A fotocatálise heterogênea e sua aplicação ambiental

This article gives some basic principles of heterogeneous photocatalysis using titanium dioxide as photocatalyst and the state of art of its applications to the abatement of aqueous and atmospheric pollutants.

Tratamento de chorume de aterro sanitário por fotocatálise heterogênea integrada a processo biológico convencional

The chemical and microbiological decomposition of the garbage deposited in landfills leads to the generation of a dark and malodorous liquid residue that shows a chemical composition of extreme variability and complexity. When matured, the leachates show low biodegradability, which makes it difficult to treat by conventional biological processes. In this work a new strategy for the treatment of landfill leachates is proposed, involving a preliminary treatment by heterogeneous photocatalysis followed by an activated sludge system. The results demonstrate that photochemical treatments of 60 and 90 min significantly enhance the leachates' biodegradability favoring subsequent biological treatment. The biodegradability rate (BOD/COD) was also greatly enhanced.

Fotocatálise heterogênea com TiO2 para oxidação de arsênio e sua remoção de águas por coprecipitação com sulfato férrico

The oxidation of arsenic (As(III) to As(V)) in water samples was performed by heterogeneous photocatalysis using a TiO2 film immobilized inside a photochemical reactor. After oxidation, As(V) was removed from the water samples by coprecipitation with ferric sulfate. The final conditions of oxidation and arsenic removal (TiO2 film prepared with a suspension: 10% (w/v); pH: 7.0; oxidation time: 30 min and Fe3+ concentration: 50 mg L-1) were applied in natural water samples which were supplemented with 1.0 mg L-1 of As(III) to verify the influence of the matrix. After treatment, more than 99% of arsenic was removed from the water.

Estudo da fotocatálise heterogênea sobre Ti/TiO2 na descoloração de corantes sintéticos

The main goal of this paper was to study the degradation of synthetic dyes using photoelectrocatalytic properties of particulate films of TiO2 supported on plates of titanium and stimulated by UV-Vis radiation. The dyes decolorizations were measured using spectrophotometric methods to verify which the conditions on Ti/TiO2 electrode was the best for the photoelectrodegradation of them. The results showed that decolorization rates were higher than 90% during a period of 270 min. FT-IR spectroscopy showed that intermediate substances were formed after the decolorization and N=N group/aromatic structures were preserved independently of the specific structure of the dyes.

Incorporação de dióxido de titânio em zeólitas para emprego em fotocatálise heterogênea

This work proposes the study of heterogeneous photocatalysis using TiO2 impregnated in zeolites beta, ZSM-5, mordenite, NaXb, NaXp and NaY for the decomposition of methylene blue. The catalysts were characterized by XRD, IR, textural analyses by N2 adsorption, SEM, DRS and the reaction of decomposition was monitored by UV visible. The results indicated that didn't have structural changes in the catalysts after Ti impregnations, only in the case of NaY and NaX zeolites. The better photocatalyst to metylene blue decomposition was beta/Ti zeolite due had one structure more accessible (with bigger porous) helping in TiO2 dispersion and catalytic active.

ÓXIDOS DE NIÓBIO: UMA VISÃO SOBRE A SÍNTESE DO Nb2O5 E SUA APLICAÇÃO EM FOTOCATÁLISE HETEROGÊNEA

Despite the fact that Brazil is the world’s largest niobium mineral producer, governmental interest in exploration of the mineral leading to more valuable derived materials is scarce, which has reduced the country’s knowledge about a wider range of technological applications for this metal. Niobium pentoxide stands out due its remarkable electronic, structural, and textural properties. Therefore, this review aims to highlight its main properties, synthetic methods, and applications, with a particular focus on photocatalysts based on Nb2O5. This review will highlight the potential of Nb2O5 and encourage the study of niobium and its compounds in technological and environmental applications.

Fotodegradação heterogênea de efluente de polpa kraft branqueada com cloro

A polpa celulósica da madeira deve ser branqueada e alvejada para atingir elevado valor comercial. O cloro é muito eficiente no branqueamento da polpa obtida por processo químico, mas também produz subprodutos altamente poluentes e tóxicos. Outros produtos químicos de branqueamento têm sido propostos para reduzir a toxicidade, mas são mais caros e menos versáteis. A fotodegradação catalítica com o uso de radiação ultravioleta (UV) foi feita para avaliar o potencial de redução do teor de poluentes encontrados em um efluente de branqueamento de celulose com o uso de cloro. A polpa celulósica de Pinus taeda foi produzida e branqueada em laboratório. Três litros de efluente receberam 3 g de dióxido de titânio (TiO2) e foram submetidos à radiação UV. Essa radiação foi produzida com o uso da ampola de lâmpada de vapor de mercúrio de alta pressão de 250 W (12.500 Lm) durante 240 min. A fotodegradação a 25 ºC por 240 min com UV reduziu em cerca de 43% a cor, 40% a DBO5, 50% a DQO, 40% de material calcinável e 45% do carbono orgânico total, além de baixar a toxicidade LC50 para o efluente tratado. O bioindicador Artemia salina apresentou o tempo de sobrevida maior do que 1.000% para o efluente tratado. A distribuição dos pontos experimentais de 0 a 240 min sugere que a fotodegradação deveria ser estendida. Assim, a redução de poluentes observada sugere que esse processo oxidativo avançado (POA), com fotocatálise com o uso de UV e TiO2, pode ser conveniente para o tratamento de efluentes clorados de branqueamento. Isso pode viabilizar o uso seguro de branqueamento com cloro.

Fotocatálise eletroquímica de atrazina sobre dióxido de titânio: efeito de diferentes parâmetros experimentais

The atrazine photoelectrochemical degradation has been examined in solutions containing TiO2 on immobilized films under a variety of experimental conditions. It was possible to observe that the supporting electrolyte nature affects the intensity of the photocurrent, being an indicative of the adsorption process. The disappearance of the organic molecule follows approximately a pseudo-first order kinetic. As mineralization product, NH4+ and NO3- ion have been identified. These results indicated that the formation of NH4+ ion can be associated to the effect of atrazine adsorption, due to need of potential adaptation together with a variation in the supporting electrolyte concentration.

Fotodegradación heterogénea de bisfenol A en agua con dióxido de titanio

Bisphenol A (BPA) is a monomer used in epoxy resin and polycarbonate manufacture. This molecule is considered as an endocrine disruptor that causes different diseases. The human exposition to this non biodegrable substance is increasing in the time; in particular, water is contaminated by industrial remainder flow. In this article heterogeneous photo degradation of a solution of BPA in water solution using a catalytic photo reactor with UV light and titanium dioxide (TiO2) was evaluated. High performance liquid chromatography (HPLC) was used to analyze the photo degradation of BPA solutions. The influence of titanium dioxide amount, BPA concentration, reaction temperature and the catalyst state like suspension and immobilized were also determinated. The highest elimination of BPA was 83.2%, in 240 min, beginning with 0.05 mM of BPA and 100 mg/L of TiO2 in suspension.

Efeitos de agentes oxidantes e oxigênio dissolvido na descoloração do azo corante acid orange 7 por fotólise e fotocatálise

The decolorization of acid orange 7 azo dye by photolysis and photocatalysis by ZnO was investigated in the presence of oxidants such as NaClO3, NaBrO3, NaIO4, and K2S2O8 in an open reactor at 30 ºC. The decolorization was relatively fast at lower oxidants concentrations and slow rate at larger concentrations, except for persulfate in the photocatalysis. Concerning photolysis the rate constant enhanced gradually, except for chlorate, outreaching the obtained values by photocatalysis, at higher concentrations. The air saturation decreased the rate constant in both processes and indicated that the azo dye can be decolorized without dissolved oxygen in persulfate medium.

Nanoestruturas em fotocatálise: uma revisão sobre estratégias de síntese de fotocatalisadores em escala nanométrica

Advanced oxidative processes (AOPs) are based on chemical processes that can generate free radicals, such as hydroxyl radicals (.OH) which are strong, non-selective oxidant species that react with the vast majority of organic compounds. Nanostructured semiconductors, especially titanium dioxide (TiO2) in the anatase phase, are well-established photocatalysts for this process, which have proved to be useful in the degradation of dyes, pesticides and other contaminants. Research in different strategies for the synthesis of nanostructured semiconductors, with particular characteristic is currently a topic of interest in many studies. Thus, this paper presents a review about various synthesis strategies of nanostructured photocatalysts.

Produção de biodiesel através de transesterificação in situ de sementes de girassol via catálise homogênea e heterogênea

The objective of this work is to show the results of the in situ transesterification of sunflower seed oil with methanol on basic homogeneous and heterogeneous catalysis for the production of biodiesel. In homogeneous catalysis, the activity of KOH and K2CO3 were evaluated using the same oil:methanol ratio of 1:90. KOH showed to be more active than K2CO3, leading to total conversion in biodiesel after 1h reaction time. In the heterogeneous catalysis the activity of K2CO3/Al2O3 was comparable to the activity of K2CO3 bulk: 53.0 and 66.6% resp. The properties of samples of biodiesel produced by homogeneous and heterogeneous catalysis were evaluated and are in accordance with the recommended fuel properties.

Biocatálise heterogênea em fase sólido/gás: princípios e aplicações

Enzymatic conversion of gaseous substrates into products in aquo-restricted media, using enzymes or whole cells (free and immobilized) as biocatalysts, constitutes a promising technology for the development of clearer processes. Solid-gas systems offer high production rates for minimal plant sizes, allow important reduction of treated volumes, and permit simplified downstream processes. In this review article, principles and applications of solid-gas biocatalysis are discussed. Comparisons of its advantages and disadvantages with those of the organic- and aqueous-phase reactions are also presented herein.

Síntese e caracterização textural do catalisador CeO2/TiO2 obtido via sol-gel: fotocatálise do composto modelo hidrogenoftalato de potássio

Este trabalho descreve um método de modificação do TiO2 obtido pelo processo sol-gel, através da adição de óxido de cério no momento da síntese. O material foi caracterizado por adsorção de N2 a 77K. A adição de CeO2 aumenta a área específica do catalisador em 135% e reduz o diâmetro de poros. A atividade catalítica desses materiais foi verificada frente à reação de foto-decomposição do hidrogenoftalato de potássio e comparada ao TiO2 comercial P25 da Degussa.

Síntese de éster de cadeia longa via catálise básica heterogênea

Um éster de cadeia longa foi sintetizado pela transesterificação do palmitato de metila com álcoois de cadeia longa usando óxido de magnésio como catalisador. Esses foram preparados pela decomposição térmica de diferentes precursores, buscando estabelecer relações entre propriedades estruturais e atividades. Temperatura e quantidade de catalisador foram variados para se avaliar o rendimento do éster em função do precursor utilizado na preparação do óxido.