticide as determined by contact bioassays remained high throughout the study and failure to control the insects was attributed to two factors: the tendency of sand flies to bite before making contact with the insecticide and the fact that the number of sand flies that entered houses represented a relatively small proportion of the population in the wooded areas surrounding the settlement in the study.

Impact of residual spraying on Rhodnius prolixus and Triatoma dimidiata in the department of Zacapa in Guatemala

As a vector control program to control Chagas disease in Guatemala, residual spraying of Rhodnius prolixus and Triatoma dimidiata was performed, and its impact was measured in the department of Zacapa. In order to identify infested villages and determine the degree of infestation, a baseline entomological survey to identify municipalities infested with vectors followed by an additional vector survey in areas known to be infested was conducted. Residual spraying using pyrethroid insecticides was performed at all the villages identified as being infested with the vectors. The residual spraying was shown to be highly effective against both vectors by the decrease in infestation indices after spraying. Analysis of the cost-effectiveness of the spraying showed that the average cost of insecticides per house is high when compared with that in Southern Cone countries.

Comparison of microscopic method and computational program for pesticide deposition evaluation of spraying

The main objective of this work was to compare two methods to estimate the deposition of pesticide applied by aerial spraying. Hundred and fifty pieces of water sensitive paper were distributed over an area of 50 m length by 75 m width for sampling droplets sprayed by an aircraft calibrated to apply a spray volume of 32 L/ha. The samples were analysed by visual microscopic method using NG 2 Porton graticule and by an image analyser computer program. The results reached by visual microscopic method were the following: volume median diameter, 398±62 mum; number median diameter, 159±22 mum; droplet density, 22.5±7.0 droplets/cm² and estimated deposited volume, 22.2±9.4 L/ha. The respective ones reached with the computer program were: 402±58 mum, 161±32 mum, 21.9±7.5 droplets/cm² and 21.9±9.2 L/ha. Graphs of the spatial distribution of droplet density and deposited spray volume on the area were produced by the computer program.

Effect of preharvest spraying with thidiazuron on fruit quality and maturity of apples

Apple trees, cultivars Gala and Fuji, were sprayed at full bloom with thidiazuron (TDZ) at the doses of 0, 5, 10, or 20 g (a.i.) ha-1 and fruit were assessed for quality and maturity. In both cultivars, the increase of TDZ dose had detrimental effects on fruit quality, causing a reduction of fruit red surface and an increase of percentage of fruit that was asymmetrical and with calyx-end rot. TDZ caused an increment of calyx-end aperture that might have increased calyx-end rot. TDZ increased density and the length : diameter (L : D) ratio of the fruit. The number of viable seeds was not affected by TDZ. TDZ resulted in a substantial delay of fruit maturity in 'Gala' but not in 'Fuji'. TDZ also reduced soluble solids content (SSC) in 'Gala' and reduced titratable acidity in both cultivars.

Systems of aerial spraying for soybean rust control

The soybean rust caused by Phakopsora pachyrhizi is considered the main soybean disease and consequently the appropriate selection and the use of spraying equipment are vital for its control. The aim of this study was to evaluate the performance of aerial application equipment for soybean rust control. It was used: Micronair AU 5000 at 10 L ha-1 (with oil) and at 20 L ha-1 (without oil); Stol ARD atomizer at 10 and 20 L ha-1 (both with oil) and Spectrum (electrostatic) at 10 L ha-1 (without oil). The adjuvant was cotton oil (1.0 L ha-1) with emulsifier (BR 455) at 0.025 L ha-1. The field trial was set up at the 3rd fungicide application, when f four replications of each treatment. There were no statistical differences among treatments related to fungicide deposits by at a Confidence Interval of 95%. It was observed that the best results were obtained with Micronair (10 L ha-1 with oil), Stol (20 L ha-1 with oil) and electrostatic system at 10 L ha-1 with the lowest relative humidity (64%).