Performance of small wind turbines: simulation of electricity supply to loads connected to the public or isolated grid

ABSTRACT The successful in the implementation of wind turbines depends on several factors, including: the wind resource at the installation site, the equipment used, project acquisition and operational costs. In this paper, the production of electricity from two small wind turbines was compared through simulation using the computer software HOMER - a national model of 6kW and an imported one of 5kW. The wind resources in three different cities were considered: Campinas (SP/BR), Cubatão (São Paulo/BR) and Roscoe (Texas/ USA). A wind power system connected to the grid and a wind isolated system - batteries were evaluated. The results showed that the energy cost ($/kWh) is strongly dependent on the windmill characteristics and local wind resource. Regarding the isolated wind system – batteries, the full supply guarantee to the simulated electrical load is only achieved with a battery bank with many units and high number of wind turbines, due to the intermittency of wind power.

Broccoli yield in response to top-dressing fertilization with green manure and biofertilizer

The objective of this work was to evaluate the productive performance of broccoli under different top-dressing organic fertilizations. The experiment was conducted under protected cultivation, in a completely randomized design with four replications, with two plants per experimental unit. Broccoli seedlings were produced in a commercial substrate in styrofoam trays. The seedlings were transplanted to plastic pots containing 10.0 L of substrate made up of subsoil and organic compost at the ratio of 3:1 (v/v), respectively, which is equivalent to about 20.0 t ha-1 of organic compost at planting. After seedling establishment, the top-dressing fertilization treatments were applied: gliricidia biomass associated or not with liquid biofertilizer of cattle manure to the soil and bokashi. Two control treatments were established: one with mineral fertilization recommended for the crop and the other without top-dressing fertilization. The broccoli production was evaluated (commercial standard). Plants that received mineral fertilizer were more productive, however, they were not significantly different (p>0.05), by Dunnet test, from the plants fertilized with 2.5 t ha-1 gliricidiabiomass (dry mass) associated with liquid biofertilizer (2.0 L m-2) applied to soil. Top-dressing fertilizations with only gliricidia, at 2.5 and 5.0 t ha-1 of biomass (dry mass), resulted in no significant increase in production of broccoli inflorescence. The use of bokashi in addition to gliricidia biomass and liquid biofertilizer reduced the efficiency of the fertilization compared with plants that received only gliricidia and liquid biofertilizer.

Estrategias emergentes au deliberadas: um estudo de caso com os vencedores do premio "Top de Morketing" da ADYB

O presente artigo tem por objetivo principal apresentar os conceitos de estratégias emergentes e deliberadas dentro de um contexto mais amplo de marketing estratégico. A administração dessas estratégias na empresa é de extrema importância para seus objetivos. Para tanto, o método do estudo de casos foi aplicado a fim de buscar as várias dimensões pertinentes a esse tema. Como contribuição à administração estratégica nas organizações, fica a composição das estratégias emergentes e deliberadas, visando, fundamentalmente, à flexibilidade no curto prazo, com consistência no longo prazo.

Convergência brasileira aos padrões internacionais de contabilidade pública vis-à-vis as estratégias top-down e bottom-up

O Brasil está em processo de convergência de sua contabilidade pública em relação aos padrões internacionais desenvolvidos pela Federação Internacional dos Contadores (Ifac). A implementação de sistemas de informação contábil é geralmente realizada por meio das abordagens top-down ou bottom-up. Assim, este estudo tem por objetivos: 1) identificar a abordagem adotada pelo governo federal brasileiro; 2) descrever o modelo de implementação do sistema de informação contábil público no Brasil; e 3) mapear o fluxo de informações e atores envolvidos no processo de convergência. A abordagem qualitativa foi adotada utilizando a pesquisa documental e análise de conteúdo de documentos disponíveis para operacionalizar a pesquisa. Foi identificado que o Brasil utiliza a abordagem middle-up-down, que favorece a interação entre múltiplos atores no processo, diferentemente da abordagem top-down, que segue o modelo internacional divulgado.

Protected environments and substrates for production of genipap seedlings

Genipap (Genipa americana L., Rubiaceae ) is a native Brazilian species and can be used in the recovery of degraded forest areas or for food supply. In order for the species to reach its potential, production of high quality seedlings is essential. The objective of this study was to evaluate genipap seedlings in protected environments and different substrates. The environments tested were: (1) a greenhouse with polyethylene film in the top, with aluminized screen (Aliminet®) of 50%-shading under this film, and lateral sides covered with 50%-shading nylon net (Sombrite®), (2) a shaded hut, all sides covered with 50%-shading nylon net (Sombrite®), and (3) a nursery shelter, with all lateral sides uncovered and the roof covered with leaves of buriti (Mauritia flexuosa). In these environments the following substrates were tested: 50% cattle manure + 50% cassava foliage, 50% cattle manure + 50% Vida Verde®, 50% cattle manure + 50% vermiculite, and 25% cattle manure + 25% vermiculite + 25% of cassava foliage + 25% Vida Verde®. Because there was no repetition of the growth environment, the effect of environment was examined using statistical procedures for analysis of combined experiments. Within environments a completely randomized design was used with five replications. All substrates are suitable for the formation of genipap seedlings, where the recommended substrates are: 50% cattle manure + 50% cassava foliage and 50% cattle manure + 50% Vida Verde® for the greenhouse and the substrates composed of 50% cattle manure + 50% vermiculite and 25% cattle manure + 25% cassava foliage + 25% Vida Verde®+ 25% vermiculite for the shaded hut. The buriti shelter is not recommended for production of genipap seedlings.

Using a top predator as a sentinel for environmental contamination with pathogenic bacteria: the Iberian wolf and leptospires

The Iberian wolf (Canis lupus) is the top predator in the Iberian environments in which it lives, feeding on a wide range of species, thus encountering a wide range of disease agents. Therefore, the wolf can serve as sentinel of environmental contamination with pathogens. We investigated the exposure of free-living wolves to 14 serovars of Leptospira interrogans sensu lato. Kidney samples from 49 wolves collected from 2010-2013 in northwestern Spain were analysed by culture, direct immunofluorescence and polymerase chain reaction. Tissue fluids were analysed for antibodies by a microscopic agglutination test. Ten wolves (observed prevalence: 20%, 95% confidence interval = 11-33%) showed evidence of contact with leptospires, eight through direct detection and nine through serology (7 wolves were positive according to both techniques). Titres below the cut-off level were also detected in seven cases. Serovars confirmed were Canicola (n = 4), Icterohaemorrhagiae (n = 3) and Sejroë, Ballum and Grippotyphosa (n = 1 each), indicating that wolves were infected with serovars for which dogs, rodents and ungulates, are the natural hosts and supporting the utility of the wolf and other large predators as environmental sentinels for pathogens.

TOP - um programa de cálculo de descritores topológicos para uso em correlações entre estrutura e atividade

A computational interface, using sybyl format as an input file, was created in order to calculate connectivity indexes. After generation and classification of all substructures, which derive from the molecular structure, this interface calculates all possible orders from zero up to the maximun number of bonds in the molecule. Other topological indexes such as Wiener and Schultz indexes can also be calculated.

Avaliação da influência da operação da termoelétrica a carvão na concentração dos metais e as no solo de Figueira, PR - Brasil

The aim of this work is to study metal and As concentrations in soil due to ash deposition from a coal plant at Figueira (PR), evaluating the macroelement (Al, Ca, Fe, Mg, Mn, Ti, V) and microelement (As, Cd, Co, Cr, Cu, Mo, Ni, Pb, Zn) concentrations in the soil around the coal plant. The plant operation caused a slight increase in the majority of the metal concentrations in the top soil close to the plant (up to 1 km) in the wind direction (NW). The elements As, Cd, Mo, Pb and Zn are considered likely soil pollutants, and As is considered the only critical element.

Development of an automated bench top electronic penetrometer

The aim of this study was to develop a an automated bench top electronic penetrometer (ABEP) that allows performing tests with high rate of data acquisition (up to 19,600 Hz) and with variation of the displacement velocity and of the base area of cone penetration. The mechanical components of the ABEP are: a supporting structure, stepper motor, velocity reducer, double nut ball screw and six penetration probes. The electronic components of ABEP are: a "driver" to control rotation and displacement, power supply, three load cells, two software programs for running and storing data, and a data acquisition module. This penetrometer presented in compact size, portable and in 32 validation tests it proved easy to operate, and showed high resolution, high velocity in reliability in data collection. During the validation tests the equipment met the objectives, because the test results showed that the ABEP could use different sizes of cones, allowed work at different velocities, showed for velocity and displacement, were only 1.3% and 0.7%, respectively, at the highest velocity (30 mm s-1) and 1% and 0.9%, respectively for the lowest velocity (0.1 mm s-1).

Effect of working pressure at different spray nozzles on drift quantification in wind tunnel

Each year, there is an increase in pesticide consumption and in its importance of use in the large-scale agricultural production, being fundamental the knowledge of application technology to the activity success. The objective of the present study was to evaluate the influence of working pressure on the drift generated by different spray nozzles, assessed in wind tunnel. The treatments were composed of two spray nozzles AXI 110015 and AXI 11002 with pressure levels of 276 and 414 kPa. The spray solution was composed by water and NaCl at 10%. The applications were conducted at wind speed of 2.0 m s-1, being the drift collected at 5.0; 10.0 and 15.0 m away from the spray boom and at heights of 0.2; 0.4; 0.6; 0.8 e 1.0 m from the tunnel floor. To both spray nozzles, the greatest drift was collected at the smallest distance to the spray-boom and at the lowest height. The AXI 11002 nozzle gave a smaller drift relative to the AXI 110015 nozzle for the two tested pressures and for all the collection points. Regardless of the nozzle, a rise in the working pressure increases the spray drift percentage at all distances in the wind tunnel.

Evaluation of roof slope and exposure with different roofing materials in reduced models of animal production facilities in spring and summer

The present study was conducted at the Department of Rural Engineering and the Department of Animal Morphology and Physiology of FCAV/Unesp, Jaboticabal, SP, Brazil. The objective was to verify the influence of roof slope, exposure and roofing material on the internal temperature of reduced models of animal production facilities. For the development of the research, 48 reduced and dissemble models with dimensions 1.00 × 1.00 × 0.50 m were used. The roof was shed-type, and the models faced to the North or South directions, with 24 models for each side of exposure. Ceramic, galvanized-steel and fibro tiles were used to build the roofs. Slopes varied between 20, 30, 40 and 50% for the ceramic tile and 10, 30, 40 and 50% for the other two. Inside the models, temperature readings were performed at every hour, for 12 months. The results were evaluated in a general linear model in a nested 3 × 4 × 2 factorial arrangement, in which the effects of roofing material and exposure were nested on the factor Slope. Means were compared by the Tukey test at 5% of probability. After analyzing the data, we observed that with the increase in the slope and exposure to the South, there was a drop in the internal temperature within the model at the geographic coordinates of Jaboticabal city (SP/Brazil).

Prediction of transients and control reactions in a transonic wind tunnel

This work describes a lumped parameter mathematical model for the prediction of transients in an aerodynamic circuit of a transonic wind tunnel. Control actions to properly handle those perturbations are also assessed. The tunnel circuit technology is up to date and incorporates a novel feature: high-enthalpy air injection to extend the tunnel’s Reynolds number capability. The model solves the equations of continuity, energy and momentum and defines density, internal energy and mass flow as the basic parameters in the aerodynamic study as well as Mach number, stagnation pressure and stagnation temperature, all referred to test section conditions, as the main control variables. The tunnel circuit response to control actions and the stability of the flow are numerically investigated. Initially, for validation purposes, the code was applied to the AWT ("Altitude Wind Tunnel" of NASA-Lewis). In the sequel, the Brazilian transonic wind tunnel was investigated, with all the main control systems modeled, including injection.

Wind tunnel simulation of atmospheric boundary layer flows

The present work shows how thick boundary layers can be produced in a short wind tunnel with a view to simulate atmospheric flows. Several types of thickening devices are analysed. The experimental assessment of the devices was conducted by considering integral properties of the flow and the spectra: skin-friction, mean velocity profiles in inner and outer co-ordinates and longitudinal turbulence. Designs based on screens, elliptic wedge generators, and cylindrical rod generators are analysed. The paper describes in detail the experimental arrangement, including the features of the wind tunnel and of the instrumentation. The results are compared with experimental data published by other authors and with naturally developed flows.

The scientific production in health and biological sciences of the top 20 Brazilian universities

Brazilian scientific output exhibited a 4-fold increase in the last two decades because of the stability of the investment in research and development activities and of changes in the policies of the main funding agencies. Most of this production is concentrated in public universities and research institutes located in the richest part of the country. Among all areas of knowledge, the most productive are Health and Biological Sciences. During the 1998-2002 period these areas presented heterogeneous growth ranging from 4.5% (Pharmacology) to 191% (Psychiatry), with a median growth rate of 47.2%. In order to identify and rank the 20 most prolific institutions in these areas, searches were made in three databases (DataCAPES, ISI and MEDLINE) which permitted the identification of 109,507 original articles produced by the 592 Graduate Programs in Health and Biological Sciences offered by 118 public universities and research institutes. The 20 most productive centers, ranked according to the total number of ISI-indexed articles published during the 1998-2003 period, produced 78.7% of the papers in these areas and are strongly concentrated in the Southern part of the country, mainly in São Paulo State.