Kinetic measurements during transient film growth on zinc

The electrochemical behaviour of zinc has been extensively studied in alkaline and acid media, but only a few studies have been reported in neutral solutions, particularly in deaerated media. Zinc passivation in neutral medium and the effect of the ClO4- ion on the nucleation and growth of the passive layer is studied in this paper by a transient technique at different electrolyte concentrations and applied potentials. ZnO growth rate was shown to decrease with increasing electrolyte concentration. Moreover, passive layer growth occurred followed by pitting nucleation and growth. Film growth and pit nucleation are explained by means of the Macdonald and Engell-Stolica models.

Preparative separation of polyphenols from artichoke by polyamide column chromatography and high-speed counter-current chromatography

An efficient method for the rapid separation and purification of polyphenols from artichoke by polyamide column chromatography in combination with high-speed counter-current chromatography (HSCCC) was successfully built. The crude ethanol extracts from dry artichoke were first pre-separated by polyamide column chromatography and divided in two parts as sample 1 and sample 2. Then, the samples were further separated by HSCCC and yielded 7.8 mg of chlorogenic acid (compound I), 24.5 mg of luteolin-7-O-β-D-rutinoside (compound II), 18.4 mg of luteolin-7-O-β-D-glucoside (compound III), and 33.4 mg of cynarin (compound IV) with purity levels of 92.0%, 98.2%, 98.5%, and 98.0%, respectively, as determined by high-performance liquid chromatography (HPLC) method. The chemical structures of these compounds were identified by electrospray ionization-mass spectrometry (ESI-MS) and nuclear magnetic resonance (NMR).

Dielectric spectroscopy and thermally stimulated discharge current in PEEK film

The complex permittivity of films of polyether ether ketone (PEEK) has been investigated over a wide range of frequency. There is no relaxation peak in the range of 1Hz to 10(5) Hz but in the low-frequency side (10-4 Hz) there is an evidence of a peak that also can be observed by thermally stimulated discharge current measurements. That peak is related with the glass transition temperature (Tg) of the polymer. The activation energy of the relaxation was found to be 0.44 eV, similar to that of several synthetic polymers. Space charges are important in the conduction mechanism as shown by discharging transient.

Effect of high hydrostatic pressure on the barrier properties of polyamide-6 films

Little is known about the barrier properties of polymer films during high pressure processing of prepackaged foods. In order to learn more about this, we examined the influence of high hydrostatic pressure on the permeation of raspberry ketone (dissolved in ethanol/water) through polyamide-6 films at temperatures between 20 and 60ºC. Permeation was lowered by increasing pressure at all temperatures. At 23°C, the increasing pressure sequence 0.1, 50, 100, 150, and 200 MPa correlated with the decreasing permeation coefficients P/(10(9) cm² s-1) of 6.2, 3.8, 3.0, 2.2, and 1.6. Analysis of the permeation kinetics indicated that this effect was due to a reduced diffusion coefficient. Pressure and temperature acted antagonistically to each other. The decrease in permeation at 200 MPa was compensated for by a temperature increase of 20ºC. After release of pressure, the former permeation coefficients were recovered, which suggests that this `pressure effect' is reversible. Taken together, our data revealed no detrimental effects of high hydrostatic pressure on the barrier properties of polymer films.

Identification of fatty foods with contamination possibilities by plasticizers when stored in PVC film packaging

Poly-(vinyl chloride) (PVC) requires the addition of plasticizers - additives that give flexibility and malleability for its processing into flexible film. The most used ones are: di-(2-ethylhexyl) adipate (DEHA) and di-(2-ethylhexyl) phthalate (DEHP). Toxic effects of DEHP have been observed by several authors. Phthalates are being replaced by alternative substances in PVC flexible products, because of their possible toxicological effects. DEHA is a substitute for phthalates widely used as a plasticizer in PVC materials for involving food. Some authors have shown that the exposure to DEHA also induces toxicity. A cross-sectional study was performed to identify which fatty foods carry the possibility of contamination by DEHP and DEHA. Eighteen different foods with at least 3% (m/m) fat and the possibility of being wrapped in plastic film were determined. This study suggested that all foods were subject to contamination by DEHP and DEHA in those conditions - in decreasing consumption order of 96 to 22% in the convenience sample. New guidelines on the limits of DEHA and DEHP established by the Brazilian legislation, as additives in PVC film for packaging fatty food, are still relevant to ensure human health.

Film with anthocyanins as an indicator of chilled pork deterioration

An indicator can be defined as a substance which indicates the presence or absence of another substance or the degree of a certain reaction through characteristic changes, especially color. Therefore, the aim of this work is to evaluate the performance of a bio-based film with anthocyanin as an indicator of chilled pork deterioration. A film made of cassava starch, glycerol, and grape anthocyanins was prepared using the casting technique. Pork loin samples were put in Petri dishes containing an anthocyanin film on the bottom and stored at 4 ºC. Psychrotrophic microorganism count and the pH of the pork loin samples were analyzed for a 14 day- period. At the same time, the films were subjected to colorimetric analysis using D65 illuminant and the CIELAB system. Chroma and hue angle data for these films were evaluated by Anova and Dunnett's test. An increase in the microbial population and in the pH was observed over the storage period as result of pork deterioration. Color changes were also identified in the film. However, only at the beginning of the storage period was it possible to establish a correlation between film color and pork deterioration. The shelf life end-point could not be clearly detected by the film.

Effect of previous chilling storage on quality loss in frozen (–20 °C) sierra (Scomberomorus sierra) muscle packed with a low-density polyethylene film containing butylated hydroxytoluene

Rancidity development during frozen storage (–20 °C) of sierra fish (Scomberomorus sierra) was studied. Fillets were packed in low-density polyethylene films with and without butylated hydroxytoluene added (BHT-LDPE and LDPE respectively). Fillets stored with no package were used as control. Special attention was given to the effect of previous ice storage (0, 3, 6, 9 and 15 days) on the quality of the frozen fish. Physical (pH and texture) and chemical (peroxide value, PV and thiobarbituric acid index, TBA-i) analyses were carried out. Lipid oxidation increased with ice storage time in fish muscle without film packing, being greater than the film packed muscle (with and without antioxidant). An effect of previous ice storage time was observed on the frozen product (in all treatments). However, fish muscle with film packing containing antioxidant showed less lipid deterioration. Under the conditions applied in this study, the plastic films with antioxidant prevented the lipids oxidation during the cold handling of the sierra muscle.

Quality changes during frozen storage of blue shrimp (Litopenaeus stylirostris) with antioxidant, α-tocopherol, under different conditions

Fresh blue shrimp (Litopenaeus stylirostris) muscle was stored with antioxidants under different conditions: ANTIOX 2%, packed in bilayer film of polyamide-low density polyethylene film (PA-LDPE) with 2% α-tocopherol; ANTIOX 4%, packed in PA-LDPE film with 4% α-tocopherol; and ANTIOX-GLAZED, samples stored glazed with 2% α-tocopherol. Shrimps packed in PA-LDPE without α-tocopherol were used as CONTROL. All samples were stored at –20 °C for 120 days. As compared to the CONTROL, the shrimp stored with the antioxidant showed lower lipid oxidation (0.10-0.14 vs 1.58 mgMA/kg of muscle), lost less firmness and astaxanthin content. ANTIOX 2% and ANTIOX-GLAZED showed the lowest concentrations of formaldehyde (0.081-0.083 μM/g). There were no significant differences in color and sensory properties, but differences in the integrity of the muscle fibers were observed. The treatments with α-tocopherol maintained the shrimp muscle quality during frozen storage. However, no significant differences were found between these treatments.

The use of film coating on the performance of treated corn seed

The main objective of seed coating technology using polymers is to improve the physical, physiological and sanitary characteristics of seed performance. The objectives of the present study were to determine: the plantability of corn seeds treated with insecticide, fungicide and graphite, covered with a film coating; the dust retention on treated corn seeds; and the leaching of applied products on corn seeds covered by a film coating. Seed plantability was determined by counting the skips and double seeds; dust was determined by using fiberglass paper in mg.100 g-1 of seeds; and the leaching was determined by collecting the material leached in a 10 cm layer of sand after irrigation. The following conclusions were made: seeds covered with film coating effectively reduce skips and double seeds; film coating effectively reduces the formation of dust from the seeds; film coated seeds minimize the leaching of the insecticide applied in seed treatment; and there are differences in effectiveness related to film coating type and dosage.